The fixation of the cemented femoral component. Effects of stem stiffness, cement thickness and roughness of the cement-bone surface.

After cemented total hip arthroplasty (THA) there may be failure at either the cement-stem or the cement-bone interface. This results from the occurrence of abnormally high shear and compressive stresses within the cement and excessive relative micromovement. We therefore evaluated micromovement and stress at the cement-bone and cement-stem interfaces for a titanium and a chromium-cobalt stem. The behaviour of both implants was similar and no substantial differences were found in the size and distribution of micromovement on either interface with respect to the stiffness of the stem. Micromovement was minimal with a cement mantle 3 to 4 mm thick but then increased with greater thickness of the cement. Abnormally high micromovement occurred when the cement was thinner than 2 mm and the stem was made of titanium. The relative decrease in surface roughness augmented slipping but decreased debonding at the cement-bone interface. Shear stress at this site did not vary significantly for the different coefficients of cement-bone friction while compressive and hoop stresses within the cement increased slightly.

Spirometric alterations in workers in the chromium electroplating industry.

The spirometric values (VC, FeV1, FEF25-75%) were studied in 44 workers of 17 chromium electroplating plants. Urinary chromium was also measured. The dynamic values of spirometry are lower amongst the workers who have higher urinary chromium. The part that can be attributed to tobacco smoking is much lower than that of chromium. The workers dealing with chromium electroplating in poor conditions seem to be subjects at risk in developing obstructive respiratory syndrome. The hazard seems to be especially high in plants dealing with hard chromium plating.