Transformation of carbon dioxide to diethyl carbonate over ceria and ceria-supported catalysts

Carbon dioxide is regarded, nowadays, as a primary anthropogenic greenhouse gas leading to global warming. Hence, chemical fixation of CO2 has attracted much attention as a possible way to manufacture useful chemicals. One of the most interesting approaches of CO2 transformations is the synthesis of organic carbonates. Since conventional production technologies of these compounds involve poisonous phosgene and carbon monoxide, there is a need to develop novel synthetic methods that would better match the principles of "Green Chemistry" towards protection of the environment and human health. Over the years, synthesis of dimethyl carbonate was under intensive investigation in the academia and industry. Therefore, this study was entirely directed towards equally important homologue of carbonic esters family namely diethyl carbonate (DEC). Novel synthesis method of DEC starting from ethanol and CO2 over heterogeneous catalysts based on ceria (CeO2) was studied in the batch reactor. However, the plausible drawback of the reaction is thermodynamic limitations. The calculated values revealed that the reaction is exothermic (ΔrHØ298K = ─ 16.6 J/ ) and does not occur spontaneously at rooms temperature (ΔrGØ 298K = 35.85 kJ/mol). Moreover, co-produced water easily shifts the reaction equilibrium towards reactants excluding achievement of high yields of the carbonate. Therefore, in-situ dehydration has been applied using butylene oxide as a chemical water trap. A 9-fold enhancement in the amount of DEC was observed upon introduction of butylene oxide to the reaction media in comparison to the synthetic method without any water removal. This result confirms that reaction equilibrium was shifted in favour of the desired product and thermodynamic boundaries of the reaction were suppressed by using butylene oxide as a water scavenger. In order to obtain insight into the reaction network, the kinetic experiments were performed over commercial cerium oxide. On the basis of the selectivity/conversion profile it could be concluded that the one-pot synthesis of diethyl carbonate from ethanol, CO2 and butylene oxide occurs via a consecutive route involving cyclic carbonate as an intermediate. Since commercial cerium oxide suffers from the deactivation problems already after first reaction cycle, in-house CeO2 was prepared applying room temperature precipitation technique. Variation of the synthesis parameters such as synthesis time, calcination temperature and pH of the reaction solution turned to have considerable influence on the physico-chemical and catalytic properties of CeO2. The increase of the synthesis time resulted in high specific surface area of cerium oxide and catalyst prepared within 50 h exhibited the highest amount of basic sites on its surface. Furthermore, synthesis under pH 11 yielded cerium oxide with the highest specific surface area, 139 m2/g, among all prepared catalysts. Moreover, CeO2─pH11 catalyst demonstrated the best catalytic activity and 2 mmol of DEC was produced at 180 oC and 9 MPa of the final reaction pressure. In addition, ceria-supported onto high specific surface area silicas MCM-41, SBA-15 and silica gel were synthesized and tested for the first time as catalysts in the synthesis of DEC. Deposition of cerium oxide on MCM-41 and SiO2 supports resulted in a substantial increase of the alkalinity of the carrier materials. Hexagonal SBA-15 modified with 20 wt % of ceria exhibited the second highest basicity in the series of supported catalysts. Evaluation of the catalytic activity of ceria-supported catalysts showed that reaction carried out over 20 wt % CeO2-SBA-15 generated the highest amount of DEC.

Biomass Utilization in PFC Co-firing System with the Slagging and Fouling Analysis

Master’s thesis Biomass Utilization in PFC Co-firing System with the Slagging and Fouling Analysis is the study of the modern technologies of different coal-firing systems: PFC system, FB system and GF system. The biomass co-fired with coal is represented by the research of the company Alstom Power Plant. Based on the back ground of the air pollution, greenhouse effect problems and the national fuel security today, the bioenergy utilization is more and more popular. However, the biomass is promoted to burn to decrease the emission amount of carbon dioxide and other air pollutions, new problems form like slagging and fouling, hot corrosion in the firing systems. Thesis represent the brief overview of different coal-firing systems utilized in the world, and focus on the biomass-coal co-firing in the PFC system. The biomass supply and how the PFC system is running are represented in the thesis. Additionally, the new problems of hot corrosion, slagging and fouling are mentioned. The slagging and fouling problem is simulated by using the software HSC Chemistry 6.1, and the emissions comparison between coal-firing and co-firing are simulated as well.

Trilling race : the political economy of racialised visual-aural encounters

This thesis investigates the matter of race in the context of Finnish language acquisition among adult migrants in Finland. Here matter denotes both the materiality of race and how race comes to matter. Drawing primarily on an auto/ethno/graphic account of learning the Finnish language as a participant in the Finnish for foreigners classes, this thesis problematises the ontology and epistemology of race, i.e., what race is, how it is known, and what an engagement with race entails. Taking cues from the bodily practices of learning the Finnish trill or the rolling r, this study proposes a notion of “trilling race” and argues for an onto-epistemological dis/continuity that marks race’s arrival. The notion of dis/continuity reworks the distinction between continuity and discontinuity, and asks about the how of the arrival of any identity, the where, and the when. In so doing, an analysis of “trilling race” engages with one of the major problematics that has exercised much critical attention, namely: how to read race differently. That is, to rethink the conundrum of the need to counter “representational weight” (Puar 2007, 191) of race on the one hand, and to account for the racialised lived realities on the other. The link between a study of the phenomenon of host country language acquisition and an examination of the question of race is not as obvious as it might seem. For example, what does the argument that the process of language learning is racialised actually imply? Does it mean that race, as a process of racialisation or an ongoing configuration of sets of power relations, exerts force from an outside on the otherwise neutral process of learning the host country language? Or does it mean that race, as an identity category, presents as among the analytical perspectives, along with gender and class for instance, of the phenomenon of host country language acquisition? With these questions in mind, and to foreground the examination of the question of race in the context of Finnish language acquisition among adult migrants, this thesis opens with a discussion of the art installation Finnexia by Lisa Erdman. Finnexia is a fictitious drug said to facilitate Finnish language learning through accelerating the cognitive learning process and reducing the anxiety of speaking the Finnish language. Not only does the Finnexia installation make visible the ways in which the lack of skill in Finnish is fgured as the threshold – a border that separates the inside from the outside – to integration, but also, and importantly, it raises questions about the nature of difference, and the process of differentiation that separates the individual from the social, fact from fiction, nature from culture. These puzzles animate much of the analysis in this dissertation. These concerns continue to be addressed in the rest of part one. Whereas chapter two offers a reconsideration of the ambiguities of ethnisme/ethnicity and race, chapter three dilates on the methodological implications of a conception of the dis/continuity of race. Part two focuses on the matter of race and examines the political economy of visual-aural encounters, whereas part three shifts the focus and rethinks the possibilities and limitations of transforming racialised and normative constraints. Taking up these particular problematics, this thesis as a whole argues that race trills itself: its identity/difference is simultaneously made possible and impossible.

Simulation model of wind turbine gearbox and lubrication system

As increasing efficiency of a wind turbine gearbox, more power can be transferred from rotor blades to generator and less power is used to cause wear and heating in the gearbox. By using a simulation model, behavior of the gearbox can be studied before creating expensive prototypes. The objective of the thesis is to model a wind turbine gearbox and its lubrication system to study power losses and heat transfer inside the gearbox and to study the simulation methods of the used software. Software used to create the simulation model is Siemens LMS Imagine.Lab AMESim, which can be used to create one-dimensional mechatronic system simulation models from different fields of engineering. When combining components from different libraries it is possible to create a simulation model, which includes mechanical, thermal and hydraulic models of the gearbox. Results for mechanical, thermal, and hydraulic simulations are presented in the thesis. Due to the large scale of the wind turbine gearbox and the amount of power transmitted, power loss calculations from AMESim software are inaccurate and power losses are modelled as constant efficiency for each gear mesh. Starting values for simulation in thermal and hydraulic simulations were chosen from test measurements and from empirical study as compact and complex design of gearbox prevents accurate test measurements. In further studies to increase the accuracy of the simulation model, components used for power loss calculations needs to be modified and values for unknown variables are needed to be solved through accurate test measurements.

Power Electronic Converters in Low-Voltage Direct Current Distribution – Analysis and Implementation

Over the recent years, smart grids have received great public attention. Many proposed functionalities rely on power electronics, which play a key role in the smart grid, together with the communication network. However, “smartness” is not the driver that alone motivates the research towards distribution networks based on power electronics; the network vulnerability to natural hazards has resulted in tightening requirements for the supply security, set both by electricity end-users and authorities. Because of the favorable price development and advancements in the field, direct current (DC) distribution has become an attractive alternative for distribution networks. In this doctoral dissertation, power electronic converters for a low-voltage DC (LVDC) distribution system are investigated. These include the rectifier located at the beginning of the LVDC network and the customer-end inverter (CEI) on the customer premises. Rectifier topologies are introduced, and according to the LVDC system requirements, topologies are chosen for the analysis. Similarly, suitable CEI topologies are addressed and selected for study. Application of power electronics into electricity distribution poses some new challenges. Because the electricity end-user is supplied with the CEI, it is responsible for the end-user voltage quality, but it also has to be able to supply adequate current in all operating conditions, including a short-circuit, to ensure the electrical safety. Supplying short-circuit current with power electronics requires additional measures, and therefore, the short-circuit behavior is described and methods to overcome the high-current supply to the fault are proposed. Power electronic converters also produce common-mode (CM) and radio-frequency (RF) electromagnetic interferences (EMI), which are not present in AC distribution. Hence, their magnitudes are investigated. To enable comprehensive research on the LVDC distribution field, a research site was built into a public low-voltage distribution network. The implementation was a joint task by the LVDC research team of Lappeenranta University of Technology and a power company Suur-Savon S¨ahk¨o Oy. Now, the measurements could be conducted in an actual environment. This is important especially for the EMI studies. The main results of the work concern the short-circuit operation of the CEI and the EMI issues. The applicability of the power electronic converters to electricity distribution is demonstrated, and suggestions for future research are proposed.

Power and Performance Management Strategies on NoC-Based Multicore Platforms, Using DVFS, Adaptive Algorithm and Task Parallelism

This work presents synopsis of efficient strategies used in power managements for achieving the most economical power and energy consumption in multicore systems, FPGA and NoC Platforms. In this work, a practical approach was taken, in an effort to validate the significance of the proposed Adaptive Power Management Algorithm (APMA), proposed for system developed, for this thesis project. This system comprise arithmetic and logic unit, up and down counters, adder, state machine and multiplexer. The essence of carrying this project firstly, is to develop a system that will be used for this power management project. Secondly, to perform area and power synopsis of the system on these various scalable technology platforms, UMC 90nm nanotechnology 1.2v, UMC 90nm nanotechnology 1.32v and UMC 0.18 μmNanotechnology 1.80v, in order to examine the difference in area and power consumption of the system on the platforms. Thirdly, to explore various strategies that can be used to reducing system’s power consumption and to propose an adaptive power management algorithm that can be used to reduce the power consumption of the system. The strategies introduced in this work comprise Dynamic Voltage Frequency Scaling (DVFS) and task parallelism. After the system development, it was run on FPGA board, basically NoC Platforms and on these various technology platforms UMC 90nm nanotechnology1.2v, UMC 90nm nanotechnology 1.32v and UMC180 nm nanotechnology 1.80v, the system synthesis was successfully accomplished, the simulated result analysis shows that the system meets all functional requirements, the power consumption and the area utilization were recorded and analyzed in chapter 7 of this work. This work extensively reviewed various strategies for managing power consumption which were quantitative research works by many researchers and companies, it's a mixture of study analysis and experimented lab works, it condensed and presents the whole basic concepts of power management strategy from quality technical papers.

In Search for the European solidarity: The rule of law within the European Union in the framework of constitutional pluralism

The dissertation examines the rule of law within the European Union in the theoretical framework of constitutional pluralism. The leading lines of constitutional pluralism are examined with relation to the traditional and prevailing, monistic and hierarchical conceptions on how to perceive legal orders in Europe. The theoretical part offers also historical perspective by highlighting some of the turning points for the Union constitutional legal order in the framework of European integration. The concept of rule of law is examined in legal terms and its meaning to the Union constitutional constellation as a constitutional principle and a common value is observed. The realization of the rule of law at supranational and national level is explored with a view to discover that recent developments in some of the Member States give rise to concern about the viability of the rule of law within the European Union. It is recognized that the inobservance of the rule of law at national level causes a threat to the supranational constitutional legal order. The relationship between the supranational and national legal orders is significant in this respect and therefore particularly the interaction between the Court of Justice of the European Union (hereinafter the ECJ) and the Member States’ (constitutional/supreme) courts takes focus. It is observed that functioning dialogue between the supranational and national courts based on mutual respect and judicial deference is an important prerequisite for the realization of the rule of law within Europe. In order to afford a concrete example, a recent case C-62/14 Gauweiler v Deutscher Bundestag is introduced and analysed in relation to the notorious relationship between the Federal Constitutional Court of Germany and the ECJ. The implications of the ECJ’s decision in Gauweiler v Deutscher Bundestag is assessed with reference to some of the pressing issues of constitutionalism within Europe and some institutional aspects are also brought forward. Lastly, the feasibility of constitutional pluralism as a theoretical setting is measured against the legal reality of today’s Europe and its many constitutions. The hierarchical idea of one ultimate source of power, stemming from the traditional approaches to legal systems, is then assessed with relation to the requirement of the realization of the rule of law within the European Union from the supranational and national point of view.