Balanceo distribuido del encaminamiento para topologías fat-tree sobre redes Infiniband

Las redes de interconexión juegan un papel importante en el rendimiento de los sistemas de altas prestaciones. Actualmente la gestión del encaminamiento de los mensajes es un factor determinante para mantener las prestaciones de la red. Nuestra propuesta es trabajar sobre un algoritmo de encaminamiento adaptativo, que distribuye el encaminamiento de los mensajes para evitar los problemas de congestión en las redes de interconexión, que aparecen por el gran volumen de comunicaciones de aplicaciones científicas ó comerciales. El objetivo es ajustar el algoritmo a una topología muy utilizada en los sistemas actuales como lo es el fat‐tree, e implementarlo en una tecnología Infiniband. En la experimentación realizada comparamos el método de control de congestión de la arquitectura Infiniband, con nuestro algoritmo. Los resultados obtenidos muestran que mejoramos los niveles de latencia por encima de un 50% y de throughput entre un 38% y un 81%.

Tree automorphisms and quasi-isometries of Thompson's group F

We prove that automorphisms of the infinite binary rooted tree T2 do not yield quasi-isometries of Thompson's group F, except for the map which reverses orientation on the unit interval, a natural outer automorphism of F. This map, together with the identity map, forms a subgroup of Aut(T2) consisting of 2-adic automorphisms, following standard terminology used in the study of branch groups. However, for more general p, we show that the analgous groups of p-adic tree automorphisms do not give rise to quasiisometries of F(p).

Multilocus sequence analysis reveals the genetic diversity of European fruit tree phytoplasmas and supports the existence of inter-species recombination

The genetic diversity of three temperate fruit tree phytoplasmas ‘Candidatus Phytoplasma prunorum’, ‘Ca. P. mali’ and ‘Ca. P. pyri’ has been established by multilocus sequence analysis. Among the four genetic loci used, the genes imp and aceF distinguished 30 and 24 genotypes, respectively, and showed the highest variability. Percentage of substitution for imp ranged from 50 to 68% according to species. Percentage of substitution varied between 9 and 12% for aceF, whereas it was between 5 and 6% for pnp and secY. In the case of ‘Ca P. prunorum’ the three most prevalent aceF genotypes were detected in both plants and insect vectors, confirming that the prevalent isolates are propagated by insects. The four isolates known to be hypo-virulent had the same aceF sequence, indicating a possible monophyletic origin. Haplotype network reconstructed by eBURST revealed that among the 34 haplotypes of ‘Ca. P. prunorum’, the four hypo-virulent isolates also grouped together in the same clade. Genotyping of some Spanish and Azerbaijanese ‘Ca. P. pyri’ isolates showed that they shared some alleles with ‘Ca. P. prunorum’, supporting for the first time to our knowledge, the existence of inter-species recombination between these two species.

Irrigation performance and gross water productivity in furrow-irrigated ornamental tree production

In the ornamental plant production region of Girona (Spain), which is one of the largest of its kind in southern Europe, most of the surface is irrigated using wide blocked-end furrows. The objectives of this paper were: (1) to evaluate the irrigation scheduling methods used by ornamental plant producers; (2) to analyse different scenarios inorder to assess how they affect irrigation performance; (3) to evaluate the risk of deep percolation; and (4) to calculategross water productivity. A two-year study in a representative commercial field, planted with Prunus cerasifera ‘Nigra’, was carried out. The irrigation dose applied by the farmers was slightly smaller than the required water dose estimated by the use of two different methods: the first based on soil water content, and the second based on evapotranspiration. Distribution uniformity and application efficiency were high, with mean values above 87%. Soil water contentmeasurements revealed that even at the end of the furrow, where the infiltrated water depth was greatest, more than 90% of the infiltrated water was retained in the shallowest 40 cm of the soil; accordingly, the risk of water loss due to deep percolation was minimal. Gross water productivity for ornamental tree production was € 11.70 m–3, approximately 20 times higher than that obtained with maize in the same region

Measuring and explaining farm inefficiency in a panel data set of mixed farms

This paper aims to estimate a translog stochastic frontier production function in the analysis of a panel of 150 mixed Catalan farms in the period 1989-1993, in order to attempt to measure and explain variation in technical inefficiency scores with a one-stage approach. The model uses gross value added as the output aggregate measure. Total employment, fixed capital, current assets, specific costs and overhead costs are introduced into the model as inputs. Stochasticfrontier estimates are compared with those obtained using a linear programming method using a two-stage approach. The specification of the translog stochastic frontier model appears as an appropriate representation of the data, technical change was rejected and the technical inefficiency effects were statistically significant. The mean technical efficiency in the period analyzed was estimated to be 64.0%. Farm inefficiency levels were found significantly at 5%level and positively correlated with the number of economic size units.

Cost stickiness revisited: Empirical aplication for farms

This article reviews previous research regarding cost stickiness and performs an empirical analysis applied to a sample of farms. It recognizes that modelization of cost stickiness is a particular case of representation of cost variations as a function of output variations. It also discusses methodological issues and analyses cost stickiness for all registered farm costs and opportunity costs of family work. Costs exhibit a considerable level of rigidity. Even for variable costs, a decrease in activity involves a lower decrease in costs than the amounts involved when activity increases. While registered indirect costs slightly decrease when activity decreases, opportunity costs always increase. The study provides empirical evidence that cost stickiness is significantly reduced with better management decision practices.

Cost stickiness revisited: Empirical aplication for farms

This article reviews previous research regarding cost stickiness and performs an empirical analysis applied to a sample of farms. It recognizes that modelization of cost stickiness is a particular case of representation of cost variations as a function of output variations. It also discusses methodological issues and analyses cost stickiness for all registered farm costs and opportunity costs of family work. Costs exhibit a considerable level of rigidity. Even for variable costs, a decrease in activity involves a lower decrease in costs than the amounts involved when activity increases. While registered indirect costs slightly decrease when activity decreases, opportunity costs always increase. The study provides empirical evidence that cost stickiness is significantly reduced with better management decision practices.

Tree edit distance as a baseline approach for paraphrase representation

Finding an adequate paraphrase representation formalism is a challenging issue in Natural Language Processing. In this paper, we analyse the performance of Tree Edit Distance as a paraphrase representation baseline. Our experiments using Edit Distance Textual Entailment Suite show that, as Tree Edit Distance consists of a purely syntactic approach, paraphrase alternations not based on structural reorganizations do not find an adequate representation. They also show that there is much scope for better modelling of the way trees are aligned.

Spatial variability of tree hight at treeline ecotones in the Pyrenees.

We describe the spatial distribution of tree height of Pinus uncinata at two undisturbed altitudinal treeline ecotones in the southern Pyrenees (Ordesa, O, and Tessó, T). At each site, a rectangular plot (30 x 140 m) was located with its longest side parallel to the slope and encompassing treeline and timberline. At site O, height increased abruptly going downslope with a high spatial autocorrelation at short distances. In contrast, the changes of tree height across the ecotone at site T were gradual, and tree height was less spatially autocorrelated. These results can be explained by the greater importance of wind and snow avalanches at sites O and T, respectively.

Dibuixar un arbre / Drawing a Tree

L’arbre, un dels símbols més universals i un element intrínsecament vinculat al desenvolupament de la nostra cultura, esdevé, en aquest llibre, el pretext idoni per donar a conèixer alguns dels interrogants que la vivència de l’art contemporani planteja. L’artista Àlex Nogué obre les portes del seu procés de creació per fer visible com es desencadena la gènesi d’una obra d’art i posa a la llum les incerteses, les intuïcions i les aspiracions que comporta la creació artística. Dibuixar un arbre tracta de les similituds entre l’emoció que produeix un plançó al mig d’un bosc i l’emoció de traslladar-lo fins a l’interior d’una presó. De les diferències de dibuixar un xiprer dret o abatut. Dels silencis i dels sorolls de les imatges. Del que una obra pretén i del que mai aconsegueix. Les imatges i els textos d’aquest llibre ens permeten transitar per l’interior de vuit processos de creació i ens mostren com els treballs artístics neixen i creixen. Per emmarcar l’experiència creativa en el context cultural contemporani, Dibuixar unarbre s’inicia amb cinc reflexions d’autors que han viscut amb empatia aquest recorregutcreatiu. Ells mateixos estan immersos de manera apassionada en la creació, producció,difusió o direcció de projectes creatius, i són: Eudald Camps, Xavier Franquesa, Rosa Pera, Víctor Sunyol i Àngels Viladomiu.

The minimum tree for a given zero-entropy period

We answer the following question: given any n∈ℕ, which is the minimum number of endpoints en of a tree admitting a zero-entropy map f with a periodic orbit of period n? We prove that en=s1s2…sk−∑i=2ksisi+1…sk, where n=s1s2…sk is the decomposition of n into a product of primes such that si≤si+1 for 1≤itree with e endpoints has positive entropy: if f has a periodic orbit of period m with em>e, then the topological entropy of f is positive

Mulching as an alternative technique for weed management in mandarine orchard tree rows

Peer reviewed

Real-time tree-foliage surface estimation using a ground laser scanner

The optimization of most pesticide and fertilizer applications is based on overall grove conditions. In this work we measurements. Recently, Wei [9, 10] used a terrestrial propose a measurement system based on a ground laser scanner to LIDAR to measure tree height, width and volume developing estimate the volume of the trees and then extrapolate their foliage a set of experiments to evaluate the repeatability and surface in real-time. Tests with pear trees demonstrated that the accuracy of the measurements, obtaining a coefficient of relation between the volume and the foliage can be interpreted as variation of 5.4% and a relative error of 4.4% in the linear with a coefficient of correlation (R) of 0.81 and the foliar estimation of the volume but without real-time capabilities. surface can be estimated with an average error less than 5 %.

Characterisation of the LMS200 laser beam under the influence of blockage surfaces. Influence on 3D scanning of tree orchards

The geometric characterisation of tree orchards is a high-precision activity comprising the accurate measurement and knowledge of the geometry and structure of the trees. Different types of sensors can be used to perform this characterisation. In this work a terrestrial LIDAR sensor (SICK LMS200) whose emission source was a 905-nm pulsed laser diode was used. Given the known dimensions of the laser beam cross-section (with diameters ranging from 12 mm at the point of emission to 47.2 mm at a distance of 8 m), and the known dimensions of the elements that make up the crops under study (flowers, leaves, fruits, branches, trunks), it was anticipated that, for much of the time, the laser beam would only partially hit a foreground target/object, with the consequent problem of mixed pixels or edge effects. Understanding what happens in such situations was the principal objective of this work. With this in mind, a series of tests were set up to determine the geometry of the emitted beam and to determine the response of the sensor to different beam blockage scenarios. The main conclusions that were drawn from the results obtained were: (i) in a partial beam blockage scenario, the distance value given by the sensor depends more on the blocked radiant power than on the blocked surface area; (ii) there is an area that influences the measurements obtained that is dependent on the percentage of blockage and which ranges from 1.5 to 2.5 m with respect to the foreground target/object. If the laser beam impacts on a second target/object located within this range, this will affect the measurement given by the sensor. To interpret the information obtained from the point clouds provided by the LIDAR sensors, such as the volume occupied and the enclosing area, it is necessary to know the resolution and the process for obtaining this mesh of points and also to be aware of the problem associated with mixed pixels.

Performance of an ultrasonic ranging sensor in apple tree canopies

Electronic canopy characterization is an important issue in tree crop management. Ultrasonic and optical sensors are the most used for this purpose. The objective of this work was to assess the performance of an ultrasonic sensor under laboratory and field conditions in order to provide reliable estimations of distance measurements to apple tree canopies. To this purpose, a methodology has been designed to analyze sensor performance in relation to foliage ranging and to interferences with adjacent sensors when working simultaneously. Results show that the average error in distance measurement using the ultrasonic sensor in laboratory conditions is ±0.53 cm. However, the increase of variability in field conditions reduces the accuracy of this kind of sensors when estimating distances to canopies. The average error in such situations is ±5.11 cm. When analyzing interferences of adjacent sensors 30 cm apart, the average error is ±17.46 cm. When sensors are separated 60 cm, the average error is ±9.29 cm. The ultrasonic sensor tested has been proven to be suitable to estimate distances to the canopy in field conditions when sensors are 60 cm apart or more and could, therefore, be used in a system to estimate structural canopy parameters in precision horticulture.