7 resultados para data transfer
em Doria (National Library of Finland DSpace Services) - National Library of Finland, Finland
Resumo:
The purpose of the work was to realize a high-speed digital data transfer system for RPC muon chambers in the CMS experiment on CERN’s new LHC accelerator. This large scale system took many years and many stages of prototyping to develop, and required the participation of tens of people. The system interfaces to Frontend Boards (FEB) at the 200,000-channel detector and to the trigger and readout electronics in the control room of the experiment. The distance between these two is about 80 metres and the speed required for the optic links was pushing the limits of available technology when the project was started. Here, as in many other aspects of the design, it was assumed that the features of readily available commercial components would develop in the course of the design work, just as they did. By choosing a high speed it was possible to multiplex the data from some the chambers into the same fibres to reduce the number of links needed. Further reduction was achieved by employing zero suppression and data compression, and a total of only 660 optical links were needed. Another requirement, which conflicted somewhat with choosing the components a late as possible was that the design needed to be radiation tolerant to an ionizing dose of 100 Gy and to a have a moderate tolerance to Single Event Effects (SEEs). This required some radiation test campaigns, and eventually led to ASICs being chosen for some of the critical parts. The system was made to be as reconfigurable as possible. The reconfiguration needs to be done from a distance as the electronics is not accessible except for some short and rare service breaks once the accelerator starts running. Therefore reconfigurable logic is extensively used, and the firmware development for the FPGAs constituted a sizable part of the work. Some special techniques needed to be used there too, to achieve the required radiation tolerance. The system has been demonstrated to work in several laboratory and beam tests, and now we are waiting to see it in action when the LHC will start running in the autumn 2008.
Resumo:
Tässä työssä perehdytään soodakattiloiden vesikiertomallin rakentamiseen. Työn päätavoitteena on kehittää simulointimallia varten taulukkolaskentapohja, jonka avulla soodakattilan lämpövuotietoja on yksinkertaista ja nopeaa käsitellä ja siirtää Apros 6 -simulointiohjelmaan. Lisäksi tarkoituksena on pyrkiä automatisoimaan työvaiheet mahdollisimman pitkälle, jolloin vesikiertolaskennan tekeminen yksinkertaistuisi, yhtenäistyisi ja tarkentuisi. Tämä on mahdollista Excel- makrojen ja Apros 6:n uusien toimintojen avulla. Apros 6:ssa on nyt mahdollista hyödyntää SCL- komentotiedostoja, joiden avulla sujuva tiedonsiirto Aproksen ja Excelin välillä vodaan toteuttaa. Vesikiertolaskentaan käytettävän datan käsittely on aikaisemmin ollut työlästä ja sen tarkkuus on pitkälti riippunut mallintajasta. Tässä diplomityössä päästään hyödyntämään uusimpia ja realistisempia soodakattiloiden CFD- malleja, joiden avulla pystytään luomaan aikaisempaa tarkemmat lämpövuojakaumat soodakattilan lämpöpinnoille. Tämä muutos parantaa vesikiertolaskennan tarkkuutta. Työn kokeellisessa osassa uutta Excel laskentatyökalua ja uusia lämpövuoarvoja testataan käytännössä. Eräs vanha Apros- vesikiertomalli päivitetään uusilla lämpövuoarvoilla ja sen rakenteeseen tehdään muutoksia tarkkuuden parantamiseksi. Uuden mallin toimivuutta testataan myös 115 %:n kapasiteetilla ja tutkitaan kuinka kyseinen vesikiertopiiri reagoi suurempaan lämpötehoon. Näitä kolmea eri tilannetta vertaillaan toisiinsa ja tarkastellaan eroavaisuuksia niiden vesi-höyrypiireissä.
Resumo:
Jatkuvasti lisääntyvä matkapuhelinten käyttäjien määrä, internetin kehittyminen yleiseksi tiedon ja viihteen lähteeksi on luonut tarpeen palvelulle liikkuvan työaseman liittämiseksi tietokoneverkkoihin. GPRS on uusi teknologia, joka tarjoaa olemassa olevia matka- puhelinverkkoja (esim. NMT ja GSM) nopeamman, tehokkaamman ja taloudellisemman liitynnän pakettidataverkkoihin, kuten internettiin ja intranetteihin. Tämän työn tavoitteena oli toteuttaa GPRS:n paketinohjausyksikön (Packet Control Unit, PCU) testauksessa tarvittavat viestintäajurit työasemaympristöön. Aidot matkapuhelinverkot ovat liian kalliita, eikä niistä saa tarvittavasti lokitulostuksia, jotta niitä voisi käyttää GPRS:n testauksessa ohjelmiston kehityksen alkuvaihessa. Tämän takia PCU-ohjelmiston testaus suoritetaan joustavammassa ja helpommin hallittavassa ympäristössä, joka ei aseta kovia reaaliaikavaatimuksia. Uusi toimintaympäristö ja yhteysmedia vaativat PCU:n ja muiden GPRS-verkon yksiköiden välisistä yhteyksistä huolehtivien ohjelman osien, viestintäajurien uuden toteutuksen. Tämän työn tuloksena syntyivät tarvittavien viestintäajurien työasemaversiot. Työssä tarkastellaan eri tiedonsiirtotapoja ja -protokollia testattavan ohjelmiston vaateiden, toteutetun ajurin ja testauksen kannalta. Työssä esitellään kunkin ajurin toteuttama rajapinta ja toteutuksen aste, eli mitkä toiminnot on toteutettu ja mitä on jätetty pois. Ajureiden rakenne ja toiminta selvitetään siltä osin, kuin se on oleellista ohjelman toiminnan kannalta.
Resumo:
This dissertation is based on four articles dealing with modeling of ozonation. The literature part of this considers some models for hydrodynamics in bubble column simulation. A literature review of methods for obtaining mass transfer coefficients is presented. The methods presented to obtain mass transfer are general models and can be applied to any gas-liquid system. Ozonation reaction models and methods for obtaining stoichiometric coefficients and reaction rate coefficients for ozonation reactions are discussed in the final section of the literature part. In the first article, ozone gas-liquid mass transfer into water in a bubble column was investigated for different pH values. A more general method for estimation of mass transfer and Henry’s coefficient was developed from the Beltrán method. The ozone volumetric mass transfer coefficient and the Henry’s coefficient were determined simultaneously by parameter estimation using a nonlinear optimization method. A minor dependence of the Henry’s law constant on pH was detected at the pH range 4 - 9. In the second article, a new method using the axial dispersion model for estimation of ozone self-decomposition kinetics in a semi-batch bubble column reactor was developed. The reaction rate coefficients for literature equations of ozone decomposition and the gas phase dispersion coefficient were estimated and compared with the literature data. The reaction order in the pH range 7-10 with respect to ozone 1.12 and 0.51 the hydroxyl ion were obtained, which is in good agreement with literature. The model parameters were determined by parameter estimation using a nonlinear optimization method. Sensitivity analysis was conducted using object function method to obtain information about the reliability and identifiability of the estimated parameters. In the third article, the reaction rate coefficients and the stoichiometric coefficients in the reaction of ozone with the model component p-nitrophenol were estimated at low pH of water using nonlinear optimization. A novel method for estimation of multireaction model parameters in ozonation was developed. In this method the concentration of unknown intermediate compounds is presented as a residual COD (chemical oxygen demand) calculated from the measured COD and the theoretical COD for the known species. The decomposition rate of p-nitrophenol on the pathway producing hydroquinone was found to be about two times faster than the p-nitrophenol decomposition rate on the pathway producing 4- nitrocatechol. In the fourth article, the reaction kinetics of p-nitrophenol ozonation was studied in a bubble column at pH 2. Using the new reaction kinetic model presented in the previous article, the reaction kinetic parameters, rate coefficients, and stoichiometric coefficients as well as the mass transfer coefficient were estimated with nonlinear estimation. The decomposition rate of pnitrophenol was found to be equal both on the pathway producing hydroquinone and on the path way producing 4-nitrocathecol. Comparison of the rate coefficients with the case at initial pH 5 indicates that the p-nitrophenol degradation producing 4- nitrocathecol is more selective towards molecular ozone than the reaction producing hydroquinone. The identifiability and reliability of the estimated parameters were analyzed with the Marcov chain Monte Carlo (MCMC) method. @All rights reserved. No part of the publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior permission of the author.
Resumo:
The purpose of the study was to explore how a public, IT services transferor, organization, comprised of autonomous entities, can effectively develop and organize its data center cost recovery mechanisms in a fair manner. The lack of a well-defined model for charges and a cost recovery scheme could cause various problems. For example one entity may be subsidizing the costs of another entity(s). Transfer pricing is in the best interest of each autonomous entity in a CCA. While transfer pricing plays a pivotal role in the price settings of services and intangible assets, TCE focuses on the arrangement at the boundary between entities. TCE is concerned with the costs, autonomy, and cooperation issues of an organization. The theory is concern with the factors that influence intra-firm transaction costs and attempting to manifest the problems involved in the determination of the charges or prices of the transactions. This study was carried out, as a single case study, in a public organization. The organization intended to transfer the IT services of its own affiliated public entities and was in the process of establishing a municipal-joint data center. Nine semi-structured interviews, including two pilot interviews, were conducted with the experts and managers of the case company and its affiliating entities. The purpose of these interviews was to explore the charging and pricing issues of the intra-firm transactions. In order to process and summarize the findings, this study employed qualitative techniques with the multiple methods of data collection. The study, by reviewing the TCE theory and a sample of transfer pricing literature, created an IT services pricing framework as a conceptual tool for illustrating the structure of transferring costs. Antecedents and consequences of the transfer price based on TCE were developed. An explanatory fair charging model was eventually developed and suggested. The findings of the study suggested that the Chargeback system was inappropriate scheme for an organization with affiliated autonomous entities. The main contribution of the study was the application of TP methodologies in the public sphere with no tax issues consideration.
Resumo:
This research has been conducted within the realm of where today’s digital media society and the timeless concept of cultural identity overlap. The aim of this thesis is to explore the nature of online cultural identity management. By focusing on the social media platform, Pinterest, this study considers the food-pinning behavior of a group of Americans living in Finland and connects their online actions with their cultural identity. Through an examination of Pinterest as a social space, and even a third place, the relative theoretical literature provides and interesting background for a contemporary discussion on the matter. Literature on food as a cultural marker is also brought into consideration. Using the methods of introspection and an adapted version of virtual ethnography, a study was conducted, and ultimately, the analysis of data obtained from the Pinterest boards of ten individuals shows that the vast majority of food-related information in this setting is US-sourced. A questionnaire provides further insight into the individuals’ Pinterest usage. I argue that pinning is an act of online identity management, whether it is a conscious act or a situational effect, and that using Pinterest maintains and even strengthens these individuals’ cultural identity as Americans. This study adds to current discussions pertaining to transnationalism, globalization, and online cultural identity, as well as opens channels for further research on this dynamic topic, which is needed to understand ourselves as cultural beings in the digital age.
Resumo:
This research has been conducted within the realm of where today’s digital media society and the timeless concept of cultural identity overlap. The aim of this thesis is to explore the nature of online cultural identity management. By focusing on the social media platform, Pinterest, this study considers the food-pinning behavior of a group of Americans living in Finland and connects their online actions with their cultural identity. Through an examination of Pinterest as a social space, and even a third place, the relative theoretical literature provides and interesting background for a contemporary discussion on the matter. Literature on food as a cultural marker is also brought into consideration. Using the methods of introspection and an adapted version of virtual ethnography, a study was conducted, and ultimately, the analysis of data obtained from the Pinterest boards of ten individuals shows that the vast majority of food-related information in this setting is US-sourced. A questionnaire provides further insight into the individuals’ Pinterest usage. I argue that pinning is an act of online identity management, whether it is a conscious act or a situational effect, and that using Pinterest maintains and even strengthens these individuals’ cultural identity as Americans. This study adds to current discussions pertaining to transnationalism, globalization, and online cultural identity, as well as opens channels for further research on this dynamic topic, which is needed to understand ourselves as cultural beings in the digital age.