Profile simulations of gas chopping etching processes : model development and comparison with experiments

The progress in microsystem technology or nano technology places extended requirements to the fabrication processes. The trend is moving towards structuring within the nanometer scale on the one hand, and towards fabrication of structures with high aspect ratio (ratio of vertical vs. lateral dimensions) and large depths in the 100 µm scale on the other hand. Current procedures for the microstructuring of silicon are wet chemical etching and dry or plasma etching. A modern plasma etching technique for the structuring of silicon is the so-called "gas chopping" etching technique (also called "time-multiplexed etching"). In this etching technique, passivation cycles, which prevent lateral underetching of sidewalls, and etching cycles, which etch preferably in the vertical direction because of the sidewall passivation, are constantly alternated during the complete etching process. To do this, a CHF3/CH4 plasma, which generates CF monomeres is employed during the passivation cycle, and a SF6/Ar, which generates fluorine radicals and ions plasma is employed during the etching cycle. Depending on the requirements on the etched profile, the durations of the individual passivation and etching cycles are in the range of a few seconds up to several minutes. The profiles achieved with this etching process crucially depend on the flow of reactants, i.e. CF monomeres during the passivation cycle, and ions and fluorine radicals during the etching cycle, to the bottom of the profile, especially for profiles with high aspect ratio. With regard to the predictability of the etching processes, knowledge of the fundamental effects taking place during a gas chopping etching process, and their impact onto the resulting profile is required. For this purpose in the context of this work, a model for the description of the profile evolution of such etching processes is proposed, which considers the reactions (etching or deposition) at the sample surface on a phenomenological basis. Furthermore, the reactant transport inside the etching trench is modelled, based on angular distribution functions and on absorption probabilities at the sidewalls and bottom of the trench. A comparison of the simulated profiles with corresponding experimental profiles reveals that the proposed model reproduces the experimental profiles, if the angular distribution functions and absorption probabilities employed in the model is in agreement with data found in the literature. Therefor the model developed in the context of this work is an adequate description of the effects taking place during a gas chopping plasma etching process.

Influence of farmers educational level on comprehending, acting-upon and sharing of agro advisories

Although short messaging service (SMS) through mobile phones has quickly gained popularity among most other sectors in India, its potential is not fully realised in the agriculture sector as a cost effective service to reach farmers and elicit desirable action. Despite the cost effectiveness, mobile messaging has remained a challenge in the farming sector in terms of its end use and action as far as extension systems are concerned. While there could be many influencing factors affecting the utility of mobile messages, this study assumed that educational level of farmers could be a major factor. A telephone survey was conducted to ascertain the influence of farmers’ education on the level of utilisation of mobile-based advisories. Farmers with higher education level showed better comprehension of advisories, actedupon the advisories more promptly and shared the information with fellow farmers more often than those with lower education level. There was a significant association between comprehending, sharing and acting upon advisories. This has implications to achieve enhanced extension reach with higher efficiency in terms of cost and time.