Calculations on a piece of “Long Point, Head Quarters” stationary with the “Long Point Company, Canada” seal

Calculations on a piece of “Long Point, Head Quarters” stationary with the “Long Point Company, Canada” seal. There are land calculations on this sheet, n.d.

Receipt from M.Y. Keating, Books, Stationary and Newspapers, St. Catharines for books

Receipt from M.Y. Keating, Books, Stationary and Newspapers, St. Catharines for books, Dec. 23, 1887.

Geological image processing of petrographic thin sections using the rotating polarizer stage

One of the fundamental problems with image processing of petrographic thin sections is that the appearance (colour I intensity) of a mineral grain will vary with the orientation of the crystal lattice to the preferred direction of the polarizing filters on a petrographic microscope. This makes it very difficult to determine grain boundaries, grain orientation and mineral species from a single captured image. To overcome this problem, the Rotating Polarizer Stage was used to replace the fixed polarizer and analyzer on a standard petrographic microscope. The Rotating Polarizer Stage rotates the polarizers while the thin section remains stationary, allowing for better data gathering possibilities. Instead of capturing a single image of a thin section, six composite data sets are created by rotating the polarizers through 900 (or 1800 if quartz c-axes measurements need to be taken) in both plane and cross polarized light. The composite data sets can be viewed as separate images and consist of the average intensity image, the maximum intensity image, the minimum intensity image, the maximum position image, the minimum position image and the gradient image. The overall strategy used by the image processing system is to gather the composite data sets, determine the grain boundaries using the gradient image, classify the different mineral species present using the minimum and maximum intensity images and then perform measurements of grain shape and, where possible, partial crystallographic orientation using the maximum intensity and maximum position images.

Investigations into the extraction and the determination of polycyclic aromatic hydrocarbons (PAHs) from water by solid-phase extraction and capillary gas chromatography/ mass spectrometry

Factors affecting the detennination of PAHs by capillary GC/MS were studied. The effect of the initial column temperature and the injection solvent on the peak areas and heights of sixteen PAHs, considered as priority pollutants, USillg crosslinked methyl silicone (DB!) and 5% diphenyl, 94% dimethyl, 1% vinyl polysiloxane (DBS) columns was examined. The possibility of using high boiling point alcohols especially butanol, pentanol, cyclopentanol, and hexanol as injection solvents was investigated. Studies were carried out to optimize the initial column temperature for each of the alcohols. It was found that the optimum initial column temperature is dependent on the solvent employed. The peak areas and heights of the PAHs are enhanced when the initial column temperature is 10-20 c above the boiling point of the solvent using DB5 column, and the same or 10 C above the boiling point of the solvent using DB1 column. Comparing the peak signals of the PAHs using the alcohols, p-xylene, n-octane, and nonane as injection solvents, hexanol gave the greatest peak areas and heights of the PAHs particularly the late-eluted peaks. The detection limits were at low pg levels, ranging from 6.0 pg for fluorene t9 83.6 pg for benzo(a)pyrene. The effect of the initial column temperature on the peak shape and the separation efficiency of the PARs was also studied using DB1 and DB5 columns. Fronting or splitting of the peaks was obseIVed at very low initial column temperature. When high initial column temperature was used, tailing of the peaks appeared. Great difference between DB! and.DB5 columns in the range of the initial column temperature in which symmetrical.peaks of PAHs can be obtained is observed. Wider ranges were shown using DB5 column. Resolution of the closely-eluted PAHs was also affected by the initial column temperature depending on the stationary phase employed. In the case of DB5, only the earlyeluted PAHs were affected; whereas, with DB1, all PAHs were affected. An analytical procedure utilizing solid phase extraction with bonded phase silica (C8) cartridges combined with GC/MS was developed to analyze PAHs in water as an alternative method to those based on the extraction with organic solvent. This simple procedure involved passing a 50 ml of spiked water sample through C8 bonded phase silica cartridges at 10 ml/min, dried by passing a gentle flow of nitrogen at 20 ml/min for 30 sec, and eluting the trapped PAHs with 500 Jll of p-xylene at 0.3 ml/min. The recoveries of PAHs were greater than 80%, with less than 10% relative standard deviations of nine determinations. No major contaminants were present that could interfere with the recognition of PAHs. It was also found that these bonded phase silica cartridges can be re-used for the extraction of PAHs from water.

Investigations into the determination of polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs) by capillary gas chromatography

Factors involved in the determination of PAHs (16 priority PAHs as an example) and PCBs (10 PCB congeners, representing 10 isomeric groups) by capillary gas chromatography coupled with mass spectrometry (GC/MS, for PAHs) and electron capture detection (GC/ECD , for PCBs) were studied, with emphasis on the effect of solvent. Having various volatilities and different polarities, solvent studied included dichloromethane, acetonitrile, hexan e, cyclohexane, isooctane, octane, nonane, dodecane, benzene, toluene, p-xylene, o-xylene, and mesitylene. Temperatures of the capillary column, the injection port, the GC/MS interface, the flow rates of carrier gas and make-up gas, and the injection volume were optimized by one factor at a time method or simplex optimization method. Under the optimized conditions, both peak height and peak area of 16 PAHs, especially the late-eluting PAHs, were significantly enhanced (1 to 500 times) by using relatively higher boiling point solvents such as p-xylene and nonane, compared with commonly used solvents like benzene and isooctane. With the improved sensitivity, detection limits of between 4.4 pg for naphthalene and 30.8 pg for benzo[g,h,i]perylene were obtained when p-xylene was used as an injection solvent. Effect of solvent on peak shape and peak intensity were found to be greatly dependent on temperature parameters, especially the initial temperature of the capillary column. The relationship between initial temperature and shape of peaks from 16 PAHs and 10 PCBs were studied and compared when toluene, p-xylene, isooctane, and nonane were used as injection solvents. If a too low initial temperature was used, fronting or split of peaks was observed. On the other hand, peak tailing occurred at a too high initial column temperature. The optimum initial temperature, at which both peak fronting and tailing were avoided and symmetrical peaks were obtained, depended on both solvents and the stationary phase of the column used. On a methyl silicone column, the alkane solvents provided wider optimum ranges of initial temperature than aromatic solvents did, for achieving well-shaped symmetrical GC peaks. On a 5% diphenyl: 1% vinyl: 94% dimethyl polysiloxane column, when the aromatic solvents were used, the optimum initial temperature ranges for solutes to form symmetrical peaks were improved to a similar degree as those when the alkanes were used as injection solvents. A mechanism, based on the properties of and possible interactions among the analyte, the injection solvent, and the stationary phase of the capillary column, was proposed to explain these observations. The effect of initial temperature on peak height and peak area of the 16 PAHs and the 10 PCBs was also studied. The optimum initial temperature was found to be dependent on the physical properties of the solvent used and the amount of the solvent injected. Generally, from the boiling point of the solvent to 10 0C above its boiling point was an optimum range of initial temperature at which cthe highest peak height and peak area were obtained.

Letter - E.C. Schmon to Arthur A. Schmon, 1 March 1918

The letter is written on Waldorf-Astoria stationary. She is in the city with her Auntie and they plan to go to dinner at the Martinique. The letter is labelled number 64.

Geographical Applications for Sound Walks

Geography has long been a predominantly visual discipline, but recent work in geography has sought to explore the multisensory, embodied, emotional and affective dimensions of people’s relations with places. One way to engage this type of exploration is through the use of sound walks: walks along a specified route accompanied by a soundtrack (on headphones or stationary speakers) that conveys information, enacts a story, produces an ambience or atmosphere, or illuminates certain aspects of the environment through which the listener is walking. This thesis aims to show how geographers can benefit from using sound walks as thinking tools, representational tools and teaching tools. Drawing on my own experiences producing sound walks, I first examine the ways that sound walk production processes help generate productive geographical thinking for those producing sound walks (Chapter Two). The various stages of producing a sound walk require different skill sets, pose different challenges, and require different sorts of environmental awareness, and therefore present novel opportunities for developing geographical insights about specific places or spatial relations. Second, I focus on four experientially-oriented aspects of sound walks – using multiple senses, walking, contingency, and moments of interaction – to argue that sound walks can be useful representational tools for geographers, whether those creating sound walks subscribe to a representational or non-representational theory of knowledge (Chapter Three). The value of sound walks as representational tools is in the experience of ‘doing’ them. That is, audiences discover for themselves through interaction what is being represented, rather than having it delivered to them. The experiential elements of ‘doing’ sound walks recommend them as potentially helpful representational tools for geographers. Third, by examining the work of a small sample of fourth year “Advanced Geography of Music” students, I develop the argument that sound walks can be effective tools for teaching students and for creating circumstances for students to learn independently (Chapter Four). Sound walks have potential to be effective pedagogical tools because they are commensurate with several key pedagogical schools of thought that emphasise the importance of requiring students to engage actively with their environment using a combination of senses. The thesis demonstrates that sound walks are a worthwhile resource for geographers to use theoretically, representationally and pedagogically in their work. The next step is for geographers to put them into practice and realize this potential.

Clippings - Road Allowances, Lock 2 Bridge, Toronto Railway Company, St. Davids' History

Clipping regarding the original road allowance which was part of Mr. Woodruff’s property, n.d. Clipping regarding the Lock 2 Bridge. This is a letter to the editor of the Journal from Calvin Phelps of Lockport, Nov. 13, 1889. Clipping entitled “Settled beyond a Dispute”: a letter to the Editor of the Star from J. G. Currie regarding the road allowance in the 5th Concession of Grantham, Nov. 16, 1889. Clipping entitled “That Old Road Allowance” which is a rebuttal to Mr. Currie’s letter, [1889] 2 newspaper clippings regarding: “Reg. vs. Toronto Railway Company”. These 2 articles are glued to a piece of paper. Beneath the newspaper articles is the name M. Chambers, Nov. 18, 1898. Notes regarding the clippings are enclosed with the articles. These notes and written on the back of “Pattison, Collier and Shaw Barristers, Solicitors, Etc.” stationary (notes are 2 pages, handwritten), Nov. 18, 1898. Clipping entitled “History on the Site: St. Davids’ Students Learn Lessons where Events Occurred” (2 copies), n.d.

Sweeps Tickets

Sweeps tickets including: an envelope that says “sweep tickets from Miss Hillman which contains a Toronto Dominion Bank envelope containing 1 Hospitals’ Trust (1940) Dublin ticket; A Toronto Dominion Bank piece of stationary containing 2 Hospitals’ Trust (1940) Dublin tickets; A Toronto Dominion Bank envelope with “Mrs. Band” written of the back, containing 2 Irish Hospitals’ Sweepstakes Tickets (1958); 1 Toronto Dominion Bank envelope with Mrs. M. W. Band typed on the front, containing 2 Irish Hospitals’ Sweepstakes Tickets (1957) and 4 Hospitals’ Trust (1940) Dublin tickets; 1 Toronto Dominion Bank envelope containing 1 Irish Hospitals’ Sweepstake ticket (1958); 1 Toronto Dominion Bank envelope containing 4 Irish Hospitals’ Sweepstakes tickets (1958) all 4 of these tickets have Margaret W. Band written on the back but one also has “Nana” and one has “Hi-Boy” also written on it, 1940, 1957-1958