Effect of substrate temperature on deposition rate of rf plasma-deposited hydrogenated amorphous silicon thin films

We present a study about the influence of substrate temperature on deposition rate of hydrogenated amorphous silicon thin films prepared by rf glow discharge decomposition of pure silane gas in a capacitively coupled plasma reactor. Two different behaviors are observed depending on deposition pressure conditions. At high pressure (30 Pa) the influence of substrate temperature on deposition rate is mainly through a modification of gas density, in such a way that the substrate temperature of deposition rate is similar to pressure dependence at constant temperature. On the contrary, at low pressure (3 Pa), a gas density effect cannot account for the observed increase of deposition rate as substrate temperature rises above 450 K with an activation energy of 1.1 kcal/mole. In accordance with laser‐induced fluorescence measurements reported in the literature, this rise has been ascribed to an increase of secondary electron emission from the growing film surface as a result of molecular hydrogen desorption.

Optimisation of doped microcrystalline silicon films deposited at very low temperatures by Hot-Wire CVD

In this paper we present new results on doped μc-Si:H thin films deposited by hot-wire chemical vapour deposition (HWCVD) in the very low temperature range (125-275°C). The doped layers were obtained by the addition of diborane or phosphine in the gas phase during deposition. The incorporation of boron and phosphorus in the films and their influence on the crystalline fraction are studied by secondary ion mass spectrometry and Raman spectroscopy, respectively. Good electrical transport properties were obtained in this deposition regime, with best dark conductivities of 2.6 and 9.8 S cm -1 for the p- and n-doped films, respectively. The effect of the hydrogen dilution and the layer thickness on the electrical properties are also studied. Some technological conclusions referred to cross contamination could be deduced from the nominally undoped samples obtained in the same chamber after p- and n-type heavily doped layers.

Investigation of defect formation and electronic transport in microcrystalline silicon deposited by hot-wire CVD

We have investigated doped and undoped layers of microcrystalline silicon prepared by hot-wire chemical vapour deposition optically, electrically and by means of transmission electron microscopy. Besides needle-like crystals grown perpendicular to the substrate's surface, all of the layers contained a noncrystalline phase with a volume fraction between 4% and 25%. A high oxygen content of several per cent in the porous phase was detected by electron energy loss spectrometry. Deep-level transient spectroscopy of the crystals suggests that the concentration of electrically active defects is less than 1% of the undoped background concentration of typically 10^17 cm -3. Frequency-dependent measurements of the conductance and capacitance perpendicular to the substrate surface showed that a hopping process takes place within the noncrystalline phase parallel to the conduction in the crystals. The parasitic contribution to the electrical circuit arising from the porous phase is believed to be an important loss mechanism in the output of a pin-structured photovoltaic solar cell deposited by hot-wire CVD.

Progress in single junction microcrystalline silicon solar cells deposited by Hot-Wire CVD

Hot-Wire Chemical Vapor Deposition has led to microcrystalline silicon solar cell efficiencies similar to those obtained with Plasma Enhanced CVD. The light-induced degradation behavior of microcrystalline silicon solar cells critically depends on the properties of their active layer. In the regime close to the transition to amorphous growth (around 60% of amorphous volume fraction), cells incorporating an intrinsic layer with slightly higher crystalline fraction and [220] preferential orientation are stable after more than 7000 h of AM1.5 light soaking. On the contrary, solar cells whose intrinsic layer has a slightly lower crystalline fraction and random or [111] preferential orientation exhibit clear light-induced degradation effects. A revision of the efficiencies of Hot-Wire deposited microcrystalline silicon solar cells is presented and the potential efficiency of this technology is also evaluated.

Energy policies for rural electrification: a social multi-criteria evaluation approach

In this article, a real-world case- study is presented with two general objectives: to give a clear and simple illustrative example of application of social multi-criteria evaluation (SMCE) in the field of rural renewable energy policies, and to help in understanding to what extent and under which circumstances solar energy is suitable for electrifying isolated farmhouses. In this sense, this study might offer public decision- makers some insight on the conditions that favour the diffusion of renewable energy, in order to help them to design more effective energy policies for rural communities.

Methodological note about the determination of key sectors in final energy consumption: a preliminary approach to the Spanish case

In this paper we analyze the determination of "key" sectors in the final energy consumption. We approach this issue from an input-output perspective and we design a methodology based on the elasticities of the demands of final energy consumption. As an exercise, we apply the proposed methodology to the Spanish economy. The analysis allows us to indicate the greater or lesser relevance of the different sectors in the consumption of final energy, pointing out which sectors deserve greater attention in the Spanish case and showing the implications for energy policy.

EU foreign policy towards Georgia: just for energy?

The paper analyses how the EU foreign policy towards Georgia changed after the Rose Revolution, reaching greater levels of involvement and assistance. It is argued that the pro-western and reformist new government in Georgia triggered a new orientation in the EU foreign policy towards the country based on a logic of appropriateness, that is EU´s values, in addition to energy interests. Comparative analysis in the Southern-Caucasus and other Eastern-European countries shows how reformist and pro-EU governments receive more EU support and assistance. This does not mean that material interest do not play an important role. However, the EU seems to be coherent with its values when regarding the European neighbourhood.

Characterisation of neutron spectra in mixed high energy fields in lineal accelerators: response functions validation

Actualment, la resposta de la majoria d’instrumentació operacional i dels dosímetres personals utilitzats en radioprotecció per a la dosimetria neutrònica és altament dependent de l’energia dels espectres neutrònics a analitzar, especialment amb camps neutrònics amb una important component intermitja. En conseqüència, la interpretació de les lectures d’aquests aparells es complicada si no es té un coneixement previ de la distribució espectral de la fluència neutrònica en els punts d’interès. El Grup de Física de les Radiacions de la Universitat Autònoma de Barcelona (GFR-UAB) ha desenvolupat en els últims anys un espectròmetre de neutrons basat en un Sistema d’Esferes Bonner (BSS) amb un contador proporcional d’3He com a detector actiu. Els principals avantatges dels espectròmetres de neutrons per BSS són: la seva resposta isotròpica, la possibilitat de discriminar la component neutrònica de la gamma en camps mixtos, i la seva alta sensibilitat neutrònica als nivells de dosi analitzats. Amb aquestes característiques, els espectròmetres neutrònics per BSS compleixen amb els estándards de les últimes recomanacions de la ICRP i poden ser utilitzats també en el camp de la dosimetria neutrònica per a la mesura de dosis en el rang d’energia que va dels tèrmics fins als 20 MeV, en nou ordres de magnitud. En el marc de la col•laboració entre el GFR - UAB i el Laboratorio Nazionale di Frascati – Istituto Nazionale di Fisica Nucleare (LNF-INFN), ha tingut lloc una experiència comparativa d’espectrometria per BSS amb els feixos quasi monoenergètics de 2.5 MeV i 14 MeV del Fast Neutron Generator de l’ENEA. En l’exercici s’ha determinat l’espectre neutrònic a diferents distàncies del blanc de l’accelerador, aprofitant el codi FRUIT recentment desenvolupat pel grup LNF. Els resultats obtinguts mostren una bona coherència entre els dos espectròmetres i les dades mesurades i simulades.

An application of MSIASM to Chinese exosomatic energy metabolism

The methodology of Multi-Scale Integrated The methodology of Multi-Scale Integrated Analysis of Societal Metabolism (MSIASM) is applied to analyze the Chinese economy. This paper presents four tasks: (i) identifying a set of benchmarks that makes it possible to compare various characteristics of the Chinese economy with those of other country groups and the world (level) average; (ii) explaining the differences over the selected set of benchmarks, by looking at the characteristics of the various sub-sectors of the Chinese economy; (iii) understanding existing trends and future feasible future development paths for China by studying the existence of reciprocal constraints between the whole economy and its sub-sectors; and (iv) examining plausible future scenarios of development.

Different trajectories of exosomatic energy metabolism for Brazil, Chile and Venezuela: using the MSIASM approach

Economic development goes hand in hand with an increase in the consumption of natural resources. Some analysts use material flows to describe such relationship [Eurostat 2001, Weisz et al., 2006], or exergy [Ayres et al., 2003]. Instead this paper will use a characterisation of the exosomatic energy metabolism based on expected benchmark values to describe possible constraints to economic development posed by available human time and energy. The aim of the paper is to identify types of exosomatic energy metabolism of different societies to interpret its consequences for economic development. This is done with the application of the accounting methodology called Multi-Scale Integrated Analysis of Societal Metabolism (MSIASM) to the particular case of energy metabolism for the analysis of the economies of Brazil, Chile and Venezuela.

Economic impact of alternative policy measures implemented on the energy activities of the Catalan production system: an input-output analysis

The aim of the paper is to analyse the economic impact of alternative policies implemented on the energy activities of the Catalan production system. Specifically, we analyse the effects of a tax on intermediate energy uses, a reduction in the final production of energy, and a reduction in intermediate energy uses. The methodology involves two versions of the input-output price model: a competitive price formulation and a mark-up price formulation. The input-output price framework will make it possible to evaluate how the alternative measures modify production prices, consumption prices, private welfare, and intermediate energy uses. The empirical application is for the Catalan economy and uses economic data for the year 2001.

Why Catalonia will see its energy metabolism increase in the near future: an application of MuSIASEM

This paper applies the so-called Multi-Scale Integrated Analysis of Societal and Ecosystem Metabolism (MuSIASEM) to the economy of the Spanish region of Catalonia. By applying Georgescu-Roegen's fund-flow model, it arrives at the conclusion that within a context of the end of cheap oil, the current development model based on the growth of low productivity sectors such as services and construction must change. The change is needed not only because of the increasing scarcity of affordable energy carriers, or because of the increasing environmental impact that the present development represents, but also because of an ageing population that demands labour productivity gains. This will imply industry requiring more energy consumption per worker in order to increase its productivity, and therefore its competitiveness. Thus, we conclude that energy intensity, and exosomatic energy metabolism of Catalonia will increase dramatically in the near future unless major conservation efforts are implemented in both the household and transport sectors.

Development of advanced silicon radiation detectors for high energy physics and medical imaging

The 1st chapter of this work presents the different experiments and collaborations in which I am involved during my PhD studies of Physics. Following those descriptions, the 2nd chapter is dedicated to how the radiation affects the silicon sensors, as well as some experimental measurements carried out at CERN (Geneve, Schwitzerland) and IFIC (Valencia, Spain) laboratories. Besides the previous investigation results, this chapter includes the most recent scientific papers appeared in the latest RD50 (Research & Development #50) Status Report, published in January 2007, as well as some others published this year. The 3rd and 4th are dedicated to the simulation of the electrical behavior of solid state detectors. In chapter 3 are reported the results obtained for the illumination of edgeless detectors irradiated at different fluences, in the framework of the TOSTER Collaboration. The 4th chapter reports about simulation design, simulation and fabrication of a novel 3D detector developed at CNM for ions detection in the future ITER fusion reactor. This chapter will be extended with irradiation simulations and experimental measurements in my PhD Thesis.

A first attempt of geographically-distributed Multi-scale integrated analysis of societal and ecosystem metabolism (MuSIASEM): mapping human time and energy throughput in metropolitan Barcelona

This study presents a first attempt to extend the “Multi-scale integrated analysis of societal and ecosystem metabolism (MuSIASEM)” approach to a spatial dimension using GIS techniques in the Metropolitan area of Barcelona. We use a combination of census and commercial databases along with a detailed land cover map to create a layer of Common Geographic Units that we populate with the local values of human time spent in different activities according to MuSIASEM hierarchical typology. In this way, we mapped the hours of available human time, in regards to the working hours spent in different locations, putting in evidence the gradients in spatial density between the residential location of workers (generating the work supply) and the places where the working hours are actually taking place. We found a strong three-modal pattern of clumps of areas with different combinations of values of time spent on household activities and on paid work. We also measured and mapped spatial segregation between these two activities and put forward the conjecture that this segregation increases with higher energy throughput, as the size of the functional units must be able to cope with the flow of exosomatic energy. Finally, we discuss the effectiveness of the approach by comparing our geographic representation of exosomatic throughput to the one issued from conventional methods.

Assessing the quality of alternative energy sources: Energy Return On the Investment (EROI), the metabolic pattern of societies and energy statistics

This paper presents an initial challenge to tackle the every so "tricky" points encountered when dealing with energy accounting, and thereafter illustrates how such a system of accounting can be used when assessing for the metabolic changes in societies. The paper is divided in four main sections. The first three, present a general discussion on the main issues encountered when conducting energy analyses. The last section, subsequently, combines this heuristic approach to the actual formalization of it, in quantitative terms, for the analysis of possible energy scenarios. Section one covers the broader issue of how to account for the relevant categories used when accounting for Joules of energy; emphasizing on the clear distinction between Primary Energy Sources (PES) (which are the physical exploited entities that are used to derive useable energy forms (energy carriers)) and Energy Carriers (EC) (the actual useful energy that is transmitted for the appropriate end uses within a society). Section two sheds light on the concept of Energy Return on Investment (EROI). Here, it is emphasized that, there must already be a certain amount of energy carriers available to be able to extract/exploit Primary Energy Sources to thereafter generate a net supply of energy carriers. It is pointed out that this current trend of intense energy supply has only been possible to the great use and dependence on fossil energy. Section three follows up on the discussion of EROI, indicating that a single numeric indicator such as an output/input ratio is not sufficient in assessing for the performance of energetic systems. Rather an integrated approach that incorporates (i) how big the net supply of Joules of EC can be, given an amount of extracted PES (the external constraints); (ii) how much EC needs to be invested to extract an amount of PES; and (iii) the power level that it takes for both processes to succeed, is underlined. Section four, ultimately, puts the theoretical concepts at play, assessing for how the metabolic performances of societies can be accounted for within this analytical framework.