Production of Chemicals from Woody Biomass by Wet Oxidation

The production of chemicals from sawdust by wet oxidation has been investigated. Two different concentrations of sawdust; 54054 mg/l and 32683 mg/l were used in the study. The wet oxidation operating conditions were; 175 deg.C – 225 deg.C, 1MPa Oxygen, and 40 minutes to 120 minutes reaction time. Carboxylic acids were among the chemicals produced in the process. The total yield of carboxylic acids was found to increase with temperature. Also, higher yields of carboxylic acids were observed at a lower sawdust concentration. This was probably due to the high oxygen-biomass ratio at lower sawdust concentration. Higher oxygen availability at low sawdust concentration resulted in increased conversion of the sawdust; hence the higher yields of carboxylic acids. At lower sawdust concentration, a total carboxylic acid yield of 25.59 wt% was attained at 200 deg.C and 40 minutes reaction time. At higher sawdust concentration, a total carboxylic acid yield of 15.57 wt% was attained at 200 deg.C and 40-minutes reaction time. The carboxylic acids identified include formic acid, acetic acid, succinic acid and oxalic acid. The optimum temperature for the production of formic acid was found to be 200 deg.C, while the optimum temperature for the production of acetic acid was found to be 225 deg.C. A temperature of 225 deg.C and relatively short reaction time of 10 minutes was found to be the optimal condition for the production of succinic acid. Formic acid was produced in the highest yield, with an optimal yield of 13.69wt %, when the reaction temperature and time are 200 deg.C and 40 minutes respectively. The yield of formic acid was found to decrease significantly when further increasing the temperature to 225 deg.C. This was presumably due to thermal decomposition of formic acid at relatively higher temperature. However, the yield of acetic acid was found to steadily increase with temperature. This is because acetic is more thermally stable than formic acid. The yield of acetic acid did not decrease after the temperature was increased to 225 deg.C. Optimal yield of acetic acid (7.98wt %) was achieved at; 225 deg.C, and 40 minutes reaction time. Succinic acid was produced only at temperatures of 200 deg.C and 225 deg.C. Optimal yield of succinic acid (5.66wt %) was attained under the following conditions; 32683 mg/l, 225 deg.C, 1MPa O2, and 10-minutes reaction time. Oxalic acid was produced in the lowest yield and, less frequently. The optimal yield of oxalic acid (4.02 wt%) was attained at 175 deg.C and 80-minutes of reaction time The Total Organic Carbon (TOC) is found to be higher when increasing the operating temperature, thus suggesting that more organic compounds are formed at higher temperatures. The identified carboxylic acids could only account for less than 30% of the measured COD content of the various wet oxidation samples. This implies that some other unidentified compounds (reaction products) must have been present. In general, wet oxidation seems to be an effective method for converting lignocellulosic biomass into useful chemicals. Relatively higher temperatures have been found to favor the production of carboxylic acids from sawdust.

Development Of Interpersonal Relationships in Global Virtual Teams

This study investigates the development of relationships in same global virtual team working on different projects. The purpose is to explore how do interpersonal relationships develop in terms of characteristics of virtuality and if there is any influence of project lifespan on the development of these relationships. Since relationships are dynamic in nature and are influenced by multiple levels of variables including individual, group and organizational level, therefore characteristics of virtuality have been considered from all these aspects so as to study their influence on development of relationships. In this study, relationships have been studied at two different levels. At first, dyadic relationships between two members of a GVT have been analyzed and thereafter, focus has been on the development of relationships among the team, based on these dyads. Characteristics having influence on development of relationships include trust, physical distance, time zone difference, cultural and language differences, level of formalization in the organization and means of communication used by team members. Level of formalization and means of communication are two characteristics which emerged after empirical study and are found to have direct influence on development of relationships. Remaining characteristics have been identified through literature review. In order to conduct the study, qualitative methodology has been applied. Empirical data has been collected based on a single case study while using semi-structured interviews as data gathering technique. Data analysis has been performed by applying thematic analysis along with the utilization of company documents such as work sheets, minutes of meetings and recordings of conferences. Findings of the study indicate that development of relationships, both at dyadic level and team level, is influenced by different events taking place among different members of GVT. These events have either positive or negative influence on the characteristics of virtuality, which leads to development of the relationships. It has been found that, trust, among all factors plays a greater role in development of these relations. Contrary to the belief that most conflicts arise among members of different cultures, they are equally likely to happen among the members from same culture in GVT environment. Study suggests that relationship development is not a smooth process but it fluctuates based on different events in teams. For further research, teams within large firms shall be studied along these lines. This study is an early attempt towards bringing different characteristics of virtuality together which previously, have been studied individually. It is therefore plausible to conduct similar studies so as to generalize the findings of this study which has provided a starting point.

Kalvon modifioinnin vaikutus pienten molekyylien nanosuodatukseen

Tässä työssä tutkittiin pienten molekyylien nanosuodatusta kolmella kalvolla. Lappeenrannan teknillisen korkeakoulun laboratoriomittakaavan nanosuodatuslaitteistolla suodatettiin glukoosin, maitohapon ja oktaanihapon vesiliuoksia 0,45 m/s virtausnopeudella. Lisäksi NF 45, NF 270 ja NTR 7450 –kalvoja modifioitiin UV-säteilytyksellä modifiointiaineen kanssa tai ilman. Modifiointiaineina olivat maito- ja oktaanihappo. Kalvon modifioinnilla pyrittiin parantamaan permeabiliteettia ilman retentiohäviöitä. Kirjallisuusosassa käsiteltiin nanosuodatuksen erottumisperiaatteita ja konsentraatiopolarisaation merkitystä liuenneiden aineiden erottumisessa. Lisäksi käsiteltiin kalvon modifioinnin merkitystä suodatuksen parantamiseen ja pienten orgaanisten molekyylien nanosuodatusta. Aluksi suodatettiin glukoosi- ja oktaanihappoliuoksia NF 270 –kalvolla. Glukoosin retentio oli 80% pitoisuudesta riippumatta, mutta oktaanihapon retentio, 70-100%, riippui pitoisuudesta. 100 ppm oktaanihapon pitoisuudessa retentio oli 100% ja suuremmilla pitoisuuksilla alhaisempi. Kun oktaanihappoa suodatettiin modifioimattomilla kalvoilla pH:n funktiona, niin retentiot olivat pH-riippuvaisia. Alhaisilla pH-arvoilla oktaanihapon retentiot olivat lähes nolla ja nousivat jyrkästi pH:ssa 6 siten, että korkeilla pH-arvoilla retentiot olivat yli 80%. Glukoosin suodatuksissa NF 270 –kalvolla modifiointi aina hieman paransi vuota, mutta retentiot huononivat. Oktaanihapon suodatuksissa vuo parani hieman, kun kalvoja (NF 270 ja NTR 7450) oli modifioitu 20 minuuttia UV-säteilytyksellä 100 ppm maitohappoliuoksessa. NTR 7450 –kalvon vuo moninkertaistui modifioimattoman kalvon vuohon verrattuna, kun kalvoa oli UV-säteilytetty 20 minuuttia 2000 ppm maitohappoliuoksessa. Oktaanihapposuodatuksissa retentiot modifioiduilla kalvoilla olivat suurimmat pH-alueella 7-10. Modifioitujen kalvojen permeabiliteetit nousivat jyrkästi pH:ssa 12 kaikilla malliaineilla, mikä viittaa siihen, että modifiointiaine irtosi pH:ssa 12. Toisaalta korkeilla pH-arvoilla kalvo muuttuu avoimemmaksi, joten modifiointiaineen irtoamista ei voitu näiden mittausten perusteella varmentaa. Kalvon modifiointi oli onnistunut, sillä malliainesuodatuksissa havaittiin vuo- ja retentiomuutoksia.

Photocatalysis Studies under Visible Light Irradiation with TiO2 Obtained by Pulsed Electric Field Assisted Sol-Gel Method

The objective of this thesis was to study the effect of pulsed electric field on the preparation of TiO2 nanoparticles via sol-gel method under the visible light irradiation. The literature part introduces properties of different TiO2 crystal forms and principle of photocatalysis. It was expected that pulsed electric field would have an influence on degradation for oxalic acid and formic acid. TiO2 samples were prepared by using three frequencies (50Hz, 294Hz, and 963Hz) and two treatment times (12 minutes and 24 minutes) of pulsed electric field. The photocatalytic activities of TiO2 samples produced with sol-gel method were also compared with the TiO2 particles made by previous study and with the commercial TiO2 powder Aeroxide® (Evonic Degussa GmbH) at the same condition. Results show that pulsed electric field does have an effect on degradation for oxalic acid and formic acid. Generally, higher photocatalytic activities for oxalic acid and formic acid were obtained with lower frequency and longer treatment time of pulsed electric field.