Grain size analyses in tin-lead glazes based on 2d-sections

A problem in the archaeometric classification of Catalan Renaissance pottery is the fact, that the clay supply of the pottery workshops was centrally organized by guilds, and therefore usually all potters of a single production centre produced chemically similar ceramics. However, analysing the glazes of the ware usually a large number of inclusions in the glaze is found, which reveal technological differences between single workshops. These inclusions have been used by the potters in order to opacify the transparent glaze and to achieve a white background for further decoration. In order to distinguish different technological preparation procedures of the single workshops, at a Scanning Electron Microscope the chemical composition of those inclusions as well as their size in the two-dimensional cut is recorded. Based on the latter, a frequency distribution of the apparent diameters is estimated for each sample and type of inclusion. Following an approach by S.D. Wicksell (1925), it is principally possible to transform the distributions of the apparent 2D-diameters back to those of the true three-dimensional bodies. The applicability of this approach and its practical problems are examined using different ways of kernel density estimation and Monte-Carlo tests of the methodology. Finally, it is tested in how far the obtained frequency distributions can be used to classify the pottery

Effect of magnesium sulphate and L-tryptophan and genotype on the feed intake, behaviour and meat quality of pigs

Sixty-nine entire male pigs with different halothane genotype (homozygous halothane positive – nn-, n=36; and homozygous halothane negative – NN-, n=33) were fed with a supplementation of magnesium sulphate (Mg) and/or L-tryptophan (Trp) in the diet for 5 days before slaughter. Animals were housed individually and were submitted to stressful ante mortem conditions (mixed in the lorry according to treatments and transported 1h on rough roads). Individual feed intake was recorded during the 5-day treatment. At the abattoir, pig behaviour was assessed in the raceway to the stunning system and during the stunning period by exposure to CO2. Muscle pH, colour, water holding capacity, texture and cathepsin activities were determined to assess meat quality. The number of pigs with an individual feed intake lower than 2kg/day was significantly different among diets (P<0.05; Control: 8.7%; Mg&Trp: 43.5%; Trp: 17.4%) and they were considered to have inadequate supplement intake. During the ante mortem period, 15.2% of pigs included in the experiment died, and this percentage decreased to 8.7% in those pigs with a feed intake > 2kg/day, all of them from the stress-sensitive pigs (nn). In general, no differences were observed in the behaviour of pigs along the corridor leading to the stunning system and inside the CO2 stunning system. During the stunning procedure, Trp diet showed shorter periods of muscular excitation than control and Mg&Trp diets. The combination of a stressful ante mortem treatment and Mg&Trp supplementation led to carcasses with high incidence of severe skin lesions. Different meat quality results were found when considering all pigs or considering only those with adequate supplement intake. In this later case, Trp increased pH45 (6.15) vs Control diet (5.96) in the Longissimus thoracis (LT) muscle (P<0.05) and pH at 24h (Trp: 5.59 vs C: 5.47) led to a higher incidence of dark, firm and dry (DFD) traits in SM muscle (P<0.05). Genotype affected negatively all the meat quality traits. Seventy-five percent of LT and 60.0% of the SM muscles from nn pigs were classified as pale, soft and exudative (PSE), while none of the NN pigs showed these traits (P<0.0001). No significant differences were found between genotypes on the incidence of DFD meat. Due to the negative effects observed in the Mg&Trp group in feed intake and carcass quality, the utilization of a mixture of magnesium sulphate and tryptophan is not recommended