Estudio de marcadores moleculares en neoplasias mieloproliferativas

Las neoplasias mieloproliferativas (NM) son un grupo de enfermedades clonales de la célula hematopoyética madre. Entre las NM clásicas se encuentran la policitemia vera (PV), la trombocitemia esencial (TE) y la mielofibrosis primaria (MFP). Durante muchos años el diagnóstico de estas patologías se hacía por exclusión utilizando biomarcadores de clonalidad poco específicos. En el año 2005, la descripción de la mutación JAK2V617F supuso un avance importante en el diagnóstico de estas patologías. Posteriormente, se han descrito mutaciones en otros genes como mutaciones en MPL, TET2, ASXL1, IDH1, IDH2, c-CBL, EZH2, IKZF1 y LNK, en distintas neoplasias mieloides y en porcentaje variable. Aun así, ninguno de estos genes son marcadores específicos de ninguna NM y todavía existe un porcentaje elevado de pacientes con TE y MFP sin un marcador de clonalidad conocido. Además, todos estos genes se han descrito como eventos genéticos implicados en la transformación de una NM a leucemia mieloide aguda. El objetivo de este proyecto fue estudiar varios marcadores moleculares en neoplasias mieloproliferativas Philadelphia negativas. En primer lugar, se estudió la modulación de la carga alélica JAK2V617F en pacientes con PV o TE que recibieron tratamiento citoreductor y a su vez se analizó la dinámica natural de la carga alélica en pacientes que no recibieron tratamiento. Posteriormente, se analizaron la presencia de alteraciones en los genes previamente mencionados, en distintos grupos de pacientes. En primer lugar, se analizó la presencia de mutaciones en TET2, ASXL1, IDH1, IDH2 y CBL en un grupo de pacientes JAK2 y MPL negativos, para determinar la frecuencia de alteraciones de estos genes en este grupo de pacientes y determinar su valor en el diagnóstico de estas patologías. En segundo lugar, se estudió la presencia de mutaciones en estos genes incluyendo EZH2, IKZF1 y LNK para estudiar la incidencia y el valor pronóstico de estas alteraciones en las NM que progresan a mielofibrosis.

Design of Novel Frequency Generation Circuit with Application to Ultra-Wideband Distributed Oscillators

Given the urgence of a new paradigm in wireless digital trasmission which should allow for higher bit rate, lower latency and tigher delay constaints, it has been proposed to investigate the fundamental building blocks that at the circuital/device level, will boost the change towards a more efficient network architecture, with high capacity, higher bandwidth and a more satisfactory end user experience. At the core of each transciever, there are inherently analog devices capable of providing the carrier signal, the oscillators. It is strongly believed that many limitations in today's communication protocols, could be relieved by permitting high carrier frequency radio transmission, and having some degree of reconfigurability. This led us to studying distributed oscillator architectures which work in the microwave range and possess wideband tuning capability. As microvave oscillators are essentially nonlinear devices, a full nonlinear analyis, synthesis, and optimization had to be considered for their implementation. Consequently, all the most used nonlinear numerical techniques in commercial EDA software had been reviewed. An application of all the aforementioned techniques has been shown, considering a systems of three coupled oscillator ("triple push" oscillator) in which the stability of the various oscillating modes has been studied. Provided that a certain phase distribution is maintained among the oscillating elements, this topology permits a rise in the output power of the third harmonic; nevertheless due to circuit simmetry, "unwanted" oscillating modes coexist with the intenteded one. Starting with the necessary background on distributed amplification and distributed oscillator theory, the design of a four stage reverse mode distributed voltage controlled oscillator (DVCO) using lumped elments has been presented. All the design steps have been reported and for the first time a method for an optimized design with reduced variations in the output power has been presented. Ongoing work is devoted to model a wideband DVCO and to implement a frequency divider.

Networks of noisy oscillators with correlated degree and frequency dispersion

We investigate how correlations between the diversity of the connectivity of networks and the dynamics at their nodes affect the macroscopic behavior. In particular, we study the synchronization transition of coupled stochastic phase oscillators that represent the node dynamics. Crucially in our work, the variability in the number of connections of the nodes is correlated with the width of the frequency distribution of the oscillators. By numerical simulations on Erdös-Rényi networks, where the frequencies of the oscillators are Gaussian distributed, we make the counterintuitive observation that an increase in the strength of the correlation is accompanied by an increase in the critical coupling strength for the onset of synchronization. We further observe that the critical coupling can solely depend on the average number of connections or even completely lose its dependence on the network connectivity. Only beyond this state, a weighted mean-field approximation breaks down. If noise is present, the correlations have to be stronger to yield similar observations.

Continuous phase shift of sinusoidal signals using injection locked oscillators

This work presents an alternative to generate continuous phase shift of sinusoidal signals based on the use of super harmonic injection locked oscillators (ILO). The proposed circuit is a second harmonic ILO with varactor diodes as tuning elements. In the locking state, by changing the varactor bias, a phase shift instead of a frequency shift is observed at the oscillator output. By combining two of these circuits, relative phases up to 90 could be achieved. Two prototypes of the circuit have been implemented and tested, a hybrid version working in the range of 200-300 MHz and a multichip module (MCM) version covering the 900¿1000 MHz band.

BPSK to ASK signal conversion using injection-locked oscillators-part II: experiment

This paper demonstrates the feasibility of a new circuit for the conversion of binary phase-shift keying signals into amplitude-shift keying signals. In its simplest form, the converter circuit is composed by a power divider, a couple of second harmonic injection-locked oscillators, and a power combiner. The operation of the converter circuit relies on the frequency synchronization of both oscillators and the generation of an interference pattern by combining their outputs, which reproduces the original phase modulation. Two prototypes of the converter have been implemented. The first one is a hybrid version working in the 400-530-MHz frequency range. The second one has been implemented using multichip-module technology, and is intended to work in the 1.8-2.2-GHz frequency range.

Ion assisted deposition of thin films by substrate tuned radio frequency magnetron sputtering

The substrate tuning technique was applied to a radio frequency magnetron sputtering system to obtain a variable substrate bias without an additional source. The dependence of the substrate bias on the value of the external impedance was studied for different values of chamber pressure, gas composition and rf input power. A qualitative explanation of the results is given, based on a simple model, and the role of the stray capacitance is clearly disclosed. Langmuir probe measurements show that this system allows independent control of the ion flux and the ion energy bombarding the growing film. For an argon flow rate of 2.8 sccm and a radio frequency power of 300 W (intermediate values of the range studied) the ion flux incident on the substrate was 1.3 X 1020-m-2-s-1. The maximum ion energy available in these conditions can be varied in the range 30-150 eV. As a practical application of the technique, BN thin films were deposited under different ion bombardment conditions. An ion energy threshold of about 80 eV was found, below which only the hexagonal phase was present in the films, while for higher energies both hexagonal and cubic phase were present. A cubic content of about 60% was found for an ion energy of 120 V.

Enhanced pulse propagation in non-linear arrays of oscillators

The propagation of a pulse in a nonlinear array of oscillators is influenced by the nature of the array and by its coupling to a thermal environment. For example, in some arrays a pulse can be speeded up while in others a pulse can be slowed down by raising the temperature. We begin by showing that an energy pulse (one dimension) or energy front (two dimensions) travels more rapidly and remains more localized over greater distances in an isolated array (microcanonical) of hard springs than in a harmonic array or in a soft-springed array. Increasing the pulse amplitude causes it to speed up in a hard chain, leaves the pulse speed unchanged in a harmonic system, and slows down the pulse in a soft chain. Connection of each site to a thermal environment (canonical) affects these results very differently in each type of array. In a hard chain the dissipative forces slow down the pulse while raising the temperature speeds it up. In a soft chain the opposite occurs: the dissipative forces actually speed up the pulse, while raising the temperature slows it down. In a harmonic chain neither dissipation nor temperature changes affect the pulse speed. These and other results are explained on the basis of the frequency vs energy relations in the various arrays

Spatial processing for frequency diversity schemes

A novel technique to obtain optimum blind spatialprocessing for frequency diversity spread spectrum (FDSS) communicationsystems is introduced. The sufficient statistics for alinear combiner, which prove ineffective due to the interferers frequencycharacteristics, are modified to yield improved detectionunder partial jamming in the spectral domain. Robustness to partialtime jamming is achieved by extending the notion of replicasover the frequency axis to a repetition over the time variable. Analysisand simulations are provided, showing the advantages of usingFDSS with spatial diversity to combat the interference when it isconfined to a narrow frequency band or short time interval relativeto the desired signal extent in either domain.

El Riesgo y las estrategias en la evaluación de los fondos de inversión de renta variable

El objetivo de este trabajo consiste en proponer una medida de performance adecuada para los fondos de inversión de renta variable. Las características específicas de este tipo de carteras inducen a tomar un enfoque basado en la L.M.C., por lo que se escoge como medida de riesgo el riesgo total de la cartera (pσ). Se introducen las estrategias pasivas y activas en el análisis, con lo que se consigue desarrollar una medida de performance que, además de medir la rentabilidad por gestión efectiva, la pondera en función del grado de actividad asumido por la cartera a evaluar.

Estimation of dynamic latent variable models using simulated nonparametric moments

Given a model that can be simulated, conditional moments at a trial parameter value can be calculated with high accuracy by applying kernel smoothing methods to a long simulation. With such conditional moments in hand, standard method of moments techniques can be used to estimate the parameter. Since conditional moments are calculated using kernel smoothing rather than simple averaging, it is not necessary that the model be simulable subject to the conditioning information that is used to define the moment conditions. For this reason, the proposed estimator is applicable to general dynamic latent variable models. Monte Carlo results show that the estimator performs well in comparison to other estimators that have been proposed for estimation of general DLV models.

Caracterització d'oscil·ladors basats en CMOS-M/NEMS i la seva aplicació com a sensors de massa

El present projecte tracta sobre la caracterització d'oscil·ladors basats en ressonadors micro/nanoelectromecànics (M/NEMS) i la seva aplicació com a sensors de massa. Els oscil·ladors utilitzats es basen en un pont i una palanca ressoants M/NEMS, integrats en tecnologia CMOS. En primer lloc s'ha fet una introducció teòrica als conceptes utilitzats per a entendre el funcionament i la caracterització dels dispositius. A continuació s'han realitzat proves per tal de caracteritzar els paràmetres importants per a l'ús dels oscil·ladors com a sensors de massa, com la seva estabilitat en freqüència. Per acabar s'han aplicat aquests sensors en la caracterització i modelització del flux de massa a través d'obertures de dimensions micromètriques.

Experimental investigation of transient natural convection cooling of high prandtl number fluid with variable viscosity

Report for the scientific sojourn at the James Cook University, Australia, between June to December 2007. Free convection in enclosed spaces is found widely in natural and industrial systems. It is a topic of primary interest because in many systems it provides the largest resistance to the heat transfer in comparison with other heat transfer modes. In such systems the convection is driven by a density gradient within the fluid, which, usually, is produced by a temperature difference between the fluid and surrounding walls. In the oil industry, the oil, which has High Prandtl, usually is stored and transported in large tanks at temperatures high enough to keep its viscosity and, thus the pumping requirements, to a reasonable level. A temperature difference between the fluid and the walls of the container may give rise to the unsteady buoyancy force and hence the unsteady natural convection. In the initial period of cooling the natural convection regime dominates over the conduction contribution. As the oil cools down it typically becomes more viscous and this increase of viscosity inhibits the convection. At this point the oil viscosity becomes very large and unloading of the tank becomes very difficult. For this reason it is of primary interest to be able to predict the cooling rate of the oil. The general objective of this work is to develop and validate a simulation tool able to predict the cooling rates of high Prandtl fluid considering the variable viscosity effects.

Patrones de tomate: resistencia variable frente al nematodo Meloidogyne

Los patrones de tomate se han propuesto como una alternativa no química al uso del bromuro de metilo. En este estudio se evaluó la respuesta de resistencia de diez patrones de tomate (comerciales y experimentales) a nematodos del género Meloidogyne mediante un ensayo de campo realizado en un invernadero de plástico cuyo suelo se hallaba infestado por Meloidogyne javanica. Al finalizar la campaña agrícola (marzo a julio), siete de los patrones ensayados mostraron altos niveles de resistencia, uno presentó resistencia intermedia y dos resultaron ser susceptibles al nematodo.

On the existence of hysteresis in the Kuramoto model with bimodal frequency distributions

We investigate the transition to synchronization in the Kuramoto model with bimodal distributions of the natural frequencies. Previous studies have concluded that the model exhibits a hysteretic phase transition if the bimodal distribution is close to a unimodal one, due to the shallowness the central dip. Here we show that proximity to the unimodal-bimodal border does not necessarily imply hysteresis when the width, but not the depth, of the central dip tends to zero. We draw this conclusion from a detailed study of the Kuramoto model with a suitable family of bimodal distributions.