An analysis of the photoelectron and Rydberg states of formaldehyde /|nby Carol R. Lessard. -- 260 St. Catharines [Ont.] : Dept. of Chemistry, Brock University,

Although it is generally accepted that Rydberg orbitals are very large and diffuse, and that electron promotion to a Rydberg orbital is not too different from ionization of the molecule, analysis of the two types of transitions proves otherwise. The photoelectron spectrum of the 2B2 (n) ion has very little vibrational structure attached to the origin band; on the other hand, several of the Rydberg transitions which involve the promotion of the n(bZ) electron exhibit a great deal of vibrational activity. In particular, the members of the n=3 Rydberg\ series interact with and perturb each other through pseudo-Jahn-Teller vibronic coupling. The vacuum ultraviolet spectrum contains a number of features which are difficult to explain, and two unusually sharp bands can only be identified as representing some form of electron promotion in formaldehyde.

Brock Cameo Tie

The Brock cameo tie featuring subtle grey stripes on red was introduced in 1988 in conjunction with the 25th anniversary celebrations of Brock University. The tie is made of polyester from Bradford, England. It originally went on sale for $15.75 in the Bookstore.

Investigations towards the synthesis of isotope labelled analogues of tocopherols and tocotrienols /

Vitamin E is considered as the most effective lipophilic chain breaking antioxidant. a-Tocopherol and its analogues have been studied thoroughly with regards to its biokinetics and bioavailabily. Deuterated tocopherols have been synthesized and utilized in such studies. Tocotrienols are arousing more and more interest because of their high efficiency as antioxidants. However, to date, there is no effective synthetic method reported for deuterated tocotrienols. This thesis is focused on the investigation of the synthetic methods of deuterated tocotrienols and their analogues: 5-trideuteromethyl-a-tocotrienol, 5- trideuteromethyl-p-tocotrienol, tocotrienol acetate, silyl tocotrienol ether, etc. Several synthetic procedures for the preparation of poly-deuterated tocopherols are known. Mainly the deuterium is introduced by use of labelled formaldehyde and deuterated hydrogen chloride under Lewis acid catalysis. However, these methods are not effective in tocotrienols due to exchange of protons for deuterium at other sites under the acidic conditions. We developed several different approaches to generate polydeuterated tocotrienols by using both morpholinomethylation followed by reduction with NaCNBDs as deuterated reducing reagents and transmetalation strategy. The 5-trideuteromethyl-a-tocotrienol was finally obtained in a satisfactory yield of 60%. In addition, this thesis also discussed the study of structural comparison and the chemical property difference of tocopherols and tocotrienols, which provides hints to explain the reactivity difference of them towards oxidation at the C3-C4 positions.Furthermore, the methodology of halogenation and dehydrohalogenation of tocotrienol was explored to prepare a hexaene tocotrienol derivative as a florescent reporter of tocopherol.

Investigations into the extraction and the determination of polycyclic aromatic hydrocarbons (PAHs) from water by solid-phase extraction and capillary gas chromatography/ mass spectrometry

Factors affecting the detennination of PAHs by capillary GC/MS were studied. The effect of the initial column temperature and the injection solvent on the peak areas and heights of sixteen PAHs, considered as priority pollutants, USillg crosslinked methyl silicone (DB!) and 5% diphenyl, 94% dimethyl, 1% vinyl polysiloxane (DBS) columns was examined. The possibility of using high boiling point alcohols especially butanol, pentanol, cyclopentanol, and hexanol as injection solvents was investigated. Studies were carried out to optimize the initial column temperature for each of the alcohols. It was found that the optimum initial column temperature is dependent on the solvent employed. The peak areas and heights of the PAHs are enhanced when the initial column temperature is 10-20 c above the boiling point of the solvent using DB5 column, and the same or 10 C above the boiling point of the solvent using DB1 column. Comparing the peak signals of the PAHs using the alcohols, p-xylene, n-octane, and nonane as injection solvents, hexanol gave the greatest peak areas and heights of the PAHs particularly the late-eluted peaks. The detection limits were at low pg levels, ranging from 6.0 pg for fluorene t9 83.6 pg for benzo(a)pyrene. The effect of the initial column temperature on the peak shape and the separation efficiency of the PARs was also studied using DB1 and DB5 columns. Fronting or splitting of the peaks was obseIVed at very low initial column temperature. When high initial column temperature was used, tailing of the peaks appeared. Great difference between DB! and.DB5 columns in the range of the initial column temperature in which symmetrical.peaks of PAHs can be obtained is observed. Wider ranges were shown using DB5 column. Resolution of the closely-eluted PAHs was also affected by the initial column temperature depending on the stationary phase employed. In the case of DB5, only the earlyeluted PAHs were affected; whereas, with DB1, all PAHs were affected. An analytical procedure utilizing solid phase extraction with bonded phase silica (C8) cartridges combined with GC/MS was developed to analyze PAHs in water as an alternative method to those based on the extraction with organic solvent. This simple procedure involved passing a 50 ml of spiked water sample through C8 bonded phase silica cartridges at 10 ml/min, dried by passing a gentle flow of nitrogen at 20 ml/min for 30 sec, and eluting the trapped PAHs with 500 Jll of p-xylene at 0.3 ml/min. The recoveries of PAHs were greater than 80%, with less than 10% relative standard deviations of nine determinations. No major contaminants were present that could interfere with the recognition of PAHs. It was also found that these bonded phase silica cartridges can be re-used for the extraction of PAHs from water.

ORGANOSILICON BIOTECHNOLOGY: A BIO-INSPIRED APPROACH TO THE HYDROLYSIS OF ALKOXYSILANES and THE LIPASE-CATALYZED SYNTHESIS OF SILOXANE-CONTAINING POLYESTERS AND POLYAMIDES

The first part of this thesis studied the capacity of amino acids and enzymes to catalyze the hydrolysis and condensation of tetraethoxysilane and phenyltrimethoxysilane. Selected amino acids were shown to accelerate the hydrolysis and condensation of tetraethoxysilane under ambient temperature, pressure and at neutral pH (pH 7±0.02). The nature of the side chain of the amino acid was important in promoting hydrolysis and condensation. Several proteases were shown to have a capacity to hydrolyze tri- and tet-ra- alkoxysilanes under the same mild reaction conditions. The second part of this thesis employed an immobilized Candida antarctica lipase B (Novozym-435, N435) to produce siloxane-containing polyesters, polyamides, and polyester amides under solvent-free conditions. Enzymatic activity was shown to be temperature dependent, increasing until enzyme denaturation became the dominant pro-cess, which typically occurred between 120-130ᵒC. The residual activity of N435 was, on average, greater than 90%, when used in the synthesis of disiloxane-containing polyesters, regardless of the polymerization temperature except at the very highest temperatures, 140-150ᵒC. A study of the thermal tolerance of N435 determined that, over ten reaction cycles, there was a decrease in the initial rate of polymerization with each consecutive use of the catalyst. No change in the degree of monomer conversion after a 24 hour reaction cycle was found.