Grain refinement studies on Mg and Mg-Al based alloys

Demand on magnesium and its alloys is increased significantly in the automotive industry because of their great potential in reducing the weight of components, thus resulting in improvement in fuel efficiency of the vehicle. To date, most of Mg products have been fabricated by casting, especially, by die-casting because of its high productivity, suitable strength, acceptable quality & dimensional accuracy and the components produced through sand, gravity and low pressure die casting are small extent. In fact, higher solidification rate is possible only in high pressure die casting, which results in finer grain size. However, achieving high cooling rate in gravity casting using sand and permanent moulds is a difficult task, which ends with a coarser grain nature and exhibit poor mechanical properties, which is an important aspect of the performance in industrial applications. Grain refinement is technologically attractive because it generally does not adversely affect ductility and toughness, contrary to most other strengthening methods. Therefore formation of fine grain structure in these castings is crucial, in order to improve the mechanical properties of these cast components. Therefore, the present investigation is “GRAIN REFINEMENT STUDIES ON Mg AND Mg-Al BASED ALLOYS”. The primary objective of this present investigation is to study the effect of various grain refining inoculants (Al-4B, Al- 5TiB2 master alloys, Al4C3, Charcoal particles) on Pure Mg and Mg-Al alloys such as AZ31, AZ91 and study their grain refining mechanisms. The second objective of this work is to study the effect of superheating process on the grain size of AZ31, AZ91 Mg alloys with and without inoculants addition. In addition, to study the effect of grain refinement on the mechanical properties of Mg and Mg-Al alloys. The thesis is well organized with seven chapters and the details of the studies are given below in detail.

Synthesis And Reactions Of Pyrazoldouinoxalines

The present work reports the synthesis of 2-ary1—3—oxo-3—pyrazolino[3,4-b]quinoxalines for the first time. These compounds have been prepared by the reaction of ethyl 2-chloroquinoxaline—3—carboxylate with different phenylhydrazines. 2-Aryl—3-oxo—3—pyrazolino[3,4—b]quinoxalines are generally light yellow in either neutral or acid solutions but changed the colour to deep violet or green in basic media. The change in colour appears to be sharp and therefore these compounds may be used as acid base indicators. Their UV absorption maxima under acidic and basic media are also very different. However, the actual conditions under which these compounds may be used as indicators have not been worked out. The synthesis and reactions of a new heterocyclic system, lH—l,5—benzodiazepino[2,3—b]quinoxaline is also reported here. This novel nitrogen heterocycke was prepared by the condensation of ethyl 2-chloroquinoxaline-3—carboxylate with o-phenylene diamine and subsequent manipulationsa to give the parent compound. Several derivatives which are expected tx> have valuable biological properties have also beenlreported. The structures of all new compounds have been established by elemental analysis and also by analysing their spectral data smch as ultraviolet, infrared, nuclear magnetic resonance and mass spectrometry. Compounds obtained from this work will be submitted for screening their biological properties.

A facile and single pot strategy for the synthesis of novel naphthyridine derivatives under microwave irradiation conditions using ZnCl2 as catalyst, evaluation of AChE inhibitory activity, and molecular modeling studies

A series of novel naphthyridine derivatives 3 and 4 was prepared from substituted pyridine 2 and ketones using ZnCl2 as catalyst under microwave irradiation conditions. All the compounds were evaluated for AChE inhibitory activity and promising compounds 3d, 3e, 4b, and 4g was identified. Representative compounds 3d and 3e were found to show insignificant THLE-2 liver cell viability/toxicity. The binding mode between X-ray crystal structure of human AChE and compounds was studied using molecular docking method and fitness scores were found to be in good correlation with the activity data.