Hardy-Weinberg Equilibrium and the Ternary Plot

The Hardy-Weinberg law, formulated about 100 years ago, states that under certain assumptions, the three genotypes AA, AB and BB at a bi-allelic locus are expected to occur in the proportions p2, 2pq, and q2 respectively, where p is the allele frequency of A, and q = 1-p. There are many statistical tests being used to check whether empirical marker data obeys the Hardy-Weinberg principle. Among these are the classical xi-square test (with or without continuity correction), the likelihood ratio test, Fisher's Exact test, and exact tests in combination with Monte Carlo and Markov Chain algorithms. Tests for Hardy-Weinberg equilibrium (HWE) are numerical in nature, requiring the computation of a test statistic and a p-value. There is however, ample space for the use of graphics in HWE tests, in particular for the ternary plot. Nowadays, many genetical studies are using genetical markers known as Single Nucleotide Polymorphisms (SNPs). SNP data comes in the form of counts, but from the counts one typically computes genotype frequencies and allele frequencies. These frequencies satisfy the unit-sum constraint, and their analysis therefore falls within the realm of compositional data analysis (Aitchison, 1986). SNPs are usually bi-allelic, which implies that the genotype frequencies can be adequately represented in a ternary plot. Compositions that are in exact HWE describe a parabola in the ternary plot. Compositions for which HWE cannot be rejected in a statistical test are typically “close" to the parabola, whereas compositions that differ significantly from HWE are “far". By rewriting the statistics used to test for HWE in terms of heterozygote frequencies, acceptance regions for HWE can be obtained that can be depicted in the ternary plot. This way, compositions can be tested for HWE purely on the basis of their position in the ternary plot (Graffelman & Morales, 2008). This leads to nice graphical representations where large numbers of SNPs can be tested for HWE in a single graph. Several examples of graphical tests for HWE (implemented in R software), will be shown, using SNP data from different human populations

Regression analysis of compositional data when both the dependent variable and independent variable are components

It is well known that regression analyses involving compositional data need special attention because the data are not of full rank. For a regression analysis where both the dependent and independent variable are components we propose a transformation of the components emphasizing their role as dependent and independent variables. A simple linear regression can be performed on the transformed components. The regression line can be depicted in a ternary diagram facilitating the interpretation of the analysis in terms of components. An exemple with time-budgets illustrates the method and the graphical features

When zero doesn't mean it and other geomathematical mischief

There is almost not a case in exploration geology, where the studied data doesn’t includes below detection limits and/or zero values, and since most of the geological data responds to lognormal distributions, these “zero data” represent a mathematical challenge for the interpretation. We need to start by recognizing that there are zero values in geology. For example the amount of quartz in a foyaite (nepheline syenite) is zero, since quartz cannot co-exists with nepheline. Another common essential zero is a North azimuth, however we can always change that zero for the value of 360°. These are known as “Essential zeros”, but what can we do with “Rounded zeros” that are the result of below the detection limit of the equipment? Amalgamation, e.g. adding Na2O and K2O, as total alkalis is a solution, but sometimes we need to differentiate between a sodic and a potassic alteration. Pre-classification into groups requires a good knowledge of the distribution of the data and the geochemical characteristics of the groups which is not always available. Considering the zero values equal to the limit of detection of the used equipment will generate spurious distributions, especially in ternary diagrams. Same situation will occur if we replace the zero values by a small amount using non-parametric or parametric techniques (imputation). The method that we are proposing takes into consideration the well known relationships between some elements. For example, in copper porphyry deposits, there is always a good direct correlation between the copper values and the molybdenum ones, but while copper will always be above the limit of detection, many of the molybdenum values will be “rounded zeros”. So, we will take the lower quartile of the real molybdenum values and establish a regression equation with copper, and then we will estimate the “rounded” zero values of molybdenum by their corresponding copper values. The method could be applied to any type of data, provided we establish first their correlation dependency. One of the main advantages of this method is that we do not obtain a fixed value for the “rounded zeros”, but one that depends on the value of the other variable. Key words: compositional data analysis, treatment of zeros, essential zeros, rounded zeros, correlation dependency

Compositional amalgamations and balances: a critical approach

The amalgamation operation is frequently used to reduce the number of parts of compositional data but it is a non-linear operation in the simplex with the usual geometry, the Aitchison geometry. The concept of balances between groups, a particular coordinate system designed over binary partitions of the parts, could be an alternative to the amalgamation in some cases. In this work we discuss the proper application of both concepts using a real data set corresponding to behavioral measures of pregnant sows

Mixing compositions and other scales

Theory of compositional data analysis is often focused on the composition only. However in practical applications we often treat a composition together with covariables with some other scale. This contribution systematically gathers and develop statistical tools for this situation. For instance, for the graphical display of the dependence of a composition with a categorical variable, a colored set of ternary diagrams might be a good idea for a first look at the data, but it will fast hide important aspects if the composition has many parts, or it takes extreme values. On the other hand colored scatterplots of ilr components could not be very instructive for the analyst, if the conventional, black-box ilr is used. Thinking on terms of the Euclidean structure of the simplex, we suggest to set up appropriate projections, which on one side show the compositional geometry and on the other side are still comprehensible by a non-expert analyst, readable for all locations and scales of the data. This is e.g. done by defining special balance displays with carefully- selected axes. Following this idea, we need to systematically ask how to display, explore, describe, and test the relation to complementary or explanatory data of categorical, real, ratio or again compositional scales. This contribution shows that it is sufficient to use some basic concepts and very few advanced tools from multivariate statistics (principal covariances, multivariate linear models, trellis or parallel plots, etc.) to build appropriate procedures for all these combinations of scales. This has some fundamental implications in their software implementation, and how might they be taught to analysts not already experts in multivariate analysis