Recovery of carboxylic acids from aqueous streams by extraction and back extraction

Separation of carboxylic acids from aqueous streams is an important part of their manufacturing process. The aqueous solutions are usually dilute containing less than 10 % acids. Separation by distillation is difficult as the boiling points of acids are only marginally higher than that of water. Because of this distillation is not only difficult but also expensive due to the evaporation of large amounts of water. Carboxylic acids have traditionally been precipitated as calcium salts. The yields of these processes are usually relatively low and the chemical costs high. Especially the decomposition of calcium salts with sulfuric acid produces large amounts of calcium sulfate sludge. Solvent extraction has been studied as an alternative method for recovery of carboxylic acids. Solvent extraction is based on mixing of two immiscible liquids and the transfer of the wanted components form one liquid to another due to equilibrium difference. In the case of carboxylic acids, the acids are transferred from aqueous phase to organic solvent due to physical and chemical interactions. The acids and the extractant form complexes which are soluble in the organic phase. The extraction efficiency is affected by many factors, for instance initial acid concentration, type and concentration of the extractant, pH, temperature and extraction time. In this paper, the effects of initial acid concentration, type of extractant and temperature on extraction efficiency were studied. As carboxylic acids are usually the products of the processes, they are wanted to be recovered. Hence the acids have to be removed from the organic phase after the extraction. The removal of acids from the organic phase also regenerates the extractant which can be then recycled in the process. The regeneration of the extractant was studied by back-extracting i.e. stripping the acids form the organic solution into diluent sodium hydroxide solution. In the solvent regeneration, the regenerability of different extractants and the effect of initial acid concentration and temperature were studied.

Anaesthesia and Pain Management for Use in Orthopaedic Day Surgery

Day surgery has gained a large popularity during the last decades. In Finland, 57% of the elective procedures, and 50% at Turku University Hospital, were already conducted on day basis during 2012. The steady growth of day surgery is mostly due to an increased safety in perioperative care and cost-effectiveness. The development of surgical techniques and anaesthetic methods has advanced the modern day surgery and extended the repertory of the procedures for use in day surgery operations. Day surgery also offers certain benefits like reduced risk for hospital-related infections, stress and confusion. Patient satisfaction, regarding several issues, is high. Most concerns and complaints are related to postoperative pain, nausea and vomiting pain and nausea. Pain can hamper recovery and pain management is a crucial factor for hospital discharge. Appropriate pain treatment is effective, safe, easy and economical. A procedure-specific approach and an individually planned, multimodal analgesia should be the basis of modern pain management. The main aim of this thesis was to evaluate the effectiveness and safety of anaesthetic technique and methods in pain treatment of orthopaedic day case surgery, and following conclusions were made. Unilateral spinal block was achieved using hyperbaric bupivacaine with a small dose of clonidine but clonidine prolonged the block. Continuous subacromial bupivacaine was found to be safe but conferring only moderate efficacy in pain care after shoulder arthroscopy. Transdermal fentanyl, 12 g/h, as part of multimodal analgesia, offered a safe and easy option to pain management in this patient group. However, after forefoot surgery, it did not reduce pain any further. In general, pain scores in all patient groups were low and the need for rescue opioid moderate.