Translational models of coronary artery disease, myocardial infarction and heart failure. Development, validation and in vivo imaging studies using positron emission tomography

Coronary artery disease is an atherosclerotic disease, which leads to narrowing of coronary arteries, deteriorated myocardial blood flow and myocardial ischaemia. In acute myocardial infarction, a prolonged period of myocardial ischaemia leads to myocardial necrosis. Necrotic myocardium is replaced with scar tissue. Myocardial infarction results in various changes in cardiac structure and function over time that results in “adverse remodelling”. This remodelling may result in a progressive worsening of cardiac function and development of chronic heart failure. In this thesis, we developed and validated three different large animal models of coronary artery disease, myocardial ischaemia and infarction for translational studies. In the first study the coronary artery disease model had both induced diabetes and hypercholesterolemia. In the second study myocardial ischaemia and infarction were caused by a surgical method and in the third study by catheterisation. For model characterisation, we used non-invasive positron emission tomography (PET) methods for measurement of myocardial perfusion, oxidative metabolism and glucose utilisation. Additionally, cardiac function was measured by echocardiography and computed tomography. To study the metabolic changes that occur during atherosclerosis, a hypercholesterolemic and diabetic model was used with [18F] fluorodeoxyglucose ([18F]FDG) PET-imaging technology. Coronary occlusion models were used to evaluate metabolic and structural changes in the heart and the cardioprotective effects of levosimendan during post-infarction cardiac remodelling. Large animal models were used in testing of novel radiopharmaceuticals for myocardial perfusion imaging. In the coronary artery disease model, we observed atherosclerotic lesions that were associated with focally increased [18F]FDG uptake. In heart failure models, chronic myocardial infarction led to the worsening of systolic function, cardiac remodelling and decreased efficiency of cardiac pumping function. Levosimendan therapy reduced post-infarction myocardial infarct size and improved cardiac function. The novel 68Ga-labeled radiopharmaceuticals tested in this study were not successful for the determination of myocardial blood flow. In conclusion, diabetes and hypercholesterolemia lead to the development of early phase atherosclerotic lesions. Coronary artery occlusion produced considerable myocardial ischaemia and later infarction following myocardial remodelling. The experimental models evaluated in these studies will enable further studies concerning disease mechanisms, new radiopharmaceuticals and interventions in coronary artery disease and heart failure.

Geochemistry and water quality of Lake Qarun, Egypt

Water geochemistry is a very important tool for studying the water quality in a given area. Geology and climate are the major natural factors controlling the chemistry of most natural waters. Anthropogenic impacts are the secondary sources of contamination in natural waters. This study presents the first integrative approach to the geochemistry and water quality of surface waters and Lake Qarun in the Fayoum catchment, Egypt. Moreover, geochemical modeling of Lake Qarun was firstly presented. The Nile River is the main source of water to the Fayoum watershed. To investigate the quality and geochemistry of this water, water samples from irrigation canals, drains and Lake Qarun were collected during the period 2010‒2013 from the whole Fayoum drainage basin to address the major processes and factors governing the evolution of water chemistry in the investigation area. About 34 physicochemical quality parameters, including major ions, oxygen isotopes, trace elements, nutrients and microbiological parameters were investigated in the water samples. Multivariable statistical analysis was used to interpret the interrelationship between the different studied parameters. Geochemical modeling of Lake Qarun was carried out using Hardie and Eugster’s evolutionary model and a model simulated by PHREEQC software. The crystallization sequence during evaporation of Lake Qarun brine was also studied using a Jänecke phase diagram involving the system Na‒K‒Mg‒ Cl‒SO4‒H2O. The results show that the chemistry of surface water in the Fayoum catchment evolves from Ca- Mg-HCO3 at the head waters to Ca‒Mg‒Cl‒SO4 and eventually to Na‒Cl downstream and at Lake Qarun. The main processes behind the high levels of Na, SO4 and Cl in downstream waters and in Lake Qarun are dissolution of evaporites from Fayoum soils followed by evapoconcentration. This was confirmed by binary plots between the different ions, Piper plot, Gibb’s plot and δ18O results. The modeled data proved that Lake Qarun brine evolves from drainage waters via an evaporation‒crystallization process. Through the precipitation of calcite and gypsum, the solution should reach the final composition "Na–Mg–SO4–Cl". As simulated by PHREEQC, further evaporation of lake brine can drive halite to precipitate in the final stages of evaporation. Significantly, the crystallization sequence during evaporation of the lake brine at the concentration ponds of the Egyptian Salts and Minerals Company (EMISAL) reflected the findings from both Hardie and Eugster’s evolutionary model and the PHREEQC simulated model. After crystallization of halite at the EMISAL ponds, the crystallization sequence during evaporation of the residual brine (bittern) was investigated using a Jänecke phase diagram at 35 °C. This diagram was more useful than PHREEQC for predicting the evaporation path especially in the case of this highly concentrated brine (bittern). The predicted crystallization path using a Jänecke phase diagram at 35 °C showed that halite, hexahydrite, kainite and kieserite should appear during bittern evaporation. Yet the actual crystallized mineral salts were only halite and hexahydrite. The absence of kainite was due to its metastability while the absence of kieserite was due to opposed relative humidity. The presence of a specific MgSO4.nH2O phase in ancient evaporite deposits can be used as a paleoclimatic indicator. Evaluation of surface water quality for agricultural purposes shows that some irrigation waters and all drainage waters have high salinities and therefore cannot be used for irrigation. Waters from irrigation canals used as a drinking water supply show higher concentrations of Al and suffer from high levels of total coliform (TC), fecal coliform (FC) and fecal streptococcus (FS). These waters cannot be used for drinking or agricultural purposes without treatment, because of their high health risk. Therefore it is crucial that environmental protection agencies and the media increase public awareness of this issue, especially in rural areas.

Doubly fed wind turbine performance in variable grid conditions

Wind turbines based on doubly fed induction generators (DFIG) become the most popular solution in high power wind generation industry. While this topology provides great performance with the reduced power rating of power converter, it has more complicated structure in comparison with full-rated topologies, and therefore leads to complexity of control algorithms and electromechanical processes in the system. The purpose of presented study is to present a proper vector control scheme for the DFIG and overall control for the WT to investigate its behavior at different wind speeds and in different grid voltage conditions: voltage sags, magnitude and frequency variations. The key principles of variable-speed wind turbine were implemented in simulation model and demonstrated during the study. Then, based on developed control scheme and mathematical model, the set of simulation is made to analyze reactive power capabilities of the DFIG wind turbine. Further, the rating of rotor-side converter is modified to not only generate active rated active power, but also to fulfill Grid Codes. Results of modelling and analyzing of the DFIG WT behavior under different speeds and different voltage conditions are presented in the work.

Climate change and global responsibility - the role of energy consumption, GDP and CO2 emissions

Climate change is one of the biggest challenges faced by this generation. Despite being the single most important environmental challenge facing the planet and despite over two decades of international climate negotiations, global greenhouse gas (GHG) emissions continue to rise. By the middle of this century, GHGs must be reduced by as much as 40-70% if dangerous climate change is to be avoided. In the Kyoto Protocol no quantitative emission limitation and reduction commitments were placed on the developing countries. For the planning of the future commitments period and possible participation of developing countries, information of the functioning of the energy systems, CO2 emissions development in different sectors, energy use and technological development in developing countries is essential. In addition to the per capita emissions, the efficiency of the energy system in relation to GHG emissions is crucial for the decision of future long-term burden sharing between countries. Country’s future development of CO2 emissions can be defined by the estimated CO2 intensity of the future and the estimated GDP growth. The changes in CO2 intensity depend on several factors, but generally developed countries’ intensity has been increasing in the industrialization phase and decreasing when their economy shifts more towards the system dominated by the service sector. The level of the CO2 intensity depends by a large extent on the production structure and the energy sources that are used. Currently one of the most urgent issues regarding global climate change is to decide the future of the Kyoto Protocol. Negotiations on this topic have already been initiated, with the aim of being finalised by the 2015. This thesis provides insights into the various approaches that can be used to characterise the concept of comparable efforts for developing countries in a future international climate agreement. The thesis examines the post-Kyoto burden sharing questions for developing countries using the contraction and convergence model, which is one approach that has been proposed to allocate commitments regarding future GHG emissions mitigation. This new approach is a practical tool for the evaluation of the Kyoto climate policy process and global climate change negotiations from the perspective of the developing countries.

Incorporating Sustainability in Global Sourcing Process, Industry Focus- Apparel / Textile

This is a Master’s thesis research, which mainly aims at identifying the sustainability issues in sourcing process and to identify the core competencies in sourcing process through triple bottom line adaptation. The focus of this thesis is on apparel industry’s sourcing process. The purpose of this thesis is to examine global apparel industry’s reality in their sourcing process and how buyers-suppliers are cooperating with their sourcing process to incorporate sustainability. Other goal of this research paper is to provide recommendation for sustainable sourcing process for companies and how the stakeholders can be benefitted by sustainable sourcing. The literature review part of this paper has presented the research gaps from the earlier researches along with the key concepts, academic purposes and key definitions. Theoretical framework chapter has focused on global sourcing strategies and firm’s competencies and sustainable strategies. From the theoretical framework, author has presented essential theory which establishes the link between research questions and proposed hypotheses. Main results and findings have been presented in empirical findings and in data analysis chapter. This study is an exploratory research followed by deductive method and primary data has been used to evaluate the current situation of apparel industry; which will assist to build the recommendation model. Primary data has been collected through online questionnaires and secondary data has used to cover the literature and theoretical parts. Therefore, the potential outcome of this paper will display the importance of sustainable sourcing from academic point of view and also from the business perspective. As a final point, this paper has followed the research objectives and has generated some new directions for further studies.

Motives and barriers for engaging in collaborative consumption in Finland

In this thesis the consumers’ expected motives and barriers for engaging in collaborative consumption in Finland are studied. The phenomenon is observed through the lens of consumer theory and it is connected to the context using Hofstede’s 6-D model. The phenomenon is new and there are almost no recorded results in the background research, and when considering the limitations of this study, there are no results at all. Therefore, combining different kinds of literature, as well as taking along consumer theory and Hofstede’s model that explains cultural factors, it was possible to compile a comprehensive general view of the present state of the phenomenon. The actual study was conducted using qualitative methods and the solution was sought collecting data from six in-depth interviews with interviewees having experience from using, or offering resources, or both. According to the results, the primary motive in all modes of consumption was economic. Anti-materialism, anti-consumption, and expanding lifestyle were another a bit more general motives. Perceived barriers were, especially as a new result, the amount of trouble one has to see and in single modes, a lack of trust, the used platform and too expensive prices.

Suomen asuntomarkkinoiden kehitys vuosina 2000-2016

Kandidaatintutkielman tarkoituksena on tutkia Suomen asuntomarkkinoiden kehitystä kuluttajamarkkinanäkökulmasta 2000-luvulta alkaen. Tutkimuksen päätavoitteena on selvittää ennalta valittujen tekijöiden avulla, kuinka nämä ovat vaikuttaneet asuntomarkkinoihin. Tekijöiden avulla pystytään selvittämään kysynnän ja tarjonnan vaikutukset asuntomyyntiin. Tutkielman teoreettisen viitekehyksen muodostavat hintakehitys ja 4C-malli. Lisäksi tutkimuksessa on selvitetty talouden heilahteluiden vaikutuksia asuntomarkkinoihin sekä rakennuslupa-asioita ja asuntotuotantoa. Aineistot koostuvat kolmesta eri haastattelusta, joita tukevat aiheeseen liittyvät tilastot ja muu kirjallisuus. Haastatteluiden analyysissä etsitään tärkeimpiä vaikuttajia asuntomarkkinoilla. Tutkimuksessa selviää kaupungistumisen aiheuttaneen suuren muuttoliikenteen kaupunkien lähettyville, minne on alkanut muodostua pienempiä kaupunkikeskuksia. Kuluttajat haluavat asunnon sijaitsevan julkisten liikenneyhteyksien ja palveluiden läheisyydessä. Asuntokoot ovat vuoden 2000 jälkeen pienentyneet, jolloin asuntotuotantoa on jouduttu sopeuttamaan. Asuntolainan koron laskun myötä asuntomyynnin kasvu ei ole ollut toivotulla tasolla. Taloudellisten heilahtelujen myötä kuluttajiin on iskenyt epävarmuus, joka vähentää ihmisten halukkuutta ostaa asuntoja.