Experimental and Numerical Analysis of Different Volutes in a Centrifugal Compressor

In a centrifugal compressor the flow around the diffuser is collected and led to the pipe system by a spiral-shaped volute. In this study a single-stage centrifugal compressor with three different volutes is investigated. The compressorwas first equipped with the original volute, the cross-section of which was a combination of a rectangle and semi-circle. Next a new volute with a fully circular cross-section was designed and manufactured. Finally, the circular volute wasmodified by rounding the tongue and smoothing the tongue area. The overall performance of the compressor as well as the static pressure distribution after the impeller and on the volute surface were measured. The flow entering the volute was measured using a three-hole Cobra-probe, and flow visualisations were carriedout in the exit cone of the volute. In addition, the radial force acting on theimpeller was measured using magnetic bearings. The complete compressor with thecircular volute (inlet pipe, full impeller, diffuser, volute and outlet pipe) was also modelled using computational fluid dynamics (CFD). A fully 3-D viscous flow was solved using a Navier-Stokes solver, Finflo, developed at Helsinki University of Technology. Chien's k-e model was used to take account of the turbulence. The differences observed in the performance of the different volutes were quite small. The biggest differences were at low speeds and high volume flows,i.e. when the flow entered the volute most radially. In this operating regime the efficiency of the compressor with the modified circular volute was about two percentage points higher than with the other volutes. Also, according to the Cobra-probe measurements and flow visualisations, the modified circular volute performed better than the other volutes in this operating area. The circumferential static pressure distribution in the volute showed increases at low flow, constant distribution at the design flow and decrease at high flow. The non-uniform static pressure distribution of the volute was transmitted backwards across the vaneless diffuser and observed at the impeller exit. At low volume flow a strong two-wave pattern developed into the static pressure distribution at the impeller exit due to the response of the impeller to the non-uniformity of pressure. The radial force of the impeller was the greatest at the choke limit, the smallest atthe design flow, and moderate at low flow. At low flow the force increase was quite mild, whereas the increase at high flow was rapid. Thus, the non-uniformityof pressure and the force related to it are strong especially at high flow. Theforce caused by the modified circular volute was weaker at choke and more symmetric as a function of the volume flow than the force caused by the other volutes.

Analysis of heat transfer coefficient in silica nanofluids with water as base fluid under transitional flow

The effect of Reynolds number variation in a vertical double pipe counterflow heat exchanger due to the changes in viscosity can cause the change in flow regime, for instance, when heats up and cools down, it can convert from turbulent to laminar or inversely, that can have significant effect on heat transfer coefficient and pressure drop. Mainly, the range of transition phase has been studied in this study with the investigation of silica nanofluid dispersed in water in three different concentrations. The results have been compared with distilled water sample and showed a remarkable raise in heat transfer coefficient while pressure drop has been increased respectively, as well. Although pumping power has to go up at the same time and it is a drawback, heat transfer efficiency grows for diluted samples. On the other hand, for the most concentrated sample, effect of pressure drop dominates which leads to decline in the overall efficiency.

The New Silk Road, a Glimpse to China's Regime?

China's Silk Road Economic Belt plan is a part of One Belt, One Road initiative that aims to create trade routes from China all the way to Europe. Despite the potential benefits, there are also problems along the way. In this research I am examining the adverse effects of one part of the Silk Road Economic Belt with my focus on Xinjiang Uyghur minority and their rights and Central Asian regional stability. Moreover, I suggest that China's past commitments in the international society as well as her actions in relations to the undertaking can give an insight into a regime where China would be the dominant power in international society. I have used qualitative analysis to study the topics. My most important methodological tools to examine the topics are as follows. I utilise conceptual analysis to borrow concepts from international relations field. I use method of situation analysis when I am describing the current circumstances in China's Xinjiang and Central Asia. Inductive analysis is the overall method since I suggest that the content I have examined could give an insight to how China regards and relates to international law in the future. Moreover, my theoretical framework of the research sees international law as a tool that a state can use to gain more power but at the same time international law restricts state's behaviour. Based on the findings of this research, in case of Xinjiang the New Silk Road is likely to worsen Uyghurs situation because of Beijing's worries and harsh actions to prevent any disturbance. However, the New Silk Road could bring stability and maintain regional security in Central Asia when the states could see it beneficial to unite for cooperation which can result with greater benefits. China's potential future regime will emphasize sovereignty and non-interference to states’ domestic matters. Moreover, there will be no room for minority rights in China's concept of human rights. Human rights are meant to protect rights of masses but are of secondary importance since development and security will be more important goals to pursue. In the field of cooperation, China is increasingly using multilateral forums to discuss the matters but reserves bilateral negotiations for executing the plans.