Introduction of sensor spectral response into image fusion methods. Application to wavelet-based methods

Usual image fusion methods inject features from a high spatial resolution panchromatic sensor into every low spatial resolution multispectral band trying to preserve spectral signatures and improve spatial resolution to that of the panchromatic sensor. The objective is to obtain the image that would be observed by a sensor with the same spectral response (i.e., spectral sensitivity and quantum efficiency) as the multispectral sensors and the spatial resolution of the panchromatic sensor. But in these methods, features from electromagnetic spectrum regions not covered by multispectral sensors are injected into them, and physical spectral responses of the sensors are not considered during this process. This produces some undesirable effects, such as resolution overinjection images and slightly modified spectral signatures in some features. The authors present a technique which takes into account the physical electromagnetic spectrum responses of sensors during the fusion process, which produces images closer to the image obtained by the ideal sensor than those obtained by usual wavelet-based image fusion methods. This technique is used to define a new wavelet-based image fusion method.

Bipolar pulsed excitation of erbium-doped nanosilicon light emitting diodes

High quantum efficiency erbium doped silicon nanocluster (Si-NC:Er) light emitting diodes (LEDs) were grown by low-pressure chemical vapor deposition (LPCVD) in a complementary metal-oxide-semiconductor (CMOS) line. Erbium (Er) excitation mechanisms under direct current (DC) and bipolar pulsed electrical injection were studied in a broad range of excitation voltages and frequencies. Under DC excitation, Fowler-Nordheim tunneling of electrons is mediated by Er-related trap states and electroluminescence originates from impact excitation of Er ions. When the bipolar pulsed electrical injection is used, the electron transport and Er excitation mechanism change. Sequential injection of electrons and holes into silicon nanoclusters takes place and nonradiative energy transfer to Er ions is observed. This mechanism occurs in a range of lower driving voltages than those observed in DC and injection frequencies higher than the Er emission rate.

Metal-Nitride-oxide-semiconductor light-emitting devices for general lighting.

The potential for application of silicon nitride-based light sources to general lighting is reported. The mechanism of current injection and transport in silicon nitride layers and silicon oxide tunnel layers is determined by electro-optical characterization of both bi- and tri-layers. It is shown that red luminescence is due to bipolar injection by direct tunneling, whereas Poole-Frenkel ionization is responsible for blue-green emission. The emission appears warm white to the eye, and the technology has potential for large-area lighting devices. A photometric study, including color rendering, color quality and luminous efficacy of radiation, measured under various AC excitation conditions, is given for a spectrum deemed promising for lighting. A correlated color temperature of 4800K was obtained using a 35% duty cycle of the AC excitation signal. Under these conditions, values for general color rendering index of 93 and luminous efficacy of radiation of 112 lm/W are demonstrated. This proof of concept demonstrates that mature silicon technology, which is extendable to lowcost, large-area lamps, can be used for general lighting purposes. Once the external quantum efficiency is improved to exceed 10%, this technique could be competitive with other energy-efficient solid-state lighting options. ©2011 Optical Society of America OCIS codes: (230.2090) Electro-optical devices; (150.2950) Illumination.

Intense green-yellow electroluminescence from Tb+-implanted silicon-rich silicon nitride/oxide light emitting devices

High optical power density of 0.5 mW/cm2, external quantum efficiency of 0.1%, and population inversion of 7% are reported from Tb+-implanted silicon-rich silicon nitride/oxide light emitting devices. Electrical and electroluminescence mechanisms in these devices were investigated. The excitation cross section for the 543 nm Tb3+ emission was estimated under electrical pumping, resulting in a value of 8.2 × 10−14 cm2, which is one order of magnitude larger than one reported for Tb3+:SiO2 light emitting devices. These results demonstrate the potentiality of Tb+-implanted silicon nitride material for the development of integrated light sources compatible with Si technology.

Growth, optical characterization, and laser operation of a stoichiometric crystal KYb(WO4)(2)

We present our recent achievements in the growing and optical characterization of KYb(WO4)2 (hereafter KYbW) crystals and demonstrate laser operation in this stoichiometric material. Single crystals of KYbW with optimal crystalline quality have been grown by the top-seeded-solution growth slow-cooling method. The optical anisotropy of this monoclinic crystal has been characterized, locating the tensor of the optical indicatrix and measuring the dispersion of the principal values of the refractive indices as well as the thermo-optic coefficients. Sellmeier equations have been constructed valid in the visible and near-IR spectral range. Raman scattering has been used to determine the phonon energies of KYbW and a simple physical model is applied for classification of the lattice vibration modes. Spectroscopic studies (absorption and emission measurements at room and low temperature) have been carried out in the spectral region near 1 µm characteristic for the ytterbium transition. Energy positions of the Stark sublevels of the ground and the excited state manifolds have been determined and the vibronic substructure has been identified. The intrinsic lifetime of the upper laser level has been measured taking care to suppress the effect of reabsorption and the intrinsic quantum efficiency has been estimated. Lasing has been demonstrated near 1074 nm with 41% slope efficiency at room temperature using a 0.5 mm thin plate of KYbW. This laser material holds great promise for diode pumped high-power lasers, thin disk and waveguide designs as well as for ultrashort (ps/fs) pulse laser systems.

Optoelectronic properties of CuPc thin films deposited at different substrate temperatures

Structural and optical characterization of copper phthalocyanine thin film thermally deposited at different substrate temperatures was the aim of this work. The morphology of the films shows strong dependence on temperature, as can be observed by atomic force microscopy and x-ray diffraction spectroscopy, specifically in the grain size and features of the grains. The increase in the crystal phase with substrate temperature is shown by x-ray diffractometry. Optical absorption coefficient measured by photothermal deflection spectroscopy and optical transmittance reveal a weak dependence on the substrate temperature. Besides, the electro-optical response measured by the external quantum efficiency of Schottky ITO/CuPc/Al diodes shows an optimized response for samples deposited at a substrate temperature of 60 °C, in correspondence to the I-V diode characteristics.

Optoelectronic studies in nanocrystalline silicon Schottky diodes obtained by Hot-Wire Chemical Vapour Deposition

The very usual columnar growth of nanocrystalline silicon leads to electronic transport anisotropies. Whereas electrical measurements with coplanar electrodes only provide information about the electronic transport parallel to the substrate, it is the transverse transport which determines the collection efficiency in thin film solar cells. Hence, Schottky diodes on transparent electrodes were obtained by hot-wire CVD in order to perform external quantum efficiency and surface photovoltage studies in sandwich configuration. These measurements allowed to calculate a transverse collection length, which must correlate with the photovoltaic performance of thin film solar cells. Furthermore, the density of charge trapped at localized states in the bandgap was estimated from the voltage dependence of the depletion capacitance of these rectifying contacts.

Efficiency and environmental regulation: a 'complex situation'

Production of desirable outputs is often accompanied by undesirable by products that have damaging effects on the environment, and whose disposal is frequently regulated by public authorities. In this paper, we compute directional technology distance functions under particular assumptions concerning disposability of bads in order to test for the existence of what we call ‘complex situations’, where the biggest producer is not the greatest polluter. Furthermore, we show that how in such situations, environmental regulation could achieve an effective reduction in the aggregate level of bad outputs without reducing the production of good outputs. Finally, we illustrate our methodology with an empirical application to a sample of Spanish tile ceramic producers.

Efficiency and quality in local government management: the case of Spanish local authorities

This study analyses efficiency levels in Spanish local governments and their determining factors through the application of DEA (Data Envelopment Analysis) methodology. It aims to find out to what extent inefficiency arises from external factors beyond the control of the entity, or on the other hand, how much it is due to inadequate management of productive resources. The results show that on the whole, there is still a wide margin within which managers could increase local government efficiency levels, although it is revealed that a great deal of inefficiency is due to exogenous factors. It is specifically found that the size of the entity, per capita tax revenue, the per capita grants or the amount of commercial activity are some of the factors determining local government inefficiency.

Consumption externalities, habit formation, and equilibrium efficiency

We analyze the welfare properties of the competitive equilibrium in a capital accumulation model where individual preferences are subjected to both habit formation and consumption spillovers. We also discuss how consumption externalities and habits interact to generate an inefficient dynamic equilibrium. Finally, we characterize optimal tax policies aimed to restore efficient decentralized paths.

A dual characterization of incentive efficiency

We show that incentive efficient allocations in economies with adverse selection and moral hazard can be determined as optimal solutions to a linear programming problem and we use duality theory to obtain a complete characterization of the optima. Our dual analysis identifies welfare effects associated with the incentives of the agents to truthfully reveal their private information. Because these welfare effects may generate non-convexities, incentive efficient allocations may involve randomization. Other properties of incentive efficient allocations are also derived.

Allocative and productive efficiency in REE with asymetric information

We characterize the divergence between informational and economic efficiency in a rational expectations competitive market with asymmetric information about the costs of production. We find that prices may contain too much or too little information with respect to incentive efficient allocations depending on whether the main role of the price is, respectively, the traditional as index of scarcity or informational. Only when REE degenerate to Cournot equilibria the market solution does not show llocative inefficiency. With multidimensional uncertainty we find that the REE price does not have in general the incentive efficient information mix: It pays to sacrifice allocative efficiency at the REE to improve productive efficiency.

Public enterprise reforms and efficiency in regulated environments: the case of the postal sector

Purpose - This paper focuses on analyzing the effect that public reforms have on the efficiency of state-owned enterprises in regulated environments. Design/methodology/approach - The research is focused in the postal sector where public and private companies must obey a legal framework related to provide a universal service. The analysis is carried out using a panel of 7 European postal operators for the period 1997-2003. The activity analyzed was the letter mail division; we take as key variable the unit cost of a letter and use a translog cost function where as independent variables we include traffic levels, labor cost per employee, quality and availability of the service as well as the type of ownership (public or private). Additionally, in a second stage the geographical differences among countries are considered. Findings - Results indicate that postal operators that experienced organizational changes without being privatized, such as the Spanish and Greek operators, do not have higher unit costs than privatized postal operators like the one of Germany and the Netherlands. Moreover, we find that in all cases the operator of Ireland appear to be the most efficient. In this case restructuring process has been carried out giving an important leadership role to workers. This suggests us that labor culture could be a key variable to study when analyzing reform processes in public enterprises. Originality/value - Our findings show that in a regulated environment like in the postal sector, public and private companies can obtain similar efficiency levels in term of unit costs.

Cooperative production and efficiency

We characterize the sharing rule for which a contribution mechanism achieves efficiency in a cooperative production setting when agents are heterogeneous. The sharing rule bears no resemblance to those considered by the previous literature. We also show for a large class of sharing rules that if Nash equilibrium yields efficient allocations, the production function displays constant returns to scale, a case in which cooperation in production is useless.

The Appraisal of projects with environmental impacts. Efficiency and Sustainability

It is usually assumed that the appraisal of the impacts experienced by present generations does not entail any difficulty. However, this is not true. Moreover, there is not a widely accepted methodology for taking these impacts into account. Some of the controversial issues are: the appropriate value for the discount rate, the choice of the units for expressing the impacts, physical or monetary units -income, consumption or investment- and the valuation of tangible and intangible goods. When approaching the problem of very long term impacts, there is also the problem of valuing the impacts experienced by future generations, through e.g., the use of an intergenerational discount rate. However, if this were the case, the present generation perspective would prevail, as if all the property rights on the resources were owned by them. Therefore, the sustainability requirement should also be incorporated into the analysis. We will analyze these problems in this article and show some possible solutions.