Number of Inmates with Life Sentences Leveling Off, April 2013, Corrections, Department of

For over three decades, the number of Iowa inmates with life sentences has shown a steady increase. As the chart below shows, that number has risen from 111 in 1980 to 680 in 2012 (data for 1987 is unavailable due to transitioning to new data systems)

Final Report: Outcomes of Mandatory Minimum Sentences for Drug Traffickers, October 2011

Individuals with disabilities have civil rights protection similar to that provided to individuals on the basis of race, sex, national origin, and religion. The advent of the Americans with Disabilities Act has improved these protections and brought this issue into the forefront. This book is not intended to be a legal translation of state or federal laws. Its purpose is to assist people with disabilities in understanding their rights. Please consult the Code of Iowa, the appropriate federal laws or an attorney if you need a legal interpretation.

State of Iowa 1998 Inmate Profile, 1999

This report was compiled at the request of the Department of Corrections. The first section describes Iowa’s prison inmate population at mid-year. The first section also provides a comparison of the mid-year 1998 prison population with the population one year ago, and five years ago. Included is analysis of sex, race/ethnicity, age categories, life terms, mandatory minimum sentences, number of sentences per inmate, and offense type. Following the statewide section are Facility Profiles that examine each Department of Corrections institution. The facility profiles cover the same types of information as the statewide report for mid-year 1998, except that committing county and judicial district, Board of Parole risk scores and sex are excluded.

Community-Based Corrections' Impact on Recidivism, Data Download, Iowa Department of Corrections, September 2013

It is no surprise that probationers are less likely to receive new felony or aggravated misdemeanor convictions than are parolees following discharge from supervision; probationers tend to be at lower risk to begin with. Likewise, parolees tend to be at lower risk and less likely to be convicted of serious offenses than are offenders who complete their sentences in prison.

Standard Specifications for Highway and Bridge Construction, 2012

When referenced, the 2012 edition of the Iowa Department of Transportation’s (Iowa DOT) Standard Specifications for Highway and Bridge Construction shall be used for contract work awarded by the Iowa DOT. They may also be incorporated by reference in other contract work on secondary, urban, local systems, or other contract work in which the Iowa DOT has an interest. As modified by the General Supplemental Specifications, these Standard Specifications represent the minimum requirements and may be modified by Supplemental Specifications, Developmental Specifications, and Special Provisions on specific contracts. These Standard Specifications have been written so the Contractor’s responsibilities are indicated by plain language using the Imperative Mood and Active Voice form. Sentences are of the form: Construct isolation joints at all points where driveways meet other walks, curbs, or fixtures in the surface. Ensure finished members are true to detailed dimensions and free from twists, bends, open joints, or other defects resulting from faulty fabrication or defective work. Personnel preparing the JMF shall be Iowa DOT certified in bituminous mix design. The Contracting Authority’s responsibilities are (with some exceptions) indicated by the use of the modal verb “will”. Sentences are of the form: The Engineer will obtain and test density samples for each lot according to Materials I.M. 204. Payment will be the contract unit price for Fabric Reinforcement per square yard (square meter). These standard specifications contain dual units of measure: the United States Standard measure (English units) and the International System of Units (SI or “metric” units). The English units are expressed first then followed by the metric units in parentheses. The measurements expressed in the two systems are not necessarily equal. In some cases the measurements in metric units is a “hard” conversion of the English measurement; i.e. the metric unit has been approximated with a rounded, rationalized metric measurement that is easy to work with and remember. The proposal form will identify whether the work was designed and shall be constructed in English or metric units.