High tidal volume ventilation affects neuronal activation in mechanically ventilated rats

Els malalts crítics presenten sovint seqüeles cognitives a llarg termini, l’aplicació de ventilació mecànica (VM) pot contribuir al seu desenvolupament. El principal objectiu del nostre estudi fou investigar l’efecte de dos patrons de ventilació (volum corrent elevat/baix) en l’activació neuronal (expressió de c-fos) en determinades àrees cerebrals en un model en rates. Després de 3 hores sota VM, es va trobar activació neuronal; la seva intensitat va ser superior al grup de volum corrent elevat, suggerint un efecte iatrogènic de la VM al cervell. Aquests resultats suggereixen que cal aprofundir en l’estudi del crosstalk cervell-pulmó en malalts crítics sota VM.

Performance of mechanical ventilators at the patient's home: a multicentric quality control study

Background: Quality control procedures vary considerably among the providers of equipment for home mechanical ventilation (HMV). Methods: A multicentre quality control survey of HMV was performed at the home of 300 patients included in the HMV programmes of four hospitals in Barcelona. It consisted of three steps: (1) the prescribed ventilation settings, the actual settings in the ventilator control panel, and the actual performance of the ventilator measured at home were compared; (2) the different ventilator alarms were tested; and (3) the effect of differences between the prescribed settings and the actual performance of the ventilator on non-programmed readmissions of the patient was determined. Results: Considerable differences were found between actual, set, and prescribed values of ventilator variables; these differences were similar in volume and pressure preset ventilators. The percentage of patients with a discrepancy between the prescribed and actual measured main ventilator variable (minute ventilation or inspiratory pressure) of more than 20% and 30% was 13% and 4%, respectively. The number of ventilators with built in alarms for power off, disconnection, or obstruction was 225, 280 and 157, respectively. These alarms did not work in two (0.9%), 52 (18.6%) and eight (5.1%) ventilators, respectively. The number of non-programmed hospital readmissions in the year before the study did not correlate with the index of ventilator error. Conclusions: This study illustrates the current limitations of the quality control of HMV and suggests that improvements should be made to ensure adequate ventilator settings and correct ventilator performance and ventilator alarm operation.

A new automated method versus continuous positive airway pressure method for measuring pressure-volume curves in patients with acute lung injury

Objective: To compare pressure–volume (P–V) curves obtained with the Galileo ventilator with those obtained with the CPAP method in patients with ALI or ARDS receiving mechanical ventilation. P–V curves were fitted to a sigmoidal equation with a mean R2 of 0.994 ± 0.003. Lower (LIP) and upper inflection (UIP), and deflation maximum curvature (PMC) points calculated from the fitted variables showed a good correlation between methods with high intraclass correlation coefficients. Bias and limits of agreement for LIP, UIP and PMC obtained with the two methods in the same patient were clinically acceptable.

Forced oscillation assessment of respiratory mechanics in ventilated patients

The forced oscillation technique (FOT) is a method for non-invasively assessing respiratory mechanics that is applicable both in paralysed and non-paralysed patients. As the FOT requires a minimal modification of the conventional ventilation setting and does not interfere with the ventilation protocol, the technique is potentially useful to monitor patient mechanics during invasive and noninvasive ventilation. FOT allows the assessment of the respiratory system linearity by measuring resistance and reactance at different lung volumes or end-expiratory pressures. Moreover, FOT allows the physician to track the changes in patient mechanics along the ventilation cycle. Applying FOT at different frequencies may allow the physician to interpret patient mechanics in terms of models with pathophysiological interest. The current methodological and technical experience make possible the implementation of portable and compact computerised FOT systems specifically addressed to its application in the mechanical ventilation setting.

Pneumococcal penumonia presenting with septic shock: host-ant pathogen-related factors and outcomes

BACKGROUND: Host- and pathogen-related factors associated with septic shock in pneumococcal pneumonia are not well defined. The aim of this study was to identify risk factors for septic shock and to ascertain patient outcomes. Serotypes, genotypes and antibiotic resistance of isolated strains were also analysed. METHODS: Observational analysis of a prospective cohort of non-severely immunosuppressed hospitalised adults with pneumococcal pneumonia. Septic shock was defined as a systolic blood pressure of <90 mm Hg and peripheral hypoperfusion with the need for vasopressors for >4 h after fluid replacement. RESULTS: 1041 patients with pneumococcal pneumonia diagnosed by Gram stain and culture of appropriate samples and/or urine antigen test were documented, of whom 114 (10.9%) had septic shock at admission. After adjustment, independent risk factors for shock were current tobacco smoking (OR, 2.11; 95% CI, 1.02 to 4.34; p = 0.044), chronic corticosteroid treatment (OR, 4.45; 95% CI, 1.75 to 11.32; p = 0.002) and serotype 3 (OR, 2.24; 95% CI, 1.12 to 4.475; p = 0.022). No significant differences were found in genotypes and rates of antibiotic resistance. Compared with the remaining patients, patients with septic shock required mechanical ventilation more frequently (37% vs 4%; p<0.001) and had longer length of stay (11 vs 8 days; p<0.001). The early (10% vs 1%; p<0.001) and overall case fatality rates (25% vs 5%; p<0.001) were higher in patients with shock. CONCLUSIONS: Septic shock is a frequent complication of pneumococcal pneumonia and causes high morbidity and mortality. Current tobacco smoking, chronic corticosteroid treatment and infection caused by serotype 3 are independent risk factors for this complication.

Effect of corticosteroids on the clinical course of community-acquired pneumonia: a randomized controlled trial

Introduction The benefit of corticosteroids as adjunctive treatment in patients with severe community-acquired pneumonia (CAP) requiring hospital admission remains unclear. This study aimed to evaluate the impact of corticosteroid treatment on outcomes in patients with CAP. Methods This was a prospective, double-blind and randomized study. All patients received treatment with ceftriaxone plus levofloxacin and methyl-prednisolone (MPDN) administered randomly and blindly as an initial bolus, followed by a tapering regimen, or placebo. Results Of the 56 patients included in the study, 28 (50%) were treated with concomitant corticosteroids. Patients included in the MPDN group show a more favourable evolution of the pO2/FiO2 ratio and faster decrease of fever, as well as greater radiological improvement at seven days. The time to resolution of morbidity was also significantly shorter in this group. Six patients met the criteria for mechanical ventilation (MV): five in the placebo group (22.7%) and one in the MPDN group (4.3%). The duration of MV was 13 days (interquartile range 7 to 26 days) for the placebo group and three days for the only case in the MPDN group. The differences did not reach statistical significance. Interleukin (IL)-6 and C-reactive protein (CRP) showed a significantly quicker decrease after 24 h of treatment among patients treated with MPDN. No differences in mortality were found among groups. Conclusions MPDN treatment, in combination with antibiotics, improves respiratory failure and accelerates the timing of clinical resolution of severe CAP needing hospital admission.

Adaptive intelligent agent approach to guide the web navigation on the PLAN-G distance learning platform

Hypermedia systems based on the Web for open distance education are becoming increasinglypopular as tools for user-driven access learning information. Adaptive hypermedia is a new direction in research within the area of user-adaptive systems, to increase its functionality by making it personalized [Eklu 961. This paper sketches a general agents architecture to include navigationaladaptability and user-friendly processes which would guide and accompany the student during hislher learning on the PLAN-G hypermedia system (New Generation Telematics Platform to Support Open and Distance Learning), with the aid of computer networks and specifically WWW technology [Marz 98-1] [Marz 98-2]. The PLAN-G actual prototype is successfully used with some informatics courses (the current version has no agents yet). The propased multi-agent system, contains two different types of adaptive autonomous software agents: Personal Digital Agents {Interface), to interacl directly with the student when necessary; and Information Agents (Intermediaries), to filtrate and discover information to learn and to adapt navigation space to a specific student

Adaptive business intelligence for an open negotiation environment

Engineering of negotiation model allows to develop effective heuristic for business intelligence. Digital ecosystems demand open negotiation models. To define in advance effective heuristics is not compliant with the requirement of openness. The new challenge is to develop business intelligence in advance exploiting an adaptive approach. The idea is to learn business strategy once new negotiation model rise in the e-market arena. In this paper we present how recommendation technology may be deployed in an open negotiation environment where the interaction protocol models are not known in advance. The solution we propose is delivered as part of the ONE Platform, open source software that implements a fully distributed open environment for business negotiation

Adaptive integral assessment package for the A2UN@ project

This paper presents a first approach of Evaluation Engine Architecture (EEA) as proposal to support adaptive integral assessment, in the context of a virtual learning environment. The goal of our research is design an evaluation engine tool to assist in the whole assessment process within the A2UN@ project, linking that tool with the other key elements of a learning design (learning task, learning resources and learning support). The teachers would define the relation between knowledge, competencies, activities, resources and type of assessment. Providing this relation is possible obtain more accurate estimations of student's knowledge for adaptive evaluations and future recommendations. The process is supported by usage of educational standards and specifications and for an integral user modelling

Influence of process parameters on part quality and mechanical properties for DMLS and SLM with iron-based materials

Rapid manufacturing is an advanced manufacturing technology based on layer-by-layer manufacturing to produce a part. This paper presents experimental work carried out to investigate the effects of scan speed, layer thickness, and building direction on the following part features: dimensional error, surface roughness, and mechanical properties for DMLS with DS H20 powder and SLM with CL 20 powder (1.4404/AISI 316L). Findings were evaluated using ANOVA analysis. According to the experimental results, build direction has a significant effect on part quality, in terms of dimensional error and surface roughness. For the SLM process, the build direction has no influence on mechanical properties. Results of this research support industry estimating part quality and mechanical properties before the production of parts with additive manufacturing, using iron-based powders