A statistical methodology for the comparison of blue gel pen inks analyzed by laser desorption/ionization mass spectrometry

A statistical methodology for the objective comparison of LDI-MS mass spectra of blue gel pen inks was evaluated. Thirty-three blue gel pen inks previously studied by RAMAN were analyzed directly on the paper using both positive and negative mode. The obtained mass spectra were first compared using relative areas of selected peaks using the Pearson correlation coefficient and the Euclidean distance. Intra-variability among results from one ink and inter-variability between results from different inks were compared in order to choose a differentiation threshold minimizing the rate of false negative (i.e. avoiding false differentiation of the inks). This yielded a discriminating power of up to 77% for analysis made in the negative mode. The whole mass spectra were then compared using the same methodology, allowing for a better DP in the negative mode of 92% using the Pearson correlation on standardized data. The positive mode results generally yielded a lower differential power (DP) than the negative mode due to a higher intra-variability compared to the inter-variability in the mass spectra of the ink samples.

High-precision satellite positioning system as a new tool to study the biomechanics of human locomotion.

New Global Positioning System (GPS) receivers allow now to measure a location on earth at high frequency (5Hz) with a centimetric precision using phase differential positioning method. We studied whether such technique was accurate enough to retrieve basic parameters of human locomotion. Eight subjects walked on an athletics track at four different imposed step frequencies (70-130steps/min) plus a run at free pace. Differential carrier phase localization between a fixed base station and the mobile antenna mounted on the walking person was calculated. In parallel, a triaxial accelerometer, attached to the low back, recorded body accelerations. The different parameters were averaged for 150 consecutive steps of each run for each subject (total of 6000 steps analyzed). We observed a perfect correlation between average step duration measured by accelerometer and by GPS (r=0.9998, N=40). Two important parameters for the calculation of the external work of walking were also analyzed, namely the vertical lift of the trunk and the velocity variation per step. For an average walking speed of 4.0km/h, average vertical lift and velocity variation were, respectively, 4.8cm and 0.60km/h. The average intra-individual step-to-step variability at a constant speed, which includes GPS errors and the biological gait style variation, were found to be 24. 5% (coefficient of variation) for vertical lift and 44.5% for velocity variation. It is concluded that GPS technique can provide useful biomechanical parameters for the analysis of an unlimited number of strides in an unconstrained free-living environment.

Processus de reconnaissance et d'identification de personnes décédées

Recognition and identification processes for deceased persons. Determining the identity of deceased persons is a routine task performed essentially by police departments and forensic experts. This thesis highlights the processes necessary for the proper and transparent determination of the civil identities of deceased persons. The identity of a person is defined as the establishment of a link between that person ("the source") and information pertaining to the same individual ("identifiers"). Various identity forms could emerge, depending on the nature of the identifiers. There are two distinct types of identity, namely civil identity and biological identity. The paper examines four processes: identification by witnesses (the recognition process) and comparisons of fingerprints, dental data and DNA profiles (the identification processes). During the recognition process, the memory function is examined and helps to clarify circumstances that may give rise to errors. To make the process more rigorous, a body presentation procedure is proposed to investigators. Before examining the other processes, three general concepts specific to forensic science are considered with regard to the identification of a deceased person, namely, matter divisibility (Inman and Rudin), transfer (Locard) and uniqueness (Kirk). These concepts can be applied to the task at hand, although some require a slightly broader scope of application. A cross comparison of common forensic fields and the identification of deceased persons reveals certain differences, including 1 - reverse positioning of the source (i.e. the source is not sought from traces, but rather the identifiers are obtained from the source); 2 - the need for civil identity determination in addition to the individualisation stage; and 3 - a more restricted population (closed set), rather than an open one. For fingerprints, dental and DNA data, intravariability and intervariability are examined, as well as changes in these post mortem (PM) identifiers. Ante-mortem identifiers (AM) are located and AM-PM comparisons made. For DNA, it has been shown that direct identifiers (taken from a person whose civil identity has been alleged) tend to lead to determining civil identity whereas indirect identifiers (obtained from a close relative) direct towards a determination of biological identity. For each process, a Bayesian model is presented which includes sources of uncertainty deemed to be relevant. The results of the different processes combine to structure and summarise an overall outcome and a methodology. The modelling of dental data presents a specific difficulty with respect to intravariability, which in itself is not quantifiable. The concept of "validity" is, therefore, suggested as a possible solution to the problem. Validity uses various parameters that have an acknowledged impact on teeth intravariability. In cases where identifying deceased persons proves to be extremely difficult due to the limited discrimination of certain procedures, the use of a Bayesian approach is of great value in bringing a transparent and synthetic value. RESUME : Titre: Processus de reconnaissance et d'identification de personnes décédées. L'individualisation de personnes décédées est une tâche courante partagée principalement par des services de police, des odontologues et des laboratoires de génétique. L'objectif de cette recherche est de présenter des processus pour déterminer valablement, avec une incertitude maîtrisée, les identités civiles de personnes décédées. La notion d'identité est examinée en premier lieu. L'identité d'une personne est définie comme l'établissement d'un lien entre cette personne et des informations la concernant. Les informations en question sont désignées par le terme d'identifiants. Deux formes distinctes d'identité sont retenues: l'identité civile et l'identité biologique. Quatre processus principaux sont examinés: celui du témoignage et ceux impliquant les comparaisons d'empreintes digitales, de données dentaires et de profils d'ADN. Concernant le processus de reconnaissance, le mode de fonctionnement de la mémoire est examiné, démarche qui permet de désigner les paramètres pouvant conduire à des erreurs. Dans le but d'apporter un cadre rigoureux à ce processus, une procédure de présentation d'un corps est proposée à l'intention des enquêteurs. Avant d'entreprendre l'examen des autres processus, les concepts généraux propres aux domaines forensiques sont examinés sous l'angle particulier de l'identification de personnes décédées: la divisibilité de la matière (Inman et Rudin), le transfert (Locard) et l'unicité (Kirk). Il est constaté que ces concepts peuvent être appliqués, certains nécessitant toutefois un léger élargissement de leurs principes. Une comparaison croisée entre les domaines forensiques habituels et l'identification de personnes décédées montre des différences telles qu'un positionnement inversé de la source (la source n'est plus à rechercher en partant de traces, mais ce sont des identifiants qui sont recherchés en partant de la source), la nécessité de devoir déterminer une identité civile en plus de procéder à une individualisation ou encore une population d'intérêt limitée plutôt qu'ouverte. Pour les empreintes digitales, les dents et l'ADN, l'intra puis l'inter-variabilité sont examinées, de même que leurs modifications post-mortem (PM), la localisation des identifiants ante-mortem (AM) et les comparaisons AM-PM. Pour l'ADN, il est démontré que les identifiants directs (provenant de la personne dont l'identité civile est supposée) tendent à déterminer une identité civile alors que les identifiants indirects (provenant d'un proche parent) tendent à déterminer une identité biologique. Puis une synthèse des résultats provenant des différents processus est réalisée grâce à des modélisations bayesiennes. Pour chaque processus, une modélisation est présentée, modélisation intégrant les paramètres reconnus comme pertinents. À ce stade, une difficulté apparaît: celle de quantifier l'intra-variabilité dentaire pour laquelle il n'existe pas de règle précise. La solution préconisée est celle d'intégrer un concept de validité qui intègre divers paramètres ayant un impact connu sur l'intra-variabilité. La possibilité de formuler une valeur de synthèse par l'approche bayesienne s'avère d'une aide précieuse dans des cas très difficiles pour lesquels chacun des processus est limité en termes de potentiel discriminant.

Spatial relational learning and memory abilities do not differ between men and women in a real-world, open-field environment

This study assesses gender differences in spatial and non-spatial relational learning and memory in adult humans behaving freely in a real-world, open-field environment. In Experiment 1, we tested the use of proximal landmarks as conditional cues allowing subjects to predict the location of rewards hidden in one of two sets of three distinct locations. Subjects were tested in two different conditions: (1) when local visual cues marked the potentially-rewarded locations, and (2) when no local visual cues marked the potentially-rewarded locations. We found that only 17 of 20 adults (8 males, 9 females) used the proximal landmarks to predict the locations of the rewards. Although females exhibited higher exploratory behavior at the beginning of testing, males and females discriminated the potentially-rewarded locations similarly when local visual cues were present. Interestingly, when the spatial and local information conflicted in predicting the reward locations, males considered both spatial and local information, whereas females ignored the spatial information. However, in the absence of local visual cues females discriminated the potentially-rewarded locations as well as males. In Experiment 2, subjects (9 males, 9 females) were tested with three asymmetrically-arranged rewarded locations, which were marked by local cues on alternate trials. Again, females discriminated the rewarded locations as well as males in the presence or absence of local cues. In sum, although particular aspects of task performance might differ between genders, we found no evidence that women have poorer allocentric spatial relational learning and memory abilities than men in a real-world, open-field environment.

A regional Industrial Symbiosis methodology and its implementation in Geneva, Switzerland

The Agenda 21 for the Geneva region is the results from a broad consultation process including all local actors. The article 12 stipulates that « the State facilitates possible synergies between economic activities in order to minimize their environmental impacts » thus opening the way for Industrial Ecology (IE) and Industrial Symbiosis (IS). An Advisory Board for Industrial Ecology and Industrial Symbiosis implementation was established in 2002 involving relevant government agencies. Regulatory and technical conditions for IS are studied in the Swiss context. Results reveal that the Swiss law on waste does not hinder by-product exchanges. Methodology and technical factors including geographic, qualitative, quantitative and economical aspects are detailed. The competition with waste operators in a highly developed recycling system is also tackled.The IS project develops an empirical and systematic method for detecting and implementing by-products synergies between industrial actors disseminated throughout the Geneva region. Database management tool for the treatment of input-output analysis data and GIS tools for detecting potentials industrial partners are constantly improved. Potential symbioses for 17 flows (including energy, water and material flows) are currently studied for implementation.

The dmf1/mid1 gene is essential for correct positioning of the division septum in fission yeast.

Little is known about the mechanisms that establish the position of the division plane in eukaryotic cells. Wild-type fission yeast cells divide by forming a septum in the middle of the cell at the end of mitosis. Dmf1 mutants complete mitosis and initiate septum formation, but the septa that form are positioned at random locations and angles in the cell, rather than in the middle. We have cloned the dmf1 gene as a suppressor of the cdc7-24 mutant. The dmf1 mutant is allelic with mid1. The gene encodes a novel protein containing a putative nuclear localization signal, and a carboxy-terminal PH domain. In wild-type cells, Dmf1p is nuclear during interphase, and relocates to form a medial ring at the cell cortex coincident with the onset of mitosis. This relocalization occurs before formation of the actin ring and is associated with increased phosphorylation of Dmf1p. The Dmf1p ring can be formed in the absence of an actin ring, but depends on some of the genes required for actin ring formation. When the septum is completed and the cells separate, Dmf1p staining is once again nuclear. These data implicate Dmf1p as an important element in assuring correct placement of the division septum in Schizosaccharomyces pombe cells.

Corporate responsibility in the postnational constellation : a multiple-case study

In my thesis I present the findings of a multiple-case study on the CSR approach of three multinational companies, applying Basu and Palazzo's (2008) CSR-character as a process model of sensemaking, Suchman's (1995) framework on legitimation strategies, and Habermas (1996) concept of deliberative democracy. The theoretical framework is based on the assumption of a postnational constellation (Habermas, 2001) which sends multinational companies onto a process of sensemaking (Weick, 1995) with regards to their responsibilities in a globalizing world. The major reason is that mainstream CSR-concepts are based on the assumption of a liberal market economy embedded in a nation state that do not fit the changing conditions for legitimation of corporate behavior in a globalizing world. For the purpose of this study, I primarily looked at two research questions: (i) How can the CSR approach of a multinational corporation be systematized empirically? (ii) What is the impact of the changing conditions in the postnational constellation on the CSR approach of the studied multinational corporations? For the analysis, I adopted a holistic approach (Patton, 1980), combining elements of a deductive and inductive theory building methodology (Eisenhardt, 1989b; Eisenhardt & Graebner, 2007; Glaser & Strauss, 1967; Van de Ven, 1992) and rigorous qualitative data analysis. Primary data was collected through 90 semi-structured interviews in two rounds with executives and managers in three multinational companies and their respective stakeholders. Raw data originating from interview tapes, field notes, and contact sheets was processed, stored, and managed using the software program QSR NVIVO 7. In the analysis, I applied qualitative methods to strengthen the interpretative part as well as quantitative methods to identify dominating dimensions and patterns. I found three different coping behaviors that provide insights into the corporate mindset. The results suggest that multinational corporations increasingly turn towards relational approaches of CSR to achieve moral legitimacy in formalized dialogical exchanges with their stakeholders since legitimacy can no longer be derived only from a national framework. I also looked at the degree to which they have reacted to the postnational constellation by the assumption of former state duties and the underlying reasoning. The findings indicate that CSR approaches become increasingly comprehensive through integrating political strategies that reflect the growing (self-) perception of multinational companies as political actors. Based on the results, I developed a model which relates the different dimensions of corporate responsibility to the discussion on deliberative democracy, global governance and social innovation to provide guidance for multinational companies in a postnational world. With my thesis, I contribute to management research by (i) delivering a comprehensive critique of the mainstream CSR-literature and (ii) filling the gap of thorough qualitative research on CSR in a globalizing world using the CSR-character as an empirical device, and (iii) to organizational studies by further advancing a deliberative view of the firm proposed by Scherer and Palazzo (2008).