From activity to active learning: drawing and dialogue interaction in virtual learning environments for computer-supported collaborative work in design.

Virtual learning environments (VLEs) would appear to be particular effective in computer-supported collaborative work (CSCW) for active learning. Most research studies looking at computer-supported collaborative design have focused on either synchronous or asynchronous modes of communication, but near-synchronous working has received relatively little attention. Yet it could be argued that near-synchronous communication encourages creative, rhetorical and critical exchanges of ideas, building on each other’s contributions. Furthermore, although many researchers have carried out studies on collaborative design protocol, argumentation and constructive interaction, little is known about the interaction between drawing and dialogue in near-synchronous collaborative design. The paper reports the first stage of an investigation into the requirements for the design and development of interactive systems to support the learning of collaborative design activities. The aim of the study is to understand the collaborative design processes while sketching in a shared white board and audio conferencing media. Empirical data on design processes have been obtained from observation of seven sessions with groups of design students solving an interior space-planning problem of a lounge-diner in a virtual learning environment, Lyceum, an in-house software developed by the Open University to support its students in collaborative learning.

HOx observations over West Africa during AMMA: impact of isoprene and NOx

Aircraft OH and HO2 measurements made over West Africa during the AMMA field campaign in summer 2006 have been investigated using a box model constrained to observations of long-lived species and physical parameters. "Good" agreement was found for HO2 (modelled to observed gradient of 1.23 ± 0.11). However, the model significantly overpredicts OH concentrations. The reasons for this are not clear, but may reflect instrumental instabilities affecting the OH measurements. Within the model, HOx concentrations in West Africa are controlled by relatively simple photochemistry, with production dominated by ozone photolysis and reaction of O(1D) with water vapour, and loss processes dominated by HO2 + HO2 and HO2 + RO2. Isoprene chemistry was found to influence forested regions. In contrast to several recent field studies in very low NOx and high isoprene environments, we do not observe any dependence of model success for HO2 on isoprene and attribute this to efficient recycling of HOx through RO2 + NO reactions under the moderate NOx concentrations (5–300 ppt NO in the boundary layer, median 76 ppt) encountered during AMMA. This suggests that some of the problems with understanding the impact of isoprene on atmospheric composition may be limited to the extreme low range of NOx concentrations.

The colour, light and contrast manual - designing and managing inclusive built environments

Endorsed by the Society of Light and Lighting, this practical book offers comprehensive guidance on how colour, light and contrast can be incorporated within buildings to enhance their usability. The book provides state-of-the-art, clear guidance as well as a valuable information source for busy professionals involved in the design or management of new and existing environments. The ways colour, light and contrast are used within built environments are critical in determining how people interact with the space, and how confident, safe, and secure they will feel when doing so. They also have a major influence on a person’s sense of well-being and their ability to use the environment independently and without undue effort. Understanding how to use colour and contrast and how they are influenced by both natural and artificial lighting is vital for all those involved in the design and management of the environments and spaces we all use. In recent years there has been a considerable amount of work undertaken to further our understanding of how colour, light and contrast affect emotion and sensory abilities, and how they can assist or hinder people in their everyday lives. Other publications consider these issues individually but The Colour, Light and Contrast Manual: designing and managing inclusive built environments draws knowledge and information together to produce a unique, comprehensive and informative guide to how the three elements can work together to improve the design and management of environments for us all.

Adaptation of crops to climate change through genotypic responses to mean and extreme temperatures

The importance of temperature in the determination of the yield of an annual crop (groundnut; Arachis hypogaea L. in India) was assessed. Simulations from a regional climate model (PRECIS) were used with a crop model (GLAM) to examine crop growth under simulated current (1961-1990) and future (2071-2100) climates. Two processes were examined: the response of crop duration to mean temperature and the response of seed-set to extremes of temperature. The relative importance of, and interaction between, these two processes was examined for a number of genotypic characteristics, which were represented by using different values of crop model parameters derived from experiments. The impact of mean and extreme temperatures varied geographically, and depended upon the simulated genotypic properties. High temperature stress was not a major determinant of simulated yields in the current climate, but affected the mean and variability of yield under climate change in two regions which had contrasting statistics of daily maximum temperature. Changes in mean temperature had a similar impact on mean yield to that of high temperature stress in some locations and its effects were more widespread. Where the optimal temperature for development was exceeded, the resulting increase in duration in some simulations fully mitigated the negative impacts of extreme temperatures when sufficient water was available for the extended growing period. For some simulations the reduction in mean yield between the current and future climates was as large as 70%, indicating the importance of genotypic adaptation to changes in both means and extremes of temperature under climate change. (c) 2006 Elsevier B.V. All rights reserved.

Adaptation and yield of pigeonpea in different environments in Tanzania

Pigeonpea is grown in wide range of cropping systems and environments, both in East Africa and internationally. An important feature of adaptation to these diverse systems and environments is the timing of flowering and maturity. Most traditional cultivars grown in Tanzania are medium to late flowering types (> 150 days), although extra-early flowering cultivars are now available. The aim of the present investigation was to measure biomass (BY) and seed (SY) yield of a set of phenologically diverse cultivars to determine their adaptation to contrasting environments in Tanzania. Ten cultivars, from extra-early (60 days) to late (> 180 days) flowering, were planted at six locations varying in mean temperature, photoperiod and rainfall. Days to flowering (DTF) and maturity, and above-ground BY and SY at maturity, were measured. A stress index (ETr:ETm ratio, 100 = no stress) was computed for each site. Rainfall and the stress index at the different sites varied from 322 to 1297 mm and 57 to 89, respectively. Among cultivars, DTF varied from 55 to 320 days, the stress index from 3 to 98, BY from 700 to 25,000 kg ha(-1), and SY from 0 to 4000 kg ha(-1). The highest yielding environment was at Selian, where mean temperatures were favourable (19 degrees C) and no stress occurred. At all sites there was an optimum DTF, which for SY varied from < 100 to 150 days. The best adapted cultivars were ICP 7035, ICPL 90094, Kat 50 and QP37, which were all medium flowering (c. 150 day) types. Extra-early cultivars such as ICPL 86005 also showed considerable potential, especially in short-season environments. (c) 2004 Elsevier B.V. All rights reserved.

Productivity and optimum plant density of pigeonpea in different environments in Tanzania

The objective of the present study was to determine the optimum plant density of four pigeonpea genotypes, representing early, medium and late maturing types, grown in five contrasting environments in Tanzania. ICPL 86005 (early), Kat 50/3 and QP 37 (medium) and Local (late) were grown at four plant densities (40 000-320 000 plants/ha) in irrigated and rainfed conditions at Ilonga and under rainfed conditions at Kibaha, Selian and Ismani. At maturity, total above-ground biomass and seed yield (SY) were measured. The highest yields were obtained in the irrigated experiment at Ilonga, where the medium/late genotypes produced 25 t biomass/ha and 5 center dot 6 t seed/ha. The lowest SY were at Kibaha, 0 58 to 1 center dot 76 t/ha, where a severe drought occurred. In nearly all cases the response to density was linear or asymptotic. The response of ICPL 86005 was significantly different from the other three genotypes. The optimum density for SY varied from 37 000 to 227 000 plants/ha in ICPL 86005, compared with 3000 to 101000 plants/ha in the medium/late genotypes. The highest optimum density was at Selian and Ismani and the lowest at Ilonga and Kibaha, where drought occurred. Optimum densities therefore varied greatly with genotype (duration) and environment, and this variation needs to be considered when planning trials.

Extreme host plant conservatism during at least 20 million years of host plant pursuit by oak gallwasps

Diversification of insect herbivores is often associated with coevolution between plant toxins and insect countermeasures, resulting in a specificity that restricts host plant shifts. Gall inducers, however, bypass plant toxins and the factors influencing host plant associations in these specialized herbivores remain unclear. We reconstructed the evolution of host plant associations in Western Palaearctic oak gallwasps (Cynipidae: Cynipini), a species-rich lineage of specialist herbivores on oak (Quercus). (1) Bayesian analyses of sequence data for three genes revealed extreme host plant conservatism, with inferred shifts between major oak lineages (sections Cerris and Quercus) closely matching the minimum required to explain observed diversity. It thus appears that the coevolutionary demands of gall induction constrain host plant shifts, both in cases of mutualism (e.g., fig wasps, yucca moths) and parasitism (oak gallwasps). (2) Shifts between oak sections occurred independently in sexual and asexual generations of the gallwasp lifecycle, implying that these can evolve independently. (3) Western Palaearctic gallwasps associated with sections Cerris and Quercus diverged at least 20 million years ago (mya), prior to the arrival of oaks in the Western Palaearctic from Asia 5-7 mya. This implies an Asian origin for Western Palaearctic gallwasps, with independent westwards range expansion by multiple lineages.

Greenhouse whitefly (Homoptera : Aleyrodidae) dispersal under different UV-light environments

The greenhouse whitefly, Dialeurodes vaporariorum (Westwood) (Homoptera: Aleyrodidae), is known to respond to UV light (UV). Field studies were conducted to improve our understanding of the behavioral effects and practical implications of using UV-blocking plastic films for the control of whitefly. Adult whiteflies were released in outdoor-located choice-chamber experiments with compartments clad with a range of films that transmitted incident UV to different extents. In release-recapture experiments, a very small proportion of the whiteflies recovered had dispersed into compartments where the entire UV spectrum was blocked, whereas the major proportion preferred compartments with UV. Compartments clad with films that blocked LTV below 375 nm attracted significantly more whiteflies than films that blocked UV below 385 nm, whereas the absorption of LTV wavelengths above 385 nm did not show any further effect on whitefly numbers. A reduction in the side cladding of the compartments by > 20% significantly reduced the advantage of using LTV-blocking films. Adult whitefly did not discriminate between direct- and diffused-light environments, as long as the UV-absorbing properties of the films were equivalent. Whitefly dispersal was influenced by the time of the day when adult whitefly were released, with a higher proportion of whitelly avoiding compartments clad with LTV-blocking films, at times of the day when light intensities were higher. The future use of UV-blocking films as a potentially highly effective component of integrated pest management systems for the control of whitefly is discussed.

Extreme gender biased post-fledging brood division in the toc-toc

The possibility that parents of one sex may preferentially invest in offspring of a certain sex raises profound evolutionary questions about the relative worth of sons and daughters to their mothers and fathers. Post-fledging brood division-in which cacti parent feeds a different subset of offspring-has been well documented in birds. However, a lack of empirical evidence that this may be based oil offspring sex, combined with the theoretical difficulty of explaining such an interaction, has led researchers to consider a gender bias in post-fledging brood division highly unlikely. Here we show that in the toc-toc, Foudia sechellarum, postfledging brood division is extreme and determined by sex; where brood composition allows, male parents exclusively provision male fledglings, whereas female parents provision female fledglings. This is the first study to provide unambiguous evidence, based on molecular sexing, that sex-biased post-fledging brood division can occur in birds. Male and female parents provisioned at the same rate and neither offspring nor parent survival appeared to be affected by the sex of the parent or offspring, respectively. The current hypotheses predicting advantages for brood division and preferential care for one specific type of offspring are discussed in the light of our results.

Development and application of in vivo expression technology (IVET) for analysing microbial gene expression in complex environments

Establishing the mechanisms by which microbes interact with their environment, including eukaryotic hosts, is a major challenge that is essential for the economic utilisation of microbes and their products. Techniques for determining global gene expression profiles of microbes, such as microarray analyses, are often hampered by methodological restraints, particularly the recovery of bacterial transcripts (RNA) from complex mixtures and rapid degradation of RNA. A pioneering technology that avoids this problem is In Vivo Expression Technology (IVET). IVET is a 'promoter-trapping' methodology that can be used to capture nearly all bacterial promoters (genes) upregulated during a microbe-environment interaction. IVET is especially useful because there is virtually no limit to the type of environment used (examples to date include soil, oomycete, a host plant or animal) to select for active microbial promoters. Furthermore, IVET provides a powerful method to identify genes that are often overlooked during genomic annotation, and has proven to be a flexible technology that can provide even more information than identification of gene expression profiles. A derivative of IVET, termed resolvase-IVET (RIVET), can be used to provide spatio-temporal information about environment-specific gene expression. More recently, niche-specific genes captured during an IVET screen have been exploited to identify the regulatory mechanisms controlling their expression. Overall, IVET and its various spin-offs have proven to be a valuable and robust set of tools for analysing microbial gene expression in complex environments and providing new targets for biotechnological development.