Feasibility of replacing multiple ADSL connections with Multi-Dwelling Access

This final project was made for the Broadband/Implementation department of TeliaSonera Finland. The question to be examined is if the operator should replace multiple ADSL connections implemented over a leased line with Multi-Dwelling access based on an Ethernet/Optical Fibre access network. The project starts with describing the technology related to these access network solu-tions and presents the technology that is used in TeliaSonera Finland's access network. It continues from the technology to describe the problem with some of the ADSL implemen-tations of TeliaSonera. The problem is the implementations done over a leased line that can cost TeliaSonera over years as much as a possible investment to extend network when there is several lines leased to the same building. The project proposes a Multi-Dwelling access as a solution to this problem and defines the circumstances when to use it. After a satisfactory solution has found the project takes a view how implementation of the solution might alter the network and a new problem is found. When used commonly to replace need of ADSL implementation Multi-Dwelling access would significantly increase optical cable congestion near operators POP. As a final deed this project also proposes a technical change to existing way to implement multi-dwelling access with EPON technology.

Timing of primary growth harvest affects the yield and nutritive value of timothy-red clover mixtures

Selostus: Ensimmäisen sadon korjuuaika vaikuttaa timotein ja puna-apilan seosnurmen satoon ja rehuarvoon

Effect of Noncondensable Gases on Circulation of Primary Coolant in Nuclear Power Plants in Abnormal Situations

The present study focuses on two effects of the presence of a noncondensable gas on the thermal-hydraulic behavior of thecoolant of the primary circuit of a nuclear reactor in the VVER-440 geometry inabnormal situations. First, steam condensation with the presence of air was studied in the horizontal tubes of the steam generator (SG) of the PACTEL test facility. The French thermal-hydraulic CATHARE code was used to study the heat transfer between the primary and secondary side in conditions derived from preliminary experiments performed by VTT using PACTEL. In natural circulation and single-phase vapor conditions, the injection of a volume of air, equivalent to the totalvolume of the primary side of the SG at the entrance of the hot collector, did not stop the heat transfer from the primary to the secondary side. The calculated results indicate that air is located in the second half-length (from the mid-length of the tubes to the cold collector) in all the tubes of the steam generator The hot collector remained full of steam during the transient. Secondly, the potential release of the nitrogen gas dissolved in the water of the accumulators of the emergency core coolant system of the Loviisa nuclear power plant (NPP) was investigated. The author implemented a model of the dissolution and release ofnitrogen gas in the CATHARE code; the model created by the CATHARE developers. In collaboration with VTT, an analytical experiment was performed with some components of PACTEL to determine, in particular, the value of the release time constant of the nitrogen gas in the depressurization conditions representative of the small and intermediate break transients postulated for the Loviisa NPP. Such transients, with simplified operating procedures, were calculated using the modified CATHARE code for various values of the release time constant used in the dissolution and release model. For the small breaks, nitrogen gas is trapped in thecollectors of the SGs in rather large proportions. There, the levels oscillate until the actuation of the low-pressure injection pumps (LPIS) that refill the primary circuit. In the case of the intermediate breaks, most of the nitrogen gas is expelled at the break and almost no nitrogen gas is trapped in the SGs. In comparison with the cases calculated without taking into account the release of nitrogen gas, the start of the LPIS is delayed by between 1 and 1.75 h. Applicability of the obtained results to the real safety conditions must take into accountthe real operating procedures used in the nuclear power plant.

Oospores of Phytophthora infestans in soil provide an important new source of primary inoculum in Finland

Selostus: Perunaruton munaitiöt maassa ovat uusi merkittävä epidemian alkulähde Suomessa

Handling of TDM Connections with Cello Media Gateway

UMTS is a 3rd generation telecommunication system, which introduces new network architecture. The change in the network architecture introduces new logical network nodes and changes the role of existing nodes in the network. This architecture changes the current vertically specialized network into a horizontally layered structure. In practice, the layering means that different levels in network hierarchy are separated, and they communicate over well-specified interfaces. The Connectivity Layer, at the bottom of the UMTS network architecture, contains Media Gateways (MGW). The GSM radio access network and UMTS access network are connected to the connectivity network via a MGW. External networks, e.g. ISDN networks, are accessed via other MGWs. The user plane is transported across the connectivity network between/via MGWs. ATM network is used as the backbone in Ericsson’s UMTS core network release 2.0. The main goal of this thesis is to study how the MGW is used to bridge ATM and TDM networks. The Circuit Emulation Service (CES) for ATM is studied, as the conversion from TDM to ATM is made according it. The transportation is made using AAL2 and the issues that it has with voice traffic are studied. The implementation and usage of TDM switching service in MGW are described in detail.