59 resultados para Grain number
em Consorci de Serveis Universitaris de Catalunya (CSUC), Spain
Resumo:
Wheat yield and grain nitrogen concentration (GNC; mg N/g grain) are frequently negatively correlated. In most growing conditions, this is mainly due to a feedback process between GNC and the number of grains/m2. In Mediterranean conditions, breeders may have produced cultivars with conservative grain set. The present study aimed at clarifying the main physiological determinants of grain nitrogen accumulation (GNA) in Mediterranean wheat and to analyse how breeding has affected them. Five field experiments were carried out in north-eastern Spain in the 2005/06 and 2006/ 07 growing seasons with three cultivars released at different times and an advanced line. Depending on the experiment, source-sink ratios during grain filling were altered by reducing grain number/m2 either through pre-anthesis shading (unshaded control or 0.75 shading only between jointing and anthesis) or by directly trimming the spikes after anthesis and before the onset of the effective grain filling period (un-trimmed control or spikes halved 7–10 days after anthesis). Grain nitrogen content (GN content ; mg N/grain) decreased with the year of release of the genotypes. As the number of grains/m2 was also increased by breeding there was a clear dilution effect on the amount of nitrogen allocated to each grain. However, the increase in GN content in old genotypes did not compensate for the loss in grain nitrogen yield (GNY) due to the lower number of grains/m2. GN content of all genotypes increased (increases ranged from 0.13 to 0.40 mg N/grain, depending on experiment and genotype) in response to the post-anthesis spike trimming or pre-anthesis shading. The degree of source-limitation for GNA increased with the year of release of the genotypes (and thus with increases in grain number/m2) from 0.22 (mean of the four manipulative experiments) in the oldest cultivar to 0.51 (mean of the four manipulative experiments) in the most modern line. It was found that final GN content depended strongly on the source-sink ratio established at anthesis between the number of grains set and the amount of nitrogen absorbed at this stage. Thus, Mediterranean wheat breeding that improved yield through increases in grain number/m2 reduced the GN content by diluting a rather limited source of nitrogen into more grains. This dilution effect produced by breeding was further confirmed by the reversal effect produced by grain number/m2 reductions due to either pre-anthesis shading or post-anthesis spike trimming.
Resumo:
The dynamics of homogeneously heated granular gases which fragment due to particle collisions is analyzed. We introduce a kinetic model which accounts for correlations induced at the grain collisions and analyze both the kinetics and relevant distribution functions these systems develop. The work combines analytical and numerical studies based on direct simulation Monte Carlo calculations. A broad family of fragmentation probabilities is considered, and its implications for the system kinetics are discussed. We show that generically these driven materials evolve asymptotically into a dynamical scaling regime. If the fragmentation probability tends to a constant, the grain number diverges at a finite time, leading to a shattering singularity. If the fragmentation probability vanishes, then the number of grains grows monotonously as a power law. We consider different homogeneous thermostats and show that the kinetics of these systems depends weakly on both the grain inelasticity and driving. We observe that fragmentation plays a relevant role in the shape of the velocity distribution of the particles. When the fragmentation is driven by local stochastic events, the longvelocity tail is essentially exponential independently of the heating frequency and the breaking rule. However, for a Lowe-Andersen thermostat, numerical evidence strongly supports the conjecture that the scaled velocity distribution follows a generalized exponential behavior f (c)~exp (−cⁿ), with n ≈1.2, regarding less the fragmentation mechanisms
Resumo:
Further genetic gains in wheat yield are required to match expected increases in demand. This may require the identification of physiological attributes able to produce such improvement, as well as the genetic bases controlling those traits in order to facilitate their manipulation. In the present paper, a theoretical framework of source and sink limitation to wheat yield is presented and the fine-tuning of crop development as an alternative for increasing yield potential is discussed. Following a top-down approach, most crop physiologists have agreed that the main attribute explaining past genetic gains in yield was harvest index (HI). By virtue of previous success, no further gains may be expected in HI and an alternative must be found. Using a bottom-up approach, the present paper firstly provides evidence on the generalized sink-limited condition of grain growth, determining that for further increases in yield potential, sink strength during grain filling has to be increased. The focus should be on further increasing grain number per m2, through fine-tuning pre-anthesis developmental patterns. The phase of rapid spike growth period (RSGP) is critical for grain number determination and increasing spike growth during pre-anthesis would result in an increased number of grains. This might be achieved by lengthening the duration of the phase (though without altering flowering time), as there is genotypic variation in the proportion of pre-anthesis time elapsed either before or after the onset of the stem elongation phase. Photoperiod sensitivity during RSGP could be then used as a genetic tool to further increase grain number, since slower development results in smoother floret development and more floret primordia achieve the fertile floret stage, able to produce a grain. Far less progress has been achieved on the genetic control of this attribute. None of the well-known major Ppd alleles seems to be consistently responsible for RSGP sensitivity. Alternatives for identifying the genetic factors responsible for this sensitivity (e.g. quantitative trait locus (QTL) identification in mapping populations) are being considered.
Resumo:
A problem in the archaeometric classification of Catalan Renaissance pottery is the fact, thatthe clay supply of the pottery workshops was centrally organized by guilds, and thereforeusually all potters of a single production centre produced chemically similar ceramics.However, analysing the glazes of the ware usually a large number of inclusions in the glaze isfound, which reveal technological differences between single workshops. These inclusionshave been used by the potters in order to opacify the transparent glaze and to achieve a whitebackground for further decoration.In order to distinguish different technological preparation procedures of the single workshops,at a Scanning Electron Microscope the chemical composition of those inclusions as well astheir size in the two-dimensional cut is recorded. Based on the latter, a frequency distributionof the apparent diameters is estimated for each sample and type of inclusion.Following an approach by S.D. Wicksell (1925), it is principally possible to transform thedistributions of the apparent 2D-diameters back to those of the true three-dimensional bodies.The applicability of this approach and its practical problems are examined using differentways of kernel density estimation and Monte-Carlo tests of the methodology. Finally, it istested in how far the obtained frequency distributions can be used to classify the pottery
Resumo:
Vegeu el resum a l'inici del document del fitxer adjunt
Resumo:
Vegeu el resum a l'inici del document del fitxer adjunt
Resumo:
The aim of this paper is to suggest a method to find endogenously the points that group the individuals of a given distribution in k clusters, where k is endogenously determined. These points are the cut-points. Thus, we need to determine a partition of the N individuals into a number k of groups, in such way that individuals in the same group are as alike as possible, but as distinct as possible from individuals in other groups. This method can be applied to endogenously identify k groups in income distributions: possible applications can be poverty
Resumo:
"Vegeu el resum a l'inici del document del fitxer adjunt"
Resumo:
"Vegeu el resum a l'inici del document del fitxer adjunt."
Resumo:
"Vegeu el resum a l'inici del document del fitxer adjunt."
Resumo:
"Vegeu el resum a l'inici del document del fitxer adjunt."
Resumo:
Projecte de recerca elaborat a partir d’una estada al Department for Feed and Food Hygiene del National Veterinary Institute, Noruega, entre novembre i desembre del 2006. Els grans de cereal poden estar contaminats amb diferents espècies de Fusarium capaces de produir metabolits secundaris altament tòxics com trichotecenes, fumonisines o moniliformines. La correcta identificació d’aquestes espècies és de gran importància per l’assegurament del risc en l’àmbit de la salut humana i animal. La identificació de Fusarium en base a la seva morfologia requereix coneixements taxonòmics i temps; la majoria dels mètodes moleculars permeten la identificació d’una única espècie diana. Per contra, la tecnologia de microarray ofereix l’anàlisi paral•lel d’un alt nombre de DNA dianes. En aquest treball, s’ha desenvolupat un array per a la identificació de les principals espècies de Fusarium toxigèniques del Nord i Sud d’Europa. S’ha ampliat un array ja existent, per a la detecció de les espècies de Fusarium productores de trichothecene i moniliformina (predominants al Nord d’Europa), amb l’addició de 18 sondes de DNA que permeten identificar les espècies toxigèniques més abundants al Sud d’Europa, les qual produeixen majoritàriament fumonisines. Les sondes de captura han estat dissenyades en base al factor d’elongació translació- 1 alpha (TEF-1alpha). L’anàlisi de les mostres es realitza mitjançant una única PCR que permet amplificar part del TEF-1alpha seguida de la hibridació al xip de Fusarium. Els resultats es visualitzen mitjançant un mètode de detecció colorimètric. El xip de Fusarium desenvolupat pot esdevenir una eina útil i de gran interès per a l’anàlisi de cereals presents en la cadena alimentària.
Resumo:
The study was performed in the installations of OCAS, a Steel Research Centre of ArcelorMittal. Taking M32 steel (3.25%Si+0.9%Al) as the basis chemical composition and three different thicknesses (0.35, 0.5 and 0.65mm), different annealing conditions (temperature and time) have been applied in the laboratory simulator at St. Chély, France. The aim was to link annealing parameters, grain size and energy loss. It was determined the optimum annealing parameters to reach the lowest power losses for three different grades of non-oriented fully processed electrical steel. In addition, M250-50 samples having different magnetic behaviour (high and low losses) but the same grain size and texture, have been analyzed in terms of TEM observations of their precipitates, in the University of Marseille. The results reveal that a high amount of medium and big precipitates (&10 nm) worsen the magnetic properties of the material. The small precipitates (&10nm) do not have a strong influence on the magnetic properties. The presence of precipitates can have a great influence on the power losses and further work is clearly necessary.
Resumo:
Report for the scientific sojourn at the James Cook University, Australia, between June to December 2007. Free convection in enclosed spaces is found widely in natural and industrial systems. It is a topic of primary interest because in many systems it provides the largest resistance to the heat transfer in comparison with other heat transfer modes. In such systems the convection is driven by a density gradient within the fluid, which, usually, is produced by a temperature difference between the fluid and surrounding walls. In the oil industry, the oil, which has High Prandtl, usually is stored and transported in large tanks at temperatures high enough to keep its viscosity and, thus the pumping requirements, to a reasonable level. A temperature difference between the fluid and the walls of the container may give rise to the unsteady buoyancy force and hence the unsteady natural convection. In the initial period of cooling the natural convection regime dominates over the conduction contribution. As the oil cools down it typically becomes more viscous and this increase of viscosity inhibits the convection. At this point the oil viscosity becomes very large and unloading of the tank becomes very difficult. For this reason it is of primary interest to be able to predict the cooling rate of the oil. The general objective of this work is to develop and validate a simulation tool able to predict the cooling rates of high Prandtl fluid considering the variable viscosity effects.
Resumo:
"Vegeu el resum a l'inici del document del fitxer adjunt."