Optimization of protoplast production in white lupin

The influence, was investigated, of abiotic parameters on the isolation of protoplasts from in vitro seedling cotyledons of white lupin. The protoplasts were found to be competent in withstanding a wide range of osmotic potentials of the enzyme medium, however, −2.25 MPa (0.5 M mannitol), resulted in the highest yield of protoplasts. The pH of the isolation medium also had a profound effect on protoplast production. Vacuum infiltration of the enzyme solution into the cotyledon tissue resulted in a progressive drop in the yield of protoplasts. The speed and duration of orbital agitation of the cotyledon tissue played a significant role in the release of protoplasts and a two step (stationary-gyratory) regime was found to be better than the gyratory-only system.

Comparison of white metal and resin socket terminations for wire ropes

Previously the authors have presented both theoretical and experimental work discussing the operating mechanism of a wire rope held in a tapered socket by means of a cast resin cone. The work reported here extends the investigation to address the question of whether the same socket fabricated with white metal operates in the same manner. To date, previous investigations have compared the operational efficiency of resin and white metal in terms of both strength and/or fatigue endurance. Some other work has analysed the operation of resin sockets or specific cast metal terminations. This paper seeks to draw the results from this work together, and, in addition to a theoretical analysis, presents experimental data obtained from a direct comparison of the operation mechanism for the same sockets filled with resin or white metal. Results show that white metal terminations have a very different distribution of stresses along the length of the socket basket from resin terminations, and a smaller but still significant amount of socket draw. For both types of termination the socket draw develops high frictional gripping forces which can transfer the load from the rope to the socket. The different stress distributions mean that the consequences of termination fabrication defects may not be the same for resin and white metal terminations.

Testing white line strength in the dairy cow

The tensile strength of 576 pieces of white line horn collected over 6 mo from 14 dairy cows restricted to parity 1 or 2 was tested. None of the cows had ever been lame. Seven cows were randomly assigned to receive 20 mg/d biotin supplementation, and 7 were not supplemented. Hoof horn samples were taken from zones 2 and 3 (the more proximal and distal sites of the abaxial white line) of the medial and lateral claws of both hind feet on d 1 and on 5 further occasions over 6 mo. The samples were analyzed at 100% water saturation. Hoof slivers were notched to ensure that tensile strength was measured specifically across the white line region. The tensile stress at failure was measured in MPa and was adjusted for the cross-sectional area of the notch site. Data were analyzed in a multilevel model, which accounted for the repeated measures within cows. All other variables were entered as fixed effects. In the final model, there was considerable variation in strength over time. Tensile strength was significantly higher in medial compared with lateral claws, and zone 2 was significantly stronger than zone 3. Where the white line was visibly damaged the tensile strength was low. Biotin supplementation did not affect the tensile strength of the white line. Results of this study indicate that damage to the white line impairs its tensile strength and that in horn with no visible abnormality the white line is weaker in the lateral hind claw than the medial and in zone 3 compared with zone 2. The biomechanical strength was lowest at zone 3 of the lateral hind claw, which is the most common site of white line disease lameness in cattle.

Responsiveness to change by standard-form contract drafters: A case study of the FIDIC White Book

Purpose – The purpose of this paper is to focus on the Fédération Internationale des Ingénieurs-Conseils (FIDIC) White Book standard form of building contract. It tracks the changes to this contract over its four editions, and seeks to identify their underlying causes. Design/methodology/approach – The changes made to the White Book are quantified using a specific type of quantitative content analysis. The amended clauses are then examined to understand the nature of the changes made. Findings – The length of the contract increased by 34 per cent between 1990 and 2006. A large proportion of the overall increase can be attributed to the clauses dealing with “conflict of interest/corruption” and “dispute resolution”. In both instances, the FIDIC drafting committees have responded to international developments to discourage corruption, and to encourage the use of alternative dispute resolution. Between 1998 and 2006, the average length of the sentences increased slightly, raising the question of whether long sentences are easily understood by users of contracts. Research limitations/implications – Quantification of text appears to be particularly useful for the analysis of documents which are regularly updated because changes can be clearly identified and the length of sentences can be determined, leading to conclusions about the readability of the text. However, caution is needed because changes of great relevance can be made to contract clauses without actually affecting their length. Practical implications – The paper will be instructive for contract drafters and informative for users of FIDIC's White Book. Originality/value – Quantifying text has been rarely used regarding standard-form contracts in the field of construction.

Textural and microstructural properties of urfa cheese (a white-brined Turkish cheese)

The texture and microstructure of white-brined cheeses similar to urfa (a traditional Turkish cheese) were studied. One batch of cheeses was made in the traditional manner and one batch was made from ultrafiltered (UF) milk. Samples from each batch were either ripened in brine after production or scalded in whey for 3 min at 90degreesC prior to ripening. The results showed only marginal differences in the ripening profiles of both batches of unscalded cheeses, but scalding slowed down the extent of proteolysis in both batches. The scalded cheeses had a firmer texture than the unscalded ones, and the unscalded UF cheese had a more 'springy' body than the unscalded traditional cheese. Overall, scalding resulted in a more homogeneous structure, but the unscalded UF cheese had a close texture that resembled the scalded samples. It was concluded that, with respect to texture and structure, cheeses made with UF milk do not need to be scalded after production.

Effect of chymosin reduction and salt substitution on the properties of white salted cheese

A whey salts mixture was used as a partial substitute for sodium chloride to provide a modified Na:K ratio (1:3.4) in the manufacture of white salted cheese using ultrafiltration. Reduction of chymosin addition from 20 to 8 mu L kg(-1) of cheese was also investigated. Variation of salt and chymosin levels did not result in any significant differences in composition and physicochemical properties. The rates of proteolysis in terms of water-soluble nitrogen (WSN) and nitrogen soluble in 12% trichloroacetic acid (TCA-SN) were affected by chymosin levels but not by salt treatment. Urea-PAGE electrophoretic analysis of caseins from the cheeses manufactured using three levels of chymosin and two salt types showed that the hydrolysis of alpha(s1)-casein was higher than for beta-caseins but the differences between the cheeses were not significant (P > 0.05). The chymosin level did not have a significant effect (P > 0.05) on hardness and fracturability, suggesting that any variation in hardness due to the initial hydrolysis was being confounded by other variables. Cheeses including the whey salts product were harder and more fracturable (P < 0.01) than the cheese treated with NaCl only. Both hardness and fracturability values decreased (P < 0.05) over the maturation period. The scores for bitterness were low; neither the effects of salt nor chymosin levels were significant (P > 0.05). (c) 2005 Elsevier Ltd. All rights reserved.

Effect of chymosin and salt reduction on the quality of ultrafiltrated white-salted cheese

This study demonstrated that both chymosin and salt-in-moisture (SM) were important factors for proteolysis in the manufacture of ultrafiltrated white-salted cheese, with significant effects on water-soluble nitrogen and nitrogen soluble in trichloroacetic acid. In contrast, the levels of free amino acids were not significantly affected by chymosin and salt treatments. The cheeses made using high levels of chymosin with low SM had lower levels of residual α(s1)- and β-casein at the end of ripening. On texture profile analysis, the hardness and fracturability of the cheeses significantly increased with SM and decreased during ripening. Increases in chymosin significantly contributed to the overall weakening of the structure throughout ripening. Bitter flavour was detected after 12 weeks in the cheese made with the higher chymosin level and lower SM, which could be the result of accumulation of γ-casein fractions. The sensory data indicated that the hedonic responses for low chymosin with low SM cheeses were good and acceptable in flavour, which may be due to the moderate levels of proteolysis products.

Effect of temperature and salt on the maturation of white-salted cheese

White-salted cheeses were prepared from ultrafiltered (UF) cows' milk and salted to give final salt-in-moisture (SM) levels of 2.5, 3.2 and 4.0%. The cheeses were stored at 5degreesC and 10degreesC for up to 15 weeks. The microflora was dominated by lactic acid bacteria (LAB) but some mould growth was evident within 15 weeks at all SM levels and both temperatures. Levels of water-soluble nitrogen (WSN), attributed to chymosin activity, increased significantly with time, the rate being inversely proportional to the SM level and increasing with storage temperature. Similar effects were noted for trichloroacetic acid-soluble nitrogen (TCA-SN) and free amino acid (FAA) levels, both of which would also be affected by bacterial protease activity. The proteolytic activity was reflected by changes in the hardness and fracturability of the cheeses.

The multidimensional measurement of the positive symptoms of psychosis

The measures most frequently used to assess psychotic symptoms fail to reflect important dimensions. The Psychotic Symptom Rating Scale (PSYRATS) aims to capture the multidimensional nature of auditory hallucinations and delusions. Individuals (N = 276) who had recently relapsed with positive symptoms completed the auditory hallucinations and delusions PSYRATS scales. These scores were compared with the relevant items from the SAPS and PANSS, and with measures of current mood. Total scores and distribution of items of the PSYRATS scales are presented and correlated with other measures. Positive symptom items from the SAPS and PANSS reflected the more objective aspects of PSYRATS ratings of auditory hallucinations and delusions (frequency and conviction) but were relatively poor at measuring distress. A major strength of the PSYRATS scales is the specific measurement of the distress dimension of symptoms, which is a key target of psychological intervention. It is advised that the PSYRATS should not be used as a total score alone, whilst further research is needed to clarify the best use of potential subscales. Copyright (c) 2007 John Wiley & Sons, Ltd.

Cognitive behaviour therapy for psychosis: current evidence and future directions

The past decade has seen considerable growth in the evidence base of cognitive behavioural therapy for psychosis. Consistent reports of moderate effect sizes have led to such interventions being recommended as part of routine clinical practice. Most of this evidence is based on a generic form of CBT for psychosis applied to a heterogeneous group. An increase in the effectiveness of cognitive behavioural interventions may require new protocols. Such therapeutic developments should be based on the theoretical understanding of the psychological processes associated with specific forms of psychotic presentation. The current evidence base of CBT for psychosis is reviewed, and barriers that have held back the development of this research are discussed.

Family interventions in psychosis: a scale to measure therapist adherence

The efficacy of family interventions in psychosis is well documented. UK and USA schizophrenia treatment guidelines advocate the practice of family interventions within routine clinical services. However, less attention has been paid to the study of treatment fidelity and the tools used in its assessment. This study reports the inter-rater reliability of a new scale: Family Intervention in Psychosis-Adherence Scale (FIPAS). This measure is designed to assess therapist adherence to the Kuipers et al. (2002) family intervention in psychosis treatment manual. Reliability ratings were based on a sample of thirteen audiotapes drawn from a randomized controlled trial of family intervention. The results indicated that the majority of items of the FIPAS had acceptable levels of inter-rater reliability. The findings are discussed in terms of their implications for the training and monitoring of the effectiveness of practitioners for family interventions in psychosis.

Intensive case management for severe psychotic illness: is there a general benefit for patients with complex needs? A secondary analysis of the UK700 trial data

The UK700 trial failed to demonstrate an overall benefit of intensive case management (ICM) in patients with severe psychotic illness. This does not discount a benefit for particular subgroups, and evidence of a benefit of ICM for patients of borderline intelligence has been presented. The aim of this study is to investigate whether this effect is part of a general benefit for patients with severe psychosis complicated by additional needs. In the UK700 trial patients with severe psychosis were randomly allocated to ICM or standard case management. For each patient group with complex needs the effect of ICM is compared with that in the rest of the study cohort. Outcome measures are days spent in psychiatric hospital and the admission and discharge rates. ICM may be of benefit to patients with severe psychosis complicated by borderline intelligence or depression, but may cause patients using illicit drugs to spend more time in hospital. There was no convincing evidence of an effect of ICM in a further seven patient groups. ICM is not of general benefit to patients with severe psychosis complicated by additional needs. The benefit of ICM for patients with borderline intelligence is an isolated effect which should be interpreted cautiously until further data are available.