Antiepileptika bei Frauen im gebärfähigen Alter und in der Schwangerschaft : Vergleich der Fachinformationen in Deutschland und der Schweiz mit dem aktuellen Wissensstand [Antiepileptics in women of childbearing age and during pregnancy : Comparison of specialized information with the current state of knowledge in Germany and Switzerland].

BACKGROUND: Healthcare professionals regularly read the summary of product characteristics (SmPC) as one of the various sources of information on the risks of drug use in women of childbearing age and during pregnancy. The aim of this article is to present an overview of the teratogenic potential of various antiepileptic drugs and to compare these data with the information provided by the SmPCs. METHODS: A literature search on the teratogenic risks of 19 antiepileptic agents was conducted and the results were compared with the information on the use in women of childbearing age and during pregnancy provided by the SmPCs of 38 commercial products available in Switzerland and Germany. RESULTS: The teratogenic risk is discussed in all available SmPCs. Quantification of the risk for birth defects and the numbers of documented pregnancies are mostly missing. Reproductive safety information in SmPCs showed poor concordance with risk levels reported in the literature. Recommendations concerning the need to monitor plasma levels and possibly perform dose adjustments during pregnancy to prevent treatment failure were missing in five Swiss and two German SmPCs. DISCUSSION: The information regarding use in women of childbearing age and during pregnancy provided by the SmPCs is heterogeneous and poorly reflects the current state of knowledge. Regular updates of SmPCs are warranted in order for these documents to be of reliable use for health care professionals.

Characterizing emission and breathing-zone concentrations following exposure cases to fluororesin-based waterproofing spray mists.

Measurements and simulations were performed to assess workers' exposure to solvent vapors and aerosols during the waterproofing of a tiled surface. This investigation followed two recent incidents in the same company where workers experienced acute respiratory illness after spraying a stain-repellent resin containing fluorinated polymers on stone-tiled walls and floors. Because the waterproofing activity had been done for years at the tile company without encountering any exposure problems prior to these cases, it was strongly suspected that the incidents were linked to a recent change in the composition of the coating mixture. Experimental measurements and simulations indicated that the emission rate of particles smaller than 10 microm may be estimated at 0.66 mg/sec (SD 0.10) for the old resin and at 0.37 mg/sec (SD 0.04) for the new one. The measurement of the solvent emission rate from surfaces coated with the two resins indicated that shortly after spraying, the emission was in the range of 18 to 20 mg/sec x m2 and was similar for both products. Solvent and overspray emission rates were introduced in a two-zone compartment model. The results obtained in the near-field indicate significant exposure to overspray mist (7 and 34 mg/m3 for new resin) and solvent vapors (80 to 350 ppm for the new resin). It was also shown that the introduction of the new resin tended to significantly decrease the levels of solvents and particulates in the workers' breathing zone. These results strongly suggest that cases of acute respiratory illness are related to the specific toxicity of the fluorinated polymer itself. The fact that the same polymer is used in various commercial products raises concern regarding other possible occupational and domestic exposures.