9 resultados para discharge
em Consorci de Serveis Universitaris de Catalunya (CSUC), Spain
Resumo:
Thin films of hydrogenated amorphous silicon (a‐Si:H), deposited by square wave modulated (SQWM) rf silane discharges, have been studied through spectroscopic and real time phase modulated ellipsometry. The SQMW films obtained at low mean rf power density (19 mW/cm2) have shown smaller surface roughness than those obtained in standard continuous wave (cw) rf discharges. At higher rf powers (≥56 mW/cm2), different behaviors depending on the modulating frequency have been observed. On the one hand, at low modulating frequencies (<40 Hz), the SQWM films have shown a significant increase of porosity and surface roughness as compared to cw samples. On the other, at higher modulating frequencies, the material density and roughness have been found to be similar in SQWM and cw films. Furthermore, the deposition rate of the films show more pronounced increases with the modulating frequency as the rf power is increased. Experimental results are discussed in terms of plasma negative charged species which can be relatively abundant in high rf power discharges and cause significant effects on the deposited layers through polymers, clusters, and powder formation.
Resumo:
Thin films of nanostructured silicon (ns-Si:H) were deposited by plasma-enhanced chemical vapor deposition in the presence of silicon nanoparticles at 100 C substrate temperature using silane and hydrogen gas mixture under continuous wave (cw) plasma conditions. The nanostructure of the films has been demonstrated by diverse ways: transmission electron microscopy, Raman spectroscopy and x-ray diffraction, which have shown the presence of ordered silicon clusters (1!=2 nm) embedded in an amorphous silicon matrix. Due to the presence of these ordered domains, the films crystallize faster than standard hydrogenated amorphous silicon samples, as evidenced by electrical measurements during the thermal annealing.
Resumo:
Spherical carbon coated iron particles of nanometric diameter in the 510 nm range have been produced by arc discharge at near-atmospheric pressure conditions (using 58·10 4 Pa of He). The particles exhibit a crystalline dense iron core with an average diameter 7.4 ± 2.0 nm surrounded by a sealed carbon shell, shown by transmission electron microscopy (TEM), selected-area diffrac- tion (SAED), energy-dispersive X-ray analysis (STEM-EDX) and electron energy loss spectroscopy (EELS). The SAED, EDX and EELS results indicate a lack of traces of core oxidized phases showing an efficient protection role of the carbon shell. The magnetic properties of the nanoparticles have been investigated in the 5300 K temperature range using a superconducting quantum interference device (SQUID). The results reveal a superparamagnetic behaviour with an average monodomain diameter of 7.6 nm of the nanoparticles. The zero field cooled and field cooled (ZFC-FC)magnetization curves show a blocking temperature (TB)at room temperature very suitable for biomedical applications (drug delivery, magnetic resonance imaging MRI, hyperthermia).
Resumo:
Background: The aim of this study was to evaluate how hospital capacity was managed focusing on standardizing the admission and discharge processes. Methods: This study was set in a 900-bed university affiliated hospital of the National Health Service, near Barcelona (Spain). This is a cross-sectional study of a set of interventions which were gradually implemented between April and December 2008. Mainly, they were focused on standardizing the admission and discharge processes to improve patient flow. Primary administrative data was obtained from the 2007 and 2009 Hospital Database. Main outcome measures were median length of stay, percentage of planned discharges, number of surgery cancellations and median number of delayed emergency admissions at 8:00 am. For statistical bivariate analysis, we used a Chi-squared for linear trend for qualitative variables and a Wilcoxon signed ranks test and a Mann–Whitney test for non-normal continuous variables. Results: The median patients’ global length of stay was 8.56 days in 2007 and 7.93 days in 2009 (p<0.051). The percentage of patients admitted the same day as surgery increased from 64.87% in 2007 to 86.01% in 2009 (p<0.05). The number of cancelled interventions due to lack of beds was 216 patients in 2007 and 42 patients in 2009. The median number of planned discharges went from 43.05% in 2007 to 86.01% in 2009 (p<0.01). The median number of emergency patients waiting for an in-hospital bed at 8:00 am was 5 patients in 2007 and 3 patients in 2009 (p<0.01). Conclusions: In conclusion, standardization of admission and discharge processes are largely in our control. There is a significant opportunity to create important benefits for increasing bed capacity and hospital throughput.
Resumo:
Background: The aim of this study was to evaluate how hospital capacity was managed focusing on standardizing the admission and discharge processes. Methods: This study was set in a 900-bed university affiliated hospital of the National Health Service, near Barcelona (Spain). This is a cross-sectional study of a set of interventions which were gradually implemented between April and December 2008. Mainly, they were focused on standardizing the admission and discharge processes to improve patient flow. Primary administrative data was obtained from the 2007 and 2009 Hospital Database. Main outcome measures were median length of stay, percentage of planned discharges, number of surgery cancellations and median number of delayed emergency admissions at 8:00¿am. For statistical bivariate analysis, we used a Chi-squared for linear trend for qualitative variables and a Wilcoxon signed ranks test and a Mann¿Whitney test for non-normal continuous variables. Results:The median patients' global length of stay was 8.56 days in 2007 and 7.93 days in 2009 (p<0.051). The percentage of patients admitted the same day as surgery increased from 64.87% in 2007 to 86.01% in 2009 (p<0.05). The number of cancelled interventions due to lack of beds was 216 patients in 2007 and 42 patients in 2009. The median number of planned discharges went from 43.05% in 2007 to 86.01% in 2009 (p<0.01). The median number of emergency patients waiting for an in-hospital bed at 8:00¿am was 5 patients in 2007 and 3 patients in 2009 (p<0.01). Conclusions: In conclusion, standardization of admission and discharge processes are largely in our control. There is a significant opportunity to create important benefits for increasing bed capacity and hospital throughput.
Resumo:
Background and objective: We aimed to identify the frequency of, reasons for and risk factors associated with additional healthcare visits and rehospitalizations (healthcare interactions) by patients with community-acquired pneumonia (CAP) within 30 days of hospital discharge. Methods: Observational analysis of a prospective cohort of adults hospitalized with CAP at a tertiary hospital (2007-2009). Additional healthcare interactions were defined as the visits to a primary care centre or emergency department and hospital readmissions within 30 days of discharge. Results: Of the 934 hospitalized patients with CAP, 282 (34.1%) had additional healthcare interactions within 30 days of hospital discharge: 149 (52.8%) needed an additional visit to their primary care centre and 177 (62.8%) attended the emergency department. Seventy-two (25.5%) patients were readmitted to hospital. The main reasons for additional healthcare interactions were worsening of signs or symptoms of CAP and new or worsening comorbid conditions independent of pneumonia, mainly cardiovascular and pulmonary diseases. The only independent factor associated with visits to primary care centre or emergency department was alcohol abuse (odds ratio [OR] = 1.65; 95% confidence interval [CI]: 1.03-2.64). Prior hospitalization (≤ 90 days) (OR = 2.47; 95% CI: 1.11-5.52) and comorbidities (OR = 3.99; 95% CI: 1.12-14.23) were independently associated with rehospitalization. Conclusions: Additional healthcare visits and rehospitalizations within 30 days of hospital discharge are common in patients with CAP. This is mainly due to a worsening of signs or symptoms of CAP and/or comorbid conditions. These findings may have implications for discharge planning and follow-up of patients with CAP.
Resumo:
Background and objective: We aimed to identify the frequency of, reasons for and risk factors associated with additional healthcare visits and rehospitalizations (healthcare interactions) by patients with community-acquired pneumonia (CAP) within 30 days of hospital discharge. Methods: Observational analysis of a prospective cohort of adults hospitalized with CAP at a tertiary hospital (2007-2009). Additional healthcare interactions were defined as the visits to a primary care centre or emergency department and hospital readmissions within 30 days of discharge. Results: Of the 934 hospitalized patients with CAP, 282 (34.1%) had additional healthcare interactions within 30 days of hospital discharge: 149 (52.8%) needed an additional visit to their primary care centre and 177 (62.8%) attended the emergency department. Seventy-two (25.5%) patients were readmitted to hospital. The main reasons for additional healthcare interactions were worsening of signs or symptoms of CAP and new or worsening comorbid conditions independent of pneumonia, mainly cardiovascular and pulmonary diseases. The only independent factor associated with visits to primary care centre or emergency department was alcohol abuse (odds ratio [OR] = 1.65; 95% confidence interval [CI]: 1.03-2.64). Prior hospitalization (≤ 90 days) (OR = 2.47; 95% CI: 1.11-5.52) and comorbidities (OR = 3.99; 95% CI: 1.12-14.23) were independently associated with rehospitalization. Conclusions: Additional healthcare visits and rehospitalizations within 30 days of hospital discharge are common in patients with CAP. This is mainly due to a worsening of signs or symptoms of CAP and/or comorbid conditions. These findings may have implications for discharge planning and follow-up of patients with CAP.
Resumo:
Background and objective: We aimed to identify the frequency of, reasons for and risk factors associated with additional healthcare visits and rehospitalizations (healthcare interactions) by patients with community-acquired pneumonia (CAP) within 30 days of hospital discharge. Methods: Observational analysis of a prospective cohort of adults hospitalized with CAP at a tertiary hospital (2007-2009). Additional healthcare interactions were defined as the visits to a primary care centre or emergency department and hospital readmissions within 30 days of discharge. Results: Of the 934 hospitalized patients with CAP, 282 (34.1%) had additional healthcare interactions within 30 days of hospital discharge: 149 (52.8%) needed an additional visit to their primary care centre and 177 (62.8%) attended the emergency department. Seventy-two (25.5%) patients were readmitted to hospital. The main reasons for additional healthcare interactions were worsening of signs or symptoms of CAP and new or worsening comorbid conditions independent of pneumonia, mainly cardiovascular and pulmonary diseases. The only independent factor associated with visits to primary care centre or emergency department was alcohol abuse (odds ratio [OR] = 1.65; 95% confidence interval [CI]: 1.03-2.64). Prior hospitalization (≤ 90 days) (OR = 2.47; 95% CI: 1.11-5.52) and comorbidities (OR = 3.99; 95% CI: 1.12-14.23) were independently associated with rehospitalization. Conclusions: Additional healthcare visits and rehospitalizations within 30 days of hospital discharge are common in patients with CAP. This is mainly due to a worsening of signs or symptoms of CAP and/or comorbid conditions. These findings may have implications for discharge planning and follow-up of patients with CAP.
Resumo:
Spherical carbon coated iron particles of nanometric diameter in the 5-10 nm range have been produced by arc discharge at near-atmospheric pressure conditions (using 5-8·10 4 Pa of He). The particles exhibit a crystalline dense iron core with an average diameter 7.4 ± 2.0 nm surrounded by a sealed carbon shell, shown by transmission electron microscopy (TEM), selected-area diffrac- tion (SAED), energy-dispersive X-ray analysis (STEM-EDX) and electron energy loss spectroscopy (EELS). The SAED, EDX and EELS results indicate a lack of traces of core oxidized phases showing an efficient protection role of the carbon shell. The magnetic properties of the nanoparticles have been investigated in the 5-300 K temperature range using a superconducting quantum interference device (SQUID). The results reveal a superparamagnetic behaviour with an average monodomain diameter of 7.6 nm of the nanoparticles. The zero field cooled and field cooled (ZFC-FC)magnetization curves show a blocking temperature (TB)at room temperature very suitable for biomedical applications (drug delivery, magnetic resonance imaging-MRI-, hyperthermia).