Comparative study of the performance of the M-cycle counter-flow and cross-flow heat exchangers for indirect evaporative cooling - paving the path towards sustainable cooling of buildings

This paper provides a comparative study of the performance of cross-flow and counter-flow M-cycle heat exchangers for dew point cooling. It is recognised that evaporative cooling systems offer a low energy alternative to conventional air conditioning units. Recently emerged dew point cooling, as the renovated evaporative cooling configuration, is claimed to have much higher cooling output over the conventional evaporative modes owing to use of the M-cycle heat exchangers. Cross-flow and counter-flow heat exchangers, as the available structures for M-cycle dew point cooling processing, were theoretically and experimentally investigated to identify the difference in cooling effectiveness of both under the parallel structural/operational conditions, optimise the geometrical sizes of the exchangers and suggest their favourite operational conditions. Through development of a dedicated computer model and case-by-case experimental testing and validation, a parametric study of the cooling performance of the counter-flow and cross-flow heat exchangers was carried out. The results showed the counter-flow exchanger offered greater (around 20% higher) cooling capacity, as well as greater (15%–23% higher) dew-point and wet-bulb effectiveness when equal in physical size and under the same operating conditions. The cross-flow system, however, had a greater (10% higher) Energy Efficiency (COP). As the increased cooling effectiveness will lead to reduced air volume flow rate, smaller system size and lower cost, whilst the size and cost are the inherent barriers for use of dew point cooling as the alternation of the conventional cooling systems, the counter-flow system is considered to offer practical advantages over the cross-flow system that would aid the uptake of this low energy cooling alternative. In line with increased global demand for energy in cooling of building, largely by economic booming of emerging developing nations and recognised global warming, the research results will be of significant importance in terms of promoting deployment of the low energy dew point cooling system, helping reduction of energy use in cooling of buildings and cut of the associated carbon emission.

A probabilistic analysis of the future potential of evaporative cooling systems in a temperate climate

The probabilistic projections of climate change for the United Kingdom (UK Climate Impacts Programme) show a trend towards hotter and drier summers. This suggests an expected increase in cooling demand for buildings – a conflicting requirement to reducing building energy needs and related CO2 emissions. Though passive design is used to reduce thermal loads of a building, a supplementary cooling system is often necessary. For such mixed-mode strategies, indirect evaporative cooling is investigated as a low energy option in the context of a warmer and drier UK climate. Analysis of the climate projections shows an increase in wet-bulb depression; providing a good indication of the cooling potential of an evaporative cooler. Modelling a mixed-mode building at two different locations, showed such a building was capable of maintaining adequate thermal comfort in future probable climates. Comparing the control climate to the scenario climate, an increase in the median of evaporative cooling load is evident. The shift is greater for London than for Glasgow with a respective 71.6% and 3.3% increase in the median annual cooling load. The study shows evaporative cooling should continue to function as an effective low-energy cooling technique in future, warming climates.

Simulation of the future performance of low-energy evaporative cooling systems using UKCP09 climate projections

Recent activity in the development of future weather data for building performance simulation follows recognition of the limitations of traditional methods, which have been based on a stationary (observed) climate. In the UK, such developments have followed on from the availability of regional climate models as delivered in UKCIP02 and recently the probabilistic projections released under UKCP09. One major area of concern is the future performance and adaptability of buildings which employ exclusively passive or low-energy cooling systems. One such method which can be employed in an integral or retrofit situation is direct or indirect evaporative cooling. The effectiveness of evaporative cooling is most strongly influenced by the wet-bulb depression of the ambient air, hence is generally regarded as most suited to hot, dry climates. However, this technology has been shown to be effective in the UK, primarily in mixed-mode buildings or as a retrofit to industrial/commercial applications. Climate projections for the UK generally indicate an increase in the summer wet-bulb depression, suggesting an enhanced potential for the application of evaporative cooling. The paper illustrates this potential by an analysis of the probabilistic scenarios released under UKCP09, together with a detailed building/plant simulation of case study building located in the South-East of England. The results indicate a high probability that evaporative cooling will still be a viable low-energy technique in the 2050s.

Colonization of 8-week-old conventionally reared goats by Escherichia coli O157:H7 after oral inoculation

Enterohaemorrhagic Escherichia coli O157 : H7 infections of man have been associated with consumption of unpasteurized goat's milk and direct contact with kid goats on petting farms, yet little is known about colonization of goats with this organism. To assess the contribution of flagella and intimin of E coli O157 : H7 in colonization of the goat, 8-week-old conventionally reared goats were inoculated orally in separate experiments with 1 X 10(10) c.f.u. of a non-verotoxigenic strain of E coli O157: H7 (strain NCTC 12900 Nal(r)), an aflagellate derivative (DMB1) and an intimin-deficient derivative (DMB2). At 24 In after inoculation, the three E coli O157 : H7 strains were shed at approximately 5 X 1 04 c.f.u. (g faeces)(-1) from all animals. Significantly fewer intimin-deficient bacteria were shed only on days 2 (P = 0(.)003) and 4 (P = 0(.)014), whereas from day 7 to 29 there were no differences. Tissues from three animals inoculated with wild-type E coli O157 : H7 strain NCTC 12900 Nalr were sampled at 24,48 and 96 In after inoculation and the organism was cultured from the large intestine of all three animals and from the duodenum and ileum of the animal examined at 96 h. Tissues were examined histologically but attaching-effacing (AE) lesions were not observed at any intestinal site of the animals examined at 24 or 48 In. However, the animal examined at 96 h, which had uniquely shed approximately 1 x 10(7) E coli O157: H7 (g faeces)(-1) for the preceding 3 days, showed a heavy, diffuse infection with cryptosporidia. and abundant, multifocal AE lesions in the distal colon, rectum and at the recto-anal junction. These AE lesions were confirmed by immunohistochemistry to be associated with E coli O157: H7.

Crossbred cow adoption and milk market participation in a multivariate count data framework

Cross-bred cow adoption is an important and potent policy variable precipitating subsistence household entry into emerging milk markets. This paper focuses on the problem of designing policies that encourage and sustain milkmarket expansion among a sample of subsistence households in the Ethiopian highlands. In this context it is desirable to measure households’ ‘proximity’ to market in terms of the level of deficiency of essential inputs. This problem is compounded by four factors. One is the existence of cross-bred cow numbers (count data) as an important, endogenous decision by the household; second is the lack of a multivariate generalization of the Poisson regression model; third is the censored nature of the milk sales data (sales from non-participating households are, essentially, censored at zero); and fourth is an important simultaneity that exists between the decision to adopt a cross-bred cow, the decision about how much milk to produce, the decision about how much milk to consume and the decision to market that milk which is produced but not consumed internally by the household. Routine application of Gibbs sampling and data augmentation overcome these problems in a relatively straightforward manner. We model the count data from two sites close to Addis Ababa in a latent, categorical-variable setting with known bin boundaries. The single-equation model is then extended to a multivariate system that accommodates the covariance between crossbred-cow adoption, milk-output, and milk-sales equations. The latent-variable procedure proves tractable in extension to the multivariate setting and provides important information for policy formation in emerging-market settings

Tobit estiamtion with unknown point of censoring with an application to milk market participation in the Ethiopian highlands

Data augmentation is a powerful technique for estimating models with latent or missing data, but applications in agricultural economics have thus far been few. This paper showcases the technique in an application to data on milk market participation in the Ethiopian highlands. There, a key impediment to economic development is an apparently low rate of market participation. Consequently, economic interest centers on the “locations” of nonparticipants in relation to the market and their “reservation values” across covariates. These quantities are of policy interest because they provide measures of the additional inputs necessary in order for nonparticipants to enter the market. One quantity of primary interest is the minimum amount of surplus milk (the “minimum efficient scale of operations”) that the household must acquire before market participation becomes feasible. We estimate this quantity through routine application of data augmentation and Gibbs sampling applied to a random-censored Tobit regression. Incorporating random censoring affects markedly the marketable-surplus requirements of the household, but only slightly the covariates requirements estimates and, generally, leads to more plausible policy estimates than the estimates obtained from the zero-censored formulation

Proportions of A1, A2, B and C β-casein protein variants in retail milk in the UK

The A1 variant protein of the β-casein family has been implicated in various disease states although much evidence is weak or contradictory. The primary objective was to measure, for the first time, the proportions of the key β-casein variant proteins in UK retail milk over the course of one year. In total, 55 samples of semi-skimmed milk were purchased from five supermarkets over the course of a year and the proportions of the A1, A2, B and C casein variant proteins were measured, using high resolution HPLC-MS. The results showed that β-casein in UK retail milk comprises approximately 0.58, 0.31, 0.07 and 0.03 A2, A1, B and C protein variants, respectively. The proportion of A2 is higher than some early studies would predict although the reasons for this and any implications for health are unclear

Incremental effect of a calcium salt of cis-monounsaturated fatty acids supplement on milk fatty acid composition in cows fed maize silage-based diets

In most Western countries, saturated fatty acid (SFA) intake exceeds recommended levels, which is considered a risk factor for cardiovascular disease (CVD). As milk and dairy products are major contributors to SFA intake in many countries, recent research has focused on sustainable methods of producing milk with a lower saturated fat concentration by altering dairy cow diets. Human intervention studies have shown that CVD risk can be reduced by consuming dairy products with reduced SFA and increased cis-monounsaturated fatty acid (MUFA) concentrations. This milk fatty acid profile can be achieved by supplementing dairy cow diets with cis-MUFA-rich unsaturated oils. However, rumen exposure of unsaturated oils also leads to enhanced milk trans fatty acid (TFA) concentrations. Because of concerns about the effects of TFA consumption on CVD, feeding strategies that increase MUFA concentrations in milk without concomitant increases in TFA concentration are preferred by milk processors. In an attempt to limit TFA production and increase the replacement of SFA by cis-MUFA, a preparation of rumen-protected unsaturated oils was developed using saponification with calcium salts. Four multiparous Holstein-Friesian cows in mid-late lactation were used in a 4 × 4 Latin square design with 21-d periods to investigate the effect of incremental dietary inclusion of a calcium salt of cis-MUFA product (Ca-MUFA; 20, 40, and 60 g/kg of dry matter of a maize silage-based diet), on milk production, composition, and fatty acid concentration. Increasing Ca-MUFA inclusion reduced dry matter intake linearly, but no change was observed in estimated ME intake. No change in milk yield was noted, but milk fat and protein concentrations were linearly reduced. Supplementation with Ca-MUFA resulted in a linear reduction in total SFA (from 71 to 52 g/100 g of fatty acids for control and 60 g/kg of dry matter diets, respectively). In addition, concentrations of both cis- and trans-MUFA were increased with Ca-MUFA inclusion, and increases in other biohydrogenation intermediates in milk fat were also observed. The Ca-MUFA supplement was very effective at reducing milk SFA concentration and increasing cis-MUFA concentrations without incurring any negative effects on milk and milk component yields. However, reduced milk fat and protein concentrations, together with increases in milk TFA concentrations, suggest partial dissociation of the calcium salts in the rumen

Seasonal variation in the fatty acid composition of milk available at retail in the United Kingdom and implications for dietary intake

Milk and dairy products are major sources of fat in the human diet, but there are few detailed reports on the fatty acid composition of retail milk, trans fatty acids in particular, and how these change throughout the year. Semi-skimmed milk was collected monthly for one year from five supermarkets and analysed for fatty acid composition. Relative to winter, milk sold in the summer contained lower total saturated fatty acid (SFA; 67 vs 72 g/100 g fatty acids) and higher cis-monounsaturated fatty acid (MUFA; 23 vs 21 g/100 g fatty acids) and total trans fatty acid (6.5 vs 4.5 g/100 g fatty acids) concentrations. Concentrations of most trans-18:1 and -18:2 isomers also exhibited seasonal variation. Results were applied to national dietary intakes, and indicated that monthly variation in the fatty acid composition of milk available at retail has limited influence on total dietary fatty acid consumption by UK adults.