Modeling of Suspended Sediment Dynamics in Tropical River Basins

It is proposed to study the suspended sediment transport characteristics of river basins of Kerala and to model suspended sediment discharge mechanism for typical micro-watersheds. The Pamba river basin is selected as a representative hydrologic regime for detailed studies of suspended sediment characteristics and its seasonal variation. The applicability of various erosion models would be tested by comparing with the observed event data (by continuous monitoring of rainfall, discharge, and suspended sediment concentration for lower order streams). Empirical, conceptual and physically distributed models were used for making the comparison of performance of the models. Large variations in the discharge and sediment quantities were noticed during a particular year between the river basins investigated and for an individual river basin during the years for which the data was available. In general, the sediment yield pattern follows the seasonal distribution of rainfall, discharge and physiography of the land. This confirms with similar studies made for other Indian rivers. It was observed from this study, that the quantity of sediment transported downstream shows a decreasing trend over the years corresponding to increase in discharge. For sound and sustainable management of coastal zones, it is important to understand the balance between erosion and retention and to quantify the exact amount of the sediments reaching this eco-system. This, of course, necessitates a good length of time series data and more focused research on the behaviour of each river system, both present and past. In this realm of river inputs to ocean system, each of the 41 rivers of Kerala may have dominant yet diversified roles to influence the coastal ecosystem as reflected from this study on the major fraction of transport, namely the suspended sediments

Dynamics of Land Use in Recently Settled Forest Areas: a Case Study of Attappady , Kerala

The present study on the dynamics of land use in recently settled forest areas. In the course of events, tribals lost their land; the demographic structure of Attappady changed; the cropping pattern got diversified; traditional techniques of production were ruined; new crops and new techniques of cultivation came to stay; and the entire cost and return structure of production underwent radical change. Migration to Attappady is essentially a continuation of the Malabar migration process from Travancore, through, some people from Tamil Nadu also had migrated to this region earlier. The demographic structure, along with land structure, has changed in favour of the settlers within a short span of time. Lack of security of ownership has acted as a strong reason for wanton exploitation of land resources. The major influencing factors on crop choices among settlers were labour endowment, date of settlement and education. Attappady is an unique ecosystem in Kerala characterized by many interdependables. The latest hand of environmental degradation is a grave danger especially on sloppy terrains,which are under cultivation of tapioca and dry annual crops like groundnuts, cotton, grams etc. Soil erosion as a result of the unplanned cultivation of these crops has resulted in dramatic decline in soil fertility and hence low crop productivity. This calls for a watershed management approach for the sustainable development of the region. A progressive agrarian transformation is warranted to maintain the homegarden as a sustainable production system in ecological and socio-economic terms.

Studies on the Effect of Randomness on the Synchronization of Coupled Systems and on the Dynamics of Intermittently driven systems

Nonlinear dynamics has emerged into a prominent area of research in the past few Decades.Turbulence, Pattern formation,Multistability etc are some of the important areas of research in nonlinear dynamics apart from the study of chaos.Chaos refers to the complex evolution of a deterministic system, which is highly sensitive to initial conditions. The study of chaos theory started in the modern sense with the investigations of Edward Lorentz in mid 60's. Later developments in this subject provided systematic development of chaos theory as a science of deterministic but complex and unpredictable dynamical systems. This thesis deals with the effect of random fluctuations with its associated characteristic timescales on chaos and synchronization. Here we introduce the concept of noise, and two familiar types of noise are discussed. The classifications and representation of white and colored noise are introduced. Based on this we introduce the concept of randomness that we deal with as a variant of the familiar concept of noise. The dynamical systems introduced are the Rossler system, directly modulated semiconductor lasers and the Harmonic oscillator. The directly modulated semiconductor laser being not a much familiar dynamical system, we have included a detailed introduction to its relevance in Chaotic encryption based cryptography in communication. We show that the effect of a fluctuating parameter mismatch on synchronization is to destroy the synchronization. Further we show that the relation between synchronization error and timescales can be found empirically but there are also cases where this is not possible. Studies show that under the variation of the parameters, the system becomes chaotic, which appears to be the period doubling route to chaos.

Mathematical Modelling of the Dynamics of Granular Materials in a Rotating Cylinder

The current study is aimed at the development of a theoretical simulation tool based on Discrete Element Method (DEM) to 'interpret granular dynamics of solid bed in the cross section of the horizontal rotating cylinder at the microscopic level and subsequently apply this model to establish the transition behaviour, mixing and segregation.The simulation of the granular motion developed in this work is based on solving Newton's equation of motion for each particle in the granular bed subjected to the collisional forces, external forces and boundary forces. At every instant of time, the forces are tracked and the positions velocities and accelarations of each partcle is The software code for this simulation is written in VISUAL FORTRAN 90 After checking the validity of the code with special tests, it is used to investigate the transition behaviour of granular solids motion in the cross section of a rotating cylinder for various rotational speeds and fill fraction.This work is hence directed towards a theoretical investigation based on Discrete Element Method (DEM) of the motion of granular solids in the radial direction of the horizontal cylinder to elucidate the relationship between the operating parameters of the rotating cylinder geometry and physical properties ofthe granular solid.The operating parameters of the rotating cylinder include the various rotational velocities of the cylinder and volumetric fill. The physical properties of the granular solids include particle sizes, densities, stiffness coefficients, and coefficient of friction Further the work highlights the fundamental basis for the important phenomena of the system namely; (i) the different modes of solids motion observed in a transverse crosssection of the rotating cylinder for various rotational speeds, (ii) the radial mixing of the granular solid in terms of active layer depth (iii) rate coefficient of mixing as well as the transition behaviour in terms of the bed turnover time and rotational speed and (iv) the segregation mechanisms resulting from differences in the size and density of particles.The transition behaviour involving its six different modes of motion of the granular solid bed is quantified in terms of Froude number and the results obtained are validated with experimental and theoretical results reported in the literature The transition from slumping to rolling mode is quantified using the bed turnover time and a linear relationship is established between the bed turn over time and the inverse of the rotational speed of the cylinder as predicted by Davidson et al. [2000]. The effect of the rotational speed, fill fraction and coefficient of friction on the dynamic angle of repose are presented and discussed. The variation of active layer depth with respect to fill fraction and rotational speed have been investigated. The results obtained through simulation are compared with the experimental results reported by Van Puyvelde et. at. [2000] and Ding et at. [2002].The theoretical model has been further extended, to study the rmxmg and segregation in the transverse direction for different particle sizes and their size ratios. The effect of fill fraction and rotational speed on the transverse mixing behaviour is presented in the form of a mixing index and mixing kinetics curve. The segregation pattern obtained by the simulation of the granular solid bed with respect to the rotational speed of the cylinder is presented both in graphical and numerical forms. The segregation behaviour of the granular solid bed with respect to particle size, density and volume fraction of particle size has been investigated. Several important macro parameters characterising segregation such as mixing index, percolation index and segregation index have been derived from the simulation tool based on first principles developed in this work.

Permutation Entropy Based Analysis of Complex Signals for Characterising Change in System Dynamics

Timely detection of sudden change in dynamics that adversely affect the performance of systems and quality of products has great scientific relevance. This work focuses on effective detection of dynamical changes of real time signals from mechanical as well as biological systems using a fast and robust technique of permutation entropy (PE). The results are used in detecting chatter onset in machine turning and identifying vocal disorders from speech signal.Permutation Entropy is a nonlinear complexity measure which can efficiently distinguish regular and complex nature of any signal and extract information about the change in dynamics of the process by indicating sudden change in its value. Here we propose the use of permutation entropy (PE), to detect the dynamical changes in two non linear processes, turning under mechanical system and speech under biological system.Effectiveness of PE in detecting the change in dynamics in turning process from the time series generated with samples of audio and current signals is studied. Experiments are carried out on a lathe machine for sudden increase in depth of cut and continuous increase in depth of cut on mild steel work pieces keeping the speed and feed rate constant. The results are applied to detect chatter onset in machining. These results are verified using frequency spectra of the signals and the non linear measure, normalized coarse-grained information rate (NCIR).PE analysis is carried out to investigate the variation in surface texture caused by chatter on the machined work piece. Statistical parameter from the optical grey level intensity histogram of laser speckle pattern recorded using a charge coupled device (CCD) camera is used to generate the time series required for PE analysis. Standard optical roughness parameter is used to confirm the results.Application of PE in identifying the vocal disorders is studied from speech signal recorded using microphone. Here analysis is carried out using speech signals of subjects with different pathological conditions and normal subjects, and the results are used for identifying vocal disorders. Standard linear technique of FFT is used to substantiate thc results.The results of PE analysis in all three cases clearly indicate that this complexity measure is sensitive to change in regularity of a signal and hence can suitably be used for detection of dynamical changes in real world systems. This work establishes the application of the simple, inexpensive and fast algorithm of PE for the benefit of advanced manufacturing process as well as clinical diagnosis in vocal disorders.

Macrobenthos And Its Relation To Ecosystem Dynamics In The Cochin Estuary

Cochin estuary is a shallow brackish water body situated on the south west coast of India. It is a tropical positive estuary extending between 90 40’ and 100 12’ N and 760 10’and 760 30’ E with its northern boundary at Azhikode and southern boundary at Thannermukkom bund.The abundance of benthic fauna in an ecosystem shows the close relationship to its environment and reflects the characteristics of an ecological niche. Seasonal and monthly variations in the distribution of macrobenthos in relation to sediment characteristics were conducted in Cochin estuary from 2009-10 periods. Oxidation-reduction potential showed reducing trends that affected the distribution and diversity of fauna. Seasonal variations in water quality and river discharge pattern affected the faunal composition in the different stations. Sewage mixing was the principal source of organic pollution in the Cochin estuary. The sediment pH was generally on the alkaline side ranging from 4.99 at St.9 and 8.33 at St.1.The Eh ranged from -11mV at St.3 to -625mV at St.2.The temperature varied from 260C to 320C in the estuary. The moisture content ranged from 1.63 to 12.155%, that of organic carbon from 0 09 at St. 6 to 4.29% at St.9 and that of organic matter from 0.16 to 7.39%. Seasonally, the average of Eh was highest during the monsoon (156.22 mV) and in the pre monsoon (140.94 mV). The average pH for the 9 study stations was 7.68 during monsoon period and 7.08 during post monsoon. Based on group wise seasonal analysis, the average mean abundance was maximum for polychaetes (43.47) followed by nematodes (33.62), crustaceans (21.62), molluscs (11.94) and Pisces (0.05) in the estuary. Monsoon season was most favourable for benthic faunal abundance followed by the post monsoon period in the study. The series of human interventions like dredging, discharge of industrial effluents, urbanisation and related aspects had a strong influence on the distribution, abundance of benthic macrofauna in the wetland.