Iowa Court Rules, 4th ed.

The Fourth Edition of the Iowa Court Rules, adopted by the supreme court November 9, 2001, effective February 15, 2002, is published pursuant to Iowa Code section 2B.5(2). Supplements to the loose-leaf compilation will be prepared and distributed as the rules are amended by the court.

Uniform Manual Real Property Acquisition and Relocation Assistance Section II - Chapter 111 Uniform Rules and Procedures April, 2006

The purpose of this chapter is to implement Iowa Code chapter 316 and sections 6B.42, 6B.45, 6B.54 and 6B.55, as required by the Uniform Relocation Assistance and Real Property Acquisition Policies Act of 1970, Pub. L. 91-646, as amended by the Uniform Relocation Act Amendments of 1987, Title IV, Pub. L. No. 100-17 , Sec. 104, Pub. L. 105-117, and federal regulations adopted pursuant thereto.

Iowa Court Rules, 4th ed.

The Fourth Edition of the Iowa Court Rules, adopted by the supreme court November 9, 2001, effective February 15, 2002, is published pursuant to Iowa Code section 2B.5(2). Supplements to the loose-leaf compilation will be prepared and distributed as the rules are amended by the court.

Development of a Computer Controlled Underbody Plow: TR412, Final Report, January 2006

Underbody plows can be very useful tools in winter maintenance, especially when compacted snow or hard ice must be removed from the roadway. By the application of significant down-force, and the use of an appropriate cutting edge angle, compacted snow and ice can be removed very effectively by such plows, with much greater efficiency than any other tool under those circumstances. However, the successful operation of an underbody plow requires considerable skill. If too little down pressure is applied to the plow, then it will not cut the ice or compacted snow. However, if too much force is applied, then either the cutting edge may gouge the road surface, causing significant damage often to both the road surface and the plow, or the plow may ride up on the cutting edge so that it is no longer controllable by the operator. Spinning of the truck in such situations is easily accomplished. Further, excessive down force will result in rapid wear of the cutting edge. Given this need for a high level of operator skill, the operation of an underbody plow is a candidate for automation. In order to successfully automate the operation of an underbody plow, a control system must be developed that follows a set of rules that represent appropriate operation of such a plow. These rules have been developed, based upon earlier work in which operational underbody plows were instrumented to determine the loading upon them (both vertical and horizontal) and the angle at which the blade was operating.These rules have been successfully coded into two different computer programs, both using the MatLab® software. In the first program, various load and angle inputs are analyzed to determine when, whether, and how they violate the rules of operation. This program is essentially deterministic in nature. In the second program, the Simulink® package in the MatLab® software system was used to implement these rules using fuzzy logic. Fuzzy logic essentially replaces a fixed and constant rule with one that varies in such a way as to improve operational control. The development of the fuzzy logic in this simulation was achieved simply by using appropriate routines in the computer software, rather than being developed directly. The results of the computer testing and simulation indicate that a fully automated, computer controlled underbody plow is indeed possible. The issue of whether the next steps toward full automation should be taken (and by whom) has also been considered, and the possibility of some sort of joint venture between a Department of Transportation and a vendor has been suggested.

Eighty-Sixth General Assembly Joint Rules of the House and Senate

Eighty-Sixth General Assembly Joint Rules of the House and Senate (House Concurrent Resolution 6), House adopted 2-3-2015, Senate adopted 2-4-2015

Eighty-Sixth General Assembly House Rules (House Resolution 4-Adopted 2-3-2015), February 3, 2015

Eighty-Sixth General Assembly House Rules (House Resolution 4-Adopted 2-3-2015)

Eighty-Sixth General Assembly Joint Rules Governing Lobbyists (House Concurrent Resolution 7) House Adopted 2-3-2015, Senate Adopted 2-4-2015, February 5, 2015

Eighty-Sixth General Assembly Joint Rules Governing Lobbyists (House Concurrent Resolution 7) House Adopted 2-3-2015, Senate Adopted 2-4-2015

Eighty-Sixth General Assembly Senate Rules (Senate Resolution 1 — Adopted 2/4/15), February 6, 2015

Eighty-Sixth General Assembly House Rules (House Resolution 4-Adopted 2-3-2015)