Power Consumption Measurement and Scenario Based Energy Model in Wearable Computing Applications

The power is still today an issue in wearable computing applications. The aim of the present paper is to raise awareness of the power consumption of wearable computing devices in specific scenarios to be able in the future to design energy efficient wireless sensors for context recognition in wearable computing applications. The approach is based on a hardware study. The objective of this paper is to analyze and compare the total power consumption of three representative wearable computing devices in realistic scenarios such as Display, Speaker, Camera and microphone, Transfer by Wi-Fi, Monitoring outdoor physical activity and Pedometer. A scenario based energy model is also developed. The Samsung Galaxy Nexus I9250 smartphone, the Vuzix M100 Smart Glasses and the SimValley Smartwatch AW-420.RX are the three devices representative of their form factors. The power consumption is measured using PowerTutor, an android energy profiler application with logging option and using unknown parameters so it is adjusted with the USB meter. The result shows that the screen size is the main parameter influencing the power consumption. The power consumption for an identical scenario varies depending on the wearable devices meaning that others components, parameters or processes might impact on the power consumption and further study is needed to explain these variations. This paper also shows that different inputs (touchscreen is more efficient than buttons controls) and outputs (speaker sensor is more efficient than display sensor) impact the energy consumption in different way. This paper gives recommendations to reduce the energy consumption in healthcare wearable computing application using the energy model.

Climate change and global responsibility - the role of energy consumption, GDP and CO2 emissions

Climate change is one of the biggest challenges faced by this generation. Despite being the single most important environmental challenge facing the planet and despite over two decades of international climate negotiations, global greenhouse gas (GHG) emissions continue to rise. By the middle of this century, GHGs must be reduced by as much as 40-70% if dangerous climate change is to be avoided. In the Kyoto Protocol no quantitative emission limitation and reduction commitments were placed on the developing countries. For the planning of the future commitments period and possible participation of developing countries, information of the functioning of the energy systems, CO2 emissions development in different sectors, energy use and technological development in developing countries is essential. In addition to the per capita emissions, the efficiency of the energy system in relation to GHG emissions is crucial for the decision of future long-term burden sharing between countries. Country’s future development of CO2 emissions can be defined by the estimated CO2 intensity of the future and the estimated GDP growth. The changes in CO2 intensity depend on several factors, but generally developed countries’ intensity has been increasing in the industrialization phase and decreasing when their economy shifts more towards the system dominated by the service sector. The level of the CO2 intensity depends by a large extent on the production structure and the energy sources that are used. Currently one of the most urgent issues regarding global climate change is to decide the future of the Kyoto Protocol. Negotiations on this topic have already been initiated, with the aim of being finalised by the 2015. This thesis provides insights into the various approaches that can be used to characterise the concept of comparable efforts for developing countries in a future international climate agreement. The thesis examines the post-Kyoto burden sharing questions for developing countries using the contraction and convergence model, which is one approach that has been proposed to allocate commitments regarding future GHG emissions mitigation. This new approach is a practical tool for the evaluation of the Kyoto climate policy process and global climate change negotiations from the perspective of the developing countries.

Dynamic Modelling of Circulating Fluidized Bed Plant with Gas Turbine Repowering

Increasing amount of renewable energy source based electricity production has set high load control requirements for power grid balance markets. The essential grid balance between electricity consumption and generation is currently hard to achieve economically with new-generation solutions. Therefore conventional combustion power generation will be examined in this thesis as a solution to the foregoing issue. Circulating fluidized bed (CFB) technology is known to have sufficient scale to acts as a large grid balancing unit. Although the load change rate of the CFB unit is known to be moderately high, supplementary repowering solution will be evaluated in this thesis for load change maximization. The repowering heat duty is delivered to the CFB feed water preheating section by smaller gas turbine (GT) unit. Consequently, steam extraction preheating may be decreased and large amount of the gas turbine exhaust heat may be utilized in the CFB process to reach maximum plant electrical efficiency. Earlier study of the repowering has focused on the efficiency improvements and retrofitting to maximize plant electrical output. This study however presents the CFB load change improvement possibilities achieved with supplementary GT heat. The repowering study is prefaced with literature and theory review for both of the processes to maximize accuracy of the research. Both dynamic and steady-state simulations accomplished with APROS simulation tool will be used to evaluate repowering effects to the CFB unit operation. Eventually, a conceptual level analysis is completed to compare repowered plant performance to the state-of-the-art CFB performance. Based on the performed simulations, considerably good improvements to the CFB process parameters are achieved with repowering. Consequently, the results show possibilities to higher ramp rate values achieved with repowered CFB technology. This enables better plant suitability to the grid balance markets.

Expressing the self in postmodern travel consumption: a case study of students

The study approaches student travel from the perspective of postmodern consumption. The background is in the observation that the student travel market has a vast potential, but it is not necessarily capitalized upon to the extent it could. This might partly have to do with the peculiarities of postmodernity: consumption is characterized by unpredictability and abstract motives. The research questions are built around what constitutes student travel consumption and how can students be categorized according to motivation, behaviour and values. Also identity and expressiveness are present and it is evaluated, if travel services facilitate these background is the observation that the student travel market has a vast potential, but it is not necessarily capitalized upon to the extent it could be. This might partly have to do with the peculiarities of postmodernity: consumption is characterized by unpredictability and abstract motives. The research questions are built around what constitutes student travel consumption and how can students be categorized according to motivation, behaviour and values. Also identity and expressiveness are present and it is evaluated whether travel services facilitate these constructs. The topic is approached by discovering the key concepts such as self-identity. This was done in order to create survey questions that reflect the underlying theories. The survey was sent to chosen student groups of Turku School of Economics. The data was analyzed using statistical methods, mainly principal component analysis, in order to categorize students’ motives and behaviour into distinct profiles. The findings indicate that students have a high level of awareness in their travel consumption choices. Travel services seem to facilitate identity and lifestyle expressiveness, one central dimension of postmodernity. Psychographics such as motivation seem to work well as a segmentation criteria when it comes to the student traveler market. Travel offers students an opportunity for relaxation, escape, enjoyment and gaining new experiences and social contacts. Furthermore, the enjoyment of the travel experience extends to the pre- and post-trip time.

Motives and barriers for engaging in collaborative consumption in Finland

In this thesis the consumers’ expected motives and barriers for engaging in collaborative consumption in Finland are studied. The phenomenon is observed through the lens of consumer theory and it is connected to the context using Hofstede’s 6-D model. The phenomenon is new and there are almost no recorded results in the background research, and when considering the limitations of this study, there are no results at all. Therefore, combining different kinds of literature, as well as taking along consumer theory and Hofstede’s model that explains cultural factors, it was possible to compile a comprehensive general view of the present state of the phenomenon. The actual study was conducted using qualitative methods and the solution was sought collecting data from six in-depth interviews with interviewees having experience from using, or offering resources, or both. According to the results, the primary motive in all modes of consumption was economic. Anti-materialism, anti-consumption, and expanding lifestyle were another a bit more general motives. Perceived barriers were, especially as a new result, the amount of trouble one has to see and in single modes, a lack of trust, the used platform and too expensive prices.