Pieces of Iowa’s Past, March 28, 2012

Pieces of Iowa’s Past, published by the Iowa State Capitol Tour Guides weekly during the legislative session, features historical facts about Iowa, the Capitol, and the early workings of state government. All historical publications are reproduced here with the actual spelling, punctuation, and grammar retained. THIS WEEK: Electric Lighting in the Iowa State Capitol BACKGROUND: REPORT OF COMMITTEE ON LIGHTING THE BUILDING AND GROUNDS WITH ELECTRICITY—1882 The Capitol Commissioners submitted biennial reports throughout the 15 years it took to build the Capitol (1871-1886). Often there were committees formed to investigate a certain phase of the construction. The following is the report of the Committee on Lighting. Note: The Capitol Commissioners determined the gas lighting to be the best choice in the 1880s. Less than 20 years later, the process began to convert the Capitol from gas to electric lighting. There was a period where both types of lighting were being used in the Capitol. The photograph of the 1904 apple harvest shows both electric and gas fixtures. The turn of the 20th century photograph of the library also shows chandeliers utilizing both gas and electricity. The photograph of the single fixture in the library is a mystery. It shows a fixture utilizing both gas and electricity, but no other photographs of the library exist where this fixture appears. Perhaps it was a prototype and never used in the Capitol.

Solar Powered Highway Delineator System, HR-367, 1993

Currently, many drivers experience some difficulty in viewing the road ahead of them during times of reduced visibility, such as rain, snow, fog, or the darkness of night- Recent studies done by the National Safety Council provide a detailed contrast between fatal accidents occurring during the day and night. Revealed was that the motor vehicle night death rate (4.41 deaths per 100 million miles driven) was sharply higher than the corresponding death rate during daylight hours (1.21). By providing a delineating system powered by the natural resource of solar power, a constant source of visibility may be maintained throughout the evening. Along with providing enough light to trace the outline of the road, other major goals defined in producing this delineator system are as follows: 1. A strong and durable design that would protect the internal components and survive extreme weather conditions. 2. A low maintenance system where components need few repairs or replacements. 3. A design which makes all components accessible in the event that maintenance is needed, but also prevents vandalism. 4. A design that provides greater visibility to drivers and will not harm a vehicle or its passengers in the event of a collision. This solar powered highway delineator consists of an adjustable solar array, a light fixture, and a standard delineator pole. The solar array houses and protects the solar panels, and can be easily adjusted to obtain a maximum amount of sunlight. The light fixture primarily houses the battery, the circuit and the light assembly. Both components allow for easy accessibility and reduce vandalism using internal connections for bolts and wires. The delineator mounting pole is designed to extensively deform in the event of a collision, therefore reducing any harm caused to the vehicle and/or the passengers. The cost of a single prototype to be produced is approximately $70.00 excluding labor costs. However, these material and labor costs will be greatly reduced if a large number of delineators are produced. It is recommended that the Iowa Department of Transportation take full advantage of the research and development put into this delineator design. The principles used in creating this delineator can be used to provide an outline for drivers to follow, or on a larger scale, provide actual roadway lighting in areas where it was never before possible or economically feasible. In either event, the number of fatal accidents will be decreased due to the improved driver visibility in the evening.