Distributed space-time block coding with incremental relay: performance improvement under imperfect synchronisation

This paper addresses the impact of imperfect synchronisation on D-STBC when combined with incremental relay. To suppress such an impact, a novel detection scheme is proposed, which retains the two key features of the STBC principle: simplicity (i.e. linear computational complexity), and optimality (i.e. maximum likelihood). These two features make the new detector very suitable for low power wireless networks (e.g. sensor networks).

Monte Carlo numerical treatment of large linear algebra problems

In this paper we deal with performance analysis of Monte Carlo algorithm for large linear algebra problems. We consider applicability and efficiency of the Markov chain Monte Carlo for large problems, i.e., problems involving matrices with a number of non-zero elements ranging between one million and one billion. We are concentrating on analysis of the almost Optimal Monte Carlo (MAO) algorithm for evaluating bilinear forms of matrix powers since they form the so-called Krylov subspaces. Results are presented comparing the performance of the Robust and Non-robust Monte Carlo algorithms. The algorithms are tested on large dense matrices as well as on large unstructured sparse matrices.

On the performance of opportunistic cooperative wireless networks

The aim of this paper is to study the impact of channel state information on the design of cooperative transmission protocols. This is motivated by the fact that the performance gain achieved by cooperative diversity comes at the price of the extra bandwidth resource consumption. Several opportunistic relaying strategies are developed to fully utilize the different types of a priori channel information. The analytical and numerical results demonstrate that the use of such a priori information increases the spectral efficiency of cooperative diversity, especially at low signal-to-noise ratio.

Numerical precision requirements on the Multiband Ultra-Wideband system for practical consumer electronic devices

This paper discusses the requirements on the numerical precision for a practical Multiband Ultra-Wideband (UWB) consumer electronic solution. To this end we first present the possibilities that UWB has to offer to the consumer electronics market and the possible range of devices. We then show the performance of a model of the UWB baseband system implemented using floating point precision. Then, by simulation we find the minimal numerical precision required to maintain floating-point performance for each of the specific data types and signals present in the UWB baseband. Finally, we present a full description of the numerical requirements for both the transmit and receive components of the UWB baseband. The numerical precision results obtained in this paper can then be used by baseband designers to implement cost effective UWB systems using System-on-Chip (SoC), FPGA and ASIC technology solutions biased toward the competitive consumer electronics market(1).

Power properties if invariant tests for spatial autocorrelation in linear regression

This paper derives some exact power properties of tests for spatial autocorrelation in the context of a linear regression model. In particular, we characterize the circumstances in which the power vanishes as the autocorrelation increases, thus extending the work of Krämer (2005). More generally, the analysis in the paper sheds new light on how the power of tests for spatial autocorrelation is affected by the matrix of regressors and by the spatial structure. We mainly focus on the problem of residual spatial autocorrelation, in which case it is appropriate to restrict attention to the class of invariant tests, but we also consider the case when the autocorrelation is due to the presence of a spatially lagged dependent variable among the regressors. A numerical study aimed at assessing the practical relevance of the theoretical results is included

Experimental measurement and numerical simulation of horizontal-coupled slinky ground source heat exchangers

Results from both experimental measurements and 3D numerical simulations of Ground Source Heat Pump systems (GSHP) at a UK climate are presented. Experimental measurements of a horizontal-coupled slinky GSHP were undertaken in Talbot Cottage at Drayton St Leonard site, Oxfordshire, UK. The measured thermophysical properties of in situ soil were used in the CFD model. The thermal performance of slinky heat exchangers for the horizontal-coupled GSHP system for different coil diameters and slinky interval distances was investigated using a validated 3D model. Results from a two month period of monitoring the performance of the GSHP system showed that the COP decreased with the running time. The average COP of the horizontal-coupled GSHP was 2.5. The numerical prediction showed that there was no significant difference in the specific heat extraction of the slinky heat exchanger at different coil diameters. However, the larger the diameter of coil, the higher the heat extraction per meter length of soil. The specific heat extraction also increased, but the heat extraction per meter length of soil decreased with the increase of coil central interval distance.

Power control requirements in linear decorrelating detectors for CDMA

This paper addresses the effects of synchronisation errors (time delay, carrier phase, and carrier frequency) on the performance of linear decorrelating detectors (LDDs). A major effect is that all LDDs require certain degree of power control in the presence of synchronisation errors. The multi-shot sliding window algorithm (SLWA) and hard decision method (HDM) are analysed and their power control requirements are examined. Also, a more efficient one-shot detection scheme, called “hard-decision based coupling cancellation”, is proposed and analysed. These schemes are then compared with the isolation bit insertion (IBI) approach in terms of power control requirements.

Performance statistics of a head-operated force-reflecting rehabilitation robot system

Researchers in the rehabilitation engineering community have been designing and developing a variety of passive/active devices to help persons with limited upper extremity function to perform essential daily manipulations. Devices range from low-end tools such as head/mouth sticks to sophisticated robots using vision and speech input. While almost all of the high-end equipment developed to date relies on visual feedback alone to guide the user providing no tactile or proprioceptive cues, the “low-tech” head/mouth sticks deliver better “feel” because of the inherent force feedback through physical contact with the user's body. However, the disadvantage of a conventional head/mouth stick is that it can only function in a limited workspace and the performance is limited by the user's strength. It therefore seems reasonable to attempt to develop a system that exploits the advantages of the two approaches: the power and flexibility of robotic systems with the sensory feedback of a headstick. The system presented in this paper reflects the design philosophy stated above. This system contains a pair of master-slave robots with the master being operated by the user's head and the slave acting as a telestick. Described in this paper are the design, control strategies, implementation and performance evaluation of the head-controlled force-reflecting telestick system.

Monetary integration and real estate markets: an investigation of the impact of the introduction of a single currency on real estate performance

This paper assesses the impact of the monetary integration on different types of stock returns in Europe. In order to isolate European factors, the impact of global equity integration and small cap factors are investigated. European countries are sub-divided according to the process of monetary convergence. Analysis shows that national equity indices are strongly influenced by global market movements, with a European stock factor providing additional explanatory power. The global and European factors explain small cap and real estate stocks much less well –suggesting an increased importance of ‘local’ drivers. For real estate, there are notable differences between core and non-core countries. Core European countries exhibit convergence – a convergence to a European rather than a global factor. The non-core countries do not seem to exhibit common trends or movements. For the non-core countries, monetary integration has been associated with increased dispersion of returns, lower correlation and lower explanatory power of a European factor. It is concluded that this may be explained by divergence in underlying macro-economic drivers between core and non-core countries in the post-Euro period.

Prediction of the thermal performance of horizontal-coupled ground source heat exchangers

The thermal performance of a horizontal-coupled ground-source heat pump system has been assessed both experimentally and numerically in a UK climate. A numerical simulation of thermal behaviour of the horizontal-coupled heat exchanger for combinations of different ambient air temperatures, wind speeds, refrigerant temperature and soil thermal properties was studied using a validated 2D transient model. The specific heat extraction by the heat exchanger increased with ambient temperature and soil thermal conductivity, however it decreased with increasing refrigerant temperature. The effect of wind speed was negligible.

Performance as social practice

Starting point for these outputs is a large scale research project in collaboration with the Zurich University for the Arts and the Kunstmuseum Thun, looking at a redefinition of Social Sculpture (Joseph Beuys/ Bazon Brock, 1970) as a functional device re-deployed to expand the art discourse into a societal discourse. Although Beuys‘ version of a social sculpture involved notions of abstruse mysticism and reformulations of a national identity these were never-the less part of a social transformation that shifted and re-arranged power relations. Following Laclau and Mouffe in their contention that democray is a fundamentally antagonistic process and contesting Grant Kester’s understanding of a ethically based relational practice, this work is alignes itself with Hirschhorn’s claim to an aesthetic practice within communities, following the possibility to view a socially based practice from both ends of the ethics debate, whereby ethical aspects fuels the aethetic to “create situations that are beautiful because they are ethical and shocking because they are ethical, thus in turn aesthetic because they are ethical” (O’Donnell). This project sets out to engage in activities which interact with surrounding communities and evoce new imaginations of site, thereby understanding site as a catalysts for subjective emergences. Performance is tested as a site for social practice. Archival research into local audio/visual resources, such as the Swiss Radio Archive, the Swiss Military Film Archives and zoological film archives of the Basel Zoo, was instrumental to the navigation of this work, under theme of crisis, catastrophy, landscape, fallout, in order to create a visual language for an active performance site. Commissioned by the Kunstmuseum Thun in collaboration with the University for the Arts in Zurich as part of a year long exhibition programme, (other artists are Jeanne Van Heeswijk (NL) and San Keller (CH), ) this project brings together a series of different works in a new performace installation. The performance process includes a performance workshop with 30 school children from local Swiss schools and their teachers, which was conducted publicly in the museum spaces. It enabled the children to engage with an unexpected set of tribal and animalistic behaviours, looking at situations of flight and rescue, resulting in a large performance choreography orchestration without an apparent conductor, it includes a collaboration with renowned Swiss zoologist, Prof Klaus Zuberbühler(University of St Andrews) and the Colonal General Haldimann commander of the military base in Thun. The installation included 2 static video images, shot in an around spectacular local cave site (Beatus Caves) including 3 children. The project will culminate in an edited edition of the Oncurating Journal, (issue no, tbc, in 2012) including interviews and essays from project collaborators. (Army Commander General, Thun, Jörg Hess, performance script, Timothy Long, and others)

Assessing the impact of occupant behaviour on the electricity consumption for lighting and small power in office buildings

Lighting and small power will typically account for more than half of the total electricity consumption in an office building. Significant variations in electricity used by different tenants suggest that occupants can have a significant impact on the electricity demand for these end-uses. Yet current modelling techniques fail to represent the interaction between occupant and the building environment in a realistic manner. Understanding the impact of such behaviours is crucial to improve the methodology behind current energy modelling techniques, aiming to minimise the significant gap between predicted and in-use performance of buildings. A better understanding of the impact of occupant behaviour on electricity consumption can also inform appropriate energy saving strategies focused on behavioural change. This paper reports on a study aiming to assess the intent of occupants to switch off lighting and appliances when not in use in office buildings. Based on the Theory of Planned Behaviour, the assessment takes the form of a questionnaire and investigates three predictors to behaviour individually: 1) behavioural attitude; 2) subjective norms; 3) perceived behavioural control. The paper details the development of the assessment procedure and discusses preliminary findings from the study. The questionnaire results are compared against electricity consumption data for individual zones within a multi-tenanted office building. Initial results demonstrate a statistically significant correlation between perceived behavioural control and energy consumption for lighting and small power

Simulation of a domestic ground source heat pump system using a three-dimensional numerical borehole heat exchanger model

Common approaches to the simulation of borehole heat exchangers (BHEs) assume heat transfer in circulating fluid and grout to be in a quasi-steady state and ignore fluctuations in fluid temperature due to transport of the fluid around the loop. However, in domestic ground source heat pump (GSHP) systems, the heat pump and circulating pumps switch on and off during a given hour; therefore, the effect of the thermal mass of the circulating fluid and the dynamics of fluid transport through the loop has important implications for system design. This may also be important in commercial systems that are used intermittently. This article presents transient simulation of a domestic GSHP system with a single BHE using a dynamic three-dimensional (3D) numerical BHE model. The results show that delayed response associated with the transit of fluid along the pipe loop is of some significance in moderating swings in temperature during heat pump operation. In addition, when 3D effects are considered, a lower heat transfer rate is predicted during steady operations. These effects could be important when considering heat exchanger design and system control. The results will be used to develop refined two-dimensional models.