Seismic behavior of capacity designed masonry walls in low seismicity regions

Eurocode 8 representing a new generation of structural design codes in Europe defines ‎requirements for the design of buildings against earthquake action. In Central and ‎Western Europe, the newly defined earthquake zones and corresponding design ground ‎acceleration values, will lead in many cases to earthquake actions which are remarkably ‎higher than those defined so far by the design codes used until now in Central Europe. ‎ In many cases, the weak points of masonry structures during an earthquake are the corner ‎regions of the walls. Loading of masonry walls by earthquake action leads in most cases ‎to high shear forces. The corresponding bending moment in such a wall typically causes a ‎significant increase of the eccentricity of the normal force in the critical wall cross ‎section. This in turn leads ultimately to a reduction of the size of the compression zone in ‎unreinforced walls and a high concentration of normal stresses and shear stresses in the ‎corner regions. ‎ Corner-Gap-Elements, consisting of a bearing beam located underneath the wall and ‎made of a sufficiently strong material (such as reinforced concrete), reduce the effect of ‎the eccentricity of the normal force and thus restricts the pinching effect of the ‎compression zone. In fact, the deformation can be concentrated in the joint below the ‎bearing beam. According to the principles of the Capacity Design philosophy, the ‎masonry itself is protected from high stresses as a potential cause of brittle failure. ‎ Shaking table tests at the NTU Athens Earthquake Engineering Laboratory have proven ‎the effectiveness of the Corner-Gap-Element. The following presentation will cover the ‎evaluation of various experimental results as well as a numerical modeling of the ‎observed phenomena.‎

Determination of the silvo-melliferous regions of Benin: a nationwide categorisation of the land based on melliferous plants suitable for timber production

Perennial plants are the main pollen and nectar sources for bees in the tropical areas where most of the annual flora are burned in dry seasons. Therefore perennial plants constitute the most reliable bio materials for determining and evaluating the beekeeping regions of the Republic of Benin. A silvo-melliferous region (S-MR) is a geographical area characterised by a particular set of homogenous melliferous plants that can produce timber. Using both the prevailing climatic and the agro-ecological conditions six S-MRs could be identified, i.e. the South region, the Common Central region, the Central West region, the Central North region, the Middle North region and the Extreme North region. At the country level, the melliferous plants were dominated by Vitellaria paradoxa which is common to all regions. The most diversified family was the Caesalpiniaceae (12 species) followed by the Combretaceae (10 species) and Combretum being the richest genus. The effect of dominance is particularly high in the South region where Elaeis guineensis alone represented 72.6% of the tree density and 140% of the total plant importance. The total melliferous plant density varied from 99.3 plants ha^(−1) in the Common Central region to 178.0 plants ha^(−1) in the Central West region. On the basis of nectar and pollen source, the best region for beekeeping is the CentralWest region with 46.7% of nectar producing trees, 9.4% of pollen producing trees and 40.6% of plants that issue both, this in opposition to the South region which was characterised by an unbalanced distribution of melliferous trees.