Inverting recurrent neural networks for internal model control of nonlinear systems

In this paper, we show how a set of recently derived theoretical results for recurrent neural networks can be applied to the production of an internal model control system for a nonlinear plant. The results include determination of the relative order of a recurrent neural network and invertibility of such a network. A closed loop controller is produced without the need to retrain the neural network plant model. Stability of the closed-loop controller is also demonstrated.

Multiband OFDM modulation and demodulation for ultra wideband communications

This chapter considers the Multiband Orthogonal Frequency Division Multiplexing (MB- OFDM) modulation and demodulation with the intention to optimize the Ultra-Wideband (UWB) system performance. OFDM is a type of multicarrier modulation and becomes the most important aspect for the MB-OFDM system performance. It is also a low cost digital signal component efficiently using Fast Fourier Transform (FFT) algorithm to implement the multicarrier orthogonality. Within the MB-OFDM approach, the OFDM modulation is employed in each 528 MHz wide band to transmit the data across the different bands while also using the frequency hopping technique across different bands. Each parallel bit stream can be mapped onto one of the OFDM subcarriers. Quadrature Phase Shift Keying (QPSK) and Dual Carrier Modulation (DCM) are currently used as the modulation schemes for MB-OFDM in the ECMA-368 defined UWB radio platform. A dual QPSK soft-demapper is suitable for ECMA-368 that exploits the inherent Time-Domain Spreading (TDS) and guard symbol subcarrier diversity to improve the receiver performance, yet merges decoding operations together to minimize hardware and power requirements. There are several methods to demap the DCM, which are soft bit demapping, Maximum Likelihood (ML) soft bit demapping, and Log Likelihood Ratio (LLR) demapping. The Channel State Information (CSI) aided scheme coupled with the band hopping information is used as a further technique to improve the DCM demapping performance. ECMA-368 offers up to 480 Mb/s instantaneous bit rate to the Medium Access Control (MAC) layer, but depending on radio channel conditions dropped packets unfortunately result in a lower throughput. An alternative high data rate modulation scheme termed Dual Circular 32-QAM that fits within the configuration of the current standard increasing system throughput thus maintaining the high rate throughput even with a moderate level of dropped packets.

Incorporating HACCP into national food control systems - Analyzing progress in the United Arab Emirates

Today governments and other parties involved in food control are under constant pressure to find more efficient and effective mechanisms to carry out their mandates for food control. This has led to international recognition of the importance of the HACCP system as a food control tool and guidance on the role of government agencies in the application of such a system has been developed. Based on this international guidance, four main elements identified as key activities have been used in this study to evaluate the progress of HACCP implementation in the UAE. The internal Strengths and Weaknesses, as well as the external Opportunities and Threats that the government is facing towards the implementation of a HACCP-based food control system have been identified. The analysis shows that the government’s dedicated role has been an essential driving force to encourage the implementation of a HACCP-based food control system. Some areas of difficulty, including the dependence on high levels of food imports, are highlighted.

Coping with delays for real-time gaze control (The Fall and Rise of the Smiths Regulator)

In this paper we describe how to cope with the delays inherent in a real time control system for a steerable stereo head/eye platform. A purposive and reactive system requires the use of fast vision algorithms to provide the controller with the error signals to drive the platform. The time-critical implementation of these algorithms is necessary, not only to enable short latency reaction to real world events, but also to provide sufficiently high frequency results with small enough delays that controller remain stable. However, even with precise knowledge of that delay, nonlinearities in the plant make modelling of that plant impossible, thus precluding the use of a Smith Regulator. Moreover, the major delay in the system is in the feedback (image capture and vision processing) rather than feed forward (controller) loop. Delays ranging between 40msecs and 80msecs are common for the simple 2D processes, but might extend to several hundred milliseconds for more sophisticated 3D processes. The strategy presented gives precise control over the gaze direction of the cameras despite the lack of a priori knowledge of the delays involved. The resulting controller is shown to have a similar structure to the Smith Regulator, but with essential modifications.

Modal coupling in linear control systems using robust eigenstructure assignment

Eigenvalue assignment methods are used widely in the design of control and state-estimation systems. The corresponding eigenvectors can be selected to ensure robustness. For specific applications, eigenstructure assignment can also be applied to achieve more general performance criteria. In this paper a new output feedback design approach using robust eigenstructure assignment to achieve prescribed mode input and output coupling is described. A minimisation technique is developed to improve both the mode coupling and the robustness of the system, whilst allowing the precision of the eigenvalue placement to be relaxed. An application to the design of an automatic flight control system is demonstrated.

Roll of the rhythmic component in the proactive control of a human hand

In terms of evolution, the strategy of catching prey would have been an important part of survival in a constantly changing environment. A prediction mechanism would have developed to compensate for any delay in the sensory-motor system. In a previous study, “proactive control” was found, in which the motion of the hands preceded the virtual moving target. These results implied that the positive phase shift of the hand motion represents the proactive nature of the visual-motor control system, which attempts to minimize the brief error in the hand motion when the target changes position unexpectedly. In our study, a visual target moves in circle (13 cm diameter) on a computer screen, and each subject is asked to keep track of the target’s motion by the motion of a cursor. As the frequency of the target increases, a rhythmic component was found in the velocity of the cursor in spite of the fact that the velocity of the target was constant. The generation of a rhythmic component cannot be explained simply as a feedback mechanism for the phase shifts of the target and cursor in a sensory-motor system. Therefore, it implies that the rhythmic component was generated to predict the velocity of the target, which is a feed-forward mechanism in the sensory-motor system. Here, we discuss the generation of the rhythmic component and its roll in the feed-forward mechanism.

Microcontroller-based peak current mode control using digital slope compensation

Microcontroller-based peak current mode control of a buck converter is investigated. The new solution uses a discrete time controller with digital slope compensation. This is implemented using only a single-chip microcontroller to achieve desirable cycle-by-cycle peak current limiting. The digital controller is implemented as a two-pole, two-zero linear difference equation designed using a continuous time model of the buck converter and a discrete time transform. Subharmonic oscillations are removed with digital slope compensation using a discrete staircase ramp. A 16 W hardware implementation directly compares analog and digital control. Frequency response measurements are taken and it is shown that the crossover frequency and expected phase margin of the digital control system match that of its analog counterpart.

Securing critical infrastructures and critical control systems: approaches for threat protection

The increased use of technology is necessary in order for industrial control systems to maintain and monitor industrial, infrastructural, or environmental processes. The need to secure and identify threats to the system is equally critical. Securing Critical Infrastructures and Critical Control Systems: Approaches for Threat Protection provides a full and detailed understanding of the vulnerabilities and security threats that exist within an industrial control system. This collection of research defines and analyzes the technical, procedural, and managerial responses to securing these systems.

Bio-inspired autonomous visual vertical control of a quadrotor UAV

Near ground maneuvers, such as hover, approach and landing, are key elements of autonomy in unmanned aerial vehicles. Such maneuvers have been tackled conventionally by measuring or estimating the velocity and the height above the ground often using ultrasonic or laser range finders. Near ground maneuvers are naturally mastered by flying birds and insects as objects below may be of interest for food or shelter. These animals perform such maneuvers efficiently using only the available vision and vestibular sensory information. In this paper, the time-to-contact (Tau) theory, which conceptualizes the visual strategy with which many species are believed to approach objects, is presented as a solution for Unmanned Aerial Vehicles (UAV) relative ground distance control. The paper shows how such an approach can be visually guided without knowledge of height and velocity relative to the ground. A control scheme that implements the Tau strategy is developed employing only visual information from a monocular camera and an inertial measurement unit. To achieve reliable visual information at a high rate, a novel filtering system is proposed to complement the control system. The proposed system is implemented on-board an experimental quadrotor UAV and shown not only to successfully land and approach ground, but also to enable the user to choose the dynamic characteristics of the approach. The methods presented in this paper are applicable to both aerial and space autonomous vehicles.

Bioinspired autonomous visual vertical control of a quadrotor unmanned aerial vehicle

Near-ground maneuvers, such as hover, approach, and landing, are key elements of autonomy in unmanned aerial vehicles. Such maneuvers have been tackled conventionally by measuring or estimating the velocity and the height above the ground, often using ultrasonic or laser range finders. Near-ground maneuvers are naturally mastered by flying birds and insects because objects below may be of interest for food or shelter. These animals perform such maneuvers efficiently using only the available vision and vestibular sensory information. In this paper, the time-tocontact (tau) theory, which conceptualizes the visual strategy with which many species are believed to approach objects, is presented as a solution for relative ground distance control for unmanned aerial vehicles. The paper shows how such an approach can be visually guided without knowledge of height and velocity relative to the ground. A control scheme that implements the tau strategy is developed employing only visual information from a monocular camera and an inertial measurement unit. To achieve reliable visual information at a high rate, a novel filtering system is proposed to complement the control system. The proposed system is implemented onboard an experimental quadrotor unmannedaerial vehicle and is shown to not only successfully land and approach ground, but also to enable the user to choose the dynamic characteristics of the approach. The methods presented in this paper are applicable to both aerial and space autonomous vehicles.

Global observations and forecast skill

The impact of selected observing systems on forecast skill is explored using the European Centre for Medium-Range Weather Forecasts (ECMWF) 40-yr reanalysis (ERA-40) system. Analyses have been produced for a surface-based observing system typical of the period prior to 1945/1950, a terrestrial-based observing system typical of the period 1950-1979 and a satellite-based observing system consisting of surface pressure and satellite observations. Global prediction experiments have been undertaken using these analyses as initial states, and which are available every 6 h, for the boreal winters of 1990/1991 and 2000/2001 and the summer of 2000, using a more recent version of the ECMWF model. The results show that for 500-hPa geopotential height, as a representative field, the terrestrial system in the Northern Hemisphere extratropics is only slightly inferior to the control system, which makes use of all observations for the analysis, and is also more accurate than the satellite system. There are indications that the skill of the terrestrial system worsens slightly and the satellite system improves somewhat between 1990/1991 and 2000/2001. The forecast skill in the Southern Hemisphere is dominated by the satellite information and this dominance is larger in the latter period. The overall skill is only slightly worse than that of the Northern Hemisphere. In the tropics (20 degrees S-20 degrees N), using the wind at 850 and 250 hPa as representative fields, the information content in the terrestrial and satellite systems is almost equal and complementary. The surface-based system has very limited skill restricted to the lower troposphere of the Northern Hemisphere. Predictability calculations show a potential for a further increase in predictive skill of 1-2 d in the extratropics of both hemispheres, but a potential for a major improvement of many days in the tropics. As well as the Eulerian perspective of predictability, the storm tracks have been calculated from all experiments and validated for the extratropics to provide a Lagrangian perspective.

Multi-agent collaboration for decision support in shared zones of intelligent buildings

In domain of intelligent buildings, saving energy in buildings and increasing preferences of occupants are two important factors. These factors are the important keys for evaluating the performance of work environment. In recent years, many researchers combine these areas to create the system that can change from original to the modern work environment called intelligent work environment. Due to advance of agent technology, it has received increasing attention in the area of intelligent pervasive environments. In this paper, we review several issues in intelligent buildings, with respect to the implementation of control system for intelligent buildings via multi-agent systems. Furthermore, we present the MASBO (Multi-Agent System for Building cOntrol) that has been implemented for controlling the building facilities to reach the balancing between energy efficiency and occupant’s comfort. In addition to enhance the MASBO system, the collaboration through negotiation among agents is presented.

The role of the Hellenic food safety authority in Greece: implementation strategies

During the last 15 years, a series of food scares and crises (BSE, dioxin. foot and mouth disease) have seriously under-mined public confidence in food producers and operators and their capacity to produce safe food. As a result, food safety has become a top priority of the European legislative authorities and systems of national food control have been tightened up and have included the establishment of the European Food Safety Authority. In Greece a law creating the Hellenic Food Safety Authority has been approved. The main objectives of this Authority are to promote the food security to consumers and inform them of any changes or any development in the food and health sector. The paper reviews the general structure of the current food control system in Greece. It describes the structure and the mission of the Hellenic Food Safety Authority and explains the strategy to carry out inspections and the analysis of the preliminary results of such inspections. Details are also given of the personnel training and certification and accreditation standards to be met by the Authority by the end of 2004. (c) 2005 Elsevier Ltd. All rights reserved.

Modelling energy consumption of relay-enabled MAC protocols in ad hoc networks

To enhance the throughput of ad hoc networks, dual-hop relay-enabled transmission schemes have recently been proposed. Since in ad hoc networks throughput is normally related to their energy consumption, it is important to examine the impact of using relay-enabled transmissions on energy consumption. In this paper, we present an analytical energy consumption model for dual-hop relay-enabled medium access control (MAC) protocols. Based on the recently reported relay-enabled distributed coordination function (rDCF), we have shown the efficacy of the proposed analytical model. This is a generalized model and can be used to predict energy consumption in saturated relay-enabled ad hoc networks via energy decomposition. This is helpful in designing MAC protocols for cooperative communications and it is shown that using a relay results not only in a better throughput but also better energy efficiency.

Adaptation of an commercially available stabilised R/C helicopter to a fully autonomous surveillance UAV

This paper presents the development of an autonomous surveillance UAV that competed in the Ministry of Defence Grand Challenge 2008. In order to focus on higher-level mission control, the UAV is built upon an existing commercially available stabilised R/C helicopter platform. The hardware architecture is developed to allow for non-invasion integration with the existing stabilised platform, and to enable to the distributed processing of closed loop control and mission goals. The resulting control system proved highly successful and was capable of flying within 40knott gusts. The software and safety architectures were key to the success of the research and also hold the potential for use in the development of more complex system comprising of multiple UAVs.