Seguretat en xarxes i aplicacions distribuïdes: MANET routing

L’objectiu del projecte és tractar de donar solució al problema d’interconnexió de dispositius mòbils, en concret de PDAs Nokia 810, en una situació on no es disposa d’un punt d’accès fixe. Per a fer-ho possible es forma una xarxa MANET, és a dir una xarxa Ad-hoc mòbil, on els nodes són els propis dispositius. Un cop establerta la connexió, s’obté un llistat actualitzat amb les adreces IP de tots els nodes visibles de la xarxa.

Predictive and distributed routing balancing (PR-DRB): high speed interconnection networks

Current parallel applications running on clusters require the use of an interconnection network to perform communications among all computing nodes available. Imbalance of communications can produce network congestion, reducing throughput and increasing latency, degrading the overall system performance. On the other hand, parallel applications running on these networks posses representative stages which allow their characterization, as well as repetitive behavior that can be identified on the basis of this characterization. This work presents the Predictive and Distributed Routing Balancing (PR-DRB), a new method developed to gradually control network congestion, based on paths expansion, traffic distribution and effective traffic load, in order to maintain low latency values. PR-DRB monitors messages latencies on intermediate routers, makes decisions about alternative paths and record communication pattern information encountered during congestion situation. Based on the concept of applications repetitiveness, best solution recorded are reapplied when saved communication pattern re-appears. Traffic congestion experiments were conducted in order to evaluate the performance of the method, and improvements were observed.

BCN-Routing : càlcul web de rutes amb pgRouting, OpenStreetMaps i OpenLayers

Es presenta un sistema acurat de càlcul web d'itineraris mínims (per a vianants i per a vehicles) entre dos punts de la ciutat de Barcelona, un dels quals es triat per l'usuari directament a sobre un mapa i l'altre, alternativament, a sobre el mateix mapa o bé a sobre una llista de selecció de les principals atraccions turístiques de Barcelona.El sistema es troba implementat per medi de MapServer (1) com a servidor, OpenLayers (2) per a la interfície d'usuari, una base de dades PostrgreSQL (3)/PostGIS (4) que recull dades d'OpenStreetMaps (5) per a la navegació i dades introduïdes manualment, per a la llista de selecció d'atraccions turístiques. Per al càlcul d'itineraris es fa servir, pgRouting (6) alhora que s'accedeix a la cartografia de CartoCiudad (7) per a mostrar un mapa de base i opcionalment els noms dels carrers i punts d'interès a partir de les capes FondoUrbano, Vial i Topónimo del servidor WMS de CartoCiudad.Tot el sistema corre a sobre Windows 7 Home Premium (8).Així mateix es presenten quatre noves funcions i un tipus definit per l'usuari de PostgreSQL per al càlcul acurat d'itineraris mínims i l'estudi teòric que justifica la seva bondat.

Problemas en la implementación de algoritmos de routing de alta complejidad en dispositivos móviles: el caso Itiner@

La aparición de terminales de telefonía móvil cada vez más potentes abre un nuevo abanico de posibilidades en cuanto a usos y aplicaciones. Sin embargo, y dadas las limitaciones tanto de memoria como de CPU que tienen estos dispositivos, algunas de las aplicaciones potenciales resultan muy difíciles o incluso imposibles de llevar a la práctica. Este es el caso, por ejemplo, de aplicaciones de cálculo de rutas. En el contexto del proyecto Itiner@, un asistente para rutas turísticas completamente autónomo que debe funcionar incluso sin conexión a Internet, todos los procesos deben ejecutarse íntegramente de forma local en el dispositivo móvil. Dado que es un proyecto orientado al ocio, es importante que la experiencia del usuario sea satisfactoria, por lo que además de poder ejecutar el algoritmo de cálculo de rutas, el sistema debe hacerlo de forma rápida. En este sentido, los algoritmos recursivos habituales son demasiado costosos o lentos para su uso en Itiner@ y ha sido necesario reinventar este tipo de algoritmos en función de las limitaciones que tienen estos dispositivos. En el presente trabajo se presenta el proceso seguido y las dificultades encontradas para implementar un algoritmo recursivo de cálculo de rutas que se ejecute íntegramente en un dispositivo móvil Android de forma eficiente. Así, finalmente se llega a un algoritmo recursivo de cálculo de rutas para dispositivos móviles que se ejecuta de forma más eficiente frente a algoritmos directamente portados a dispositivos móviles. La principal contribución del trabajo es doble: por un lado ofrece algunas guías útiles al desarrollo de algoritmos más eficientes para dispositivos móviles; y por el otro, muestra un algoritmo de cálculo de rutas que funciona con un tiempo de respuesta aceptable, en un entorno exigente, como es el de las aplicaciones de turismo en móviles

Enhancing fault management performance of two-step QoS routing algorithms in GMPLS networks

In this paper a novel methodology aimed at minimizing the probability of network failure and the failure impact (in terms of QoS degradation) while optimizing the resource consumption is introduced. A detailed study of MPLS recovery techniques and their GMPLS extensions are also presented. In this scenario, some features for reducing the failure impact and offering minimum failure probabilities at the same time are also analyzed. Novel two-step routing algorithms using this methodology are proposed. Results show that these methods offer high protection levels with optimal resource consumption

Enhancing MPLS QoS routing algorithms by using the network protection degree paradigm

IP based networks still do not have the required degree of reliability required by new multimedia services, achieving such reliability will be crucial in the success or failure of the new Internet generation. Most of existing schemes for QoS routing do not take into consideration parameters concerning the quality of the protection, such as packet loss or restoration time. In this paper, we define a new paradigm to develop new protection strategies for building reliable MPLS networks, based on what we have called the network protection degree (NPD). This NPD consists of an a priori evaluation, the failure sensibility degree (FSD), which provides the failure probability and an a posteriori evaluation, the failure impact degree (FID), to determine the impact on the network in case of failure. Having mathematical formulated these components, we point out the most relevant components. Experimental results demonstrate the benefits of the utilization of the NPD, when used to enhance some current QoS routing algorithms to offer a certain degree of protection

Minimum interference routing with fast protection

One of the most effective techniques offering QoS routing is minimum interference routing. However, it is complex in terms of computation time and is not oriented toward improving the network protection level. In order to include better levels of protection, new minimum interference routing algorithms are necessary. Minimizing the failure recovery time is also a complex process involving different failure recovery phases. Some of these phases depend completely on correct routing selection, such as minimizing the failure notification time. The level of protection also involves other aspects, such as the amount of resources used. In this case shared backup techniques should be considered. Therefore, minimum interference techniques should also be modified in order to include sharing resources for protection in their objectives. These aspects are reviewed and analyzed in this article, and a new proposal combining minimum interference with fast protection using shared segment backups is introduced. Results show that our proposed method improves both minimization of the request rejection ratio and the percentage of bandwidth allocated to backup paths in networks with low and medium protection requirements

QoS online routing and MPLS multilevel protection: a survey

A survey of MPLS protection methods and their utilization in combination with online routing methods is presented in this article. Usually, fault management methods pre-establish backup paths to recover traffic after a failure. In addition, MPLS allows the creation of different backup types, and hence MPLS is a suitable method to support traffic-engineered networks. In this article, an introduction of several label switch path backup types and their pros and cons are pointed out. The creation of an LSP involves a routing phase, which should include QoS aspects. In a similar way, to achieve a reliable network the LSP backups must also be routed by a QoS routing method. When LSP creation requests arrive one by one (a dynamic network scenario), online routing methods are applied. The relationship between MPLS fault management and QoS online routing methods is unavoidable, in particular during the creation of LSP backups. Both aspects are discussed in this article. Several ideas on how these actual technologies could be applied together are presented and compared

Adding QoS protection in order to enhance MPLS QoS routing

In this paper, a method for enhancing current QoS routing methods by means of QoS protection is presented. In an MPLS network, the segments (links) to be protected are predefined and an LSP request involves, apart from establishing a working path, creating a specific type of backup path (local, reverse or global). Different QoS parameters, such as network load balancing, resource optimization and minimization of LSP request rejection should be considered. QoS protection is defined as a function of QoS parameters, such as packet loss, restoration time, and resource optimization. A framework to add QoS protection to many of the current QoS routing algorithms is introduced. A backup decision module to select the most suitable protection method is formulated and different case studies are analyzed

All-Optical Label Stacking: Easing the Trade-offs Between Routing and Architecture Cost in All-Optical Packet Switching

All-optical label swapping (AOLS) forms a key technology towards the implementation of all-optical packet switching nodes (AOPS) for the future optical Internet. The capital expenditures of the deployment of AOLS increases with the size of the label spaces (i.e. the number of used labels), since a special optical device is needed for each recognized label on every node. Label space sizes are affected by the way in which demands are routed. For instance, while shortest-path routing leads to the usage of fewer labels but high link utilization, minimum interference routing leads to the opposite. This paper studies all-optical label stacking (AOLStack), which is an extension of the AOLS architecture. AOLStack aims at reducing label spaces while easing the compromise with link utilization. In this paper, an integer lineal program is proposed with the objective of analyzing the softening of the aforementioned trade-off due to AOLStack. Furthermore, a heuristic aiming at finding good solutions in polynomial-time is proposed as well. Simulation results show that AOLStack either a) reduces the label spaces with a low increase in the link utilization or, similarly, b) uses better the residual bandwidth to decrease the number of labels even more

Multicast algorithms evaluation using an adaptative routing in ATM networks

This paper proposes a multicast implementation based on adaptive routing with anticipated calculation. Three different cost measures for a point-to-multipoint connection: bandwidth cost, connection establishment cost and switching cost can be considered. The application of the method based on pre-evaluated routing tables makes possible the reduction of bandwidth cost and connection establishment cost individually

Predictable Life-Cycle Shocks, Income Risk and Consumption Inequality

Was the increase in income inequality in the US due to permanent shocks or merely to an increase in the variance of transitory shocks? The implications for consumption and welfare depend crucially on the answer to this question. We use CEX repeated cross-section data on consumption and income to decompose idiosyncratic changes in income into predictable life-cycle changes, transitory and permanent shocks and estimate the contribution of each to total inequality. Our model fits the joint evolution of consumption and income inequality well and delivers two main results. First, we find that permanent changes in income explain all of the increase in inequality in the 1980s and 90s. Second, we reconcile this finding with the fact that consumption inequality did not increase much over this period. Our results support the view that many permanent changes in income are predictable for consumers, even if they look unpredictable to the econometrician, consistent with models of heterogeneous income profiles.

Inventory-routing model, for a multi-period problem with stochastic and deterministic demand

The need for integration in the supply chain management leads us to considerthe coordination of two logistic planning functions: transportation andinventory. The coordination of these activities can be an extremely importantsource of competitive advantage in the supply chain management. The battle forcost reduction can pass through the equilibrium of transportation versusinventory managing costs. In this work, we study the specific case of aninventory-routing problem for a week planning period with different types ofdemand. A heuristic methodology, based on the Iterated Local Search, isproposed to solve the Multi-Period Inventory Routing Problem with stochasticand deterministic demand.

Anonymous Routing Protocol in decentralized networks

Peer-reviewed

Secure Dynamic MANET On-demand (SEDYMO) Routing Protocol

This paper describes the state of the art of secure ad hoc routing protocols and presents SEDYMO, a mechanism to secure a dynamic multihop ad hoc routing protocol. The proposed solution defeats internal and external attacks usinga trustworthiness model based on a distributed certification authority. Digital signatures and hash chains are used to ensure the correctness of the protocol. The protocol is compared with other alternatives in terms of security strength, energy efficiency and time delay. Both computational and transmission costs are considered and it is shown that the secure protocol overhead is not a critical factor compared to the high network interface cost.