Studies on the Cure Characteristics of Elastomer Blends

Blends of natural rubber (NR) with styrene-butadiene rubber (SBR), polybutadiene rubber (BR), ethylene-propylene terpolymer (EPDM) and acrylonitrile-butadiene rubber (NBR) were vulcanised using an efficient vulcanisation (EV) system and a semi-EV system. Compatible blends show a definite pattern of curing whereas the incompatible blends show no such pattern.

Degenerate four wave mixing in some metal phthalocyanines and naphthalocyanines

Here we report measurements of third-order susceptibility χ(3), figure of merit F defined as χ(3)/α (where α is the absorption coefficient) and second hyperpolarizability 〈γ〉 of some metal substituted phthalocyanines and a naphthalocyanine in solutions of dimethyl formamide using degenerate four wave mixing at 532 nm under nanosecond excitation. It was found that among samples investigated, bis-naphthalocyanine possessed the highest value of 〈γ〉 followed by the bis-phthalocyanine. This observation is explained on the basis that bis-naphthalocyanine followed by bis-phthalocyanine has higher degree of π electron conjugation.

Marine Microalgae in the EEZ of India

As the title of the thesis indicates, a detailed analysis of microalgae, the major primary producers and the first link in aquatic food chains, was carried out during this study. Microalgae are either planktonic or benthic. The studies on these microscopic autotrophs are having an upsurge of interest recently due to their variations, adaptations, short generation time and various utilitarian aspects, including food, fodder and fuel. The surface water samples collected during the cruises (cruise nos. 189, 193, 195, 196, 203, 204, 205, 207 and 209) of Fisheries and Oceanographic Research Vessel (FORV) Sagar Sampada (Fig.2.2), conducted during the period from November 2000 to November 2002, are used as samples for microalgal estimation in the EEZ of India. The present research work includes the identification and distributional pattern of planktonic microalgae in the EEZ of India. The blooms encountered during the above mentioned cruises of FORV Sagar Sampada and the blooms of Kerala coast during the period from 2001-2005 are also studied

Spray pyrolysed In2S3 thin films: A potential electron selective layer for large area inverted bulk-heterojunction polymer solar cells

In this paper, we report the results of investigations on the potential of spray pyrolysis technique in depositing electron selective layer over larger area for the fabrication of inverted bulk-heterojunction polymer solar cells. The electron selective layer (In2S3) was deposited using spray pyrolysis technique and the linear heterojunction device thus fabricated exhibited good uniformity in photovoltaic properties throughout the area of the device. An MEH-PPV:PCBM inverted bulk-heterojunction device with In2S3 electron selective layer (active area of 3.25 3.25 cm2) was also fabricated and tested under indoor and outdoor conditions. Fromthe indoor measurements employing a tungsten halogen lamp (50mW/cm2 illumination), an opencircuit voltage of 0.41V and a short-circuit current of 5.6mA were obtained. On the other hand, the outdoor measurements under direct sunlight (74mW/cm2) yielded an open-circuit voltage of 0.46V and a short-circuit current of 9.37mA