Seismic behavior of capacity designed masonry walls in low seismicity regions

Eurocode 8 representing a new generation of structural design codes in Europe defines ‎requirements for the design of buildings against earthquake action. In Central and ‎Western Europe, the newly defined earthquake zones and corresponding design ground ‎acceleration values, will lead in many cases to earthquake actions which are remarkably ‎higher than those defined so far by the design codes used until now in Central Europe. ‎ In many cases, the weak points of masonry structures during an earthquake are the corner ‎regions of the walls. Loading of masonry walls by earthquake action leads in most cases ‎to high shear forces. The corresponding bending moment in such a wall typically causes a ‎significant increase of the eccentricity of the normal force in the critical wall cross ‎section. This in turn leads ultimately to a reduction of the size of the compression zone in ‎unreinforced walls and a high concentration of normal stresses and shear stresses in the ‎corner regions. ‎ Corner-Gap-Elements, consisting of a bearing beam located underneath the wall and ‎made of a sufficiently strong material (such as reinforced concrete), reduce the effect of ‎the eccentricity of the normal force and thus restricts the pinching effect of the ‎compression zone. In fact, the deformation can be concentrated in the joint below the ‎bearing beam. According to the principles of the Capacity Design philosophy, the ‎masonry itself is protected from high stresses as a potential cause of brittle failure. ‎ Shaking table tests at the NTU Athens Earthquake Engineering Laboratory have proven ‎the effectiveness of the Corner-Gap-Element. The following presentation will cover the ‎evaluation of various experimental results as well as a numerical modeling of the ‎observed phenomena.‎

Sensor-based Control of Chewing and Rumination Behavior of Dairy Cows

The measurement of feed intake, feeding time and rumination time, summarized by the term feeding behavior, are helpful indicators for early recognition of animals which show deviations in their behavior. The overall objective of this work was the development of an early warning system for inadequate feeding rations and digestive and metabolic disorders, which prevention constitutes the basis for health, performance, and reproduction. In a literature review, the current state of the art and the suitability of different measurement tools to determine feeding behavior of ruminants was discussed. Five measurement methods based on different methodological approaches (visual observance, pressure transducer, electrical switches, electrical deformation sensors and acoustic biotelemetry), and three selected measurement techniques (the IGER Behavior Recorder, the Hi-Tag rumination monitoring system and RumiWatchSystem) were described, assessed and compared to each other within this review. In the second study, the new system for measuring feeding behavior of dairy cows was evaluated. The measurement of feeding behavior ensues through electromyography (EMG). For validation, the feeding behavior of 14 cows was determined by both the EMG system and by visual observation. The high correlation coefficients indicate that the current system is a reliable and suitable tool for monitoring the feeding behavior of dairy cows. The aim of a further study was to compare the DairyCheck (DC) system and two additional measurement systems for measuring rumination behavior in relation to efficiency, reliability and reproducibility, with respect to each other. The two additional systems were labeled as the Lely Qwes HR (HR) sensor, and the RumiWatchSystem (RW). Results of accordance of RW and DC to each other were high. The last study examined whether rumination time (RT) is affected by the onset of calving and if it might be a useful indicator for the prediction of imminent birth. Data analysis referred to the final 72h before the onset of calving, which were divided into twelve 6h-blocks. The results showed that RT was significantly reduced in the final 6h before imminent birth.

How Death Guides Human Behavior - The Role of Cultural Norms and Values in Terror Management Theory

Die Dissertation besteht im Wesentlichen aus zwei Teilen: der Synopse und einem empirischen Teil. In der Synopse werden die Befunde aus dem empirischen Teil zusammengefasst und mit der bisherigen Forschungsliteratur in Zusammenhang gesetzt. Im empirischen Teil werden alle Studien, die für diese Dissertation durchgeführt wurden, in Paper-Format berichtet. Im ersten Teil der Synopse werden grundlegende Annahmen der Terror Management Theorie (TMT) dargelegt—mit besonderem Schwerpunkt auf die Mortalitätssalienz (MS)-Hypothese, die besagt, dass die Konfrontation mit der eigenen Sterblichkeit die Motivation erhöht das eigene Weltbild zu verteidigen und nach Selbstwert zu streben. In diesem Kontext wird auch die zentrale Rolle von Gruppen erklärt. Basierend auf diesen beiden Reaktionen, wird TMT Literatur angeführt, die sich auf bestimmte kulturelle Werte und soziale Normen bezieht (wie prosoziale und pro-Umwelt Normen, materialistische und religiöse Werte, dem Wert der Ehrlichkeit, die Norm der Reziprozität und deskriptive Normen). Darüber hinaus werden Randbedingungen, wie Gruppenmitgliedschaft und Norm-Salienz, diskutiert. Zuletzt folgt eine Diskussion über die Rolle von Gruppen, der Funktion des Selbstwerts und über Perspektiven einer friedlichen Koexistenz. Der empirische Teil enthält elf Studien, die in acht Papern berichtet werden. Das erste Paper behandelt die Rolle von Gruppenmitgliedschaft unter MS, wenn es um die Bewertung von anderen geht. Das zweite Manuskript geht der Idee nach, dass Dominanz über andere für Sadisten eine mögliche Quelle für Selbstwert ist und daher unter MS verstärkt ausgeübt wird. Das dritte Paper untersucht prosoziales Verhalten in einer Face-to-Face Interaktion. Im vierten Paper wird gezeigt, dass Personen (z.B. Edward Snowden), die im Namen der Wahrheit handeln, unter MS positiver bewertet werden. Im fünften Paper zeigen zwei Studien, dass MS dazu führt, dass mögliche gelogene Aussagen kritischer beurteilt werden. Das sechste Paper zeigt, dass der Norm der Reziprozität unter MS stärker zugestimmt wird. Das siebte Paper geht der Frage nach, inwiefern MS das Einhalten dieser Norm beeinflusst. Und schließlich wird im achten Paper gezeigt, dass MS die Effektivität der Door-in-the-Face Technik erhöht—eine Technik, die auf der Norm der Reziprozität basiert.

Punching Shear Behavior of UHPC Flat Slabs

At the Institute of Structural Engineering of the Faculty of Civil Engineering, Kassel University, series tests of slab-column connection were carried out, subjected to concentrated punching load. The effects of steel fiber content, concrete compressive strength, tension reinforcement ratio, size effect, and yield stress of tension reinforcement were studied by testing a total of six UHPC slabs and one normal strength concrete slab. Based on experimental results; all the tested slabs failed in punching shear as a type of failure, except the UHPC slab without steel fiber which failed due to splitting of concrete cover. The post ultimate load-deformation behavior of UHPC slabs subjected to punching load shows harmonic behavior of three stages; first, drop of load-deflection curve after reaching maximum load, second, resistance of both steel fibers and tension reinforcement, and third, pure tension reinforcement resistance. The first shear crack of UHPC slabs starts to open at a load higher than that of normal strength concrete slabs. Typically, the diameter of the punching cone for UHPC slabs on the tension surface is larger than that of NSC slabs and the location of critical shear crack is far away from the face of the column. The angle of punching cone for NSC slabs is larger than that of UHPC slabs. For UHPC slabs, the critical perimeter is proposed and located at 2.5d from the face of the column. The final shape of the punching cone is completed after the tension reinforcement starts to yield and the column stub starts to penetrate through the slab. A numerical model using Finite Element Analysis (FEA) for UHPC slabs is presented. Also some variables effect on punching shear is demonstrated by a parametric study. A design equation for UHPC slabs under punching load is presented and shown to be applicable for a wide range of parametric variations; in the ranges between 40 mm to 300 mm in slab thickness, 0.1 % to 2.9 % in tension reinforcement ratio, 150 MPa to 250 MPa in compressive strength of concrete and 0.1 % to 2 % steel fiber content. The proposed design equation of UHPC slabs is modified to include HSC and NSC slabs without steel fiber, and it is checked with the test results from earlier researches.

Does interpersonal behavior of psychotherapy trainees differ in private and professional relationships?

• Aim: The present study aimed to evaluate the effect of trainees’ interpersonal behavior on work involvement (WI) and compared their social behavior within professional and private relationships as well as between different psychotherapeutic orientations. • Methods: The interpersonal scales of the Intrex short-form questionnaire and the Work Involvement Scale (WIS) were used to evaluate two samples of German psychotherapy trainees in psychoanalytic, psychodynamic, and cognitive behavioral therapy training. Trainees from Sample 1 (N = 184) were asked to describe their interpersonal behavior in relation to their patients when filling out the Intrex, whereas trainees from Sample 2 (N = 135) were asked to describe the private relationship with a significant other. • Results: Interpersonal affiliation in professional relationships significantly predicted the level of healing involvement, while stress involvement was predicted by interpersonal affiliation and interdependence in trainees’ relationships with their patients. Social behavior within professional relationships provided higher correlations with WI than private interpersonal behavior. Significant differences were found between private and professional relation settings in trainees’ interpersonal behavior with higher levels of affiliation and interdependence with significant others. Differences between therapeutic orientation and social behavior could only be found when comparing trainees’ level of interdependence with the particular relationship setting. • Conclusion: Trainees’ interpersonal level of affiliation in professional relationships is a predictor for a successful psychotherapeutic development. Vice versa, controlling behavior in professional settings can be understood as a risk factor against psychotherapeutic growth. Both results strengthen an evidence-based approach for competence development during psychotherapy training.

Institutions, Behavior and Evolution

The three articles constituting this thesis are for reasons of content or method related to the following three fields in economics: Behavioral Economics, Evolutionary Game Theory and Formal Institutional Economics. A core element of these fields is the concept of individual preferences. Preferences are of central importance for the conceptional framework to analyze human behavior. They form the foundation for the theory of rational choice which is defined by the determination of the choice set and the selection of the most preferred alternative according to some consistency requirements. The theory of rational choice is based on a very simplified description of the problem of choice (object function and constraints). However, that choices depend on many more factors is for instance propagated by psychological theories and is supported by many empirical and experimental studies. This thesis adds to a better understanding of individual behavior to the extent that the evolution of certain characteristics of preferences and their consequences on human behavior forms the overarching theme of the dissertation. The long-term effect of evolutionary forces on a particular characteristic of importance in the theoretical, empirical and experimental economic literature, the concept of inequality aversion, is subject of the article “The evolution of inequality aversion in a simplified game of life” (Chapter 4). The contribution of the article is the overcoming of a restriction of former approaches to analyze the evolution of preferences in very simple environments. By classifying human interaction into three central economic games, the article provides a first step towards a simplified and sufficiently complete description of the interaction environment. Within such an environment the article characterizes the evolutionary stable preference distribution. One result shows, that the interaction of the aforementioned three classes can stabilize a preference of inequality aversion in the subpopulation which is favored in the problem of redistribution. The two remaining articles are concerned with social norms, which dissemination is determined by medium-run forces of cultural evolution. The article “The impact of market innovations on the evolution of social norms: the sustainability case.“ (Chapter 2) studies the interrelation between product innovations which are relevant from a sustainability perspective and an according social norm in consumption. This relation is based on a conformity bias in consumption and the attempt to avoid cognitive dissonances resulting from non-compliant consumption. Among others, it is shown that a conformity bias on the consumption side can lead to multiple equilibria on the side of norm adoption. The article “Evolution of cooperation in social dilemmas: signaling internalized norms.” (Chapter 3) studies the emergence of cooperation in social dilemmas based on the signaling of social norms. The article provides a potential explanation of cooperative behavior, which does not rely on the assumption of structured populations or on the unmotivated ability of social norms to restrict individual actions or strategy spaces. A comprehensive result of the single articles is the explanation of the phenomenon of partial norm adaption or dissemination of preferences. The plurality of the applied approaches with respect to the proximity to the rational choice approach and regarding the underlying evolutionary mechanics is a particular strength of the thesis. It shows the equality of these approaches in their potential to explain the phenomenon of cooperation in environments that provide material incentives for defective behavior. This also points to the need of a unified framework considering the biological and cultural coevolution of preference patterns.

Accuracy of outcome anticipation, but not gaze behavior, differs against left- and right-handed penalties in team-handball goalkeeping

Low perceptual familiarity with relatively rarer left-handed as opposed to more common right-handed individuals may result in athletes' poorer ability to anticipate the former's action intentions. Part of such left-right asymmetry in visual anticipation could be due to an inefficient gaze strategy during confrontation with left-handed individuals. To exemplify, observers may not mirror their gaze when viewing left- vs. right-handed actions but preferentially fixate on an opponent's right body side, irrespective of an opponent's handedness, owing to the predominant exposure to right-handed actions. So far empirical verification of such assumption, however, is lacking. Here we report on an experiment where team-handball goalkeepers' and non-goalkeepers' gaze behavior was recorded while they predicted throw direction of left- and right-handed 7-m penalties shown as videos on a computer monitor. As expected, goalkeepers were considerably more accurate than non-goalkeepers and prediction was better against right- than left-handed penalties. However, there was no indication of differences in gaze measures (i.e., number of fixations, overall and final fixation duration, time-course of horizontal or vertical fixation deviation) as a function of skill group or the penalty-takers' handedness. Findings suggest that inferior anticipation of left-handed compared to right-handed individuals' action intentions may not be associated with misalignment in gaze behavior. Rather, albeit looking similarly, accuracy differences could be due to observers' differential ability of picking up and interpreting the visual information provided by left- vs. right-handed movements.