The influence of a certain volume of fluid in the lower tear meniscus on intraocular pressure measurements using the non-contact tonometer

Background: Intraocular pressure (IOP) is the pressure inside the eye that helps to maintain the integrity and the suitable form of the ocular globe. Precise and accurate measures of IOP are needed for the diagnosis as well as follow-up of glaucoma. In daily clinical practice, Goldmann applanation tonometer (GAT) and Non-contact tonometer (NCT) are the most common devices for measuring IOP. A close agreement between these methods has been showed, particularly in normotensive patients and a poor agreement, especially when IOP levels are above the normal range. Ophthalmologists have noticed a poor agreement between NCT and GAT, observing that by using NCT and after comparing with GAT, there is an overestimation of IOP readings, and particularly it occurs when the eyes are tearful. Previous studies investigate the effect of tears in Non-contact tonometer readings by the instillation of artificial tears, concluding in one of the studies that the variation was less than 1mmHg and not clinically significant, in contrast with another study which the increases were sadistically significant. Tear menisci are a thin strip of tear fluid located between the bulbar conjunctiva and the eyelid margins. We think that the overestimation of IOP readings using NCT could be due to the presence of a higher volume of tear in the lower tear meniscus which might cause an optical interference in the optoelectronic applanation monitoring system of this deviceObjectives: To research the influence of a certain volume of fluid in the lower tear meniscus on IOP measurements using the NCT in healthy eyes. Moreover, to investigate the agreement between IOP readings obtained by NCT and GAT in the presence and absence of this volume of fluidMethods: The study design will be transversal for diagnostic tests of repeated measures. We will study patients with no ocular pathology and IOP<21mmHg. It will consist in the measurement of IOP using NCT before and after the instillation of COLIRCUSÍ FLUOTEST, used as a volume of fluid in the lower tear meniscus, to observe if there will be differences using the paired t-test. Moreover, we will take IOP measures by GAT in order to know the agreement between these methods after and before the application of these eyedrops, using the ICC (intraclass correlation coefficient) and the Bland-Altmann method

Pressure-dependent scaling scenarios in experiments of spontaneous imbibition

The scaling properties of the rough liquid-air interface formed in the spontaneous imbibition of a viscous liquid by a model porous medium are found to be very sensitive to the magnitude of the pressure difference applied at the liquid inlet. Interface fluctuations change from obeying intrinsic anomalous scaling at large negative pressure differences, to being super-rough with the same dynamic exponent z¿3 at less negative pressure differences, to finally obeying ordinary Family-Vicsek scaling with z¿2 at large positive pressure differences. This rich scenario reflects the relative importance on different length scales of capillary and permeability disorder, and the role of surface tension and viscous pressure in damping interface fluctuations.

Fluid dynamical prediction of changed v1 flow at energies available at the CERN Large Hadron Collider

Substantial collective flow is observed in collisions between lead nuclei at Large Hadron Collider (LHC) as evidenced by the azimuthal correlations in the transverse momentum distributions of the produced particles. Our calculations indicate that the global v1-flow, which at RHIC peaked at negative rapidities (named third flow component or antiflow), now at LHC is going to turn toward forward rapidities (to the same side and direction as the projectile residue). Potentially this can provide a sensitive barometer to estimate the pressure and transport properties of the quark-gluon plasma. Our calculations also take into account the initial state center-of-mass rapidity fluctuations, and demonstrate that these are crucial for v1 simulations. In order to better study the transverse momentum flow dependence we suggest a new "symmetrized" v1S(pt) function, and we also propose a new method to disentangle global v1 flow from the contribution generated by the random fluctuations in the initial state. This will enhance the possibilities of studying the collective Global v1 flow both at the STAR Beam Energy Scan program and at LHC.

Interfacial instabilities of a fluid annulus in a rotating Hele-Shaw cell

We have studied the interfacial instabilities experienced by a liquid annulus as it moves radially in a circular Hele-Shaw cell rotating with angular velocity Omega. The instability of the leading interface (oil displacing air) is driven by the density difference in the presence of centrifugal forcing, while the instability of the trailing interface (air displacing oil) is driven by the large viscosity contrast. A linear stability analysis shows that the stability of the two interfaces is coupled through the pressure field already at a linear level. We have performed experiments in a dry cell and in a cell coated with a thin fluid layer on each plate, and found that the stability depends substantially on the wetting conditions at the leading interface. Our experimental results of the number of fingers resulting from the instability compare well with the predictions obtained through a numerical integration of the coupled equations derived from a linear stability analysis. Deep in the nonlinear regime we observe the emission of liquid droplets through the formation of thin filaments at the tip of outgrowing fingers.

Fluid dynamical prediction of changed v1-flow at energies available at the CERN Large Hadron Collider

Substantial collective flow is observed in collisions between lead nuclei at Large Hadron Collider (LHC) as evidenced by the azimuthal correlations in the transverse momentum distributions of the produced particles. Our calculations indicate that the global v1-flow, which at RHIC peaked at negative rapidities (named third flow component or antiflow), now at LHC is going to turn toward forward rapidities (to the same side and direction as the projectile residue). Potentially this can provide a sensitive barometer to estimate the pressure and transport properties of the quark-gluon plasma. Our calculations also take into account the initial state center-of-mass rapidity fluctuations, and demonstrate that these are crucial for v1 simulations. In order to better study the transverse momentum flow dependence we suggest a new"symmetrized" vS1(pt) function, and we also propose a new method to disentangle global v1 flow from the contribution generated by the random fluctuations in the initial state. This will enhance the possibilities of studying the collective Global v1 flow both at the STAR Beam Energy Scan program and at LHC.

Fluid dynamical prediction of changed v1-flow at energies available at the CERN Large Hadron Collider

Substantial collective flow is observed in collisions between lead nuclei at Large Hadron Collider (LHC) as evidenced by the azimuthal correlations in the transverse momentum distributions of the produced particles. Our calculations indicate that the global v1-flow, which at RHIC peaked at negative rapidities (named third flow component or antiflow), now at LHC is going to turn toward forward rapidities (to the same side and direction as the projectile residue). Potentially this can provide a sensitive barometer to estimate the pressure and transport properties of the quark-gluon plasma. Our calculations also take into account the initial state center-of-mass rapidity fluctuations, and demonstrate that these are crucial for v1 simulations. In order to better study the transverse momentum flow dependence we suggest a new"symmetrized" vS1(pt) function, and we also propose a new method to disentangle global v1 flow from the contribution generated by the random fluctuations in the initial state. This will enhance the possibilities of studying the collective Global v1 flow both at the STAR Beam Energy Scan program and at LHC.

Stability and asymptotic analysis of a fluid-particle interaction model

We are interested in coupled microscopic/macroscopic models describing the evolution of particles dispersed in a fluid. The system consists in a Vlasov-Fokker-Planck equation to describe the microscopic motion of the particles coupled to the Euler equations for a compressible fluid. We investigate dissipative quantities, equilibria and their stability properties and the role of external forces. We also study some asymptotic problems, their equilibria and stability and the derivation of macroscopic two-phase models.

Pressure groups and experts in environmental regulation

We study a problem of adverse selection in the context of environmental regulation, where the firm may suffer from a certain degree of ignorance about its own type. In a framework like the construction of a certain infrastructure project, the presence of ignorance about its impact on the environment, can play an important role in the determination of the regulatory policy. First, an optimal contract is constructed for any exogenous level of ignorance. Second, the presence of potentially informed third-parties is studied from the perspective of the regulator, which allows us to analyze the impact on the efficiency of the contract, of the presence of environmentalists and of experts. Then, we obtain some insights on how the problem differs when the degree of ignorance is a choice variable for the firm. We finally use our results to derive policy implications concerning the existing envoronmental regulation, and the potential role of interested parties as information providers.

Effect of high pressure processing on the microbiology of skin-vacuum packaged sliced meat products: cooked pork ham, dry cured pork ham and marinated beef loin

High hydrostatic pressure is being increasingly investigated in food processing. It causes microbial inactivation and therefore extends the shelf life and enhances the safety of food products. Yeasts, molds, and vegetative cells of bacteria can be inactivated by pressures in the range of 200 to 700 MPa. Microorganisms are more or less sensitive to pressure depending on several factors such as type, strain and the phase or state of the cells. In general, Gram-positive organisms are usually more resistant than Gram-negative. High pressure processing modifies the permeability of the cell membrane, the ion exchange and causes changes in morphology and biochemical reactions, protein denaturations and inhibition of genetic mechanisms. High pressure has been used successfully to extend the shelf life of high-acid foods such as refrigerated fruit juices, jellies and jams. There is now an increasing interest in the use of this technology to extend the shelf life of low-acid foods such as different types of meat products.

Bioequivalence of meat products treated with high pressure processing

The effects of high pressure on the composition of food products have not been evaluated extensively. Since, it is necessary to take in consideration the possible effects in basis to the changes induced in the bio molecules by the application of high pressures. The main effect on protein is the denaturation, because the covalent bonds are not affected; however hydrogen bonding, hydrophobic and intermolecular interactions are modified or destroyed. 1 High pressure can modify the activity of some enzymes. If this is done the proteolysis and lipolysis could be more or less intense and the content of free amino acids and fatty acids will be different. This could be related to the bioavailability of these compounds. Low pressures (100 MPa) have been shown to activate some enzymes (monomeric enzymes). Higher pressures induce loss of the enzyme activity. However some enzymes are very stable (ex. Lipase ~ 600 - 1000 MPa). Lipoxygenase is less stable, and there is little information about the effects on antioxidant enzymes. Other important issue is the influence of high pressure on oxidation susceptibility. This could modify the composition of lipids if the degree of the oxidation would have been higher or lower than in the traditional product. Pressure produces the damage of cell membranes favouring the contact between substrates and enzymes, exposure to oxidation of membrane fatty acids and loos of the efficiency of vitamin E. These effects can also affect to protein oxidation. In this study different compounds were analysed to establish the differences between non-treated and high-pressure treated products.

Tourism and urban transport: holding demand pressure under supply constraints

Scholars and local planners are increasingly interested in tourism contribution to economic and social development. To this regard, several European cities lead the world rankings on tourist arrivals, and their governments have promoted tourism activity. Mobility is an essential service for tourists visiting large cities, since it is a crucial factor for their comfort. In addition, it facilitates the spread of benefits across the city. The aim of this study is to determine whether city planners respond to this additional urban transport demand pressure by extending supply services. We use an international database of European cities. Our results confirm that tourism intensity is a demand enhancing factor on urban transport. Contrarily, cities do not seem to address this pressure by increasing service supply. This suggests that tourism exerts a positive externality on public transport since it provides additional funding for these services, but it imposes as well external costs on resident users because of congestion given supply constraints.

Experimental investigation of transient natural convection cooling of high prandtl number fluid with variable viscosity

Report for the scientific sojourn at the James Cook University, Australia, between June to December 2007. Free convection in enclosed spaces is found widely in natural and industrial systems. It is a topic of primary interest because in many systems it provides the largest resistance to the heat transfer in comparison with other heat transfer modes. In such systems the convection is driven by a density gradient within the fluid, which, usually, is produced by a temperature difference between the fluid and surrounding walls. In the oil industry, the oil, which has High Prandtl, usually is stored and transported in large tanks at temperatures high enough to keep its viscosity and, thus the pumping requirements, to a reasonable level. A temperature difference between the fluid and the walls of the container may give rise to the unsteady buoyancy force and hence the unsteady natural convection. In the initial period of cooling the natural convection regime dominates over the conduction contribution. As the oil cools down it typically becomes more viscous and this increase of viscosity inhibits the convection. At this point the oil viscosity becomes very large and unloading of the tank becomes very difficult. For this reason it is of primary interest to be able to predict the cooling rate of the oil. The general objective of this work is to develop and validate a simulation tool able to predict the cooling rates of high Prandtl fluid considering the variable viscosity effects.

Authoritarian Responses to Foreign Pressure: Spending, Repression, and Sanctions

This paper explores how international sanctions affect authoritarian rulers’ decisions concerning repression and public spending composition, and how different authoritarian rulers respond to foreign pressure. If sanctions are assumed to increase the price of loyalty to the regime, then rulers whose budgets are not severely constrained by sanctions will tend to increase spending in those categories that most benefit their core support groups. In contrast, when constraints are severe due to reduced aid and trade, dictators are expected to greatly increase their levels of repression. Using data on regime types, public expenditures and spending composition (1970–2000) as well as on repression levels (1976–2001), we show that the empirical patterns conform well to our theoretical expectations. Single-party regimes, when targeted by sanctions, increase spending on subsidies and transfers which largely benefit more substantial sectors of the population and especially the urban classes. Likewise, military regimes increase their expenditures on goods and services, which include military equipment and soldiers’ and officers’ wages. Conversely, personalist regimes reduce spending in all categories, especially capital expenditures, while increasing repression much more than other regime types when targeted by sanctions.

Product differentiation, competitive pressure and the effects of innovation on the success and survivability of firms in oligopoly markets

In a recent paper Tishler and Milstein (2009) fi…nd that increased competition may increase aggregate R&D spending while market output decreases. Therefore, they obtain the surprising result that R&D spending is excessive when competition becomes intense. Their result is based on the standard linear demand function for differentiated products introduced by Bowley (1924) where decreased product differentiation is interpreted as more competitive pressure. In this paper I show that at an aggregate level this interpretation is problematic because equilibrium effects are dominated by a demand reduction effect. A slight modifi…cation of the standard demand function eliminates this effect. For the Tishler and Milstein (2009) setting it is shown that then increased competition increases both R&D spending and aggregate market output. Therefore, at least for consumers, more intense competition increases welfare. Journal of Economic Literature Classi…fication Numbers: D43, L1, O3. Keywords: Oligopoly markets, Product differentiation, Competitive pressure.

Obtenció de matrius poroses d'àcid polilàctic (PDLLA) mitjançant fluids comprimits per a ús en regeneració tissular

En aquest treball es pretén obtenir material porós de PDLLA, amb ús potencial com a bastida en enginyeria tissular, mitjançant l’ús de freó R-134a com a fluid escumant. Per aquest motiu, s’ha realitzat un estudi on es valoren diferents variables com la temperatura de procés, la pressió de treball i l’ús de N2 en la despressurització que poden modificar la microestructura final de la bastida.