Mental Health & Disabilities Workforce Workgroup, December 12, 2012

The Iowa 2012 General Assembly charged the Iowa Department of Public Health with creating a mental health and disabilities group to make workforce recommendations in support of services to Iowans (Senate File 2315, Division II, Section 24). The Department of Human Services Mental Health Redesign Initiative was already underway since 2010. Workforce supply is a critical element of service capacity. IDPH leadership reviewed the legislative language, conferred with DHS leadership, appointed the workforce, and began deliberations in fall 2012.

Children's Mental Health and Well-Being Work-group Final Report, December 15, 2015

The children's mental health and well-being work group was formed in response to legislative direction to facilitate a study and make recommendations regarding children's mental health and the systems that assist children and families in Iowa.

Audit report on Southern Hills Regional Mental Health for the year ended June 30, 2015

Audit report on Southern Hills Regional Mental Health for the year ended June 30, 2015

Iowa Mental Health and Disability Services Commission, January 2016

This Annual Report of the Iowa Mental Health and Disability Services Commission (the Commission) is being submitted pursuant to Iowa Code § 225C.6(1)(h). The report is organized in two sections: (1) an overview of the activities of the Commission during 2015, and (2) recommendations formulated by the Commission for changes in Iowa law.

A Continuous Span Aluminum Girder Concrete Deck Bridge - Part 2 of 2: Fatigue Tests of Aluminum Girders, Final Report, 1997

In 1957, the Iowa State Highway Commission, with financial assistance from the aluminum industry, constructed a 220-ft (67-m) long, four-span continuous, aluminum girder bridge to carry traffic on Clive Road (86th Street) over Interstate 80 near Des Moines, Iowa. The bridge had four, welded I-shape girders that were fabricated in pairs with welded diaphragms between an exterior and an interior girder. The interior diaphragms between the girder pairs were bolted to girder brackets. A composite, reinforced concrete deck served as the roadway surface. The bridge, which had performed successfully for about 35 years of service, was removed in the fall of 1993 to make way for an interchange at the same location. Prior to the bridge demolition, load tests were conducted to monitor girder and diaphragm bending strains and deflections in the northern end span. Fatigue testing of the aluminum girders that were removed from the end spans were conducted by applying constant-amplitude, cyclic loads. These tests established the fatigue strength of an existing, welded, flange-splice detail and added, welded, flange-cover plates and horizontal web plate attachment details. This part, Part 2, of the final report focuses on the fatigue tests of the aluminum girder sections that were removed from the bridge and on the analysis of the experimental data to establish the fatigue strength of full-size specimens. Seventeen fatigue fractures that were classified as Category E weld details developed in the seven girder test specimens. Linear regression analyses of the fatigue test results established both nominal and experimental stress-range versus load cycle relationships (SN curves) for the fatigue strength of fillet-welded connections. The nominal strength SN curve obtained by this research essentially matched the SN curve for Category E aluminum weldments given in the AASHTO LRFD specifications. All of the Category E fatigue fractures that developed in the girder test specimens satisfied the allowable SN relationship specified by the fatigue provisions of the Aluminum Association. The lower-bound strength line that was set at two standard deviations below the least squares regression line through the fatigue fracture data points related well with the Aluminum Association SN curve. The results from the experimental tests of this research have provided additional information regarding behavioral characteristics of full-size, aluminum members and have confirmed that aluminum has the strength properties needed for highway bridge girders.