EEG Windowed statitical wavelet deviation for estimation of muscular artifacts

Electroencephalographic (EEG) recordings are, most of the times, corrupted by spurious artifacts, which should be rejected or cleaned by the practitioner. As human scalp EEG screening is error-prone, automatic artifact detection is an issue of capital importance, to ensure objective and reliable results. In this paper we propose a new approach for discrimination of muscular activity in the human scalp quantitative EEG (QEEG), based on the time-frequency shape analysis. The impact of the muscular activity on the EEG can be evaluated from this methodology. We present an application of this scoring as a preprocessing step for EEG signal analysis, in order to evaluate the amount of muscular activity for two set of EEG recordings for dementia patients with early stage of Alzheimer’s disease and control age-matched subjects.

Dynamic estimation of three-dimensional cerebrovascular deformation from rotational angiography

Purpose: The objective of this study is to investigate the feasibility of detecting and quantifying 3D cerebrovascular wall motion from a single 3D rotational x-ray angiography (3DRA) acquisition within a clinically acceptable time and computing from the estimated motion field for the further biomechanical modeling of the cerebrovascular wall. Methods: The whole motion cycle of the cerebral vasculature is modeled using a 4D B-spline transformation, which is estimated from a 4D to 2D + t image registration framework. The registration is performed by optimizing a single similarity metric between the entire 2D + t measured projection sequence and the corresponding forward projections of the deformed volume at their exact time instants. The joint use of two acceleration strategies, together with their implementation on graphics processing units, is also proposed so as to reach computation times close to clinical requirements. For further characterizing vessel wall properties, an approximation of the wall thickness changes is obtained through a strain calculation. Results: Evaluation on in silico and in vitro pulsating phantom aneurysms demonstrated an accurate estimation of wall motion curves. In general, the error was below 10% of the maximum pulsation, even in the situation when substantial inhomogeneous intensity pattern was present. Experiments on in vivo data provided realistic aneurysm and vessel wall motion estimates, whereas in regions where motion was neither visible nor anatomically possible, no motion was detected. The use of the acceleration strategies enabled completing the estimation process for one entire cycle in 5-10 min without degrading the overall performance. The strain map extracted from our motion estimation provided a realistic deformation measure of the vessel wall. Conclusions: The authors' technique has demonstrated that it can provide accurate and robust 4D estimates of cerebrovascular wall motion within a clinically acceptable time, although it has to be applied to a larger patient population prior to possible wide application to routine endovascular procedures. In particular, for the first time, this feasibility study has shown that in vivo cerebrovascular motion can be obtained intraprocedurally from a 3DRA acquisition. Results have also shown the potential of performing strain analysis using this imaging modality, thus making possible for the future modeling of biomechanical properties of the vascular wall.

Trinocular System for 3D motion and Dense Stucture Estimation

The relief of the seafloor is an important source of data for many scientists. In this paper we present an optical system to deal with underwater 3D reconstruction. This system is formed by three cameras that take images synchronously in a constant frame rate scheme. We use the images taken by these cameras to compute dense 3D reconstructions. We use Bundle Adjustment to estimate the motion ofthe trinocular rig. Given the path followed by the system, we get a dense map of the observed scene by registering the different dense local reconstructions in a unique and bigger one

SAR Interferometric phase noise reduction using wavelet transform

The problem of synthetic aperture radar interferometric phase noise reduction is addressed. A new technique based on discrete wavelet transforms is presented. This technique guarantees high resolution phase estimation without using phase image segmentation. Areas containing only noise are hardly processed. Tests with synthetic and real interferograms are reported.

The Gaussian assumption in second-order estimation problems in digital communications

This paper deals with the goodness of the Gaussian assumption when designing second-order blind estimationmethods in the context of digital communications. The low- andhigh-signal-to-noise ratio (SNR) asymptotic performance of the maximum likelihood estimator—derived assuming Gaussiantransmitted symbols—is compared with the performance of the optimal second-order estimator, which exploits the actualdistribution of the discrete constellation. The asymptotic study concludes that the Gaussian assumption leads to the optimalsecond-order solution if the SNR is very low or if the symbols belong to a multilevel constellation such as quadrature-amplitudemodulation (QAM) or amplitude-phase-shift keying (APSK). On the other hand, the Gaussian assumption can yield importantlosses at high SNR if the transmitted symbols are drawn from a constant modulus constellation such as phase-shift keying (PSK)or continuous-phase modulations (CPM). These conclusions are illustrated for the problem of direction-of-arrival (DOA) estimation of multiple digitally-modulated signals.

Concentrations of resveratrol and derivatives in foods and estimation of dietary intake in a Spanish population: European Prospective Investigation into Cancer and Nutrition (EPIC)-Spain cohort

Resveratrol has been shown to have beneficial effects on diseases related to oxidant and/or inflammatory processes and extends the lifespan of simple organisms including rodents. The objective of the present study was to estimate the dietary intake of resveratrol and piceid (R&P) present in foods, and to identify the principal dietary sources of these compounds in the Spanish adult population. For this purpose, a food composition database (FCDB) of R&P in Spanish foods was compiled. The study included 40 685 subjects aged 3564 years from northern and southern regions of Spain who were included in the European Prospective Investigation into Cancer and Nutrition (EPIC)-Spain cohort. Usual food intake was assessed by personal interviews using a computerised version of a validated diet history method. An FCDB with 160 items was compiled. The estimated median and mean of R&P intake were 100 and 933 mg/d respectively. Approximately, 32% of the population did not consume RΠ The most abundant of the four stilbenes studied was trans-piceid (53·6 %), followed by trans-resveratrol (20·9 %), cis-piceid (19·3 %) and cis-resveratrol (6·2 %). The most important source of R&P was wines (98·4 %) and grape and grape juices (1·6 %), whereas peanuts, pistachios and berries contributed to less than 0·01 %. For this reason the pattern of intake of R&P was similar to the wine pattern. This is the first time that R&P intake has been estimated in a Mediterranean country.

Concentrations of resveratrol and derivatives in foods and estimation of dietary intake in a Spanish population: European Prospective Investigation into Cancer and Nutrition (EPIC)-Spain cohort

Resveratrol has been shown to have beneficial effects on diseases related to oxidant and/or inflammatory processes and extends the lifespan of simple organisms including rodents. The objective of the present study was to estimate the dietary intake of resveratrol and piceid (R&P) present in foods, and to identify the principal dietary sources of these compounds in the Spanish adult population. For this purpose, a food composition database (FCDB) of R&P in Spanish foods was compiled. The study included 40 685 subjects aged 35-64 years from northern and southern regions of Spain who were included in the European Prospective Investigation into Cancer and Nutrition (EPIC)-Spain cohort. Usual food intake was assessed by personal interviews using a computerised version of a validated diet history method. An FCDB with 160 items was compiled. The estimated median and mean of R&P intake were 100 and 933 mg/d respectively. Approximately, 32% of the population did not consume RΠ The most abundant of the four stilbenes studied was trans-piceid (53·6 %), followed by trans-resveratrol (20·9 %), cis-piceid (19·3 %) and cis-resveratrol (6·2 %). The most important source of R&P was wines (98·4 %) and grape and grape juices (1·6 %), whereas peanuts, pistachios and berries contributed to less than 0·01 %. For this reason the pattern of intake of R&P was similar to the wine pattern. This is the first time that R&P intake has been estimated in a Mediterranean country.

Postnatal ontogenesis of the tibia. Implications for age and sex estimation

The growth of five variables of the tibia (diaphyseal length, diaphyseal length plus distal epiphysis, condylo-malleolar length, sagittal diameter of the proximal epiphysis, maximum breadth of the distal epiphysis) were analysed using polynomial regression in order to evaluate their significance and capacity for age and sex determination during and after growth. Data were collected from 181 (90♂ and 91♀) individuals ranging from birth to 25 years of age and belonging to three documented collections from Western Europe. Results indicate that all five variables exhibit linear behaviour during growth, which can be expressed by a first-degree polynomial function. Sexual significant differences were observed from age 15 onward in the two epiphysis measurements and condylo-malleolar length, suggesting that these three variables could be useful for sex determination in individuals older than 15 years. Strong correlation coefficients were identified between the five tibial variables and age. These results indicate that any of the studied tibial measurements is likely to serve as a useful source for estimating sub-adult age in both archaeological and forensic samples.

Source separation techniques applied to linear prediction

The prediction filters are well known models for signal estimation, in communications, control and many others areas. The classical method for deriving linear prediction coding (LPC) filters is often based on the minimization of a mean square error (MSE). Consequently, second order statistics are only required, but the estimation is only optimal if the residue is independent and identically distributed (iid) Gaussian. In this paper, we derive the ML estimate of the prediction filter. Relationships with robust estimation of auto-regressive (AR) processes, with blind deconvolution and with source separation based on mutual information minimization are then detailed. The algorithm, based on the minimization of a high-order statistics criterion, uses on-line estimation of the residue statistics. Experimental results emphasize on the interest of this approach.

Estimation of lung cancer diagnosis and treatment costs based on a patient-level analysis in Catalonia (Spain)

Background: Assessing of the costs of treating disease is necessary to demonstrate cost-effectiveness and to estimate the budget impact of new interventions and therapeutic innovations. However, there are few comprehensive studies on resource use and costs associated with lung cancer patients in clinical practice in Spain or internationally. The aim of this paper was to assess the hospital cost associated with lung cancer diagnosis and treatment by histology, type of cost and stage at diagnosis in the Spanish National Health Service. Methods: A retrospective, descriptive analysis on resource use and a direct medical cost analysis were performed. Resource utilisation data were collected by means of patient files from nine teaching hospitals. From a hospital budget impact perspective, the aggregate and mean costs per patient were calculated over the first three years following diagnosis or up to death. Both aggregate and mean costs per patient were analysed by histology, stage at diagnosis and cost type. Results: A total of 232 cases of lung cancer were analysed, of which 74.1% corresponded to non-small cell lung cancer (NSCLC) and 11.2% to small cell lung cancer (SCLC); 14.7% had no cytohistologic confirmation. The mean cost per patient in NSCLC ranged from 13,218 Euros in Stage III to 16,120 Euros in Stage II. The main cost components were chemotherapy (29.5%) and surgery (22.8%). Advanced disease stages were associated with a decrease in the relative weight of surgical and inpatient care costs but an increase in chemotherapy costs. In SCLC patients, the mean cost per patient was 15,418 Euros for limited disease and 12,482 Euros for extensive disease. The main cost components were chemotherapy (36.1%) and other inpatient costs (28.7%). In both groups, the Kruskall-Wallis test did not show statistically significant differences in mean cost per patient between stages. Conclusions: This study provides the costs of lung cancer treatment based on patient file reviews, with chemotherapy and surgery accounting for the major components of costs. This cost analysis is a baseline study that will provide a useful source of information for future studies on cost-effectiveness and on the budget impact of different therapeutic innovations in Spain.

Parametric and semiparametric estimation of sample selection models: an empirical application to the female labour force in Portugal

This comment corrects the errors in the estimation process that appear in Martins (2001). The first error is in the parametric probit estimation, as the previously presented results do not maximize the log-likelihood function. In the global maximum more variables become significant. As for the semiparametric estimation method, the kernel function used in Martins (2001) can take on both positive and negative values, which implies that the participation probability estimates may be outside the interval [0,1]. We have solved the problem by applying local smoothing in the kernel estimation, as suggested by Klein and Spady (1993).

Agglomeration and location: a nonparametric approach

The aim of this article is to assess the effects of several territorial characteristics, specifically agglomeration economies, on industrial location processes in the Spanish region of Catalonia. Theoretically, the level of agglomeration causes economies which favour the location of new establishments, but an excessive level of agglomeration might cause diseconomies, since congestion effects arise. The empirical evidence on this matter is inconclusive, probably because the models used so far are not suitable enough. We use a more flexible semiparametric specification, which allows us to study the nonlinear relationship between the different types of agglomeration levels and location processes. Our main statistical source is the REIC (Catalan Manufacturing Establishments Register), which has plant-level microdata on location of new industrial establishments. Keywords: agglomeration economies, industrial location, Generalized Additive Models, nonparametric estimation, count data models.

Estimation of dynamic latent variable models using simulated nonparametric moments

Given a model that can be simulated, conditional moments at a trial parameter value can be calculated with high accuracy by applying kernel smoothing methods to a long simulation. With such conditional moments in hand, standard method of moments techniques can be used to estimate the parameter. Since conditional moments are calculated using kernel smoothing rather than simple averaging, it is not necessary that the model be simulable subject to the conditioning information that is used to define the moment conditions. For this reason, the proposed estimator is applicable to general dynamic latent variable models. Monte Carlo results show that the estimator performs well in comparison to other estimators that have been proposed for estimation of general DLV models.

Estimation of lean meat content in pig carcasses using X-ray Computed Tomography and PLS regression

Lean meat percentage (LMP) is an important carcass quality parameter. The aim of this work is to obtain a calibration equation for the Computed Tomography (CT) scans with the Partial Least Square Regression (PLS) technique in order to predict the LMP of the carcass and the different cuts and to study and compare two different methodologies of the selection of the variables (Variable Importance for Projection — VIP- and Stepwise) to be included in the prediction equation. The error of prediction with cross-validation (RMSEPCV) of the LMP obtained with PLS and selection based on VIP value was 0.82% and for stepwise selection it was 0.83%. The prediction of the LMP scanning only the ham had a RMSEPCV of 0.97% and if the ham and the loin were scanned the RMSEPCV was 0.90%. Results indicate that for CT data both VIP and stepwise selection are good methods. Moreover the scanning of only the ham allowed us to obtain a good prediction of the LMP of the whole carcass.

System GMM estimation with a small sample

Properties of GMM estimators for panel data, which have become very popular in the empirical economic growth literature, are not well known when the number of individuals is small. This paper analyses through Monte Carlo simulations the properties of various GMM and other estimators when the number of individuals is the one typically available in country growth studies. It is found that, provided that some persistency is present in the series, the system GMM estimator has a lower bias and higher efficiency than all the other estimators analysed, including the standard first-differences GMM estimator.