Active tectonics of the Alhama de Murcia fault, Betic Cordillera, Spain

We present an overview of the knowledge of the structure and the seismic behavior of the Alhama de Murcia Fault (AMF). We utilize a fault traces map created from a LIDAR DEM combined with the geodynamic setting, the analysis of the morphology, the distribution of seismicity, the geological information from E 1:50000 geological maps and the available paleoseismic data to describe the recent activity of the AMF. We discuss the importance of uncertainties regarding the structure and kinematics of the AMF applied to the interpretation and spatial correlation of the paleoseismic data. In particular, we discuss the nature of the faults dipping to the SE (antithetic to the main faults of the AMF) in several segments that have been studied in the previous paleoseismic works. A special chapter is dedicated to the analysis of the tectonic source of the Lorca 2011 earthquake that took place in between two large segments of the fault.

On the origin of the North Pacific arcs

We present a new hypothesis that relates global plate tectonics to the formation of marginal basins, island arcs, spreading ridges and arc-shaped mountain belts around the North Pacific Ocean. According to our model, the ellipsoidal-shaped Paleogene basins of the South China Sea, Parece-Vela Basin, Shikoku Basin, Sea of Japan and the Sea of Okhotsk in addition to those of the North American Cordillera can be attributed to the change in plate convergence direction at 42 Ma between the Indoaustralian and Eurasian plates. The new direction of convergence was parallel to the eastern continental margin of Asia and resulted in widespread extension perpendicular to this margin and to the western margin of North America. Both margins form part of a circle parallel to the Indoaustralian-Eurasian direction of convergence.

The Hercynian structure of the Catalonian Coastal Ranges (NE Spain)

In the Catalonian Coastal Ranges, Paleozoic sedimentary and meta-sedimentary rocks crop out in severa1 areas, intruded by late tectonic Hercynian granitoids and separated by Mesozoic and Tertiary cover sediments. Large structures are often difficult to recognize, although a general east-west trend can be observed on the geological map. Deformation was accompanied by the development of cleavages and regional metamorphism. Green-schist facies rocks are prominent throughout the Ranges, while amphibolite facies are restricted to small areas. In low-grade areas, the main deformation phase generated south-facing folds with an axial plane cleavage (slaty cleavage in metapelitic rocks). The intersection lineation (Ss/Sl) and the axes of minor folds trend cast-west, as do all mapable structures. Late deformations generated coarse crenulations, small chevrons and kink-bands, all intersecting the slaty cleavage at high angles. In medium- to high-grade areas no major folds have been observed. In these areas, the main foliation is a schistosity and is often folded, giving centimetric to decimetric, nearly isoclinal intrafolial folds. In schists, these folds aremuchmore common than inother lithologies, and can be associated with a crenulation cleavage. All these planar structures in high-grade rocks are roughly parallel. The late Hercynian deformational events, which gave rise to the crenulations and small chevrons, also produced large (often kilometric) open folds which fold the slaty cleavage and schistosity. As aconsequence, alternating belts with opposite dip (north and south) of the main foliation were formed. With respect to the Hercynian orogenic belt, the Paleozoic outcrops of the Catalonian Coastal Ranges are located within the northern branch of the Ibero-Armorican arc, and have a relatively frontal position within the belt. The Carboniferous of the Priorat-Prades area, together with other outcrops in the Castellón Province, the Montalbán massif (Iberian Chain) and the Cantabrian zone (specially the Pisuerga-Carrión Province) probably form part of a wide area of foreland Carboniferous deposition placed at the core of the arc.

Morfoestructura y evolución del ramal N160 de la dorsal de la Cuenca Nor-Fidjiana (Pacífico sudoeste)

La campaña oceanográfica franco-japonesa Yokosuka 90, llevada a cabo del 10 de Enero al 6 de Febrero de 1991, tuvo por objeto el estudio geológico y geofísico del segmento de segundo orden o ramal de dirección N160 de la dorsal de la Cuenca Nor-Fidjiana (Pacífico sudoeste). Este ramal es especialmente interesante, no sólo por estar situado en una cuenca de tras-arco, sino también en el marco de las hipótesis que intentan establecer las relaciones entre tasas de expansión y morfoestructura en las dorsales oceánicas. Así, en el ramal estudiado coinciden una tasa de expansión intermedia (5 cm/a) y una morfología típica de dorsal lenta. Dicho ramal, segmentado y constituido por una sucesión de crestas y de grabens desplazados lateralmente, se sitúa entre dos puntos mples, uno de tipo dorsal-dorsal-zona de fractura (RRF), al sur, y otro, de tipo dorsal-dorsal-dorsal (RRR), al norte. El ramal N160 de la Cuenca Nor-Fidjiana es, por otra parte, extremadamente joven ya que de acuerdo con las anomalías magnéticas se habna formado durante un episodio volcano-tectónico iniciado hace menos de 1 Ma.

Caracterización geológica de la región de enlace entre la Cuenca de Bransfield y la Dorsal Sur de Scotia (Antártida)

La Dorsal Sur de Scotia (DSS) constituye une frontera de placas transformante con sentido senestral, que limita las placas de Scotia, al norte, y Antártica, al sur. Durante la campaña de geología y geofísica marinas 'Scotia 92', realizada en Febrero de 1992 a bordo del BIO Hespérides, se ha estudiado su extremo occidental y sectores próximos a la Cuenca de Bransfield, entre el margen nor-occidental de la Península Antártica y las islas Shetland del Sur, Elefante y Orcadas del Sur. Al norte y sur de la DSS se desarrollan las cuencas de Scotia y de Powell, respectivamente. Los datos de sísmica de multicanal, magnetismo y gravimetna obtenidos muestran caracteristicas diferenciales entre ambas cuencas. La morfoestructura de la DSS, formada por dos crestas paralelas separadas por una profunda depresión axial, ha sido recubierta mediante perfilaje de multihaz con el sistema SIMRAD EM-12 en una área de 50 x 100 km. La batimetría resultante ha permitido reconocer en detalle las caracteristicas de una depresión de más de 5.300 m de profundidad y de 10 a 30 km de anchura, bautizada como Fosa Hespérides. En ella se aprecia la existencia de dos famílias de lineaciones, la primera de dirección E-W y paralela al límite de placas, y la segunda de dirección NW-SE. La primera acomodaría el movimiento cizallante regional mientras que la segunda estaría asociada con una componente extensional probablemente relacionada con la dirección de la Cuenca de Bransfield. La forma romboédrica de la fosa está determinada por la interacción de ambas famílias de lineaciones. Teniendo en cuenta que el límite de placas transcurre entre las dos crestas, interpretamos la Fosa Hespérides como una cuenca de pull-apart desarrollada como consecuencia del movimiento de cizalla a lo largo de la DSS.

Present-day deformation of the Pyrenees revealed by GPS surveying and earthquake focal mechanisms until 2011

The Pyrenean mountain range is a slowly deforming belt with continuous and moderate seismic activity. To quantify its deformation field, we present the velocity field estimated from a GPS survey of the Pyrenees spanning 18 yr. The PotSis and ResPyr networks, including a total of 85 GPS sites, were installed and first measured in 1992 and 1995 1997, respectively, and remeasured in 2008 and 2010. We obtain a deformation field with velocities less than 1 mm yr−1 across the range. The estimated velocities for individual stations do not differ significantly from zero with 95 per cent confidence. Even so, we estimate a maximum extensional horizontal strain rate of 2.0 ± 1.7 nanostrain per year in a N S direction in the western part of the range. We do not interpret the vertical displacements due to their large uncertainties. In order to compare the horizontal strain rates with the seismic activity, we analyse a set of 194 focal mechanisms using three methods: (i) the 'r' factor relating their P and T axes, (ii) the stress tensors obtained by fault slip inversion and (iii) the strain-rate tensors. Stress and strain-rate tensors are estimated for: (i) the whole data set, (ii) the eastern and western parts of the range separately, and (iii) eight zones, which are defined based on the seismicity and the tectonic patterns of the Pyrenees. Each of these analyses reveals a lateral variation of the deformation style from compression and extension in the east to extension and strike-slip in the west of the range. Although the horizontal components of the strain-rate tensors estimated from the seismic data are slightly smaller in magnitude than those computed from the GPS velocity field, they are consistent within the 2σ uncertainties. Furthermore, the orientations of their principal axes agree with the mapped active faults.

An approximate solution method for boundary layer flow of a power law fluid over a flat plate

The work in this paper deals with the development of momentum and thermal boundary layers when a power law fluid flows over a flat plate. At the plate we impose either constant temperature, constant flux or a Newton cooling condition. The problem is analysed using similarity solutions, integral momentum and energy equations and an approximation technique which is a form of the Heat Balance Integral Method. The fluid properties are assumed to be independent of temperature, hence the momentum equation uncouples from the thermal problem. We first derive the similarity equations for the velocity and present exact solutions for the case where the power law index n = 2. The similarity solutions are used to validate the new approximation method. This new technique is then applied to the thermal boundary layer, where a similarity solution can only be obtained for the case n = 1.

Ophiolite-related ultramafic rocks (Serpentinites) in the Caribbean region: a review of their occurrence, composition, origin, emplacements and Ni-Laterite soil formation

Ultramafic rocks, mainly serpentinized peridotites of mantle origin, are mostly associated with the ophiolites of Mesozoic age that occur in belts along three of the margins of the Caribbean plate. The most extensive exposures are in Cuba. The ultramafic-mafic association (ophiolites) were formed and emplaced in several different tectonic environments. Mineralogical studies of the ultramafic rocks and the chemistry of the associated mafic rocks indicate that most of the ultramafic-mafic associations in both the northern and southern margins of the plate were formed in arc-related environments. There is little mantle peridotite exposed in the ophiolitic associations of the west coast of Central America, in the south Caribbean in Curacao and in the Andean belts in Colombia. In these occurrences the chemistry and age of the mafic rocks indicates that this association is mainly part of the 89 Ma Caribbean plateau province. The age of the mantle peridotites and associated ophiolites is probably mainly late Jurassic or Early Cretaceous. Emplacement of the ophiolites possibly began in the Early Cretaceous in Hispaniola and Puerto Rico, but most emplacement took place in the Late Cretaceous to Eocene (e.g. Cuba). Along the northern South America plate margin, in the Caribbean mountain belt, emplacement was by major thrusting and probably was not completed until the Oligocene or even the early Miocene. Caribbean mantle peridotites, before serpentinization, were mainly harzburgites, but dunites and lherzolites are also present. In detail, the mineralogical and chemical composition varies even within one ultramafic body, reflecting melting processes and peridotite/melt interaction in the upper mantle. At least for the northern Caribbean, uplift (postemplacement tectonics) exposed the ultramafic massifs as a land surface to effective laterization in the beginning of the Miocene. Tectonic factors, determining the uplift, exposing the peridotites to weathering varied. In the northern Caribbean, in Guatemala, Jamaica, and Hispaniola, uplift occurred as a result of transpresional movement along pre-existing major faults. In Cuba, uplift occurred on a regional scale, determined by isostatic adjustment. In the south Caribbean, uplift of the Cordillera de la Costa and Serrania del Interior exposing the peridotites, also appears to be related to strike-slip movement along the El Pilar fault system. In the Caribbean, Ni-laterite deposits are currently being mined in the central Dominican Republic, eastern Cuba, northern Venezuela and northwest Colombia. Although apparently formed over ultramafic rocks of similar composition and under similar climatic conditions, the composition of the lateritic soils varies. Factors that probably determined these differences in laterite composition are geomorphology, topography, drainage and tectonics. According to the mineralogy of principal ore-bearing phases, Dominican Ni-laterite deposits are classified as the hydrous silicate-type. The main Ni-bearing minerals are hydrated Mg-Ni silicates (serpentine and ¿garnierite¿) occurring deeper in the profile (saprolite horizon). In contrast, in the deposits of eastern Cuba, the Ni and Cooccurs mainly in the limonite zone composed of Fe hydroxides and oxides as the dominant mineralogy in the upper part of the profile, and are classified as the oxide-type.

Sedimentological and palaeohydrological responses to tectonics and climate in a small, closed lacustrine system: Oligocene As Pontes Basin (Spain)

A small, closed, lacustrine system developed during the restraining overstep stages of the Oligocene As Pontes strike-slip basin (Spain). The increase in basin accommodation and the headward spread of the drainage, which increased the water input, triggered a change from shallow, holomictic to deeper, meromictic conditions.