Buried Treasure: The Economics of Leak Detection and Water Loss Prevention in Ontario

On average approximately 13% of the water that is withdrawn by Canadian municipal water suppliers is lost before it reaches final users. This is an important topic for several reasons: water losses cost money, losses force water agencies to draw more water from lakes and streams thereby putting more stress on aquatic ecosystems, leaks reduce system reliability, leaks may contribute to future pipe failures, and leaks may allow contaminants to enter water systems thereby reducing water quality and threatening the health of water users. Some benefits of leak detection fall outside water agencies’ accounting purview (e.g. reduced health risks to households connected to public water supply systems) and, as a result, may not be considered adequately in water agency decision-making. Because of the regulatory environment in which Canadian water agencies operate, some of these benefits-especially those external to the agency or those that may accrue to the agency in future time periods- may not be fully counted when agencies decide on leak detection efforts. Our analysis suggests potential reforms to promote increased efforts for leak detection: adoption of a Canada-wide goal of universal water metering; development of full-cost accounting and, pricing for water supplies; and co-operation amongst the provinces to promulgate standards for leak detection efforts and provide incentives to promote improved efficiency and rational investment decision-making.

Biotransformations of water insoluble substrates in aqueous, two-phase and encapsulated systems /

The biotransformation of water insoluble substrates by mammalian and bacterial cells has been problematic, since these whole cell reactions are primarily performed in an aqueous environment The implementation of a twophase or encapsulated system has the advantages of providing a low water system along with the physiological environment the cells require to sustain themselves. Encapsulation of mammalian cells by formation of polyamide capsules via interfacial polymerization illustrated that the cells could not survive this type of encapsulation process. Biotransformation of the steroid spironolactone [3] by human kidney carcinoma cells was performed in a substrate-encapsulated system, yielding canrenone [4] in 70% yield. Encapsulation of nitrile-metabolizing Rhodococcus rhodochrous cells using a polyamide membrane yielded leaky capsules, but biotransformation of 2-(4- chlorophenyl)-3-methylbutyronitrile (CPIN) [6] in a free cell system yielded CPIN amide [7] in 40% yield and 94% ee. A two-phase biotransformation of CPIN consisting of a 5:1 ratio of tris buffer, pH 7.2 to octane respectively, gave CPIN acid [8] in 30% yield and 97% ee. It was concluded that Rhodococcus rhodochrous ATCC 17895 contained a nonselective nitrile hydratase and a highly selective amidase enzyme.

Environmental assessment of Lake Gibson sediments, water quality, and soils of the Niagara Region

In light of the fact that literature on toxicity of heavy metals in non-acidified freshwater systems is sparse, this project was initiated to conduct an environmental assessment of Lake Gibson. Chemistry of soils from adjacent areas and vineyards in the region provide a comparative background database. Water quality determinations were used to identify and highlight areas of environmental concern within the Lake Gibson watershed. A Shelby Corer was used to obtain 66 sediment cores from Lake Gibson. These were sectioned according to lithology and color to yield 298 samples. A suite of 122 soil samples was collected in the region and vicinity of Lake Gibson. All were tested for metals and some for Total Petroleum Hydrocarbons (TPH). Evaluation of the results leads to the following conclusions: 1. Metal concentrations ofAI, Cd, Cu, Cr, Pb, Ni, Fe and Zn in soils from the Niagara Region are well below background limits set by the Ministry of the Environment and Energy (MOEE) for provincial soils. 2. There is a spatial and depth difference for some of the metals within the various soils. The Cr, Ni and Pb contents of soils vary throughout the region (psystems. 4. All other metal contents exceed the LEL, and in some instances they also exceed the SEL (Severe Effect Level) guideline. In this instance acute toxicity testing of 11 the sediments is required to assess impact on the aquatic biota. 5. Specifically, effluents and discharges from outfalls, roadways, railways and industrial activities are all degrading the local ecosystem. 6. Mineral oil and greases are a major environmental concern in the sediments of Lake Gibson. Ofthe 240 samples tested for TPH, 200 samples exceed the MOEE Open Water Disposal Guideline of 1,500 mg/kg. 7. Four areas within Lake Gibson are especially degraded with respect to TPH. One area is just downstream from the Old WeIland Canal divergence point and waterfall. Other areas of concern are located just south of Beaverdams Road and just west ofthe Ontario Hydro control pipes; south ofthe Village ofBeaverdams. The fourth area of environmental concern and TPH impact is located between Highway 406 and Merrittville Highway.

Investigations in flow injection analysis (FIA): conventional FIA determination of chloride in water; sequential injection (SI)-FIA determination of mercury in water

Flow injection analysis (FIA) was applied to the determination of both chloride ion and mercury in water. Conventional FIA was employed for the chloride study. Investigations of the Fe3 +/Hg(SCN)2/CI-,450 nm spectrophotometric system for chloride determination led to the discovery of an absorbance in the 250-260 nm region when Hg(SCN)2 and CI- are combined in solution, in the absence of iron(III). Employing an in-house FIA system, absorbance observed at 254 nm exhibited a linear relation from essentially 0 - 2000 Jlg ml- 1 injected chloride. This linear range spanning three orders of magnitude is superior to the Fe3+/Hg(SCN)2/CI- system currently employed by laboratories worldwide. The detection limit obtainable with the proposed method was determin~d to be 0.16 Jlg ml- 1 and the relative standard deviation was determined to be 3.5 % over the concentration range of 0-200 Jig ml- 1. Other halogen ions were found to interfere with chloride determination at 254 nm whereas cations did not interfere. This system was successfully applied to the determination of chloride ion in laboratory water. Sequential injection (SI)-FIA was employed for mercury determination in water with the PSA Galahad mercury amalgamation, and Merlin mercury fluorescence detection systems. Initial mercury in air determinations involved injections of mercury saturated air directly into the Galahad whereas mercury in water determinations involved solution delivery via peristaltic pump to a gas/liquid separator, after reduction by stannous chloride. A series of changes were made to the internal hardware and valving systems of the Galahad mercury preconcentrator. Sequential injection solution delivery replaced the continuous peristaltic pump system and computer control was implemented to control and integrate all aspects of solution delivery, sample preconcentration and signal processing. Detection limits currently obtainable with this system are 0.1 ng ml-1 HgO.

The role of Stl1p in glycerol accumulation in osmotically stressed icewine yeast Saccharomyces cerevisiae K1 V1116

The high sugar concentration in Icewine juice exerts hyperosmotic stress in the wine yeast causing water loss and cell shrinkage. To counteract the dehydration, yeast synthesize and accumulate glycerol as an internal osmolyte. In a laboratory strain of S. cerevisiae, STLl encodes for Stllp, an H+ /glycerol symporter that is glucose inactivated, but induced upon hyperosmotic stress. STLl, was found to be a highly upregulated gene in Icewine fermenting cells and its expression was 25-fold greater than in yeast cells fermenting diluted Icewine juice, making it one of the most differentially expressed genes between the two fermentation conditions. In addition, Icewine fermenting cells showed a two-fold higher glycerol production in the wine compared to yeast fermenting diluted Icewine juice. We proposed that Stllp is (1) active during Icewine fermentation and is not glucose inactivated and (2) its activity contributes to the limited cell growth observed during Icewine fermentation as a result of the dissipation of the plasma membrane proton gradient. To measure the contribution ofStl1p in active glycerol transport (energy dependent) during Icewine fermentation, we first developed an Stllp-dependent (14C]glycerol uptake assay using a laboratory strain of S. cerevisiae (BY 4742 and LiSTLl) that was dependent on the plasma membrane proton gradient and therefore energy-dependent. Wine yeast K1-Vll16 was also shown to have this energy dependent glycerol uptake induced under salt stress. The expression of STLl and Stllp activity were compared between yeast cells harvested from Icewine and diluted Icewine fermentations. Northern blot analysis revealed that STLl was expressed in cells fermenting Icewine juice but not expressed under the diluted juice conditions. Glycerol uptake by cells fermenting Icewine juice was not significantly different than cells fermenting diluted Icewine juice on day 4 and day 7 of Vidal and Riesling fermentations respectively, despite encountering greater hyperosmotic stress. Furthermore, energy- dependent glycerol uptake was not detected under either fermentation conditions. Because our findings show that active glycerol uptake was not detected in yeast cells harvested from Icewine fermentation, it is likely that Stllp was glucose inactivated despite the hyperosmotic stress induced by the Icewine juice and therefore did not play a role in active glycerol uptake during Icewine fermentation.

Delineation of within-site terroir effects using soil and vine water measurements in Riesling vineyards within the Niagara Peninsula

The major focus of this dissertation was to explain terroir effects that impact wine varietal character and to elucidate potential determinants of terroir by testing vine water status (VWS) as the major factor of the terroir effect. It was hypothesized that consistent water status zones could be identified within vineyard sites, and, that differences in vine performance, fruit composition and wine sensory attributes could be related to VWS. To test this hypothesis, ten commercial Riesling vineyards representative of each Vintners Quality Alliance sub-appellation were selected. Vineyards were delineated using global positioning systems and 75 to 80 sentinel vines per vineyard were geo-referenced for data collection. During the 2005 to 2007 growing seasons, VWS measurements [midday leaf water potential ('l')] were collected from a subset of these sentinel vines. Data were collected on soil texture and composition, soil moisture, vine performance (yield components, vine size) and fruit composition. These variables were mapped using global information system (GIS) software and relationships between them were elucidated. Vines were categorized into "low" and "high" water status regions within each vineyard block and replicate wines were made from each. Many geospatial patterns and relationships were spatially and temporally stable within vineyards. Leaf'l' was temporally stable within vineyards despite different weather conditions during each growing season. Generally, spatial relationships between 'l', soil moisture, vine size, berry weight and yield were stable from year to year. Leaf", impacted fruit composition in several vineyards. Through sorting tasks and multidimensional scaling, wines of similar VWS had similar sensory properties. Descriptive analysis further indicated that VWS impacted wine sensory profiles, with similar attributes being different for wines from different water status zones. Vineyard designation had an effect on wine profiles, with certain sensory and chemical attributes being associated from different subappellations. However, wines were generally grouped in terms of their regional designation ('Lakeshore', 'Bench', 'Plains') within the Niagara Peninsula. Through multivariate analyses, specific sensory attributes, viticulture and chemical variables were associated with wines of different VWS. Vine water status was a major contributor to the terroir effect, as it had a major impact on vine size, berry weight and wine sensory characteristics.