Modelling and simulation of a photovoltaic fuel cell hybrid system

A stand-alone power system is an autonomous system that supplies electricity to the user load without being connected to the electric grid. This kind of decentralized system is frequently located in remote and inaccessible areas. It is essential for about one third of the world population which are living in developed or isolated regions and have no access to an electricity utility grid. The most people live in remote and rural areas, with low population density, lacking even the basic infrastructure. The utility grid extension to these locations is not a cost effective option and sometimes technically not feasible. The purpose of this thesis is the modelling and simulation of a stand-alone hybrid power system, referred to as “hydrogen Photovoltaic-Fuel Cell (PVFC) hybrid system”. It couples a photovoltaic generator (PV), an alkaline water electrolyser, a storage gas tank, a proton exchange membrane fuel cell (PEMFC), and power conditioning units (PCU) to give different system topologies. The system is intended to be an environmentally friendly solution since it tries maximising the use of a renewable energy source. Electricity is produced by a PV generator to meet the requirements of a user load. Whenever there is enough solar radiation, the user load can be powered totally by the PV electricity. During periods of low solar radiation, auxiliary electricity is required. An alkaline high pressure water electrolyser is powered by the excess energy from the PV generator to produce hydrogen and oxygen at a pressure of maximum 30bar. Gases are stored without compression for short- (hourly or daily) and long- (seasonal) term. A proton exchange membrane (PEM) fuel cell is used to keep the system’s reliability at the same level as for the conventional system while decreasing the environmental impact of the whole system. The PEM fuel cell consumes gases which are produced by an electrolyser to meet the user load demand when the PV generator energy is deficient, so that it works as an auxiliary generator. Power conditioning units are appropriate for the conversion and dispatch the energy between the components of the system. No batteries are used in this system since they represent the weakest when used in PV systems due to their need for sophisticated control and their short lifetime. The model library, ISET Alternative Power Library (ISET-APL), is designed by the Institute of Solar Energy supply Technology (ISET) and used for the simulation of the hybrid system. The physical, analytical and/or empirical equations of each component are programmed and implemented separately in this library for the simulation software program Simplorer by C++ language. The model parameters are derived from manufacturer’s performance data sheets or measurements obtained from literature. The identification and validation of the major hydrogen PVFC hybrid system component models are evaluated according to the measured data of the components, from the manufacturer’s data sheet or from actual system operation. Then, the overall system is simulated, at intervals of one hour each, by using solar radiation as the primary energy input and hydrogen as energy storage for one year operation. A comparison between different topologies, such as DC or AC coupled systems, is carried out on the basis of energy point of view at two locations with different geographical latitudes, in Kassel/Germany (Europe) and in Cairo/Egypt (North Africa). The main conclusion in this work is that the simulation method of the system study under different conditions could successfully be used to give good visualization and comparison between those topologies for the overall performance of the system. The operational performance of the system is not only depending on component efficiency but also on system design and consumption behaviour. The worst case of this system is the low efficiency of the storage subsystem made of the electrolyser, the gas storage tank, and the fuel cell as it is around 25-34% at Cairo and 29-37% at Kassel. Therefore, the research for this system should be concentrated in the subsystem components development especially the fuel cell.

Ein computergestütztes Kurskonzept für den Stochastik-Leistungskurs mit kontinuierlicher Verwendung der Software Fathom - Didaktisch kommentierte Unterrichtsmaterialien

Die Unterrichtsmaterialien beschreiben einen Unterrichtsvorschlag für einen kontinuierlich computergestützten Stochastikunterricht in der gymnasialen Oberstufe. Verwendet wird die Software Fathom. Die Unterrichtsmaterialien wurden bislang in fünf verschiedenen Kasseler Oberstufenkursen (Jahrgangsstufe 12 bzw. 13) erprobt und dabei jeweils weiter entwickelt. Ausgearbeitet sind drei Unterrichtseinheiten: 1. „Einstieg in die Stochastik mit Simulationen“ 2. Unterrichtseinheit „Binomialverteilung“ 3. Unterrichtseinheit „Testen von Hypothesen“ Zu jeder der drei Unterrichtseinheiten existieren eine didaktische Beschreibung, die Arbeitsmaterialien (Arbeitsblätter, Merkblätter zur Ergebnissicherung, dynamische Lernumgebungen) sowie Musterlösungen zu den Aufgaben. Für alle Aufgaben mit Verwendung der Software Fathom stehen die zugehörigen Fathom-Dateien zur Verfügung. Alle Fathom-Dateien (Lernumgebungen und Musterlösungen der Aufgaben) erhalten Sie als *.zip-Datei zum Download.

CEM - visualization and discovery in Email

This paper presents a lattice-based visual metaphor for knowledge discovery in electronic mail. It allows a user to navigate email using a visual lattice metaphor rather than a tree structure. By using such a conceptual multi-hierarchy, the content and shape of the lattice can be varied to accommodate any number of queries against the email collection. The system provides more flexibility in retrieving stored emails and can be generalised to any electronic documents. The paper presents the underlying mathematical structures, and a number of examples of the lattice and multi-hierarchy working with a prototypical email collection.

The DIADEM Software Development Methodology extended to Multimedia Interfaces

DIADEM, created by THOMSON-CSF, is a methodology for specifying and developing user interfaces. It improves productivity of the interface development process as well as quality of the interface. The method provides support to user interface development in three aspects. (1) DIADEM defines roles of people involved and their tasks and organises the sequence of activities. (2) It provides graphical formalisms supporting information exchange between people. (3) It offers a basic set of rules for optimum human-machine interfaces. The use of DIADEM in three areas (process control, sales support, and multimedia presentation) was observed and evaluated by our laboratory in the European project DIAMANTA (ESPRIT P20507). The method provides an open procedure that leaves room for adaptation to a specific application and environment. This paper gives an overview of DIADEM and shows how to extend formalisms for developing multimedia interfaces.

Understanding Recreational Services of Urban Riverfront Space for Planning Purposes

In the process of urbanization, natural and semi-natural landscapes are increasingly cherished as open space and recreational resource. Urban rivers are part of this kind of resource and thus play an important role in managing urban resilience and health. Employing the example of Tianjin, this doctoral dissertation research aims at learning to understand how to plan and design for the interface zones between urban water courses and for the land areas adjacent to such water courses. This research also aims at learning how to link waterfront space with other urban space in order to make a recreational space system for the benefit of people. Five questions of this dissertation are: 1) what is the role of rivers in spatial and open space planning? 2) What are the human needs regarding outdoor open space? 3) How do river and water front spatial structures affect people's recreational activities? 4) How to define the recreational service of urban river and waterfront open space? 5) How might answering these question change planning and design of urban open space? Quantitative and qualitative empirical approaches were combined in this study for which literature review and theoretical explorations provide the basis. Empirical investigations were conducted in the city of Tianjin. The quantitative approach includes conducting 267 quantitative interviews, and the qualitative approach includes carrying out field observations and mappings. GIS served to support analysis and visualization of empirical information that was generated through this study. By responding to the five research questions, findings and lessons include the following: 1) In the course of time rivers have gained importance in all levels and scales of spatial planning and decision making. Regarding the development of ecological networks, mainly at national scale, rivers are considered significant linear elements. Regarding regional and comprehensive development, river basins and watersheds are often considered as the structural link for strategic ecological, economic, social and recreational planning. For purposes of urban planning, particularly regarding recreational services in cities, the distribution of urban open spaces often follows the structure of river systems. 2) For the purpose of classifying human recreational needs that relate to outdoor open space Maslow's hierarchy of human needs serves as theoretical basis. The classes include geographical, safety, physiological, social and aesthetic need. These classes serve as references while analyzing river and waterfront open space and other kinds of open space. 3) Regarding the question how river and waterfront spatial structures might affect people's recreational activities, eight different landscape units were identified and compared in the case study area. Considering the thermal conditions of Tianjin, one of these landscape units was identified as affording the optimal spatial arrangement which mostly meets recreational needs. The size and the shape of open space, and the plants present in an open space have been observed as being most relevant regarding recreational activities. 4) Regarding the recreational service of urban river and waterfront open space the results of this research suggest that the recreational service is felt less intensively as the distances between water 183 front and open space user’s places of residence are increasing. As a method for estimating this ‘Service Distance Effect’ the following formula may be used: Y = a*ebx. In this equation Y means the ‘Service Distance’ between homes and open space, and X means the percentage of the people who live within this service distance. Coefficient "a" represents the distance of the residential area nearest to the water front. The coefficient "b" is a comprehensive capability index that refers to the size of the available and suitable recreational area. 5) Answers found to the questions above have implications for the planning and design of urban open space. The results from the quantitative study of recreational services of waterfront open space were applied to the assessment of river-based open space systems. It is recommended that such assessments might be done employing the network analysis function available with any GIS. In addition, several practical planning and designing suggestions are made that would help remedy any insufficient base for satisfying recreational needs. The understanding of recreational need is considered helpful for the proposing planning and designing ideas and for the changing of urban landscapes. In the course of time Tianjin's urban water system has shrunk considerably. At the same time rivers and water courses have shaped Tianjin's urban structure in noticeable ways. In the process of urbanization water has become increasingly important to the citizens and their everyday recreations. Much needs to be changed in order to improve recreational opportunities and to better provide for a livable city, most importantly when considering the increasing number of old people. Suggestions made that are based on results of this study, might be implemented in Tianjin. They are 1) to promote the quality of the waterfront open space and to make all linear waterfront area accessible recreational spaces. Then, 2), it is advisable to advocate the concept of green streets and to combine green streets with river open space in order to form an everyday recreational network. And 3) any sound urban everyday recreational service made cannot rely on only urban rivers; the whole urban structure needs to be improved, including adding small open space and optimize the form of urban communities, finally producing a multi-functional urban recreational network.

The Human in the Loop: User Participation in Self-Adaptive Software

Self-adaptive software provides a profound solution for adapting applications to changing contexts in dynamic and heterogeneous environments. Having emerged from Autonomic Computing, it incorporates fully autonomous decision making based on predefined structural and behavioural models. The most common approach for architectural runtime adaptation is the MAPE-K adaptation loop implementing an external adaptation manager without manual user control. However, it has turned out that adaptation behaviour lacks acceptance if it does not correspond to a user’s expectations – particularly for Ubiquitous Computing scenarios with user interaction. Adaptations can be irritating and distracting if they are not appropriate for a certain situation. In general, uncertainty during development and at run-time causes problems with users being outside the adaptation loop. In a literature study, we analyse publications about self-adaptive software research. The results show a discrepancy between the motivated application domains, the maturity of examples, and the quality of evaluations on the one hand and the provided solutions on the other hand. Only few publications analysed the impact of their work on the user, but many employ user-oriented examples for motivation and demonstration. To incorporate the user within the adaptation loop and to deal with uncertainty, our proposed solutions enable user participation for interactive selfadaptive software while at the same time maintaining the benefits of intelligent autonomous behaviour. We define three dimensions of user participation, namely temporal, behavioural, and structural user participation. This dissertation contributes solutions for user participation in the temporal and behavioural dimension. The temporal dimension addresses the moment of adaptation which is classically determined by the self-adaptive system. We provide mechanisms allowing users to influence or to define the moment of adaptation. With our solution, users can have full control over the moment of adaptation or the self-adaptive software considers the user’s situation more appropriately. The behavioural dimension addresses the actual adaptation logic and the resulting run-time behaviour. Application behaviour is established during development and does not necessarily match the run-time expectations. Our contributions are three distinct solutions which allow users to make changes to the application’s runtime behaviour: dynamic utility functions, fuzzy-based reasoning, and learning-based reasoning. The foundation of our work is a notification and feedback solution that improves intelligibility and controllability of self-adaptive applications by implementing a bi-directional communication between self-adaptive software and the user. The different mechanisms from the temporal and behavioural participation dimension require the notification and feedback solution to inform users on adaptation actions and to provide a mechanism to influence adaptations. Case studies show the feasibility of the developed solutions. Moreover, an extensive user study with 62 participants was conducted to evaluate the impact of notifications before and after adaptations. Although the study revealed that there is no preference for a particular notification design, participants clearly appreciated intelligibility and controllability over autonomous adaptations.

Interface issues in the ESCHER visual database editor

Presentation at the 1997 Dagstuhl Seminar "Evaluation of Multimedia Information Retrieval", Norbert Fuhr, Keith van Rijsbergen, Alan F. Smeaton (eds.), Dagstuhl Seminar Report 175, 14.04. - 18.04.97 (9716). - Abstract: This presentation will introduce ESCHER, a database editor which supports visualization in non-standard applications in engineering, science, tourism and the entertainment industry. It was originally based on the extended nested relational data model and is currently extended to include object-relational properties like inheritance, object types, integrity constraints and methods. It serves as a research platform into areas such as multimedia and visual information systems, QBE-like queries, computer-supported concurrent work (CSCW) and novel storage techniques. In its role as a Visual Information System, a database editor must support browsing and navigation. ESCHER provides this access to data by means of so called fingers. They generalize the cursor paradigm in graphical and text editors. On the graphical display, a finger is reflected by a colored area which corresponds to the object a finger is currently pointing at. In a table more than one finger may point to objects, one of which is the active finger and is used for navigating through the table. The talk will mostly concentrate on giving examples for this type of navigation and will discuss some of the architectural needs for fast object traversal and display. ESCHER is available as public domain software from our ftp site in Kassel. The portable C source can be easily compiled for any machine running UNIX and OSF/Motif, in particular our working environments IBM RS/6000 and Intel-based LINUX systems. A porting to Tcl/Tk is under way.

Instant Storyboarding

This thesis aims at empowering software customers with a tool to build software tests them selves, based on a gradual refinement of natural language scenarios into executable visual test models. The process is divided in five steps: 1. First, a natural language parser is used to extract a graph of grammatical relations from the textual scenario descriptions. 2. The resulting graph is transformed into an informal story pattern by interpreting structurization rules based on Fujaba Story Diagrams. 3. While the informal story pattern can already be used by humans the diagram still lacks technical details, especially type information. To add them, a recommender based framework uses web sites and other resources to generate formalization rules. 4. As a preparation for the code generation the classes derived for formal story patterns are aligned across all story steps, substituting a class diagram. 5. Finally, a headless version of Fujaba is used to generate an executable JUnit test. The graph transformations used in the browser application are specified in a textual domain specific language and visualized as story pattern. Last but not least, only the heavyweight parsing (step 1) and code generation (step 5) are executed on the server side. All graph transformation steps (2, 3 and 4) are executed in the browser by an interpreter written in JavaScript/GWT. This result paves the way for online collaboration between global teams of software customers, IT business analysts and software developers.