295 resultados para Legal action


Relevância:

20.00% 20.00%

Publicador:

Resumo:

This report is prepared from data submitted by the Title IIIB providers and Area Agencies on Aging.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Agency performancce plan and action plan for the Iowa Civil Rights Commission

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This report is prepared from data submitted by the Title IIIB providers and Area Agencies on Aging.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The objectives of the project were to develop methodologies for (i) prediction and measurement of the magnitude of pressure which develops within pores of saturated porous materials upon freezing, (ii) determination of pore structure (pore size distribution) of porous materials; (iii) prediction and measurement of the rate with which pore ice grows; and (iv) prediction of frost susceptibility of porous materials with varying pore structures. As with all research endeavors solution of one problem leads to another one and this project was no exception. Emergence of new problems and the measures taken as the work progressed were discussed in progress reports submitted to the board. This final report will discuss only the conclusive finds and suggest measures to be taken for future investigations. The theory discussed in the proposal is not repeated in this report for the sake of brevity. However, the paper published as part of this project containing the theory is attached as Appendix I for the reader interested in the theory. In conformity with the objectives, this report consists of four parts. In accordance with the project contract two ice porosimeters were built and one will be delivered to the Iowa DOT after training of a DOT technician under the supervision of Mr. Wendell Dubberke with assistance from ISU researchers. During the training period debugging and further improvements in software will continue.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This project continues the research which addresses the numerous bridge problems on the Iowa secondary road system. It is a continuation (Phase 2) of Project HR-382, in which two replacement alternatives (Concept 1: Steel Beam Precast Units and Concept 2: Modification of the Benton County Beam-in-Slab Bridge) were investigated. In previous research for concept 1, a precast unit bridge was developed through laboratory testing. The steel-beam precast unit bridge requires the fabrication of precast double-tee (PCDT) units, each consisting of two steel beams connected by a reinforced concrete deck. The weight of each PCDT unit is minimized by limiting the deck thickness to 4 in., which permits the units to be constructed off-site and then transported to the bridge site. The number of units required is a function of the width of bridge desired. Once the PCDT units are connected, a cast-in-place reinforced concrete deck is cast over the PCDT units and the bridge railing attached. Since the steel beam PCDT unit bridge design is intended primarily for use on low-volume roads, used steel beams can be utilized for a significant cost savings. In previous research for concept 2, an alternate shear connector (ASC) was developed and subjected to static loading. In this investigation, the ASC was subjected to cyclic loading in both pushout specimens and composite beam tests. Based on these tests, the fatigue strength of the ASC was determined to be significantly greater than that required in typical low volume road single span bridges. Based upon the construction and service load testing, the steel-beam precast unit bridge was successfully shown to be a viable low volume road bridge alternative. The construction process utilized standard methods resulting in a simple system that can be completed with a limited staff. Results from the service load tests indicated adequate strength for all legal loads. An inspection of the bridge one year after its construction revealed no change in the bridge's performance. Each of the systems previously described are relatively easy to construct. Use of the ASC rather than the welded studs significantly simplified the work, equipment, and materials required to develop composite action between the steel beams and the concrete deck.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Retailer newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Retailer Newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Retailer Newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Retailer Newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Retailer Newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Retailer Newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Retailer Newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Retailer Newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Retailer Newsletter

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Iowa Lottery Action Special Edition Retailer Newsletter