Image quality assessment in digital mammography: part I. Technical characterization of the systems.

In many European countries, image quality for digital x-ray systems used in screening mammography is currently specified using a threshold-detail detectability method. This is a two-part study that proposes an alternative method based on calculated detectability for a model observer: the first part of the work presents a characterization of the systems. Eleven digital mammography systems were included in the study; four computed radiography (CR) systems, and a group of seven digital radiography (DR) detectors, composed of three amorphous selenium-based detectors, three caesium iodide scintillator systems and a silicon wafer-based photon counting system. The technical parameters assessed included the system response curve, detector uniformity error, pre-sampling modulation transfer function (MTF), normalized noise power spectrum (NNPS) and detective quantum efficiency (DQE). Approximate quantum noise limited exposure range was examined using a separation of noise sources based upon standard deviation. Noise separation showed that electronic noise was the dominant noise at low detector air kerma for three systems; the remaining systems showed quantum noise limited behaviour between 12.5 and 380 µGy. Greater variation in detector MTF was found for the DR group compared to the CR systems; MTF at 5 mm(-1) varied from 0.08 to 0.23 for the CR detectors against a range of 0.16-0.64 for the DR units. The needle CR detector had a higher MTF, lower NNPS and higher DQE at 5 mm(-1) than the powder CR phosphors. DQE at 5 mm(-1) ranged from 0.02 to 0.20 for the CR systems, while DQE at 5 mm(-1) for the DR group ranged from 0.04 to 0.41, indicating higher DQE for the DR detectors and needle CR system than for the powder CR phosphor systems. The technical evaluation section of the study showed that the digital mammography systems were well set up and exhibiting typical performance for the detector technology employed in the respective systems.

Performance comparison of an active matrix flat panel imager, computed radiography system, and a screen-film system at four standard radiation qualities.

Four standard radiation qualities (from RQA 3 to RQA 9) were used to compare the imaging performance of a computed radiography (CR) system (general purpose and high resolution phosphor plates of a Kodak CR 9000 system), a selenium-based direct flat panel detector (Kodak Direct View DR 9000), and a conventional screen-film system (Kodak T-MAT L/RA film with a 3M Trimax Regular screen of speed 400) in conventional radiography. Reference exposure levels were chosen according to the manufacturer's recommendations to be representative of clinical practice (exposure index of 1700 for digital systems and a film optical density of 1.4). With the exception of the RQA 3 beam quality, the exposure levels needed to produce a mean digital signal of 1700 were higher than those needed to obtain a mean film optical density of 1.4. In spite of intense developments in the field of digital detectors, screen-film systems are still very efficient detectors for most of the beam qualities used in radiology. An important outcome of this study is the behavior of the detective quantum efficiency of the digital radiography (DR) system as a function of beam energy. The practice of users to increase beam energy when switching from a screen-film system to a CR system, in order to improve the compromise between patient dose and image quality, might not be appropriate when switching from screen-film to selenium-based DR systems.

Evolutionary forces affect multigenomic arbuscular mycorhizal fungi : an experimental approach using Glomus intraradices

Abstract Arbuscular Mycorhizal Fungi (AMF) are important plant symbionts that can improve floristic diversity and ecosystem productivity. These important fungi are obligate biotrophs and form symbioses with roots of the majority of plant species, improving plant nutrient acquisition in exchange of photosynthates. AM fungi are successful both ecologically as they occupy a very large spectrum of environments as well as host range and evolutionarily, as this symbiosis is over 400 million years old. These fungi grow and reproduce clonally by hyphae and multinucleate spores. AMF are coenocytic and recent work has shown that they harbor genetically different nuclei and that AMF populations are genetically diverse. How AMF species diversity is maintained has been addressed theoretically and experimentally at the community level. Much less attention has been drawn to understand how genetic diversity is maintained within populations although closely related individuals are more likely to compete for the same resources and occupy similar niches. How infra-individual genetic diversity is shaped and maintained has received even less attention. In Chapter 2, we show that individuals from a field population may differ in their symbiotic efficiency under reduced phosphate availability: We show there is genetic variation in an AMF field population for fitness-related growth traits in response to different phosphate availability acid host species. Furthermore, AFLP fingerprints of the same individuals growing in contrasting environments diverged suggesting that the composition in nuclei of AMF is dynamical and affected by environmental factors. Thus environmental heterogeneity is likely to play an important role for the maintenance of genetic diversity at the population level. In Chapter 3 we show that single spores do not inherit necessarily the same genetic material. We have found genetic divergences using two different types of molecular marker, as well as phenotypic divergences among single spore lines. Our results stress the importance of considering these organisms as a multilevel hierarchical system and of better knowing their life cycle. They have important consequences for the understanding of AMF genetics, ecology and the development of commercial AMF inocculum. Résumé Les champignons endomycorhiziens arbusculaires (CEA) sont d'importants symbiontes pour les plantes, car ils augmentent la diversité et la productivité des écosystèmes. Ces importants symbiontes sont des biotrophes obligatoires et forment une symbiose avec la plupart des plantes terrestres. Ils améliorent l'acquisition de substances nutritives de leurs hôtes en échange de sucres obtenus par photosynthèse. Ces champignons ont un grand succès écologique, ils colonisent une grande rangée d'environnements ainsi que d'hôtes. Ils ont aussi un succès évolutif certain de part le fait que cette symbiose existe depuis plus de 400 millions d'années. Les CEA sont asexués et croissent clonalement en formant des hyphes et des spores multinuclées. Les CEA sont des coenocytes et des travaux de recherche récents ont montré qu'ils possèdent des noyaux génétiquement différents. D'autres travaux ont aussi révélé que les populations de CEA sont génétiquement diversifiées. Comment la diversité des CEA est maintenue a seulement été adressée par des études théoriques et expérimentalement au niveau des communautés. Très peu d'attention a été portée sur le maintien de la diversité génétique infra et inter populationnelle, or ce sont les individus les plus proches génétiquement qui vont entrer en compétition pour des ressources et niches similaires. La formation et le maintien de la diversité intra-individu des CEA a reçu très peu d'attention. Dans le chapitre 2, nous montrons que des individus CEA d'un même champ différent dans leur efficacité symbiotique lorsque la concentration en phosphoré est réduite. Nous montrons qu'il existe de la variance génétique dans une population de CEA provenant d'un même champ en réponse à différentes concentrations de phosphore, ainsi qu'en réponse à différentes espèces d'hôtes, et ceci pour des traits de croissance vraisemblablement liés au succès reproducteur. De plus grâce à des AFLP nous avons pu montrer que le génome de ces individus subissent des changements lorsqu'ils croissent dans des environnements contrastés. Ceci suggère que les noyaux génétiquement différents des CEA sont des entités dynamiques. Il est fort probable que l'hétérogénéité environnementale joue un rôle dans le maintien de la diversité génétique des populations de CEA. Dans le chapitre 3, nous montrons que toutes les spores d'un même mycélium parental de CEA ne reçoivent pas exactement le même contenu génétique. Nous avons mis en évidence des divergences entre des Lignées monosporales en utilisant deux types de marqueur moléculaires, ainsi que des différences phénotypiques. Nos résutats soulignent l'importance de considézer ces organismes comme dés systëmes hiérarchiques mufti-niveaux, ainsi que de mieux connaître leur cycle de vie. Nos résultats ont d'importantes conséquences pour la compréhension du système génétique des CEA, ainsi que de leur évolution, leur écológie, mais également des conséquences pour la production d' inoccultim commercial.

A comparison of the imaging characteristics of the new Kodak Hyper Speed G film with the current T-MAT G/RA film and the CR 9000 system.

Three standard radiation qualities (RQA 3, RQA 5 and RQA 9) and two screens, Kodak Lanex Regular and Insight Skeletal, were used to compare the imaging performance and dose requirements of the new Kodak Hyper Speed G and the current Kodak T-MAT G/RA medical x-ray films. The noise equivalent quanta (NEQ) and detective quantum efficiencies (DQE) of the four screen-film combinations were measured at three gross optical densities and compared with the characteristics for the Kodak CR 9000 system with GP (general purpose) and HR (high resolution) phosphor plates. The new Hyper Speed G film has double the intrinsic sensitivity of the T-MAT G/RA film and a higher contrast in the high optical density range for comparable exposure latitude. By providing both high sensitivity and high spatial resolution, the new film significantly improves the compromise between dose and image quality. As expected, the new film has a higher noise level and a lower signal-to-noise ratio than the standard film, although in the high frequency range this is compensated for by a better resolution, giving better DQE results--especially at high optical density. Both screen-film systems outperform the phosphor plates in terms of MTF and DQE for standard imaging conditions (Regular screen at RQA 5 and RQA 9 beam qualities). At low energy (RQA 3), the CR system has a comparable low-frequency DQE to screen-film systems when used with a fine screen at low and middle optical densities, and a superior low-frequency DQE at high optical density.