Fat oxidation in nonobese and obese adolescents: effect of body composition and pubertal development.

OBJECTIVES: To measure postabsorptive fat oxidation (F(ox)) and to assess its association with body composition (lean body mass [LBM] and body fat mass [BFM]) and pubertal development. DESIGN: We studied 235 control (male/female ratio = 116/119; age [mean +/- SD]: 13.1 +/- 1.7 years; weight: 45.3 +/- 10.5 kg; LBM: 34.3 +/- 7.1 kg; BFM: 11.0 +/- 4.5 kg) and 159 obese (male/female ratio = 93/66; age: 12.9 +/- 2.1 years; weight: 76.2 +/- 19.1 kg; LBM: 47.4 +/- 10.9 kg; BFM: 28.8 +/- 9.2 kg) adolescents. Postabsorptive F(ox) was calculated from oxygen consumption, carbon dioxide production, and urinary nitrogen as measured by indirect calorimetry and Kjeldahl's method, respectively. Body composition was determined by anthropometry. RESULTS: Postabsorptive F(ox) (absolute value and percentage of resting metabolic rate) was significantly (p < 0.001) higher in the obese adolescents (76.7 +/- 26.3 gm/24 hours, 42.3% +/- 18.7%) than in the control subjects (40.0 +/- 26.3 gm/24 hours, 28.7% +/- 17.0%), even if adjusted for LBM. F(ox) corrected for BFM was similar in control and in obese children, but was significantly lower in girls compared with boys (control male subjects: 62.1 +/- 29.1 gm/24 hours, control female subjects: 51.6 +/- 28.4 gm/24 hours, obese male subjects: 57.3 +/- 29 gm/24 hour, obese female subjects: 45.0 +/- 28.4 gm/24 hours). BFM and LBM showed a significant positive correlation with F(ox). By stepwise regression analysis the most important determinant of F(ox) was BFM in obese and LBM in control children. There was a significant rise in F(ox) during puberty; however, it was mainly explained by changes in body composition. CONCLUSIONS: Obese adolescents have higher F(ox) rates than their normal-weight counterparts. Both LBM and fat mass are important determinants of F(ox).

Plant DNA barcodes and the influence of gene flow.

Success of species assignment using DNA barcodes has been shown to vary among plant lineages because of a wide range of different factors. In this study, we confirm the theoretical prediction that gene flow influences species assignment with simulations and a literature survey. We show that the genome experiencing the highest gene flow is, in the majority of the cases, the best suited for species delimitation. Our results clearly suggest that, for most angiosperm groups, plastid markers will not be the most appropriate for use as DNA barcodes. We therefore advocate shifting the focus from plastid to nuclear markers to achieve an overall higher success using DNA barcodes.

Ligand-dependent inhibition of CD1d-restricted NKT cell development in mice transgenic for the activating receptor Ly49D.

In addition to their CD1d-restricted T cell receptor (TCR), natural killer T (NKT) cells express various receptors normally associated with NK cells thought to act, in part, as modulators of TCR signaling. Immunoreceptor-tyrosine activation (ITAM) and inhibition (ITIM) motifs associated with NK receptors may augment or attenuate perceived TCR signals respectively, potentially influencing NKT cell development and function. ITIM-containing Ly49 family receptors expressed by NKT cells are proposed to play a role in their development and function. We have produced mice transgenic for the ITAM-associated Ly49D and ITIM-containing Ly49A receptors and their common ligand H2-Dd to determine the importance of these signaling interplays in NKT cell development. Ly49D/H2-Dd transgenic mice had selectively and severely reduced numbers of thymic and peripheral NKT cells, whereas both ligand and Ly49D transgenics had normal numbers of NKT cells. CD1d tetramer staining revealed a blockade of NKT cell development at an early precursor stage. Coexpression of a Ly49A transgene partially rescued NKT cell development in Ly49D/H2-Dd transgenics, presumably due to attenuation of ITAM signaling. Thus, Ly49D-induced ITAM signaling is incompatible with the early development of cells expressing semi-invariant CD1d-restricted TCRs and appropriately harmonized ITIM-ITAM signaling is likely to play an important role in the developmental program of NKT cells.

Accurate and efficient simulation of multiphase flow in a heterogeneous reservoir by using error estimate and control in the multiscale finite-volume framework

The multiscale finite-volume (MSFV) method is designed to reduce the computational cost of elliptic and parabolic problems with highly heterogeneous anisotropic coefficients. The reduction is achieved by splitting the original global problem into a set of local problems (with approximate local boundary conditions) coupled by a coarse global problem. It has been shown recently that the numerical errors in MSFV results can be reduced systematically with an iterative procedure that provides a conservative velocity field after any iteration step. The iterative MSFV (i-MSFV) method can be obtained with an improved (smoothed) multiscale solution to enhance the localization conditions, with a Krylov subspace method [e.g., the generalized-minimal-residual (GMRES) algorithm] preconditioned by the MSFV system, or with a combination of both. In a multiphase-flow system, a balance between accuracy and computational efficiency should be achieved by finding a minimum number of i-MSFV iterations (on pressure), which is necessary to achieve the desired accuracy in the saturation solution. In this work, we extend the i-MSFV method to sequential implicit simulation of time-dependent problems. To control the error of the coupled saturation/pressure system, we analyze the transport error caused by an approximate velocity field. We then propose an error-control strategy on the basis of the residual of the pressure equation. At the beginning of simulation, the pressure solution is iterated until a specified accuracy is achieved. To minimize the number of iterations in a multiphase-flow problem, the solution at the previous timestep is used to improve the localization assumption at the current timestep. Additional iterations are used only when the residual becomes larger than a specified threshold value. Numerical results show that only a few iterations on average are necessary to improve the MSFV results significantly, even for very challenging problems. Therefore, the proposed adaptive strategy yields efficient and accurate simulation of multiphase flow in heterogeneous porous media.

Properties of debris flow deposits and source materials compared: implications for debris flow characterization

In the Alps, debris flow deposits generally contain < 5% clay-size particles, and the role of the surface-charged < 2 mu m particles is often neglected, although these particles may have a significant impact on the rheological properties of the interstitial fluid. The objective of this study was to compare debris flow deposits and parent materials from two neighbouring catchments of the Swiss Alps, with special emphasis on the colloidal constituents. The catchments are small in area (4 km(2)), 2.5 km long, similar in morphology, but different in geology. The average slopes are 35-40%. The catchments were monitored for debris flow events and mapped for surface aspect and erosion activity. Debris flow deposits and parent materials were sampled, the clay and silt fractions extracted and the bulk density, < 2 mm fraction bulk density, particle size distribution, chemical composition, cation exchange capacity (CEC) and mineralogy analysed. The results show that the deposits are similar to the parent screes in terms of chemical composition, but differ in terms of: (i) particle size distribution; and (ii) mineralogy, reactivity and density of the < 2 mm fraction. In this fraction, compared with the parent materials the deposits show dense materials enriched in coarse monocrystalline particles, of which the smallest and more reactive particles were leached. The results suggest that deposit samples should not be considered as representative of source or flow materials, particularly with respect to their physical properties.

Detection and Characterization of Preferential Flow Paths in the Downstream Area of a Hazardous Landfill

We have used surface-based electrical resistivity tomography to detect and characterize preferential hydraulic pathways in the immediate downstream area of an abandoned, hazardous landfill. The landfill occupies the void left by a former gravel pit and its base is close to the groundwater table and lacking an engineered barrier. As such, this site is remarkably typical of many small- to medium-sized waste deposits throughout the densely populated and heavily industrialized foreland on both sides of the Alpine arc. Outflows of pollutants lastingly contaminated local drinking water supplies and necessitated a partial remediation in the form of a synthetic cover barrier, which is meant to prevent meteoric water from percolating through the waste before reaching the groundwater table. Any future additional isolation of the landfill in the form of lateral barriers thus requires adequate knowledge of potential preferential hydraulic pathways for outflowing contaminants. Our results, inferred from a suite of tomographically inverted surfaced-based electrical resistivity profiles oriented roughly perpendicular to the local hydraulic gradient, indicate that potential contaminant outflows would predominantly occur along an unexploited lateral extension of the original gravel deposit. This finds its expression as a distinct and laterally continuous high-resistivity anomaly in the resistivity tomograms. This interpretation is ground-truthed through a litholog from a nearby well. Since the probed glacio-fluvial deposits are largely devoid of mineralogical clay, the geometry of hydraulic and electrical pathways across the pore space of a given lithological unit can be assumed to be identical, which allows for an order-of-magnitude estimation of the overall permeability structure. These estimates indicate that the permeability of the imaged extension of the gravel body is at least two to three orders-of-magnitude higher than that of its finer-grained embedding matrix. This corroborates the preeminent role of the high-resistivity anomaly as a potential preferential flow path.

The role of epilepsy in early language development in a child with a congenital lesion in the right hemisphere

Early epilepsy is known to worsen the developmental prognosis of young children with a congenital focal brain lesion, but its direct role is often very difficult to delineate from the other variables. This requires prolonged periods of follow-up with simultaneous serial electrophysiological and developmental assessments which are rarely obtained. We studied a male infant with a right prenatal infarct in the territory of the right middle cerebral artery resulting in a left spastic hemiparesis, and an epileptic disorder (infantile spasms with transient right hemihypsarrhythmia and focal seizures) from the age of 7 months until the age of 4 years. Pregnancy and delivery were normal. A dissociated delay of early language acquisition affecting mainly comprehension without any autistic features was documented. This delay was much more severe than usually expected in children with early focal lesions, and its evolution, with catch-up to normal, was correlated with the active phase of the epilepsy. We postulate that the epilepsy specifically amplified a pattern of delayed language emergence, mainly affecting lexical comprehension, reported in children with early right hemisphere damage.