On wideband deconvolution using wavelet transform

A discussion on the expression proposed in [1]–[3]for deconvolving the wideband density function is presented. Weprove here that such an expression reduces to be proportionalto the wideband correlation receiver output, or continuous wavelettransform of the received signal with respect to the transmittedone. Moreover, we show that the same result has been implicitlyassumed in [1], when the deconvolution equation is derived. Westress the fact that the analyzed approach is just the orthogonalprojection of the density function onto the image of the wavelettransform with respect to the transmitted signal. Consequently,the approach can be considered a good representation of thedensity function only under the prior knowledge that the densityfunction belongs to such a subspace. The choice of the transmittedsignal is thus crucial to this approach.

Design of Novel Frequency Generation Circuit with Application to Ultra-Wideband Distributed Oscillators

Given the urgence of a new paradigm in wireless digital trasmission which should allow for higher bit rate, lower latency and tigher delay constaints, it has been proposed to investigate the fundamental building blocks that at the circuital/device level, will boost the change towards a more efficient network architecture, with high capacity, higher bandwidth and a more satisfactory end user experience. At the core of each transciever, there are inherently analog devices capable of providing the carrier signal, the oscillators. It is strongly believed that many limitations in today's communication protocols, could be relieved by permitting high carrier frequency radio transmission, and having some degree of reconfigurability. This led us to studying distributed oscillator architectures which work in the microwave range and possess wideband tuning capability. As microvave oscillators are essentially nonlinear devices, a full nonlinear analyis, synthesis, and optimization had to be considered for their implementation. Consequently, all the most used nonlinear numerical techniques in commercial EDA software had been reviewed. An application of all the aforementioned techniques has been shown, considering a systems of three coupled oscillator ("triple push" oscillator) in which the stability of the various oscillating modes has been studied. Provided that a certain phase distribution is maintained among the oscillating elements, this topology permits a rise in the output power of the third harmonic; nevertheless due to circuit simmetry, "unwanted" oscillating modes coexist with the intenteded one. Starting with the necessary background on distributed amplification and distributed oscillator theory, the design of a four stage reverse mode distributed voltage controlled oscillator (DVCO) using lumped elments has been presented. All the design steps have been reported and for the first time a method for an optimized design with reduced variations in the output power has been presented. Ongoing work is devoted to model a wideband DVCO and to implement a frequency divider.

Non-peaky signals in wideband fading channels: achievable bit rates and optimal bandwidth

In the context of fading channels it is well established that, with a constrained transmit power, the bit rates achievable by signals that are not peaky vanish as the bandwidth grows without bound. Stepping back from the limit, we characterize the highest bit rate achievable by such non-peaky signals and the approximate bandwidth where that apex occurs. As it turns out, the gap between the highest rate achievable without peakedness and the infinite-bandwidth capacity (with unconstrained peakedness) is small for virtually all settings of interest to wireless communications. Thus, although strictly achieving capacity in wideband fading channels does require signal peakedness, bit rates not far from capacity can be achieved with conventional signaling formats that do not exhibit the serious practical drawbacks associated with peakedness. In addition, we show that the asymptotic decay of bit rate in the absence of peakedness usually takes hold at bandwidths so large that wideband fading models are called into question. Rather, ultrawideband models ought to be used.

Bit loading for MIMO with statistical channel information at the transmitter and ZF receivers

For single-user MIMO communication with uncoded and coded QAM signals, we propose bit and power loading schemes that rely only on channel distribution information at the transmitter. To that end, we develop the relationship between the average bit error probability at the output of a ZF linear receiver and the bit rates and powers allocated at the transmitter. This relationship, and the fact that a ZF receiver decouples the MIMO parallel channels, allow leveraging bit loading algorithms already existing in the literature. We solve dual bit rate maximization and power minimization problems and present performance resultsthat illustrate the gains of the proposed scheme with respect toa non-optimized transmission.

Wideband dual sphere detector of gravitational waves

We present the concept of a sensitive and broadband resonant mass gravitational wave detector. A massive sphere is suspended inside a second hollow one. Short, high-finesse Fabry-Perot optical cavities read out the differential displacements of the two spheres as their quadrupole modes are excited. At cryogenic temperatures, one approaches the standard quantum limit for broadband operation with reasonable choices for the cavity finesses and the intracavity light power. A molybdenum detector, of overall size of 2 m, would reach spectral strain sensitivities of 2x10-23Hz-1/2 between 1000 and 3000 Hz.

Joint array combining and MLSE for single-user receivers in multipath Gaussian multiuser channels

The well-known structure of an array combiner along with a maximum likelihood sequence estimator (MLSE) receiveris the basis for the derivation of a space-time processor presentinggood properties in terms of co-channel and intersymbol interferencerejection. The use of spatial diversity at the receiver front-endtogether with a scalar MLSE implies a joint design of the spatialcombiner and the impulse response for the sequence detector. Thisis faced using the MMSE criterion under the constraint that thedesired user signal power is not cancelled, yielding an impulse responsefor the sequence detector that is matched to the channel andcombiner response. The procedure maximizes the signal-to-noiseratio at the input of the detector and exhibits excellent performancein realistic multipath channels.

ML estimator and hybrid beamformer for multipath and interference mitigation in GNSS receivers

This paper addresses the estimation of the code-phase(pseudorange) and the carrier-phase of the direct signal received from a direct-sequence spread-spectrum satellite transmitter. Thesignal is received by an antenna array in a scenario with interferenceand multipath propagation. These two effects are generallythe limiting error sources in most high-precision positioning applications.A new estimator of the code- and carrier-phases is derivedby using a simplified signal model and the maximum likelihood(ML) principle. The simplified model consists essentially ofgathering all signals, except for the direct one, in a component withunknown spatial correlation. The estimator exploits the knowledgeof the direction-of-arrival of the direct signal and is much simplerthan other estimators derived under more detailed signal models.Moreover, we present an iterative algorithm, that is adequate for apractical implementation and explores an interesting link betweenthe ML estimator and a hybrid beamformer. The mean squarederror and bias of the new estimator are computed for a numberof scenarios and compared with those of other methods. The presentedestimator and the hybrid beamforming outperform the existingtechniques of comparable complexity and attains, in manysituations, the Cramér–Rao lower bound of the problem at hand.

Space-time front-ends for RAKE receivers in the FDD mode of UTRA

A unified and general vision of different space-time processors is presented. Many popular receivers can beaccomodated, like V-RAKE receivers, weighted V-RAKE, or spatial narrowband beamforming. By makingappropriate assumptions on the space/time characteristic of the interference it is possible to enhance theperformance of the receiver through spatial/temporal pre-processors. These receivers will be tested in the FDDmode of UTRA.

Retribution in a cheap-talk experiment

We use a two-person 3-stage game to investigate whether people choose to punish or reward another player by sacrificing money to increase or decrease the other person’s payoff. One player sends a message indicating an intended play, which is either favorable or unfavorable to the other player in the game. After the message, the sender and the receiver play a simultaneous 2x2 game. A deceptive message may be made, in an effort to induce the receiver to make a play favorable to the sender. Our focus is on whether receivers’ rates of monetary sacrifice depend on the process and the perceived sender’s intention, as is suggested by the literature on deception and procedural satisfaction. Models such as Rabin (1993), Sen (1997), and Charness and Rabin (1999) also permit rates of sacrifice to be sensitive to the sender’s perceived intention, while outcome-based models such as Fehr and Schmidt (1999) and Bolton and Ockenfels (1997) predict otherwise. We find that deception substantially increases the punishment rate as a response to an action that is unfavorable to the receiver. We also find that a small but significant percentage of subjects choose to reward a favorable action choice made by the sender.

Spillovers and growth in a local interaction model

In this paper we aim at studying to what extent spillovers between firms may foster economic growth. The attention is addressed to the spillovers connected with the R&D activity that improves the quality of the goods firms supply. Our model develops a growth theory framework and we assume that firms spread around a circle. Our study assesses that spillovers between neighbors affect the probability of successful research for each of them. In particular, spillovers are the forces fuelling growth when, on the whole, firms turn out to be net receivers with respect to their neighbors.

Diseño del subsistema RF para el receptor SAR biestático en banda-C SABRINA

Este proyecto tiene como objetivo diseñar un nuevo receptor SAR biestático para el sistema SABRINA (SAR Bistatic fixed Receiver for INterferometric Applications) caracterizando el sistema que ya existía. El nuevo dispositivo deberá cumplir con las características y requisitos del escenario teniendo en cuenta la potencia recibida y el ruido de cuantificación de la tarjeta digitalizadora. Con este fin se introducen previamente conocimientos de teoría RADAR y SAR. Además, se deberá compactar al máximo el sistema para conseguir un receptor autocontenido que facilite su traslado. Para tal fin se ha incorporado a la caja del receptor un sintetizador programable que actúa de oscilador local de las cadenas de recepción y una fuente de alimentación que provee la tensión a todos los componentes activos del dispositivo. Por otra parte el proyecto ilustra las diferentes campañas de experimentos que se han realizado durante el periodo de trabajo.

Diseño e implementación de un receptor multifrecuencia basado en muestreo paso banda aplicado al sistema Galileo

Este trabajo tiene como objetivo diseñar e implementar un receptor multifrecuencia requerido para aplicaciones Galileo centradas a realizar correcciones de errores y estudios de la ionosfera. Estas características obligan a buscar alternativas respecto los receptores superheterodinos convencionales dado que para éstos los retardos de propagación entre las diferentes bandas de interés son inaceptables. Por ello, se presenta un receptor basado en la técnica de muestreo paso banda, que permite trasladar el espectro mediante el conversor ADC a través de un aliasing intencionado, eliminando así los retardos de propagación entre bandas de interés, dado que todas se albergan en un mismo canal. En este trabajo nos hemos centrado únicamente en las etapas críticas del receptor presentado, siendo éstas la etapa de filtrado y conversión digital. La etapa de filtrado requerirá filtros muy selectivos, ya que el ruido existente fuera de banda se solapará a nuestra banda de interés, degradando la SNR del sistema a medida que tenga más potencia. Esta etapa se ha realizado mediante una estructura duplexora conjuntamente con dos filtros de líneas acopladas. La etapa de conversión se ha realizado fabricando el layout de un conversor comercial, del cual se ha validado el correcto funcionamiento para la aplicación requerida.

Automatic DVB signal analyser

El problema de controlar les emissions de televisió digital a tota Europa pel desenvolupament de receptors robustos i fiables és cada vegada més significant, per això, sorgeix la necessitat d’automatitzar el procés d’anàlisi i control d’aquests senyals. Aquest projecte presenta el desenvolupament software d’una aplicació que vol solucionar una part d’aquest problema. L’aplicació s’encarrega d’analitzar, gestionar i capturar senyals de televisió digital. Aquest document fa una introducció a la matèria central que és la televisió digital i la informació que porten els senyals de televisió, concretament, la que es refereix a l’estàndard "Digital Video Broadcasting". A continuació d’aquesta part, l’escrit es concentra en l’explicació i descripció de les funcionalitats que necessita cobrir l'aplicació, així com introduir i explicar cada etapa d’un procés de desenvolupament software. Finalment, es resumeixen els avantatges de la creació d’aquest programa per l’automatització de l’anàlisi de senyal digital partint d’una optimització de recursos.

Diseño de filtros transversales mediante el híbrido de 90º

Los filtros de microondas son uno de los elementos clave en el diseño de la mayoría de sistemas de RF que soportan servicios de telecomunicaciones modernos. Algunas de las aplicaciones actuales son, por ejemplo, los nuevos sistemas radar de banda ultra ancha (UWB – Ultra Wide Band) y sistemas de transmisión de servicios multimedia, donde se requieren dimensiones pequeñas del circuito, bajas pérdidas de inserción y una alta selectividad. Una de las tendencias que ha surgido como alternativa a las teorías clásicas de diseño de filtros, es el diseño de filtros basados en técnicas de señales interferentes, conocidos como filtros transversales. En esta memoria es muestra como diseñar un filtro transversal mediante el Híbrido de 90º y mediante el Híbrido de 90º con líneas acopladas, planteando 3 posibles soluciones de la ubicación de las líneas acopladas.

Calling vs receiving party pays: market penetration and the importance of the call externality

In this paper we study how the access price affects the choice of the tariff regime taken by the network operators. We show that for high values of the access price, that is taken as a parameter by the firms, networks decide to charge only the callers. Otherwise, for low values of the access charge, networks charge also the receivers. Moreover, we compare market penetration and total welfare between the two price regimes. Our model suggests that, for high values of call externality, market penetration and total welfare are larger in Receiving Party Pays regime when the access charge is close to zero.