79 resultados para Bounded parameters
Resumo:
A combined mathematical model for predicting heat penetration and microbial inactivation in a solid body heated by conduction was tested experimentally by inoculating agar cylinders with Salmonella typhimurium or Enterococcus faecium and heating in a water bath. Regions of growth where bacteria had survived after heating were measured by image analysis and compared with model predictions. Visualisation of the regions of growth was improved by incorporating chromogenic metabolic indicators into the agar. Preliminary tests established that the model performed satisfactorily with both test organisms and with cylinders of different diameter. The model was then used in simulation studies in which the parameters D, z, inoculum size, cylinder diameter and heating temperature were systematically varied. These simulations showed that the biological variables D, z and inoculum size had a relatively small effect on the time needed to eliminate bacteria at the cylinder axis in comparison with the physical variables heating temperature and cylinder diameter, which had a much greater relative effect. (c) 2005 Elsevier B.V All rights reserved.
Resumo:
An atoxigenic strain of Penicillium camemberti was superficially inoculated on fermented sausages in an attempt to improve their sensory properties. The growth of this mould on the surface of the sausages resulted in an intense proteolysis and lipolysis, which caused an increase in the concentration of free amino acids, free fatty acids (FFA) and volatile compounds. Many of these were derived from amino acid catabolism and were responsible for the "ripened flavour", i.e. branched aldehydes and the corresponding alcohols, acids and esters. The development of the fungal mycelia on the surface of the sausages also protected lipids from oxidation, resulting in both lower 2-thiobarbituric acid (TBARS) values and lipid oxidation-derived compounds, such as aliphatic aldehydes and alcohols. The sensory analysis of superficially inoculated sausages showed clear improvements in odour and flavour and, as a consequence, in the overall quality of the sausages. Therefore, this strain is proposed as a potential starter culture for dry fermented sausage production. (C) 2002 Elsevier Science B.V All rights reserved.
Resumo:
In this paper new robust nonlinear model construction algorithms for a large class of linear-in-the-parameters models are introduced to enhance model robustness, including three algorithms using combined A- or D-optimality or PRESS statistic (Predicted REsidual Sum of Squares) with regularised orthogonal least squares algorithm respectively. A common characteristic of these algorithms is that the inherent computation efficiency associated with the orthogonalisation scheme in orthogonal least squares or regularised orthogonal least squares has been extended such that the new algorithms are computationally efficient. A numerical example is included to demonstrate effectiveness of the algorithms. Copyright (C) 2003 IFAC.
Resumo:
Hidden Markov Models (HMMs) have been successfully applied to different modelling and classification problems from different areas over the recent years. An important step in using HMMs is the initialisation of the parameters of the model as the subsequent learning of HMM’s parameters will be dependent on these values. This initialisation should take into account the knowledge about the addressed problem and also optimisation techniques to estimate the best initial parameters given a cost function, and consequently, to estimate the best log-likelihood. This paper proposes the initialisation of Hidden Markov Models parameters using the optimisation algorithm Differential Evolution with the aim to obtain the best log-likelihood.
Resumo:
We propose a simple and computationally efficient construction algorithm for two class linear-in-the-parameters classifiers. In order to optimize model generalization, a forward orthogonal selection (OFS) procedure is used for minimizing the leave-one-out (LOO) misclassification rate directly. An analytic formula and a set of forward recursive updating formula of the LOO misclassification rate are developed and applied in the proposed algorithm. Numerical examples are used to demonstrate that the proposed algorithm is an excellent alternative approach to construct sparse two class classifiers in terms of performance and computational efficiency.
Resumo:
Pine beauty moth (Panolis flammea D&S, Lepidoptera: Noctuidae) were reared individually from egg hatch to pupation on one of three host plants, Pinus sylvestris (native host plant), Pinus contorta (Central Interior seed origin - good quality introduced host) and P. contorta (Alaskan seed origin - poor quality introduced host). After emerging from the pupae the adult moths were confined to a Skeena River seed origin of P. contorta. Female pupal weight and adult life span were significantly higher on P. sylvestris than on the two lodgepole pine seed origins. Development time was, however, not significantly different between treatments, but larval mean relative growth rate was found to be negatively correlated with birth weight and positively correlated with pupal weight. The time to emerge from the pupa was also not significantly different between treatments. However, there were marked differences between the genders. Male moths lost a significantly greater proportion of their weight over the pupal stage but lived significantly longer as adults than the females. Female moths emerged from the pupal stage significantly sooner than male moths. There was no apparent advantage of lai-ge birth size when looked at in terms of subsequent performance. These results are discussed in light of current life history theory.
Resumo:
Accurate single trial P300 classification lends itself to fast and accurate control of Brain Computer Interfaces (BCIs). Highly accurate classification of single trial P300 ERPs is achieved by characterizing the EEG via corresponding stationary and time-varying Wackermann parameters. Subsets of maximally discriminating parameters are then selected using the Network Clustering feature selection algorithm and classified with Naive-Bayes and Linear Discriminant Analysis classifiers. Hence the method is assessed on two different data-sets from BCI competitions and is shown to produce accuracies of between approximately 70% and 85%. This is promising for the use of Wackermann parameters as features in the classification of single-trial ERP responses.
Resumo:
This paper discusses how the use of computer-based modelling tools has aided the design of a telemetry unit for use with oil well logging. With the aid of modern computer-based simulation techniques, the new design is capable of operating at data rates of 2.5 times faster than previous designs.
Resumo:
Convincing lipid-lowering effects of the fructooligosaccharide inulin have been demonstrated in animals, yet attempts to reproduce similar effects in humans have generated conflicting results. This may be because of the much lower doses used in humans as a result of the adverse gastrointestinal symptoms exhibited by most subjects consuming daily doses in excess of 30 g. Two studies that fed either oligofructose (20 g/d) or inulin (14 g/d) observed no effect on fasting total, LDL or HDL cholesterol, or serum triglycerides. Two other studies that fed inulin either in a breakfast cereal (9 g/d) or as a powdered addition to beverages and meals (10 g/d) reported similar reductions in fasting triglycerides (227 and 219%, respectively). In one of these studies, total and LDL cholesterol concentrations were also modestly reduced (5 and 7%, respectively). Because animal studies have identified inhibition of hepatic fatty acid synthesis as the major site of action for the triglyceride-lowering effects of inulin, and because this pathway is relatively inactive in humans unless a high carbohydrate diet is fed, future attempts to demonstrate lipid-lowering effects of inulin should consider the nature of the background diet as a determinant of response.
Resumo:
We present the results of a systematic study of the influence of carbon surface oxidation on Dubinin–Astakhov isotherm parameters obtained from the fitting of CO2 adsorption data. Using GCMC simulations of adsorption on realistic VPC models differing in porosity and containing the most frequently occurring carbon surface functionalities (carboxyls, hydroxyls and carbonyls) and their mixtures, it is concluded that the maximum adsorption calculated from the DA model is not strongly affected by the presence of oxygen groups. Unfortunately, the same cannot be said of the remaining two parameters of this model i.e. the heterogeneity parameter (n) and the characteristic energy of adsorption (E0). Since from the latter the pore diameters of carbons are usually calculated, by inverse-type relationships, it is concluded that they are questionable for carbons containing surface oxides, especially carboxyls.
Resumo:
This paper develops and tests formulas for representing playing strength at chess by the quality of moves played, rather than by the results of games. Intrinsic quality is estimated via evaluations given by computer chess programs run to high depth, ideally so that their playing strength is sufficiently far ahead of the best human players as to be a `relatively omniscient' guide. Several formulas, each having intrinsic skill parameters s for `sensitivity' and c for `consistency', are argued theoretically and tested by regression on large sets of tournament games played by humans of varying strength as measured by the internationally standard Elo rating system. This establishes a correspondence between Elo rating and the parameters. A smooth correspondence is shown between statistical results and the century points on the Elo scale, and ratings are shown to have stayed quite constant over time. That is, there has been little or no `rating inflation'. The theory and empirical results are transferable to other rational-choice settings in which the alternatives have well-defined utilities, but in which complexity and bounded information constrain the perception of the utility values.