Classification of sags according to their origin based on the waveform similarity

A statistical method for classification of sags their origin downstream or upstream from the recording point is proposed in this work. The goal is to obtain a statistical model using the sag waveforms useful to characterise one type of sags and to discriminate them from the other type. This model is built on the basis of multi-way principal component analysis an later used to project the available registers in a new space with lower dimension. Thus, a case base of diagnosed sags is built in the projection space. Finally classification is done by comparing new sags against the existing in the case base. Similarity is defined in the projection space using a combination of distances to recover the nearest neighbours to the new sag. Finally the method assigns the origin of the new sag according to the origin of their neighbours

Reliable entertainment: Spanish consumers' preferences regarding a film's country of origin

This article contributes to the study of cinema audiences in Europe by analyzing the actual behavior of Spanish moviegoers and their level of satisfaction. We modeled moviegoers’ choice of film by country of origin (U.S.A., Spain, and other countries) according to a set of determinants: (1) consumers’ interpretation of several sources of information, (2) motivations and (3) choice rules. We found three clear consumer stereotypes related to each type of film: (1) U.S.A. films were preferred by almost everyone (especially families and younger audiences); (2) Spanish films had audiences composed of middle-age and middle-class moviegoers; and (3) European productions were preferred by a social or intellectual elite. U.S.A. films dominate the Spanish market for the reason that they provide most of what moviegoers prefer, namely, familiar, reliable entertainment in Spanish; three characteristics that are not satisfied by Spanish and European films. Additionally, we discuss the implications for the European cultural policy

Tracing the Origin and Spread of Agriculture in Europe

The origins of early farming and its spread to Europe have been the subject of major interest for some time. The main controversy today is over the nature of the Neolithic transition in Europe: the extent to which the spread was, for the most part, indigenous and animated by imitatio (cultural diffusion) or else was driven by an influx of dispersing populations (demic diffusion). We analyze the spatiotemporal dynamics of the transition using radiocarbon dates from 735 early Neolithic sites in Europe, the Near East, and Anatolia. We compute great-circle and shortest-path distances from each site to 35 possible agricultural centers of origin—ten are based on early sites in the Middle East and 25 are hypothetical locations set at 58 latitude/longitude intervals. We perform a linear fit of distance versus age (and vice versa) for each center. For certain centers, high correlation coefficients (R . 0.8) are obtained. This implies that a steady rate or speed is a good overall approximation for this historical development. The average rate of the Neolithic spread over Europe is 0.6–1.3 km/y (95% confidence interval). This is consistent with the prediction of demic diffusion(0.6–1.1 km/y). An interpolative map of correlation coefficients, obtained by using shortest-path distances, shows that the origins of agriculture were most likely to have occurred in the northern Levantine/Mesopotamian area

Knowledge-based modelling and simulation of operational problems of microbiological origin in wastewater treatment plants

The activated sludge and anaerobic digestion processes have been modelled in widely accepted models. Nevertheless, these models still have limitations when describing operational problems of microbiological origin. The aim of this thesis is to develop a knowledge-based model to simulate risk of plant-wide operational problems of microbiological origin.For the risk model heuristic knowledge from experts and literature was implemented in a rule-based system. Using fuzzy logic, the system can infer a risk index for the main operational problems of microbiological origin (i.e. filamentous bulking, biological foaming, rising sludge and deflocculation). To show the results of the risk model, it was implemented in the Benchmark Simulation Models. This allowed to study the risk model's response in different scenarios and control strategies. The risk model has shown to be really useful providing a third criterion to evaluate control strategies apart from the economical and environmental criteria.