Maintenance of male sterile germplasm in Brassica rapa in vitro propagation

Selostus: Isästeriilin kevätrypsin geeniaineksen ylläpito in vitro mikroviljelyllä

Propagation of the Ignition Front against Airflow in Packed Beds of Wood Particles

Combustion of wood is increasing because of the needs of decreasing the emissions of carbon dioxide and the amount of waste going to landfills. Wood based fuels are often scattered on a large area. The transport distances should be short enough to prevent too high costs, and so the size of heating and power plants using wood fuels is often rather small. Combustion technologies of small-size units have to be developed to reach efficient and environmentally friendly energy production. Furnaces that use different packed bed combustion or gasification techniques areoften most economic in small-scale energy production. Ignition front propagation rate affects the stability, heat release rate and emissions of packed bed combustion. Ignition front propagation against airflow in packed beds of wood fuels has been studied. The research has been carried out mainly experimentally. Theoretical aspects have been considered to draw conclusions about the experimental results. The effects of airflow rate, moisture content of the fuel, size, shape and density of particles, and porosity of the bed on the propagation rate of the ignition front have been studied. The experiments were carried out in a pot furnace. The fuels used in the experiments were mainly real wood fuels that are often burned in the production of energy. The fuel types were thin wood chips, saw dust, shavings, wood chips, and pellets with different sizes. Also a few mixturesof the above were tested. Increase in the moisture content of the fuel decreases the propagation rates of the ignition front and makes the range of possible airflow rates narrower because of the energy needed for the evaporation of water and the dilution of volatile gases due to evaporated steam. Increase in the airflow rate increases the ignition rate until a maximum rate of propagation is reached after which it decreases. The maximum flame propagation rate is not always reached in stoichiometric combustion conditions. Increase in particle size and density transfers the optimum airflow rate towards fuel lean conditions. Mixing of small and large particles is often advantageous, because small particles make itpossible to reach the maximum ignition rate in fuel rich conditions, and large particles widen the range of possible airflow rates. A correlation was found forthe maximum rate of ignition front propagation in different wood fuels. According to the correlation, the maximum ignition mass flux is increased when the sphericity of the particles and the porosity of the bed are increased and the moisture content of the fuel is decreased. Another fit was found between sphericity and porosity. Increase in sphericity decreases the porosity of the bed. The reasons of the observed results are discussed.

Minimization of the experimental workload for the prediction of pollutants propagation in rivers. Mathematical modelling and knowledge re-use

The present thesis in focused on the minimization of experimental efforts for the prediction of pollutant propagation in rivers by mathematical modelling and knowledge re-use. Mathematical modelling is based on the well known advection-dispersion equation, while the knowledge re-use approach employs the methods of case based reasoning, graphical analysis and text mining. The thesis contribution to the pollutant transport research field consists of: (1) analytical and numerical models for pollutant transport prediction; (2) two novel techniques which enable the use of variable parameters along rivers in analytical models; (3) models for the estimation of pollutant transport characteristic parameters (velocity, dispersion coefficient and nutrient transformation rates) as functions of water flow, channel characteristics and/or seasonality; (4) the graphical analysis method to be used for the identification of pollution sources along rivers; (5) a case based reasoning tool for the identification of crucial information related to the pollutant transport modelling; (6) and the application of a software tool for the reuse of information during pollutants transport modelling research. These support tools are applicable in the water quality research field and in practice as well, as they can be involved in multiple activities. The models are capable of predicting pollutant propagation along rivers in case of both ordinary pollution and accidents. They can also be applied for other similar rivers in modelling of pollutant transport in rivers with low availability of experimental data concerning concentration. This is because models for parameter estimation developed in the present thesis enable the calculation of transport characteristic parameters as functions of river hydraulic parameters and/or seasonality. The similarity between rivers is assessed using case based reasoning tools, and additional necessary information can be identified by using the software for the information reuse. Such systems represent support for users and open up possibilities for new modelling methods, monitoring facilities and for better river water quality management tools. They are useful also for the estimation of environmental impact of possible technological changes and can be applied in the pre-design stage or/and in the practical use of processes as well.

Marketing culture of Finnish research libraries : an analysis of marketing attitude, knowledge and behaviour

The aim of the present dissertation is to investigate the marketing culture of research libraries in Finland and to understand the awareness of the knowledge base of library management concerning modern marketing theories and practices. The study was based onthe notion that a leader in an organisation can have large impact on its culture. Therefore, it was considered important to learn about the market orientation that initiates at the top management and flows throughout the whole organisationthus resulting in a particular kind of library culture. The study attempts to examine the marketing culture of libraries by analysing the marketing attitudes, knowledge (underlying beliefs, values and assumptions), behaviour (market orientation), operational policies and activities, and their service performance (customer satisfaction). The research was based on the assumption that if the top management of libraries has market oriented behaviour, then their marketing attitudes, knowledge, operational policies and activities and service performance should also be in accordance. The dissertation attempts to connect all these theoretical threads of marketing culture. It investigates thirty three academic and special libraries in the south of Finland. The library director and three to ten customers from each library participated as respondents in this study. An integrated methodological approach of qualitative as well as quantitative methods was used to gain knowledge on the pertinent issues lying behind the marketing culture of research libraries. The analysis of the whole dissertation reveals that the concept of marketing has very varied status in the Finnish research libraries. Based on the entire findings, three kinds of marketing cultures were emerged: the strong- the high fliers; the medium- the brisk runners; and the weak- the slow walkers. The high fliers appeared to be modern marketing believers as their marketing approach was customer oriented and found to be closer to the emerging notions of contemporary relational marketing. The brisk runners were found to be traditional marketing advocates as their marketing approach is more `library centred¿than customer defined and thus is in line of `product orientation¿ i.e. traditional marketing. `Let the interested customers come to the library¿ was appeared to be the hallmark of the slow walkers. Application of conscious market orientation is not reflected in the library activities of the slow walkers. Instead their values, ideology and approach to serving the library customers is more in tuneof `usual service oriented Finnish way¿. The implication of the research is that it pays to be market oriented which results in higher customer satisfaction oflibraries. Moreover, it is emphasised that the traditional user based service philosophy of Finnish research libraries should not be abandoned but it needs to be further developed by building a relational based marketing system which will help the libraries to become more efficient and effective from the customers¿ viewpoint. The contribution of the dissertation lies in the framework showing the linkages between the critical components of the marketing culture of a library: antecedents, market orientation, facilitators and consequences. The dissertationdelineates the significant underlying dimensions of market-oriented behaviour of libraries which are namely customer philosophy, inter-functional coordination,strategic orientation, responsiveness, pricing orientation and competition orientation. The dissertation also showed the extent to which marketing attitudes, behaviour, knowledge were related and impact of market orientation on the serviceperformance of libraries. A strong positive association was found to exist between market orientation and marketing attitudes and knowledge. Moreover, it also shows that a higher market orientation is positively connected with the service performance of libraries, the ultimate result being higher customer satisfaction. The analysis shows that a genuine marketing culture represents a synthesis of certain marketing attitudes, knowledge and of selective practices. This finding is particularly significant in the sense that it manifests that marketing culture consists of a certain sets of beliefs and knowledge (which form a specific attitude towards marketing) and implementation of a certain set of activities that actually materialize the attitude of marketing into practice (market orientation) leading to superior service performance of libraries.

Negative refractive index materials and propagation

Negative refractive index materials and propagation of electromagnetic waves in them started to draw attention of scientists not so long ago. This review highlights historically important and recent papers on practical and theoretical aspects related to these issues. Namely, basic properties and peculiarities of such materials related to both their design and wave propagation in them, experimental verification of predictions theoretically made for them, possible practical applications and prospects in this area are considered.